Factors affecting the direct mineralization of CO2 with olivine

Olivine, one of the most abundant minerals existing in nature, is explored as a CO2 carbonation agent for direct carbonation of CO2 in flue gas. Olivine based CO2 capture is thermodynamically favorable and can form a stable carbonate for long-term storage. Experimental results have shown that water vapor plays an important role in improving CO2 carbonation rate and capacities. Other operation conditions including reaction temperature, initial CO2 concentration, residence time corresponding to the flow rate of CO2 gas stream, and water vapor concentration also considerably affect the performance of the technology.     

Silver impregnated carbon for adsorption and desorption of elemental mercury vapors

The Hg0 vapor adsorption experimental results on a novel sorbent obtained by impregnating a commercially available activated carbon (Darco G60 from BDH) with silver nitrate were reported. The study was performed by using a fundamental approach, in an apparatus at laboratory scale in which a synthetic flue gas, formed by Hg0 vapors in a nitrogen gas stream, at a given temperature and mercury concentration, was flowed through a fixed bed of adsorbent material. Breakthrough curves and adsorption isotherms were obtained for bed temperatures of 90, 120 and 150°C and for Hg0 concentrations in the gas varying in the range of 0.8–5.0 mg/m3. The experimental gas-solid equilibrium data were used to evaluate the Langmuir parameters and the heat of adsorption. The experimental results showed that silver impregnated carbon was very effective to capture elemental mercury and the amount of mercury adsorbed by the carbon decreased as the bed temperature increased. In addition, to evaluate the possibility of adsorbent recovery, desorption was also studied. Desorption runs showed that both the adsorbing material and the mercury could be easily recovered, since at the end of desorption the residue on solid was almost negligible. The material balance on mercury and the constitutive equations of the adsorption phenomenon were integrated, leading to the evaluation of only one kinetic parameter which fits well both the experimentally determined breakthrough and desorption curves.     

基于REOF方法的辽宁气候舒适度区域特征分析

基于辽宁省50个气象站1964-2008年的气象资料,采用适应东北地区的人体舒适度计算公式及分级标准,得出辽宁省近45年历年人体各舒适度级别日数,使用旋转经验正交分解法(REOF),对辽宁省气候舒适度进行区域划分,并分析了各区域气候舒适度的空间分布特征和变化趋势.结果表明:(1)根据前4个旋转倚载向量场高载荷区分布,将...     

Ru-Ta/Ti阳极电解深度处理垃圾渗滤液

采用Ru-Ta/Ti三元电极为阳极,以不锈钢电极为阴极对垃圾渗滤液生物处理出水进行了电解处理研究,以COD为控制指标.重点研究了电解电压、电解时间、pH值、曝气量、电解质的添加等因素对电解处理效果的影响.研究结果表明:电压为7 V、处理时间为30 min、pH=9、曝气量为0.04m3/h、添加电解质为MnⅡ的条件下电...     

福州城市边缘区森林土壤重金属污染特征及评价

为掌握福州城市边缘区森林土壤重金属污染特征,选取10个典型区域作为研究对象,分析森林土壤中Zn、Mn、Cr、Pb、Cu 5种重金属的含量及分布特征,并采用单项污染指数和综合污染指数法对土壤进行质量评价,结果表明:Cr、Pb是该区土壤重金属污染最主要的元素;Zn、Cu、Pb、Cr含量随土层深度增加而减少,Mn则相反;Zn...     

有机质对土壤气相抽提去除四氯化碳效率的影响

某重要岩溶地下水源地因附近农药厂排放含四氯化碳污水而受到严重污染,实验采用土柱通风试验模拟土壤气相抽提(SVE),研究环境温度为20℃,通风速率为40mL/min,土壤含水率10%,而土壤有机质含量分别为3.02%和0.13%条件下的两种供试土壤中四氯化碳污染物的去除过程.结果表明,土柱通风能有效去除土壤中的四氯化碳污...     

电镀行业清洁生产指标体系的修正

文章旨在通过剖析清洁生产指标体系建立的全过程,发现《电镀行业清洁生产指标体系(试行)》存在的缺陷与不足,并进行修正,采用层次分析法对修正后的定量指标体系赋权.最后选用三家电镀企业,对修正前后的指标体系进行评价与对比,并据此证明:修正后的指标体系更能客观评价企业真实的清洁生产水平.     

兰州银滩湿地5种植物对重金属吸附能力的分析

利用原子吸收分光光度法测定兰州银滩湿地5种植物及其生长土壤(表层)中Cu、Pb、Zn的含量,结果表明,采样区域表层土壤存在轻度Cu、Zn、Pb污染,其中Cu、Pb的来源或污染途径可能相同,且Cu、Zn、Pb的生物可利用性较低,TCLP生态风险评价显示均小于国际标准值;采样区域表层土壤Cu、Zn、Pb总量与TCLP提取量...     

中药工业废水处理研究进展

概述了目前中药工业废水处理应用的各种物化、生物处理技术;对主要处理工艺的应用特点进行了论述;指出了中药工业废水处理技术今后的研究开发方向和思路。     

电厂二氧化碳捕捉技术对比研究

由于全球温室效应的不断加剧,发展二氧化碳捕捉技术变得十分必要.通过分析燃烧前捕捉、燃烧后捕捉和富氧燃烧捕捉三种二氧化碳捕捉方式流程及其特点,指出三种不同的二氧化碳捕捉技术的发展现状以及应用途径.通过具体对比现有二氧化碳捕捉技术的工作原理以及优缺点,针对现有的几种具体的二氧化碳捕捉技术进行详细的分析,积极应用各种物理、化...