Fe2O3-Cr2O3/TiO2系列催化剂的结构和脱硝性能

研究以纳米TiO2为载体,浸渍负载过渡金属氧化物,以CO为还原剂的脱硝催化剂的脱硝性能。实验中以计算量的Ni(NO3)2和Fe(NO3)3混合溶液浸渍纳米TiO2粉末,室温下搅拌30 min至混合均匀,放入旋转蒸发器中,70℃下至水分蒸干为止;所得粉末在550℃下、空气气氛中焙烧4 h即得所需催化剂。用以上方法分别制备2%Fe2O3-10%Cr2O3/TiO2、4%Fe2O3-8%Cr2O3/TiO2、6%Fe2O3-6%Cr2O3/TiO2、8%Fe2O3-4%Cr2O3/TiO2与10%Fe2O3-2%Cr2O3/TiO2等5种催化剂样品。实验结果表明,制备的催化剂具有较好的结构,分散较为均匀。对于CO+NO反应,Fe2O3-Cr2O3/TiO2系列催化剂具有较好的催化活性,NO的转化率都达到了100%。其中,10%Fe2O3-2%Cr2O3/TiO2样品具有最好的低温活性,H2-TPR结果表明,这是由于10%Fe2O3-2%Cr2O3/TiO2催化剂更易于被CO预还原。     

负载型TiO2膜太阳光光催化降解活性深蓝K-R的研究

采用抛物线槽型反应装置,研究了玻璃弹簧和微珠负载型TiO2膜太阳光催化降解活性深蓝K-R,结果表明,由于玻璃弹簧具有良好的光透距离,脱色性能显著优于玻璃微珠,玻璃弹簧为载体,水溶液浓度为15mg/L,pH为3,流速为20mL/s,太阳光强度在1200 μW/cm2以上,光降解6h时,脱色率达到96%; 该降解反应可用一级反应动力学方程进行描述,反应速率常数（K）与光强I的关系为：K∝I1.92。     

Desorption of polycyclic aromatic hydrocarbons from field-contaminated soil to a two-dimensional hydrophobic surface before and after bioremediation

This study investigated environmental distributions and production mechanisms of chlorinated polycyclic aromatic hydrocarbons (Cl-PAHs) in the sediments from some tidal flats located in Asia. Cl-PAHs were found in sediments taken from Arao tidal flat, Kikuchigawa River and Shirakawa River. The range of ∑Cl-PAHs was from 25.5 to 483 pg g⁻¹ for Kikuchigawa River and Arao tidal flat, respectively.Concentrations of PAHs and Cl-PAHs showed no significant correlations (r = 0.134). This result suggests that the origins of these compounds differ. In the identified Cl-PAH isomers, the most abundant Cl-PAH isomer was 9,10-dichloroanthracene (9,10-di-Cl-ANT) in the three sites. In general, concentrations of Cl-ANTs in the coastal environment are about 3-5 orders of magnitude lower than those of anthracene (ANT). However, concentration ratios between Cl-ANTs and ANT (Cl-ANTs/ANT) in the sediments ranged from 4.1% to 24.6%. This result indicated that Cl-PAHs were not generated under industrial processes but the high concentration ratios have resulted from the contribution of photochemical production of Cl-ANTs in the sediments because ANT is known to have high photochemical reactivity.For examining this phenomenon, ANT adsorbed onto glass beads was irradiated with UV under the mimicked field conditions of tidal flats. As a result, it was noticed that, while chlorinated derivatives were negligible in a light-controlled group, production of 2-Cl-ANT, 9-Cl-ANT and 9,10-diCl-ANT on the irradiated surface were found in this study. These results suggest that photochemical reaction of PAHs can be a potential source of the occurrence of Cl-PAHs in the coastal environment.     

Prenatal diagnosis for dystrophia myotonica using the polymerase chain reaction

The polymerase chain reaction has been used to detect an abundant class of short repeat DNA families of the form (dC-dA)n.(dG-dT)n, known as microsatellites. These units are found throughout the human genome and have been characterized for several loci including APOC2 on chromosome 19ql2-ql3.2. The locus APOC2 is linked to the gene for dystrophia myotonica and a microsatellite within this locus was used to derive polymorphisms in a family to predict the inheritance of the disease. Chorionic villus sampling (CVS) was performed at 151/2 weeks' gestation. Following DNA extraction from the CVS material and parental blood samples, microsatellite analysis was carried out by the polymerase chain reaction.     

An approach to preimplantation diagnosis of β-thalassaemia

Using the polymerase chain reaction (PCR), it was possible to amplify a single copy fragment of the β-globin gene from 2–32 human embryonic cells obtained from arrested preimplantation embryos. For the detection of β-thalassaemia mutations, allele specific priming of the PCR using nested primers was employed using approximately 10 pg of DN A from individuals known to carry these mutations. This approach was successful in detecting the presence or absence of five Asian Indian β-thalassaemia mutations that were selected for this study. In spite of meticulous precautions against contamination, false-positive amplification was observed, a problem that will have to be overcome before this approach can be used in clinical practice.     

钢绞线逐根张拉下锚墩基床沉陷所致锚索预应力损失问题

在预应力锚索锚墩下部地基岩土的基床系数较低情况下,采用钢绞线逐根张拉来施加预应力会导致较大的预应力损失以及各钢绞线较显著的预应力不均。基于锚墩基床岩土体的弹性压缩模型,理论探讨了钢绞线逐根对称循环张拉下的锚索预应力损失,及钢绞线的预应力均匀性问题。分析表明,基床系数越低,逐根张拉下的锚索预应力损失越大,且其所含各钢绞线预应力的均匀性越差;而同样荷载和基床系数下,锚索所含钢绞线根数越多, 逐根张拉后的预应力损失和不均匀性也越大。但采用分级循环张拉、正序张拉及调整、锚墩下部一定扩散角填石等工序及措施有助于减轻预应力损失和解决不均匀性问题。     

用溶解氧浓度作为SBR法过程和反应时间控制参数

进行了以DO作为SBR法过程和反应时间控制参数的试验研究。结果表明,无论使曝气量或初始污泥浓度大幅度变化,还是逐渐或突然改变初始有机物浓度等各种试验条件,都会在反应阶段开始不久出现所谓平衡DO浓度现象;当有机物达到其难降解浓度时DO浓度迅速地大幅度升高。因此,在目前还没有简易、快速的有机物浓度传感器的情况下,DO不仅可作为反应时间的指示性控制参数,而且也能可靠地作为反应阶段的过程控制参数。     

碳酸镁与镉离子的吸附和沉淀作用研究

以碳酸镁为吸附剂,在镉离子初始浓度为0~6 mmol/L,初始pH值为4和7的条件下,研究了碳酸镁与镉离子的吸附与沉淀作用。结果表明,由于碳酸镁的溶解及与体系中氢离子的中和,碳酸镁—镉体系的最终pH值为10.4左右;体系的平衡pH值随着镉离子初始浓度的增加而减小;体系中镉的平衡浓度随着初始镉离子浓度的增加缓慢上升;碳酸镁对镉的吸附等温线为折线型,不符合Freundlich和Langmuir模型,符合伪二阶吸附动力学模型。结合碳酸镁吸附镉前后固相表征的结果,说明碳酸镁与镉离子的作用机制随着镉离子浓度的增加,从离子交换发展为离子交换和表面配位反应并存,最后表现为表面沉淀。     

铁炭微电解法降解TAIC废水

TAIC（三烯丙基异氰脲酸酯）作为过氧化物交联或自由基反应交联的助交联剂被广泛应用。由于TAIC性质稳定难于生物降解,采用铁炭微电解法处理TAIC生产废水,并考察了铁炭比、进水pH值、反应时间对处理效果的影响,以及TAIC降解机理和反应动力学过程。结果表明,影响微电解工艺的因素主次关系为：pH>Fe/C质量比>反应时间;在最佳条件进水pH值为5,铁炭质量比为2：1,反应时间为135 min时,COD的去除率达到46%以上,TAIC的去除率达到48%以上。TAIC去除机理研究表明,微电解对TAIC废水的作用主要通过·H的还原和铁离子的絮凝作用,其中·H的还原作用是TAIC降解的主要原因。反应动力学分析表明,铁炭微电解法处理TAIC的降解过程基本符合二级反应动力学规律,通过建立模型并拟合出了TAIC降解的二级反应动力学方程。     

Stabilization of heavy metals in MSWI fly ash using silica fume

The objective of this work was to investigate the feasibility and effectiveness of silica fume on stabilizing heavy metals in municipal solid waste incineration (MSWI) fly ash. In addition to compressive strength measurements, hydrated pastes were characterized by X-ray diffraction (XRD), thermal-analyses (DTA/TG), and MAS NMR (²⁷Al and ²⁹Si) techniques. It was found that silica fume additions could effectively reduce the leaching of toxic heavy metals. At the addition of 20% silica fume, leaching concentrations for Cu, Pb and Zn of the hydrated paste cured for 7 days decreased from 0.32 mg/L to 0.05 mg/L, 40.99 mg/L to 4.40 mg/L, and 6.96 mg/L to 0.21 mg/L compared with the MSWI fly ash. After curing for 135 days, Cd and Pb in the leachates were not detected, while Cu and Zn concentrations decreased to 0.02 mg/L and 0.03 mg/L. The speciation of Pb and Cd by the modified version of the European Community Bureau of Reference (BCR) extractions showed that these metals converted into more stable state in hydrated pastes of MSWI fly ash in the presence of silica fume. Although exchangeable and weak-acid soluble fractions of Cu and Zn increased with hydration time, silica fume addition of 10% can satisfy the requirement of detoxification for heavy metals investigated in terms of the identification standard of hazardous waste of China.