聚硅酸钛制备及其助凝特性

采用在活化硅酸制备过程中加入适量TiCl4的方法,试制了一种新型无机高分子助凝剂—聚硅酸钛。研究了不同/条件下制备的聚硅酸钛在固定pH值的水中分散物的粒径和Zeta电位随着活化时间的变化趋势,并与活化硅酸作比较。结果表明,在Si/Ti=20,活化48 h的条件下能制备出较为稳定的聚硅酸钛。与活化硅酸相比,聚硅酸钛在水中的分散物具有较大的粒径和更高的Zeta电位。通过对比制备的活化硅酸和聚硅酸钛的红外图谱发现,聚硅酸钛中有Ti-O-Si键,证明钛离子参与了聚合反应,新生成的化学键提高了它的聚合度和稳定性。采用硫酸铝为混凝剂,聚硅酸钛为助凝剂进行混凝除浊实验。测定了絮凝体的Zeta电位和混凝沉淀后的上清液浊度,研究了硫酸铝投加量和混凝pH对聚硅酸钛助凝效果的影响。结果表明,投加适量的聚硅酸钛助凝剂,明显提高了混凝除浊效果且拓宽了有效混凝pH值的范围。     

硫酸盐还原菌污泥固定化特性

采用玉米芯为碳源,聚乙烯醇(PVA)为包埋载体,饱和硼酸(H3BO3)为交联剂,研究了硫酸盐还原菌污泥(SRBS)、铁屑、麦饭石共固处理合成煤矿酸性废水的最优配比与机理,并分析了固定化过程中小球稳定性及活性的变化规律。实验结果表明,SRBS投加量是影响处理效果的最显著因子,当投加30%SRBS、2%铁屑、3%麦饭石时SO42-、Mn2+去除率分别为94.13%和84.39%,溶液pH为7.03,未检测出Fe2+;随着交联时间的延长,小球膨胀率及SO42-还原率分别呈线性与指数下降,从保持小球稳定性与活性角度考虑,可将交联时间设定为4~8 h;该法可为市政污泥的处置以及生物法处理煤矿酸性废水的工程应用提供技术参考。     

发烟硫酸贮罐清洗安全技术

根据事故隐患分析 ,采取安全措施 ,成功地用中和法清洗发烟硫酸贮罐 ,并提出了贮罐的改进措施。     

树脂相分光光度法测定水中痕量苦味酸

建立了树脂相分光光度法测定水中痕量苦味酸的新方法。该法灵敏度高,表观摩尔吸光系数为1.08×105L/(mol·cm);精密度理想(测定苦味酸质量浓度为5μg/mL的实验5次,相对标准偏差为1.0%);线性范围为0～7.0μg/mL;以3σ衡量,检出限为0.14μg/mL;加标回收率为97%～103%。采用该法直接测定水样中的苦味酸、间接测定烟草中的烟碱,结果令人满意。     

柠檬酸生产废水处理技术

分析了柠檬酸生产废水的来源及水质特性,综述了厌氧生物法、厌氧-好氧生物组合法、乳状液膜法等在柠檬酸废水处理中的应用,介绍了中和废水回用和利用柠檬酸发酵废液开发糖化酶制剂的技术。     

Comparative Biodegradation Study of Starch- and Polylactic Acid-Based Materials

The degradation of starch- and polylactic acid-based plastic films by microorganisms extracted from compost was studied in a liquid medium. The various degradation products produced were measured throughout the duration of the experiment, and total carbon balances were estimated. For an easily biodegradable material, the evolution of the way carbon repartitioned between different degradation products was quite similar whatever the experimental condition or the type of substrate. On the other hand, for a resistant material exposed to these microorganisms, the nature of the biodegradation depended strongly on the experimental conditions. In the latter case, a differential scanning calorimetry analysis confirmed the importance of the applied norm on the state of the residual material. The consequences for improved methods of estimation of biodegradability of these materials are discussed.     

Application of a Second-Order Kinetic Model to a Complex Melt Polymerization Reaction

A novel copolymer system has been synthesized using methyl hydroquinone diacetate (MHQDA), 1,4 naphthalene dicarboxylic acid (1,4 NDCA), and polybutylene terephthalate (PBT) using the melt polymerization technique. The optimum kinetic parameters pertinent to this system are reported in this study. A simple second-order reaction sequence summarizes catalyzed and uncatalyzed reactions between MHQDA, 1,4 NDCA, and PBT. The kinetic parameters for the copolymerization reaction were determined using a new second-order model. This technique was used to compute the moles of acetic acid generated in the polymerization process. The model was compared to that of the experimentally determined data. Close comparison (percentage error of less than 5%) was obtained between the experimental and theoretical data. The kinetic data support block copolyester formation. The thermal data also supports formation of block polymers.     

The Relation Between Sandstorms and Strong Winds in Xinjiang,China

With observational data spanning 1961–1999 from 90 meteorological stations in Xinjiang, China, the spatial and temporal characteristics of sandstorms and strong winds, and the contribution of strong winds to the occurrence of sandstormsare analyzed. Moreover, the dominant wind direction and minimumwind speeds during sandstorm periods are discussed. The research shows that although possessing similar climatic trends, sandstorms and strong winds in Xinjiang have opposite geographical distributions, i.e. places with more sandstorms show fewer strong winds. The contribution of strongwinds to sandstorms in northern Xinjiang is larger than that insouthern Xinjiang. The dominant wind directions clearly indicatethe paths of the weather systems that introduced the sandstorms.The minimum wind speeds in the sandstorms were over 10 ms^-1in northern and eastern Xinjiang and in the Turpan and Yanqi Basins of southern Xinjiang. In Tarim Basin of southern Xinjiang,however, the minimum wind speed was about 6–8 ms^-1, and even 6 ms^-1 at its southern edge.     

仪化热电厂提高循环水浓缩倍率的措施

针对仪化热电厂将循环水用作冲灰水，导致浓缩倍率只有1.6，以及凝汽器铜管腐蚀结垢严重等问题，提出了隔断循环水与冲灰水的直接联系，实现闲路循环，对凝汽器铜管进行酸洗，并对循环水实施加缓蚀阻垢荆、杀菌剂和旁流过滤等办法，全部实施后产生了很好的效益，值得借鉴。     

强夯引起地面振动的衰减特征

对强夯施工的现场进行了近距离的测量 ,得到了最大地动位移值随距离的变化特征 ,其衰减规律较好地符合负幂函数衰减规律 ,水平径向与垂直向的衰减指数分别为 1 495 3,0 4714。