Review of hydrogen safety during storage,transmission, and applications processes

Hydrogen is considered an excellent clean fuel with potential applications in several fields. There are serious safety concerns associated with the hydrogen process. These concerns need to be thoroughly understood and addressed to ensure its safe operation. To better understand the safety challenges of hydrogen use, application, and process, it is essential to undertake a detailed risk analysis. This can be achieved by performing detailed consequence modellings and assessing risk using the computational fluid dynamics (CFD) approach. This study comprehensively reviews and analyses safety challenges related to hydrogen, focusing on hydrogen storage, transmission, and application processes. Range of release and dispersion scenarios are investigated to analyse associated hazards. Approaches to quantitative risk assessment are also briefly discussed.     

Green energy generation through PEHF – a blueprint of alternate energy harvesting

In this work, an attempt has been made to harvest green energy from piezoelectric material using fluid flow in a conduit. Piezoelectric Energy Harvesting using Fluid Flow (PEHF) experimental model has been designed and the outputs obtained are compared with results obtained from simulations using ANSYS (computational fluid dynamics) and also with the mathematical modeling. The PEHF model has been utilized to analyze the effect of flow rate of water with reference to energy extracted. The full wave bridge rectifier and voltage doubler circuits have been used to obtain the direct current (DC) from the PEHF model. It is observed that the output obtained using experiments holds good in agreement with the results retrieved through simulations and mathematical results. The increase in flow rate of fluid leads to initially increase and then decrease in output of PEHF model as the maximum energy generated when flow rates (external force) matches with the frequency of excitation of the systems, i.e., at its resonance. The maximum energy output is generated at its resonance frequencies. It is observed that the full wave bridge rectifier circuit gives greater output as compared to a voltage doubler circuit.     

Dynamic contact angle effects on gas-liquid behaviors in the cathode of proton exchange membrane fuel cell with stirred tank reactor design

Liquid water management is still a critical issue in the improvement of proton exchange membrane fuel cell (PEMFC) performance. In this work, for the first time, the liquid water behavior and transport inside the cathode of a PEMFC with a stirred tank reactor (STR) design, rather than the conventional PEMFC flow channel design, are numerically studied. The dynamic contact angle (DCA) is applied to multiple wall boundaries in the numerical model through a user-defined-function (UDF) code, i.e., STR-DCA model. Another numerical model with the static contact angle (SCA) and same operating conditions, i.e., STR-SCA model, is also developed for comparison. The volume of fluid (VOF) method is employed in the simulation to track the gas-liquid interface. The results show that the liquid water distribution and transport are significantly different between these two models, indicating the remarkable effects of DCA on the simulation results. It is also verified the capability of STR-PEMFC to reduce the liquid water flooding, showing the potential of this channel-less type fuel cell in the further development.     

毛竹遗态 Fe2O3／Fe3O4／C 复合材料对水中锑（III）的吸附研究

以毛竹遗态Fe2 O3／Fe3 O4／C复合材料为吸附剂,锑（III ）初始含量、溶液初始pH值、吸附剂投加量以及吸附剂粒径为影响因素开展吸附影响研究。结果表明,随着锑（III ）初始浓度的升高,毛竹遗态Fe2 O3／Fe3 O4／C复合材料对锑（III ）的吸附量逐渐增加;初始溶液pH为7时,对锑（III ）的吸附效果最好,吸附量为4．7821 mg／g;块状吸附剂对水中锑（III ）的去除率和吸附量与粉末状吸附剂吸附效果相当。     

A~2/O联合臭氧污泥减量技术的改造研究

研究了臭氧化污泥减量技术联合A~2/O、倒置A~2/O与传统A~2/O在出水和污泥产率上的变化。结果表明,臭氧化A~2/O、臭氧化倒置A~2/O的出水与传统A~2/O相比未出现恶化,它们对COD和含氮物质的去除率分别为87.4%,53.7%和93%,66.5%,存在倒置A~2/O对臭氧混合液中有机质及含氮物质的利用率较A~2/O高的可能。试验按每克SS投加0.05 g O_3对A2/O与倒置A~2/O产生的约60%剩余污泥处理时,在短期内未造成出水磷含量的大幅升高,并且出水磷含量受臭氧混合液DO、二沉池底部DO的影响,两系统的污泥产率分别较传统A~2/O降低50%,56%。     

基于互联网+的轨道交通动力设备安全管理系统的研究

根据我国轨道交通设备安全管理的需求,提出基于互联网+的轨道交通动力设备安全管理系统平台的框架,运用J2EE开发工具,采用嵌入式高速数据采集技术、故障诊断技术,构建形成集成化、网络化和信息化的轨道交通动力设备安全管理系统。完善智能的设备安全管理系统,能有效提高轨道交通动力设备的安全监管力度,保障设备安全。     

SO2和H2O对Mn-Ce/TiO2催化剂低温SCR活性的影响

采用溶胶凝胶法制备Mn-Ce/TiO_2低温SCR催化剂并考察其活性,研究了SO_2和H_2O对Mn-Ce/TiO_2低温脱硝催化剂的影响,并运用XRD、BET、SEM和FT-IR对中毒前后的催化剂进行表征。结果表明,催化剂在无SO_2和H_2O条件下具有良好的脱硝性能,在140℃时NO_x去除率达到84%。但若向模拟烟气中加入SO_2和H_2O,则随其体积分数增大对催化剂活性产生明显抑制作用。当H_2O的体积分数为5%、SO_2为700×10-6时,反应4 h后,NO_x去除率降为53%。H_2O对催化剂的抑制作用随H_2O的除去而消除,H_2O主要通过与NO_x的竞争吸附来抑制催化剂的活性。低浓度的SO_2对催化剂活性影响较小,SO_2体积分数为100×10~(-6)时,稳定后NO_x去除率仍能维持在80%以上,但较高体积分数的SO_2引起的催化剂失活不可自行恢复。SO_2毒化作用主要是引起了硫酸铵盐覆盖催化剂的表面活性位,以及造成活性组分MnO_x的晶化,并破坏了MnO_x与TiO_2间的强相互作用。H_2O和SO_2共同存在时,H_2O可以弱化SO_2对催化剂的毒化作用,主要因为H_2O与SO_2的竞争吸附作用而使SO_2对催化剂活性的影响减弱。     

RGO/TiO2光催化降解2,4-二氯苯氧乙酸研究

通过Hummers法及紫外光/热还原工艺制得还原氧化石墨烯(RGO),采用溶胶-凝胶-煅烧法,以RGO和钛酸酊脂为前驱体制备出RGO/TiO2光催化复合材料,并利用XRD、FT-IR等对其进行了表征.对RGO/TiO2光催化降解性能的研究发现,复合光催化剂RGO/TiO2对2,4-二氯苯氧乙酸(2,4-D)的光催化降解活性显著优于纯TiO2,并且发现负载量和pH值对光催化降解性能有较大的影响:RGO/TiO2投加量为1.2g·L~(-1)、RGO负载量2%、pH为3、初始浓度为50 mg·L~(-1)反应12 h,2,4-D去除率达到98.75%;2,4-D降解率随着RGO/TiO2投加量的增大先增大后减小;RGO/TiO2对2,4-D的降解为脱氯还原和催化氧化过程,产生氯酚、苯酚等中间产物.     

Reference gene validation for quantification of gene expression during final oocyte maturation induced by diethylstilbestrol and di-(2-ethylhexyl)-phthalate in common carp

Final oocyte maturation is the key step to successful spawning and fertilization.Quantitative real-time PCR(q PCR) is the technique of election to quantify the abundance of functional genes in such study. Reference gene is essential for correct interpretation of q PCR data. However, an ideal universal reference gene that is stable under all experimental circumstances has not been described. Researchers should validate their reference genes while performing q PCR analysis. The expression of 6 candidate reference genes: 18 s r RNA,28 s r RNA, Cathepsin Z, Elongation factor 1-α, Glyceraldehyde-3-phosphate dehydrogenase andβ-actin were investigated during final oocyte maturation induced by different compounds(DES and DEHP) in common carp(Cyprinus carpio). Four softwares(Bestkeeper, ge Norm,Norm Finder and Ref Finder) were used to screen the most stable gene in order to evaluate their expression stability. The results revealed that EF1α was highly stable expressed when final oocyte maturation was induced by DES, while gapdh was the most stable gene when final oocyte maturation was induced by DEHP. Stable expressed reference gene selection is critical for all q PCR analysis to get accurate target gene m RNA expression information.