Rapid determination of phenolic compounds in water samples by alternating-current oscillopolarographic titration

A rapid, simple and sensitive method was demonstrated for the determination of phenolic compounds in water samples by alternating-current oscillopolarographic titration. With the presence of sulfuric acid, phenol could be transferred into a nitroso-compound by reacting with NaNO2. The titration end-point was obtained by the formation of a sharp cut in the oscillopolarographic with infinitesimal NaNO2 on double platinum electrodes. The results showed that phenol concentration had an excellent linear relationship over the range of 4.82×10-6-9.65×10-3 mol/L, the RSD of the proposed method was lower than 1.5%, and the spiked recoveries of three real water samples were in the range of 95.6%-106.9%.     

A novel online analyzer for accurate and rapid measurement of volatile fatty acids in anaerobic wastewater treatment

Volatile fatty acids (VFAs), which are largely generated during the anaerobic acidification process, are considered to be reliable indicators of the stable process operation. However, the common methods for monitoring VFAs are offline, and they are typically manual requiring time-consuming, costly and complex instruments. This study aims to develop a novel online analyzer for automatic measuring VFAs, which was based on the 5-pH point titration, embedded with a proportional-integral-derivative (PID) feedback control system. The results show that it can achieve accurate and rapid monitoring of VFAs ranging between 0-400 mg/L (<9 min/sample) but simultaneously faces the problems of overtitration and interference of complex characteristics of wastewater. In order to improve its accuracy and stability, the effects of three general coefficients (K_I, K_P, and K_D) of PID on the titration were investigated, and the optimal values of K_I, K_P, and K_D were found to be 1.5, 1.0, and -1.0~0.5, respectively. Besides, the initial titration speed was set at 0.06 mL/min, equal to the minimum speed of the peristaltic pump, and the dichotomy approach was integrated into the PID feedback controller. Owing to the above improvements, the relative mean deviation and standard deviation of measuring VFAs in both synthetic and real wastewaters were mostly lower than 5.0% and 5.0 mg/L, proving the online analyzer is rapid, accurate and reliable.     

EDTA滴定法测定水中总硬度时缓冲溶液配制的改进

针对EDTA滴定法测定水中总硬度(简称标准法)时,缓冲溶液配制繁琐,耗时较长的情况,提出了对缓冲溶液配制的改进方法(简称改进法)。改进法很好地克服了标准法的不足。通过地表水、地下水以及总硬度标准样品的比对测定,两者的测定结果无显著差异。     

自动电位滴定仪测定氯化物的探讨

该实验就自动电位滴定仪测定氯化物的检出限、适用的水样pH范围及对其干扰物质的最大容忍浓度作了实验研究,对分析实际水样有一定的参考作用。     

电导滴定法快速测定不同水中硫酸根的含量

采用电导法，用氯化钡标准溶液滴定水样中硫酸根的含量对测定结果的影响因素进行了探讨，本方法测定的回收率在９８￣１０２％之间，装置简单，试样测定时间仅需几分钟，准确度较高，适用范围广，如海水，卤水，自来水、深井水、雨水和部分工业废水等硫酸根含量的测定。     

离子色谱法测定水中总硬度

水质硬度的测定方法很多,本研究选用离子色谱法和EDTA络合滴定法对地下水和地表水样品分别进行测定,结果表明离子色谱法相对于传统的EDTA络合滴定法有干扰小,对环境污染少的优点,但水质测定的国标方法中没有该方法,因此建议可用离子色谱法测定水质硬度。     

水中阴离子表面活性剂的偶氮红滴定法测定

采用偶氮红两相滴定法测定水中阴离子表面活性剂,有效地消除了环境水体中硬度、蛋白质、淀粉及非离子表面活性剂的干扰。其平均回收率为100.6％,相对标准偏差为1.0％。     

催化燃烧／库仑滴定法测定植物叶片中硫

以三氧化钨为催化剂，燃烧处理植物叶片，硫转化为SO2，后者被吸收液吸收后采用库仑滴定法测定。方法快速简便，测定植物叶片中硫的含量，相对标准偏差为1．5％，适用于大批量样品的快速测定。     

乐安江沉积物对重金属的吸附模式研究──表面络合模式在天然沉积物研究中的应用

应用表面络合理论及其研究方法对乐安江沉积物的表面特征及对重金属的吸附特性进行了研究．进行了乐安江沉积物样品的表面电位滴定实验及样品对重金属Ｃｕ、Ｃｄ的吸附实验．应用图解法及ＦＩＴＥＱＬ优化程序确定了表面络合模式中的相应参数，并对模式的预测能力进行了检验．研究了３种表面络合模式即恒定容量模式，扩散层模式和三层模式的拟合应用情况．结果表明，３种表面络合模式均能较好地描述天然沉积物的吸附过程，但哪种模式从化学原理上看更正确尚不能证明．从模式计算的难易程度分析，扩散层模式有一定优势．模式应用中应特别强调的是模式参数间的相关性和一致性．     

电导返滴定法测定苯酚含量

向苯酚试液中加入定量过量的ＮａＯＨ标准溶液，用Ｈ３ＢＯ３标准溶液滴定过量的ＮａＯＨ，通过计算求得苯酚含量，测定下限为１０－５ｍｏｌ／Ｌ。并成功地测定了某化工厂废液中苯酚含量。