铁阳极电解脱色直接黄11染料模拟废水

研究采用铁为阳极电化学法处理直接黄11染料模拟废水脱色性能的影响进行研究。影响因素包括:电流密度、pH值、染料浓度和电解质浓度。研究结果表明,电流密度大有利于染料废水脱色,但能耗消耗大;初始溶液在中性条件下不仅取得很好的处理效果,而且脱色能耗较低;随着染料初始浓度增加脱色率和脱色能耗降低的趋势;随着电解质浓度升高染料脱色率下降的趋势,脱色能耗先减少,然后缓慢增大。在染料初始浓度50 mg/L、pH值为7.11、电流密度2.083 mA/cm2、电解质Na2SO4浓度0.01 mol/L、温度20℃、搅拌速度600 r/min、电解时间60min条件下,脱色率达到92.2%,脱色能耗1.709 kW.h/kg染料。     

电催化氧化法处理阳离子染料废水的试验研究

以结晶紫作为阳离子染料,采用电催化氧化法对阳离子染料溶液进行了电解脱色处理试验,研究了电流密度、电解质种类、电解质浓度、pH值等对该溶液脱色率的影响,测定了电解时溶液中生成的余氯浓度和溶液的紫外-可见吸收光谱曲线,并对不同电解时间的溶液的吸光度进行了归一化计算。结果表明:随着电解时间的延长,水溶液中活性氯浓度不断上升,经一定时间后达到最大值;在电催化和活性氯的协同作用下,阳离子染料结晶紫分子中的大π共轭体系被破坏、苯环结构基本瓦解,溶液快速脱色;在电流密度为5.1mA/cm2、NaCl浓度为4g/L、pH值为9.41的条件下,初始浓度为100mg/L的结晶紫溶液经过20min的电解,其脱色率可高达98.31%。     

纳米铁强化的混凝-沉淀-过滤工艺对典型印染废水中有机物去除

以东江流域某典型印染企业尾水为研究对象,将混凝剂与少量的纳米铁进行复合投加,再结合多介质过滤器对印染尾水进行深度处理实验研究.结果表明,新型混凝剂HPAC-9对极性有机物具有较强的去除能力,但对非极性或弱极性有机物去除效果不很理想.通过将纳米铁与HPAC-9复合投加并结合多介质过滤工艺,对印染企业尾水中的有机污染物进行...     

偶氮染料分子结构对其生物脱色影响的研究进展

偶氮染料是工业中染料用量最大的一类,不同的分子结构对其微生物脱色性能具有一定的影响作用。文章综述了偶氮染料分子结构中的取代基种类及其取代位置对染料的脱色规律,以及分子特征结构对微生物脱色的量化分析。对目前染料生物脱色规律研究中存在的问题进行了分析,提出相应的对策措施。     

磁性膨润土材料吸附处理印染废水研究

针对目前膨润土在应用中的一些问题,对膨润土进行磁性能改性,通过共沉淀法制备磁性膨润土颗粒,并对其进行了X射线衍射和磁性能表征分析.以阴离子染料OrangeⅡ为目标化合物,研究了磁性膨润土材料对OrangeⅡ废水的吸附效果,并探讨了主要工艺参数如阳离子表面活性剂的质量浓度、pH、温度等对染料去除率的影响.结果表明:阳离子...     

液相高压放电降解RB5染料废水的试验研究

随着印染工艺不断更新,大量化学分子结构复杂的化工染料应用到印染行业,使得常规的水处理工艺难以降解印染废水中的染料。本文以活性黑（RB5）染料为研究对象,采用液相高压放电产生强氧化性自由基来降解染料废水,考察反应时间、初始浓度和气体流量对RB5降解的影响,研究结果表明：在外部功率相同的情况下,浓度高染料其降解率相对较低;通入氧气量增加,产生的活性自由基和活性物质数量也增加,RB5的降解率也增大,但气流量不宜过大;高压放电产生的各种活性物质容易破坏染料发色基团的分子链,使其脱色。     

Catalytic bubble-free hydrogenation reduction of azo dye by porous membranes loaded with palladium nanoparticles

Catalytic bubble-free hydrogenation reduction of azo dye by porous membranes loaded with palladium （Pd） nanoparticles was studied for the first time. The effects of Pd loading, dye concentration and reuse repetitions of membranes were investigated. In reduction, the dye concentration decreased whereas the pH rose gradually. An optimal Pd loading was found. The catalytic membranes were able to be reused more than 3 times.     

Evaluating the effectiveness of marine actinobacterial extract and its mediated titanium dioxide nanoparticles in the degradation of azo dyes

Aim of the present study was to synthesize titanium dioxide nanoparticles （YiO2 NPs） from marine actinobacteria and to develop an eco-friendly azo-dye degradation method. A total of five actinobacterial isolates were isolated from Chennai marine sediments, Tamilnadu, India and analyzed for the synthesis of TiO2 NPs using titanium hydroxide. Among these, the isolate PSV 3 showed positive results for the synthesis of TiO2 NPs, which was confirmed by UV analysis. Further characterization of the synthesized TiO2 NPs was done using XRD, AFM and FI＇-IR analysis. Actinobacterial crude extract and synthesized TiO2 NPs was found efficient in degrading azo dye such as Acid Red 79 （AR-79） and Acid Red 80 （AR-80）. Degradation percentage was found to be 81% for AR-79, 83% for AR-80 using actinobacterial crude extract and 84% for AR-79, 85% for AR-80 using TiO2 NPs. Immobilized actinobacterial ceils showed 88% for AR-79 and 81% for AR- 80, dye degrading capacity. Degraded components were characterized by FT-IR and GC-MS analysis. The phytotoxicity test with 500 μg/mL of untreated dye showed remarkable phenotypic as well as cellular damage to Tagetes erecta plant. Comparatively no such damage was observed on plants by degraded dye components. In biotoxicity assay, treated dyes showed less toxic effect as compared to the untreated dyes.     

Dyes adsorption using a synthetic carboxymethyl cellulose-acrylic acid adsorbent

Removal of noxious dyes is gaining public and technological attention. Herein grafting polymerization was employed to produce a novel adsorbent using acrylic acid and carboxymethyl cellulose for dye removal. Scanning electron microscopy and Fourier-transform infrared spectroscopy verified the adsorbent formed under optimized reaction conditions. The removal ratio of adsorbent to Methyl Orange, Disperse Blue 2BLN and malachite green chloride reached to 84.2%, 79.6% and 99.9%, respectively. The greater agreement between the calculated and experimental results suggested that pseudo second-order kinetic model better represents the kinetic adsorption data. Equilibrium adsorptions of dyes were better explained by the Temkin isotherm. The results implied that this new cellulose-based absorbent had the universaiity for removal of dyes through the chemical adsorption mechanism.     

Myrothecium verrucaria NF-08产漆酶条件的响应面法优化及粗酶染料脱色研究

以半知菌属疣孢漆斑菌Myrothecium verrucaria NF-08为供试菌,采用响应面方法优化菌株产漆酶条件,并以其漆酶粗酶进行3种结构类型6种染料的脱色试验,考察了粗酶浓度、温度和p H值对脱色率的影响.两水平析因设计、中心组合设计和验证试验结果表明:葡萄糖浓度为15.4 g·L~(-1)、蛋白胨浓度为43.3 g·L~(-1)和培养基初始p H值为6.68时,漆酶活性达到最大值(25.58±1.60)U·m L~(-1),是单因素试验(16.82 U·m L~(-1))的1.52倍,提高了52.1%.以上述发酵条件获得的M.verrucaria NF-08漆酶粗酶对3种结构类型染料均有脱色效果,排序为偶氮类优于芳甲烷类优于蒽醌类.脱色率随粗酶浓度增大(2~8 U·m L~(-1))、反应温度升高(15~35℃)而上升,随p H值上升(4~10)而下降.粗酶浓度为5 U·m L~(-1),反应温度为25℃,p H值为4时,偶氮类染料铬黑T和芳甲烷类染料碱性品红即可几乎完全脱色,脱色率分别为99.2%和94.6%.