湿法脱硫真空皮带机运行控制分析与改进

介绍了真空皮带机脱水过程的基本原理及其在石灰石—石膏湿法脱硫系统中的应用情况,分析了PID控制真空皮带机运行的原理。由于真空皮带机常规PID控制系统的滞后严重,采用模糊控制后系统的响应得到了较好的改善,实际应用结果证明了理论的正确性。     

Investigation of titanium liquid/gas diffusion layers in proton exchange membrane electrolyzer cells

In a proton exchange membrane electrolyzer cell (PEMEC), liquid/gas diffusion layer (LGDL) is expected to transport electrons, heat, and reactants/products to and from the catalyst layer with minimum voltage, current, thermal, interfacial, and fluidic losses. In addition, carbon materials, which are typically used in PEM fuel cells (PEMFCs), are unsuitable in PEMECs due to the high ohmic potential and highly oxidative environment of the oxygen electrode. In this study, a set of titanium gas diffusion layers with different thicknesses and porosities are designed and examined coupled with the development of a robust titanium bipolar plate. It has been found that the performance of electrolyzer improves along with a decrease in thickness or porosity of the anode LGDL of titanium woven meshes. The ohmic resistance of anode LGDL and contact resistance between anode LGDL and the anode catalyst play dominant roles in electrolyzer performance, and better performance can be obtained by reducing ohmic resistance. Thin titanium LGDLs with straight-through pores and optimal pore morphologies are recommended for the future developments of low-cost LGDLs with minimum ohmic/transport losses.     

Experimental investigation of a solar water distillation-cum-drying unit

In this communication, a new design of solar-energy-based water distillation cum drying unit with parabolic reflector has been designed, fabricated, and tested. Bitter gourd and potato slices are chosen as a drying commodity. Thermal performance of the developed system has been evaluated based on the experimental results and using linear regression analysis. Heat transfer coefficients (convective, evaporative, and radiative) for solar distillation system have been observed to be 2.48–4.09, 13.25–52.38, and 8.75–9.66 W/m²°C, respectively. Overall thermal efficiency and exergy efficiency for the distillation system has been found to be 18.77% and 1.2%, respectively. The convective heat transfer coefficient for potato slices are observed higher for initial hours and decreases as the day progresses. The average convective heat transfer coefficients for bitter gourd and potato slices have been observed as 2.18 and 5.04 W/m²°C, respectively. Experimental error in terms of percent uncertainty for bitter gourd and potato slices are found to be 42.93% and 37.06%, respectively. The present design of solar distillation and drying in a single unit could be beneficial for the development of remote, arid, and rural areas.     

膜蒸馏去除水中砷的研究

采用新型膜蒸馏技术对水中As（III）与As（Ⅴ）的去除展开了研究。实验结果表明,膜蒸馏对水中As (III)及As (Ⅴ)具有较高的去除能力：当产水中砷含量超过10 μg/L时,原水中As (III)与As (Ⅴ)的浓度可分别高达40 mg/L和2 000 mg/L。局部润湿现象的存在导致As (III)及As (Ⅴ)跨膜至产水侧,PVDF微孔膜在溶液中的负电性以及As (III)与 As (Ⅴ)在溶液中存在形式的不同导致膜蒸馏对两者去除能力的差异。360 h连续运行过程中产水通量及电导率稳定,且整个过程中As (III)均低于检测限,说明PVDF微孔膜具有良好的疏水性和稳定的除砷性能。     

好氧硝化颗粒污泥膜生物反应器性能和膜污染研究

实验研究了好氧硝化颗粒污泥膜生物反应器AGMBR的处理性能,并将其与活性污泥膜生物反应器ASMBR进行对比,考察了颗粒污泥在减缓膜污染中所起的作用.好氧硝化颗粒污泥膜生物反应器AGMBR连续稳定运行102 d,系统具有良好的去除有机物和同时硝化反硝化能力,在进水COD和NH+4-N浓度分别为500和200 mg/L时,COD、NH+4-N和TN的去除率分别稳定在86%、94%和45%以上.颗粒污泥有效减缓了膜污染,延长了膜清洗的周期,AGMBR中的膜污染以膜孔堵塞为主,占总阻力的64.81%;滤饼层的阻力为2.1×1012m-1,远小于ASMBR中的16.07×10"m-1;膜清洗周期是相同条件下ASMBR的2.43倍以上;而且AGMBR内不断有新颗粒生成,维持了AGMBR系统性能和运行的稳定.     

微曝气Fenton氧化法处理模拟双酚A废水的效果及其生物验证

研究了微曝气Fenton氧化法关键工艺参数对模拟双酚A（BPA）废水处理效果的影响,并从活性污泥性质和污染物去除率两方面,采用膜生物反应器(membrane bioreactor, MBR)对微曝气Fenton氧化法的处理效果进行了实验验证,为实现BPA废水的生物处理奠定基础。结果表明,初始pH值、反应时间、H₂O₂/COD(质量浓度比)、H₂O₂/Fe²⁺ (摩尔浓度比)、反应温度及曝气量均对预处理效果有较大影响,在最佳条件下,COD去除率可达70%,BOD/COD值则由原废水的0.02提高到0.50以上。MBR处理上述出水的结果表明,经微曝气Fenton氧化处理BPA的废水,可较好地适应后续的生化处理。     

真空灭弧室导电回路产生的磁场环境对灭弧室短路开断的影响

设计良好的导电回路对真空断路器灭弧性能的提高有着重要的意义。本文首先从结构上分析了三种不同导电回路的优缺点,接着,分析了三种不同导电回路的电动斥力和吹弧磁场,为通过选择不同导电回路,触头直径和开距提高真空断路器灭弧性能提供方法和思路。     

活性炭在膜生物反应器中的应用研究进展

活性炭是一种非常优良的吸附剂,具有物理吸附和化学吸附的双重特性。本文介绍了近年来向膜生物反应器中投加活性炭的应用研究进展,表明投加活性炭可以提高膜生物反应器的处理效果,同时对改善膜污染有很好的效果。     

膜生物反应器中溶解性微生物产物特性的研究进展

溶解性微生物产物是制约生物处理出水达标和回用的主要污染物,处理工艺和操作条件的不同可能造成其特性差异。阐述了溶解性微生物产物的定义和产生机制,对膜生物反应器中溶解性微生物产物的组成、分子质量分布、亲水／疏水性、螯合性和毒性进行了概述,分析了影响其产生、特性和去除的因素。由于膜的截留作用使溶解性微生物产物在膜生物反应器中积累,容易引起膜污染。可以通过优化操作条件,减少溶解性微生物产物的产生,提高出水水质,有效地抑制膜污染。     

陶瓷膜污染过程分析与膜清洗方法优化

采用膜孔径为50 nm的陶瓷膜错流过滤方式,对碱性高浓度有机洗涤废水进行9个周期的膜通量衰减及反向脉冲清洗再生实验研究.通过设计膜污染阻力构成实验,测算膜污染总阻力及其构成比例.实验结果表明,膜固有阻力比例较低,浓差极化污染较弱,Rt和Rc+Rirt污染阻力稳定性较高,膜堵塞形式兼有孔内堵塞和滤饼过滤;选择质量分数0.1％的稀盐酸和0.2％的草酸溶液膜清洗效果均较好,清洗时间为3 min,脉冲时间和频率为3 s/5 s.