新型单级A/O程序无回流复合膜生物反应器处理氨氮废水的试验

采用单级A/O程序复合膜生物反应器(HSMBR)处理高氨氮废水,研究在低DO浓度下系统对有机物、氨氮和总氮的去除效率。研究结果表明:在低DO浓度下,CODCr、氨氮的平均去除率分别为94.4%和92.8%。由于进水CODCr/TN值仅为2.01,则使得总氮平均去除率仅为69.4%,但是当系统亚硝化累积率从60.5%～67.1%提高到83.5%～86.4%时,系统总氮去除率提高了17.7%。另外,维持低DO浓度可以实现亚硝酸型同时硝化反硝化反应。     

超滤处理洗涤污水循环利用的中试研究

采用不同材质国产超滤膜聚丙烯（PP）、聚丙烯腈（PAN）和聚砜（PS）,进行了洗涤污水处理循环利用的现场中试研究.结合超滤工艺出水水质和膜污染分析,3种膜材质中PAN膜较优,有效去除了水中浊度、悬浮物、油脂等污染物,一定程度保留了游离阴离子表面活性剂（LAS）,长期循环洗涤对衣物的白度无不良影响.根据相关性分析,超滤出水较高COD值很大程度上是由水中LAS引起的.超滤膜对细菌、大肠菌群的去除率较低,出水通过紫外消毒,当紫外线密度≥3?750 J/m²时,微生物水平能够达到国家饮用水水质标准.根据不同水力反冲洗条件下膜渗透通量和净产水量比较,PAN膜最佳水力反冲洗条件为0.5 h反冲洗2 min.长期运行时超滤膜化学清洗方法采用碱洗法方便有效.     

蒽对太平洋牡蛎不同组织抗氧化酶活性差异性影响与膜脂质过氧化研究

在实验条件下采用生态毒理学和生物化学方法,选用常见的环境污染物多环芳烃蒽,以太平洋牡蛎(Crassostrea gigas)为实验材料进行毒理实验.研究了太平洋牡蛎消化腺、鳃、唇瓣和肌肉4种不同组织中的3种抗氧化酶--超氧化物歧化酶(SOD)、过氧化物酶(POD)和过氧化氢酶(CAT)对蒽胁迫的敏感性;同时研究了4种不同组织膜脂过氧化的差异.结果表明:(1)4种不同组织中3种不同抗氧化酶对蒽敏感性有显著差异性.(2)4种不同组织的膜脂过氧化伤害程度表现为:消化腺＞鳃＞唇瓣＞肌肉.     

Improvement of the antifouling characteristics in a bioreactor of polypropylene microporous membrane by the adsorption of Tween 20

Surface modification by physical adsorption of Tween 20 was accomplished on polypropylene microporous membranes (PPMMs). Attenuated total reflection-Fourier transform infrared spectroscopy (ATR/FT-IR) and scanning electron microscope (SEM) were used to characterize the chemical and morphological changes on the membrane surfaces. Water contact angles and relative pure water fluxes were measured. The data showed that the hydrophilic performance for the modified membranes increased with the increase in the adsorption amount of Tween 20 onto the surface or into the pores of polypropylene microporous membranes. To test the antifouling property of the membranes by the adsorption of Tween 20 in a membrane bioreactor (MBR), filtration for active sludge was performed using synthetic wastewater. With the help of the data of water fluxes and the FE-SEM photos of the modified PPMMs before or after operating in a MBR for about 12 d, the PPMMs with monolayer adsorption of Tween 20 showed higher remained flux and stronger antifouling ability than unmodified membrane and other modification membranes studied.     

热真空试验系统温度均匀度试验研究

热真空试验是航天器研制过程中非常重要的一项试验,作为满足热真空试验必不可少的工具,好的热真空试验系统可以保证试验件在不失真的情况下试验,使试验受控,而热真空试验系统温度均匀度不好,会造成过试验或欠试验的产生。文中以某型热真空试验设备为例,通过试验研究分析其温度均匀度,可以提高热真空试验的精度。     

Clam shell catalyst for continuous production of biodiesel

Continuous flow transesterification of waste frying oil (WFO) with methanol for the biodiesel production was tested in a laboratory scale jacketed reactive distillation (RD) unit packed with clam shell based CaO as solid catalyst. The physiochemical properties of the clam shell catalysts were characterized by X-ray Diffraction (XRD), Brunauer–Emmett–Teller (BET), Scanning Electron Microscopy (SEM), and Energy Dispersive Atomic X-ray Spectrometry (EDAX). The effects of the reactant flow rate, methanol-to-oil ratio, and catalyst bed height were studied to obtain the maximum methyl ester conversion. Reboiler temperature of 65°C was maintained throughout the process for product purification and the system reached the steady state at 7 hr. The experimental results revealed that the jacketed RD system packed with clam shell based CaO showed high catalytic activity for continuous production of biodiesel and a maximum methyl ester conversion of 94.41% was obtained at a reactant flow rate of 0.2 mL/min, methanol/oil ratio of 6:1, and catalyst bed height of 180 mm.     

膜蒸馏去除水中砷的研究

采用新型膜蒸馏技术对水中As（III）与As（Ⅴ）的去除展开了研究。实验结果表明,膜蒸馏对水中As (III)及As (Ⅴ)具有较高的去除能力：当产水中砷含量超过10 μg/L时,原水中As (III)与As (Ⅴ)的浓度可分别高达40 mg/L和2 000 mg/L。局部润湿现象的存在导致As (III)及As (Ⅴ)跨膜至产水侧,PVDF微孔膜在溶液中的负电性以及As (III)与 As (Ⅴ)在溶液中存在形式的不同导致膜蒸馏对两者去除能力的差异。360 h连续运行过程中产水通量及电导率稳定,且整个过程中As (III)均低于检测限,说明PVDF微孔膜具有良好的疏水性和稳定的除砷性能。     

好氧硝化颗粒污泥膜生物反应器性能和膜污染研究

实验研究了好氧硝化颗粒污泥膜生物反应器AGMBR的处理性能,并将其与活性污泥膜生物反应器ASMBR进行对比,考察了颗粒污泥在减缓膜污染中所起的作用.好氧硝化颗粒污泥膜生物反应器AGMBR连续稳定运行102 d,系统具有良好的去除有机物和同时硝化反硝化能力,在进水COD和NH+4-N浓度分别为500和200 mg/L时,COD、NH+4-N和TN的去除率分别稳定在86%、94%和45%以上.颗粒污泥有效减缓了膜污染,延长了膜清洗的周期,AGMBR中的膜污染以膜孔堵塞为主,占总阻力的64.81%;滤饼层的阻力为2.1×1012m-1,远小于ASMBR中的16.07×10"m-1;膜清洗周期是相同条件下ASMBR的2.43倍以上;而且AGMBR内不断有新颗粒生成,维持了AGMBR系统性能和运行的稳定.     

微曝气Fenton氧化法处理模拟双酚A废水的效果及其生物验证

研究了微曝气Fenton氧化法关键工艺参数对模拟双酚A（BPA）废水处理效果的影响,并从活性污泥性质和污染物去除率两方面,采用膜生物反应器(membrane bioreactor, MBR)对微曝气Fenton氧化法的处理效果进行了实验验证,为实现BPA废水的生物处理奠定基础。结果表明,初始pH值、反应时间、H₂O₂/COD(质量浓度比)、H₂O₂/Fe²⁺ (摩尔浓度比)、反应温度及曝气量均对预处理效果有较大影响,在最佳条件下,COD去除率可达70%,BOD/COD值则由原废水的0.02提高到0.50以上。MBR处理上述出水的结果表明,经微曝气Fenton氧化处理BPA的废水,可较好地适应后续的生化处理。     

真空灭弧室导电回路产生的磁场环境对灭弧室短路开断的影响

设计良好的导电回路对真空断路器灭弧性能的提高有着重要的意义。本文首先从结构上分析了三种不同导电回路的优缺点,接着,分析了三种不同导电回路的电动斥力和吹弧磁场,为通过选择不同导电回路,触头直径和开距提高真空断路器灭弧性能提供方法和思路。