煤巷掘进过程中粉尘浓度影响因素分析

为了掌握煤巷掘进过程中粉尘浓度变化的影响因素,根据气固两相流理论,针对矿井掘进工作面的特点,采用计算流体力学的离散相模型（DPM）考察了掘进巷道风速、风筒直径、风筒出风口到掘进工作面距离以及风筒的悬挂高度对粉尘浓度变化的影响。结果发现：当掘进巷道风速为0.25-4 m/s时,提高巷道内的通风风速,可以降低巷道内的粉尘浓度,缩短呼吸性粉尘浓度达到稳定的时间,减小工作面粉尘的危害;有利于通风除尘的风筒相关参数为风筒直径0.4-0.6 m、风筒出风口到掘进工作面距离6-7 m、风筒悬挂高度2.0-2.2 m。     

基于CFD对袋式除尘器流场的分析

采用计算流体力学(CFD)软件对袋式除尘器单元气流组织进行数值模拟分析,给出了 沿滤袋高度方向过滤风速的分布,以及袋间隙气流抬升速度在不同高度上的分布特征,为袋式除尘器的改进和设计提供理论依据.     

诱导排烟系统应用于地下车库的实验研究

运用实验研究的方法分析了诱导排烟系统在地下车库中应用的可行性,研究了布置方式、诱导风速等敏感参数对排烟效果的影响,主要分析了火源上游不同位置处温度的变化。结果表明,诱导排烟系统能有效地抑制烟气向上游的逆流并能加强烟气的热对流,降低上游烟气的温度;另外,开启少于均匀布置诱导风机数目下,菱形布置诱导风机下的排烟效果优于均匀排列布置;在实验风速范围内,诱导排烟系统对上游烟气的控制和降温能力随着诱导风速的增加而提高,同时,在火源功率一定的条件下,增大诱导风速对控烟效果的改善存在临界值。     

螺旋式旋流器的切向速度分析

借助CFD软件,采用RSM模型对螺旋式旋流器内的切向速度场进行了数值模拟。模拟结果表明:旋流器内部的流场分为螺旋通道内的准自由涡和内筒区域的准强制涡;在柱锥交界区域的内筒外壁附近有一低速区,易导致颗粒富集而出现高浓度区进而影响分离效率;此外通过改变入口速度和螺旋通道的螺距,研究对旋流器切向速度的影响。通过对流场特性的研究,为进一步充分认识此类旋流器的分离机理提供了依据。     

风速测量仪器的动力学性能研究

探讨了几种风速测量仪器的测头平面法线和来流方向成某一角度时 ,产生的测量偏差的大小     

Predicting the mating system from phenotypic correlations between life-history and sperm quality traits in the Alpine whitefish <Emphasis Type="Italic">Coregonus zugensis</Emphasis>

The mating behavior and reproductive strategies of Alpine whitefish like Coregonus zugensis (Nüsslin) are poorly understood, probably because they spawn in deep water where direct observations are difficult. In this study, we interpret life-history and sperm quality traits of fish that we caught from their spawning place. We found that males invest heavily into gonadal tissue (up to 5.6% of their body weight), which is, in comparison to other fish, consistent with external fertilization, distinct pairing and moderate to high communal spawning, or no pairing and low to moderate communal spawning. Sperm competition theory and recent experimental studies on other salmonids predict that males optimize ejaculate characteristics in relation to the costs of sperm and the level of competition they have to expect: dominant males are predicted to invest less into ejaculate quality and to have slower spermatozoa than subdominant males. We found that spermatozoa of older males are slower than those of younger males. Moreover, older males have larger breeding tubercles, a secondary sexual trait that has, in some previous studies, been found to be linked to good condition and to good genetic quality. Our results suggest that C. zugensis has age-linked reproductive strategies, that multimale spawning is common, i.e., that sperm competition plays a significant role, and that older males are on average dominant over younger males at the spawning place.     

DPIV技术测量流冰速度应用研究

基于数字信号分析原理,对连续两幅图像进行互相关分析,寻找互相关函数的峰值;应用数字粒子图像测速(digital particle image velocimetry)技术,并通过计算机VC编程,解决了用于雷达测量单点流冰速度的不足;为大范围区域内流冰场瞬时速度的计算,实时雷达测量辽东湾海上流冰速度场提供了有应用价值的方法.     

A~2/O工艺中好氧污泥絮体的分形结构与理化特征分析

采用图像法和沉降柱法分别研究了A2/O工艺中好氧污泥絮体的形貌、粒度分布、低维分形维数和沉降速率、有效密度、空隙率以及质量分形维数,并尝试探讨了上述相关性质与这些污泥宏观操作性质(沉降、压缩、脱水和稳定性)相关的各种理化指标以及胞外高分子物质(EPS)的含量之间的变化关系.结果表明,污泥絮体呈现不规则的形貌,表面具有空隙.其有效密度一般随着其粒径的增加而降低,而空隙率和沉降速率却呈现与有效密度相反的变化趋势,这些均表明了污泥絮体的分形结构的存在.2次所采集的污泥絮体的中位直径分别为248.81、332.86μm,有效密度的平均值分别为0.0040、0.0072g·cm-3,自由沉降速率的平均值分别为2.67、4.79mm·s-1,空隙率的平均值分别为0.94、0.89,一维分形维数分别为1.03、1.19,二维分形维数分别为1.64、1.84,采用基于Logan经验公式的有效密度-最大直径的双对数关系确定的质量分形维数分别为1.74、2.29.尽管第2次所采集的污泥絮体较为密实,但其表面粗糙程度却比第1次的低.此外,研究中发现絮凝能力较高或负电荷较高的A2/O好氧污泥絮体具有高的SVI和ZSV值;分形维数较低...     

Critical velocity in phosphorus exchange processes across the sediment-water interface

Sediments are ultimate sinks of nutrients in lakes that record the pollution history evolutionary processes, and anthropogenic activities of a lake. However, sediments are considered as inner sources of environmental factor changes such as the variation in hydrodynamic conditions because of the nutrients they release. How does this process happen？ This study investigates a typical nutrient phosphorus （P） exchange among sediment, suspended particle matter （SPM）, and water. Compared with numerical and experimental studies, this study confirms that the critical velocity that occurs at a lower flow rate state exists in the range of 7 to 15 crn/sec. Critical velocity below the critical flow rate promotes the migration of particulate phosphorus （PP） to the SPM. On the other hand, critical velocity above the critical flow rate promotes the release of PP in water.     

UASB反应器中颗粒污泥的沉降性能与终端沉降速度

从流体力学角度,通过建立沉降速度模型探讨了UASB反应器中颗粒污泥的沉降性能与终端沉降速度．计算结果表明,(1)绝大多数颗粒污泥的沉降过程属于过渡区(1＜Re＜100)而非层流区,其沉降速度与直径成正比,可用Allen公式进行计算;(2)颗粒污泥的终端沉降速度远高于厌氧反应器中废水的上流速度,其良好的沉降性能解决了在高负荷情况下污泥的流失问题．所建模型能较好地反映实际条件下的情况．为厌氧反应器的工艺设计与正常运行提供理论依据．