脱除SO2活性炭的再生方法

分别用溶剂和气体对脱除SO2后失活的活性炭进行了再生。在固定床反应器上考察了再生后活性炭的脱硫性能。实验结果表明：用溶剂再生时,质量分数为60％的HNO3溶液的再生效果最好,活性炭的再生率达到80％以上。用气体再生时,400℃左右时的再生效果最好,活性炭的再生率达到70％以上。再生后活性炭的比表面积和pH是衡量活性炭再生效果的重要参数。在实际脱硫生产中,用H2O对失活活性炭进行反复洗涤再生,是一种经济、实用的方法,活性炭的再生率达60％以上。     

玻璃纸生产废气中CS2和H2S的治理

阐述了玻璃纸生产中CS2和H2S废气产生的原理,介绍了该废气处理的现状,总结了目前普遍采用的冷凝法、活性炭吸附法、活性碳纤维吸附法、改性活性炭吸附法、螯合铁氧化法、吸收-吸附法等处理方法的特点和效果。介绍了一种先采用螯合铁氧化法、再采用冷凝法、最后采用活性炭吸附法的综合处理工艺,可使废气达标排放。     

基于效果-效率-适应性的养殖废弃物资源化利用管理模式评价框架构建及初步应用

由于产业发展正处于转型阶段,我国畜禽养殖污染治理中的管理问题比技术问题更加突出,选择适宜的组织管理模式尤其重要。融合了效果分析、效率评价和适应性分析,尝试构建一个养殖废弃物资源化利用管理模式综合评价框架,并选择太湖流域4个不同类型的典型案例进行方法例证。研究表明,传统的养殖企业主导型管理模式应用于小型、分散养殖废弃物资源化利用时面临着经济效率低、适应性差难题;农村废弃物处理中心、种植企业和有机肥企业的参与可以改善小型、分散养殖废弃物资源化利用的经济效率;综合考虑效果、效率与适应性,种植企业、有机肥企业主导型模式的适宜推广范围更广。应根据不同地区种植-养殖产业关系、污染治理需求、经济发展水平与政府投入能力等,灵活组合应用不同管理模式。     

生物反应器填埋的沉降加速效应

通过实验室填埋柱模拟实验,研究了生物反应器填埋操作方式对填埋层沉降的影响。结果表明：与传统卫生填埋方式相比,回灌经厌氧生物处理后渗滤液的生物反应器填埋方式能够加速填埋层的沉降,140 d内沉降提高比例达10%以上。我国填埋垃圾高含水率、高易腐有机物含量的特性,使得其填埋层的次沉降系数高于文献值。填埋垃圾有机物降解量及其引起的垃圾水分排出量与填埋层沉降有显著相关性,表明有机物降解是引起填埋层沉降的重要因素,也是造成生物反应器填埋与传统卫生填埋方式初期沉降差异的主要原因。     

生活垃圾加载介质层填埋法对初期渗滤液污染抑制效果研究

以传统卫生填埋柱R2为对照,通过往生物反应器填埋柱R1内加载可渗透反应介质层1和2进行模拟试验,主要探讨了填埋柱R1垃圾渗滤液COD、总氮、氨氮及总磷的变化趋势,探索一种新型的加载介质层垃圾填埋处理方法。试验结果表明,填埋20周后, R1柱COD浓度基本维持在40 000～45 000 mg/L间,约为R2柱的20%～30%;第24周,R1柱总氮和氨氮分别为206.5 mg/L和167.3 mg/L,在16～24周内,R1总氮和氨氮分别约为R2的14.5%～17.5%和36.2%～43.6%;18周时,R1柱总磷达最大值1.704 mg/L,至第24周降为0.673 mg/L, 整个实验过程R1柱总磷约为R2的0.15%～0.56%。     

废弃印刷线路板碘化法浸金研究

针对碘化法从废弃印刷线路板中提取金的工艺设计,分别考察了碘的质量分数、n(I₂)/n(I^-)比值、固液比、双氧水的质量分数、pH值、浸出时间和浸出温度对金浸出率的影响。结合正交设计优化实验方法,提出了从废弃印刷线路板中碘化法浸取金的最佳工艺条件：碘的质量分数为1.1％,n(I₂)∶n(I^-)=1∶10,双氧水的质量分数为1.5％,浸出时间4 h,固液比为1∶10,浸出温度为常温（25℃）,溶液pH值为中性,此时金浸出率可达97.5％。     

砒霜生产化工厂危险废物处置工程设计

通过对砒霜生产化工厂原场址废渣及污染场地调查的基础上,进行了处置方案比选及技术经济比较,确定了就地安全填埋的处置方案。根据区域性危险废物集中安全填埋场的设计经验,本工程采用先进的HDPE双层防渗的安全填埋方式,并设置了雨水分流系统、渗滤液收集系统、封场处理和填埋气体导排系统,整个场区布置合理,对周围环境的影响小,投资少,取得了良好的社会效益和环境效益,并对危险废物处理处置工程设计中应注意的问题提出了建议。     

Combustion characteristics of Malaysian municipal solid waste and predictions of air flow in a rotary kiln incinerator

Malaysia is in dire need of alternatives to landfilling for solid waste management. Recently, landfills have faced the problems of overfilling, overflowing of leachates leading to pollution of water resources, and uncontrolled dust emissions adversely affecting the local environment. With the rising cost of urbanization coupled with the high rate of waste generation, one possible method of waste treatment that is receiving particular attention by the government is incineration. Incineration of solid waste is rather new in Malaysia, with limited usage in handling small sources of waste generation such as the municipal solid waste (MSW) of resort islands; however, its potential in ameliorating the problems associated with solid waste treatment may make it an attractive alternative to landfill. This article presents the results of test runs conducted to investigate the performance of a locally designed and manufactured rotary kiln incinerator (RKI). The test runs were conducted using MSW collected from the Shah Alam municipality. The combustion efficiency was analyzed by looking at the temperature profiles and chemical species concentrations. To complement the combustion characteristics measurements, predictions of the air flow in the incinerator during the process were also investigated. The overall performance of the RKI suggests that it is suitable for treating MSW.     

Occurrence of phenols in leachates from municipal solid waste landfill sites in Japan

The concentrations of 41 phenols in leachates from 38 municipal solid waste (MSW) landfill sites in Japan were measured. The main phenols detected in leachates were phenol, three cresols, 4-tert-butylphenol, 4-tertoctylphenol, 4-nonylphenol, bisphenol A, and some chlorophenols. The concentration levels of phenols were affected by the pH values of the leachates and the different types of landfill waste. The origins of phenol and p-cresol were considered to be incineration residues, and the major origin of 4-tert-butylphenol, bisphenol A, and 2,4,6-trichlorophenol was considered to be solidified fly ash. In contrast, the major origins of 4-tert-octylphenol and 4-nonylphenol were considered to be incombustibles. The discharge of leachates to the environment around MSW landfill sites without water treatment facilities can cause environmental pollution by phenols. In particular, the disposal of incineration residues including solidified fly ash and the codisposal of solidified fly ash and incombustibles might raise the possibility of environmental pollution. Moreover, the discharge of leachates at pH values of 9.8 or more could pollute the water environment with phenol. However, phenol, 4-nonylphenol, and bisphenol A can be removed to below the con centration levels that impact the environment around landfill sites by a series of conventional water treatment processes.     

废旧电池资源化、无害化

对当前国内外在废旧电池的处理处置方面进行了综合性论述,对废旧电池的危害及当前应采取的对策进行分析。