二段生物接触氧化工艺在中水回用中的特性研究

以规模小区生活污水为水源,对采用聚丙烯网状填料和强化炉渣组合填料的二段生物接触氧化工艺（以下简称二段法）进行了试验研究,试验针对本工艺的各项技术指标、影响因素以及各相关参数进行了较系统的试验测试。结果表明,反应器在第一接触氧池HRT为20 min、气水比为6∶1和第二接触氧池HRT为25 min、气水比为5∶1条件下,接触氧化池达到最佳降碳条件;反应器在第一接触沉池上升流速5.5 m/h和第二接触沉池上升流速4.5 m/h条件下,接触沉淀池达到最佳处理条件。     

固相萃取富集高效液相色谱法测定环境水样中的重金属元素

研究了用固相萃取富集高效液相色谱法测定环境水样中痕量重金属镍、铜、银、铅、镉和汞的方法。环境水样中的镍、铜、银、铅、镉和汞用四 -(对二甲氨基苯基 ) -卟啉 (T4 -DMAPP)柱前衍生 ,用C18固相萃取小柱萃取富集镍、铜、银、铅、镉和汞的T4 -DMAPP络合物 ,富集倍数为 1 0 0倍 ,然后用甲醇和四氢呋喃梯度洗脱为流动相 ,WatersXter raTMRP18( 3 9mm× 1 5 0mm)色谱柱为固定相分离 ,用二极管矩阵检测器检测。镍、铜、银、铅、镉和汞的检测限分别为3、2、4、3、1 5ng/L和 3ng/L。方法相对标准偏差为 1 8%— 3 2 % ,标准回收率为 92 %— 1 0 7%。该方法用于测定环境水样中的痕量重金属 ,结果令人满意     

测定水中阴离子表面活性剂方法探讨

阴离子表面活性剂的监测方法一般采用亚甲蓝分光光度法，此方法非常繁琐，尤其调节pH的过程和萃取、洗涤的过程，另外，亚甲蓝分光光度法要萃取三次，不仅消耗大量的三氯甲烷，而且带来二次污染．而本文所采用的二氮杂菲萃取分光光度法操作简单，且消耗试剂只有亚甲蓝分光光度法的1／5．通过实验，两种方法平均相对偏差为5．2％，分析结果一致性令人满意，说明目前地表水监测中可以用二氮杂菲萃取分光光度法取代亚甲蓝分光光度法．     

DPSD在PT二次侧检测中的应用

随着电能计量准确性要求的不断提高,以及“注入信号法”在故障选线及电容电流测量中的广泛应用,PT二次侧信号的准确检测就显得尤为重要。在PT二次侧提取信号时,传统的检测方法检测精度不高,很难满足实际应用要求。因此,提出将数字相敏检波(DPSD)应用到PT二次侧的信号检测中,该方法的优点是不仅能检测信号幅值大小,同时能检测信号的相位。此外,DPSD检测精度较高,特别适用于低信噪比(SNR)的检测场合。设计DPSD检测算法,在MATLAB/SIMULINK环境下建立仿真模型,验证在PT二次侧检测低SNR信号的效果,检测结果证明DPSD有效地抑制了电网中谐波信号和强噪声,并能准确地将感兴趣信号提取出来。     

砷中毒及其预防

2003年9月7日,位于云南省楚雄市郊区的滇中铜冶炼厂发生了一起急性职业中毒事件。当日中午,一些工人出现了严重的头晕、胸闷、恶心、呕吐、腹痛、腹泻等中毒症状,先后有76人被送进楚雄州人民医院治疗,8人观察治疗。经省、州职业病专家现场调查,     

《大气污染防治行动计划》对郑州市冬季PM2.5浓度及化学组成影响

基于《大气污染防治行动计划》实施前后,在污染严重的冬季（2013年和2018年12月同期）,采集郑州市监测站的PM_2.5样品,分析PM_2.5化学组成,通过对比分析PM_2.5中的EC、OC、水溶性离子和金属元素的浓度变化来评估PM_2.5浓度及化学组成的变化,同时选取不同阶段重污染过程,探究PM_2.5浓度及组成的变化. 结果表明：①郑州市冬季ρ（PM_2.5）平均值由2013年的（215.38 ±107.28） μg·m^-3 下降至2018年的（77.45 ±49.81） μg·m^-3,下降率高达64%. ②PM_2.5中EC、K⁺、SO₄^2-和Cl^-,分别下降了85%、80%、78%和72%;OC、NH₄⁺和NO₃^-下降幅度较小,分别为50%、41%和32%. ③与2013年冬季相比,2018年冬季OC/EC的值升高了2.6倍,二次有机碳在OC中占比升高至57%;同时,硫氧化率和氮氧化率的值分别升高了1.5倍和1.0倍,表明郑州市二次污染较为严重,二次转化程度升高. ④NO₃^-/SO₄^2-（质量比）由2013年的0.8 ±0.2升高至2018年2.5 ±1.0,表明郑州市移动源贡献上升并且超过固定源成为冬季大气污染的主要来源. ⑤不同阶段重污染过程对比结果显示,与2013年相比,2018年重污染过程中PM_2.5浓度下降显著,峰值浓度下降了61%,主要化学组成由OC、NO₃^-、SO₄^2-和NH₄⁺变为OC、NO₃^-和NH₄⁺. 研究结果表明郑州市一次排放源管控取得了显著的成效,但二次生成对PM_2.5贡献呈现升高趋势,因此未来需要关注二次生成的影响.     

Adsorption thermodynamics and kinetic investigation of aromatic amphoteric compounds onto different polymeric adsorbents

The adsorption behavior of p-aminobenzoic acid and o-aminobenzoic acid onto the different polymeric adsorbents was systematically investigated as a function of the solution concentration and temperature.Experimental results indicated that the equilibrium adsorption data of the four polymeric adsorbents fitted well in the Freundlich isotherm.The adsorption capacity of multi-functional polymeric adsorbent NJ-99 was the highest,which might be attributed to the strong hydrogen-bonding interaction between the amino groups on the resin and the carboxyl group of aminobenzoic acid.The adsorption capacity of o-aminobenzoic acid onto any adsorbent was higher than p-aminobenzoic acid.Thermodynamic studies suggested the exothermic,spontaneous physical adsorption process.Adsorption kinetics results showed that the adsorption followed the pseudo-second-order kinetics model and the intraparticle mass transfer process was the rate-controlling step.     

Leaching of styrene and other aromatic compounds in drinking water from PS bottles

Bottled water may not be safer, or healthier, than tap water. The present studies have proved that styrene and some other aromatic compounds leach continuously from polystyrene （PS） bottles used locally for packaging. Water sapmles in contact with PS were extracted by a preconcentration technique called as ＂purge and trap＂ and analysed by gas chromatograph-mass spectrometer （GC/MS）. Eleven aromatic compounds were identified in these studies. Maximum concentration of styrene in PS bottles was 29.5 μg/L. Apart from styrene, ethyl benzene, toluene and benzene were also quantified but their concentrations were much less than WHO guide line values. All other compounds were in traces. Quality of plastic and storage time were the major factor in leaching of styrene. Concentration of styrene was increased to 69.53 μg/L after one-year storage. In Styrofoam and PS cups studies, hot water was found to be contaminated with styrene and other aromatic compounds. It was observed that temperature played a major role in the leaching of styrene monomer from Styrofoam cups. Paper cups were found to be safe for hot drinks.     

Modeling of air quality with a modified two-dimensional Eulerian model： A case study in the Pearl River Delta （PRD） region of China

A modified two-dimensional Eulerian air quality model was used to simulate both the gaseous and particulate pollutant concentrations during October 21-24, 2004 in the Pearl River Delta （PRD） region, China. The most significant improvement to the model is the added capability to predict the secondary organic aerosols （SOA） concentrations because of the inclusion of the SOA formation chemistry. The meteorological input data were prepared using the CALMET meteorological model. The concentrations of aerosol-bound species such as NO3^-, NH4^＋, SO4^2-, and SOA were calculated in the fine particle size range （〈2.5 μm）. The results of the two-dimensional model were compared to the measurements at the ground level during the PRD Intensive Monitoring Campaign （IMC）. Overall, there were good agreements between the measured and modeled concentrations of inorganic aerosol components and O3. Both the measured and the modeled results indicated that the maximum hourly O3 concentrations exceeded the China National Air Quality Standard. The predicted 24-h average SOA concentrations were in reasonable agreement with those predicted by the method of minimum OC/EC ratio.     

南京市2000~2014年城市建设用地变化及驱动因子研究

基于土地利用模型测度2000~2014年南京市城市建设用地的动态变化,再运用典型相关分析、主成分分析及逐步回归分析组合的偏最小二乘回归法对南京市城市建设用地的驱动因子进行分析。结果表明：（1）2000~2014年南京市城市建设用地面积总体上呈上升趋势,年均增长率为11.73%;（2）南京市用地结构信息熵呈波动下降趋势,城市建设用地系统结构性增强,但是用地扩展的综合效益趋降;（3）人口增长、道路扩展、投资水平提高及文化产业发展等能够较好的解释南京市城市建设用地的增长,这4类因子对城市建设用地变化具有正向作用;（4）逐步线性回归结果表明,园林绿地面积的增加相对其他因子对南京市建设用地规模增长的作用最大,其次是道路长度和公路里程。