Comparison of quartz sand, anthracite, shale and biological ceramsite for adsorptive removal of phosphorus from aqueous solution

The choice of substrates with high phosphorus adsorption capacity is vital for sustainable phosphorus removal from waste water in constructed wetlands. In this study, four substrates were used： quartz sand, anthracite, shale and biological ceramsite. These substrate samples were characterized by X- ray diffractometry and scanning electron microscopy studies for their mineral components （chemical components） and surface characteristics. The dynamic experimental results revealed the following ranking order for total phosphorus （TP） removal efficiency： anthracite 〉 biological ceramsite 〉 shale 〉 quartz sand. The adsorptive removal capacities for TP using anthracite, biological ceramsite, shale and quartz sand were 85.87, 81.44, 59.65, and 55.98 mg/kg, respectively. Phosphorus desorption was also studied to analyze the substrates＇ adsorption efficiency in wastewater treatment as well as the substrates＇ ability to be reused for treatment. It was noted that the removal performance for the different forms of phosphorus was dependent on the nature of the substrate and the adsorption mechanism. A comparative analysis showed that the removal of particulate phosphorus was much easier using shale. Whereas anthracite had the highest soluble reactive phosphorus （SRP） adsorptive capacity, biological ceramsite had the highest dissolved organic phosphorus （DOP） removal capacity. Phosphorus removal by shale and biological ceramsite was mainly through chemical adsorption, precipitation or biological adsorption. On the other hand, phosphorus removal through physical adsorption （electrostatic attraction or ion exchange） was dominant in anthracite and quartz sand.     

Enhanced struvite recovery from wastewater using a novel cone-inserted fluidized bed reactor

The feasibility of struvite recovery at low （12.5 mg/L） and high （120 mg[L） phosphorus concentrations was studied by constructing a novel fluidized bed reactor with cones （FBRwc） and without cones （FBRwoc）. The crystallization process was continuously operated for 133 days under different hydraulic retention times （HRT = 1-10 hr）, pH （7.5-10）, and molar ratios of Mg/P （0.75-1.75）, N/P （1-10） and Ca/Mg （0-2）. The optimum operating conditions of HRT, pH, Mg/P and N/P molar ratios were found to be 2 hr, 9, 1.25, and 7.5, respectively. Under these optimum conditions, the phosphorus precipitation efficiencies of FBRwc were 93% for low and 98% for high phosphorus influent; however, the efficiencies were 78% and 81% for FBRwoc, respectively. Due to crystal losses at each junction （17%-31%）, the crystal recovery efficiency of FBRwoc was relatively low （47%-65%） for both influent concentrations. However, the losses were minimal in FBRwc, which showed 75% and 92% crystal recovery for low and high phosphorus concentrations, respectively. At low calcium concentration, crystal chemical analysis showed the product to be pure struvite （〉 99%）. The scanning electron microscope and X-ray diffraction results further confirmed that the crystal recovered from FBRwc contained pure struvite, which could be considered a high quality fertilizer. Except HRT, all parameters （pH, Mg/P, N/P and Ca/Mg） were found to be influencing factors for FBRwc performance. Overall, inserting cones in each part of the reactor played a significant role in enhancing struvite recovery from a wide range of phosphorus-containing wastewater.     

Fabrication and photoelectrocatalytic properties of nanocrystalline monoclinic BiVO4 thin-film electrode

Monoclinic bismuth vanadate(BiVO4) thin film was fabricated on indium-tin oxide glass from an amorphous heteronuclear complex via dip-coating.After annealation at 400,500,and 600°C,the thin films were characterized by X-ray diffraction,field emission scanning electron microscopy,X-ray photoelectron spectroscopy,and UV-Vis spectrophotometry.The BiVO4 particles on the ITO glass surface had a monoclinic structure.The UV-Visible diffuse reflection spectra showed the BiVO4 thin film had photoabsorption propertie...     

土壤胡敏素对铜离子的吸附作用及其机理研究

以暗棕壤为供试土壤,研究了不同溶液pH值、离子强度、接触时间、反应温度和初始铜离子(Cu~(2+))浓度条件下,胡敏素对Cu~(2+)的吸附作用;利用扫描电子显微镜(SEM)、X-射线能量色散谱(EDS)、傅立叶变换红外光谱(FTIR)和X-射线光电子能谱(XPS),对胡敏素/胡敏素-Cu~(2+)复合物的表面形貌、元素分布和官能团组成进行了分析;应用延展X-射线吸收精细结构谱(EXAFS),对吸附态Cu~(2+)的局域配位结构进行了表征.结果表明:胡敏素对Cu~(2+)的吸附量随pH值、接触时间、反应温度和Cu~(2+)浓度的增加而增加,但随离子强度的增加而下降;吸附动力学符合准二级动力学方程,而吸附等温线用Langmuir方程的拟合效果较好;吸附过程需要能量,是自发、吸热和自由度增加的缔合反应;吸附Cu~(2+)之后,胡敏素表面产生了团聚现象,表面羧基、羟基、吡啶氮和N—O基团参与了Cu~(2+)的吸附作用,同时吸附态Cu~(2+)是以内层配位形式与胡敏素表面的O/N和C原子结合.     

Effect of manufacturing methods of AgCl/Al2O3 catalyst on selective catalytic reduction of NOx

The AgCl/Al2O3 catalyst has potential for use in the selective catalytic reduction (SCR) of NOx. A compound hydrocarbon, following oxygenation is used as a type of reducing agent. In this experiment, the AgCl/Al2O3 catalyst was produced by four different methods, and the differences among their reduction catalysis of NOx were compared. Ethanol was used as a type of reducing agent. X-ray diffraction analysis was performed to study the crystalline structure and scanning electron microscope and transmission electron microscope (TEM) were applied to determine the microindentation. The results indicated that, in the range of 350–400°C, there was no significant difference on the NOx reduction rate; however, there was dispersion at high and low temperature ranges. The size of the AgCl particles was about 20–100 nm.     

Ultrasonic preparation of nano-nickel/activated carbon composite using spent electroless nickel plating bath and application in degradation of 2,6-dichlorophenol

Ni was effectively recovered from spent electroless nickel （EN） plating baths by forming a nano-nickel coated activated carbon composite. With the aid of ultrasonication, melamine- formaldehyde-tetraoxalyl-ethylenediamine chelating resins were grafted on activated carbon （MFT/AG）. PdC12 sol was adsorbed on MFT/AC, which was then immersed in spent electroless nickel plating bath; then nano-nickel could be reduced by ascorbic acid to form a nano-nickel coating on the activated carbon composite （Ni/AC） in situ. The materials present were carefully examined by Fourier transform infrared spectroscopy, X-ray diffraction, field emission scanning electron microscopy, X-ray photoelectron spectroscopy and electro- chemistry techniques. The resins were well distributed on the inside and outside surfaces of activated carbon with a size of 120 ± 30 nm in MFT/AC, and a great deal of nano-nickel particles were evenly deposited with a size of 3.8 ± 1.1 nm in Ni/MFT. Moreover, Ni/AC was successfully used as a catalyst for ultrasonic degradation of 2.6-dichloronhenol.     

固定化混合菌修复油污染地表水的研究

从辽河油田受石油污染的河床底泥中筛选出一株芽孢杆菌(Bacillus sp.)和一株黄杆菌(Flavobacterium sp.),采用二次交联化学方法对2株细菌单独及混合固定,分别进行了不同接种量的固定化细菌对油的降解,以及固定化混合菌对环境的耐受性和在自然地表水中对油的降解进行研究,结果表明,在相同时间内固定化混合菌对油的降解效果明显优于固定化单株菌,而且都优于游离菌。固定化混合菌pH在6～10、温度在20～40℃范围内能保持较好的活性。在120 h时,固定化混合菌对自然地表水中油的降解率达94.5%,对地表水中COD的去除率达89.6%。扫描电子显微镜分析显示,固定化载体的微观结构适合细菌的生长,固定化混合菌在载体内部形成高密度的菌群。以上的研究为固定化微生物应用于油污染地表水的生物修复提供了一定的理论基础。     

大气细颗粒物的透射电子显微镜研究

利用透射电子显微镜(TEM)对北京市区和背景点的细颗粒物(PM2.5)的形貌特征和集聚状态进行分析,结合颗粒物能谱(EDX)和选区电子衍射(SAED)特征,将北京市大气细颗粒物分为烟尘集合体、飞灰、矿物颗粒、硫酸盐和有机颗粒等5种单颗粒类型,并讨论了它们的来源.TEM分析表明,北京市区和背景点大气细颗粒物中不同类型的单颗粒所占比例不同,表明市区和背景点细颗粒物的污染物源有所不同.研究还表明,不同类型的细颗粒之间常常发生聚集.     

Synthesis of novel CeO2-BiVO4/FAC composites with enhanced visible-light photocatalytic properties

To utilize visible light more effectively in photocatalytic reactions, a fly ash cenosphere （FAC）-supported CeO2-BiV04 （CeO2-BiVO4/FAC） composite photocatalyst was prepared by modified metalorganic decomposition and impregnation methods. The physical and photophysical properties of the composite have been characterized by X-ray diffraction （XRD）, scanning electron microscope （SEM） and energy dispersive X-ray spectroscopy （EDX）, X-ray photoelectron spectroscopy （XPS）, and UV-Visible diffuse reflectance spectra. The XRD patterns exhibited characteristic diffraction peaks of both BiVO4 and Ce02 crystalline phases. The XPS results showed that Ce was present as both Ce4＋ and Ce3＋ oxidation states in Ce02 and dispersed on the surface of BiV04 to constitute a p-n heterojunction composite. The absorption threshold of the CeO2-BiVO4/FAC composite shifted to a longer wavelength in the UV-Vis absorption spectrum compared to the pure Ce02 and pure BiV04. The composites exhibited enhanced photocatalytic activity for Methylene Blue （MB） degradation under visible light irradiation. It was found that the 7.5 wt.% CeO2-BiVO4/FAC composite showed the highest photocatalytic activity for MB dye wastewater treatment.     

电子显微技术研究生物膜特性

介绍了激光共聚焦扫描显微镜、扫描电子显微镜、环境扫描电子显微镜的工作原理、特点和功能,分析了电子显微技术在观察生物膜结构、形貌和微生物群落分布的优缺点.