AgNO3滴定水中Cl终点误差的校正

依据AgNO3滴定水中Cl^-的实验原理，指出了经典空白实验存在的问题，并分析了指标剂的用量和滴定液浓度对滴定终点的影响，进而探索出一种行之有效校正滴定终点误差的方法。     

高浓度Cl-水样CODcr的测定

阐述了高浓度Cl-水样,以铬酸钾做指示剂,加入适量的硝酸银,形成AgCl沉淀,消除了Cl-的干扰,再用离心沉淀机充分沉淀,取上清液,用COD快速测定仪测定CODcr,有很高的准确度,符合测定要求.     

工业废弃物硒的氧化利用

在化学反应中,二氧化硒作为温和的氧化剂,可以将羟基、甲基等基团氧化为醛基,而本身被还原成为硒.以合成反应中生成的硒为原料,用浓硝酸和浓硫酸的混合物进行氧化反应,使其氧化为可以重复使用的二氧化硒,反应收率为94%,并用滴定法测定其含量为96%,符合工业化生产的要求.     

水中氨氮测定不确定度的评定

采用蒸馏-中和滴定法测定水中氨氮,建立数学模型,找出影响不确定度的来源并进行各分量不确定度的评价,如实反映测量的置信度和准确度.     

Silver impregnated carbon for adsorption and desorption of elemental mercury vapors

The Hg0 vapor adsorption experimental results on a novel sorbent obtained by impregnating a commercially available activated carbon (Darco G60 from BDH) with silver nitrate were reported. The study was performed by using a fundamental approach, in an apparatus at laboratory scale in which a synthetic flue gas, formed by Hg0 vapors in a nitrogen gas stream, at a given temperature and mercury concentration, was flowed through a fixed bed of adsorbent material. Breakthrough curves and adsorption isotherms were obtained for bed temperatures of 90, 120 and 150°C and for Hg0 concentrations in the gas varying in the range of 0.8–5.0 mg/m3. The experimental gas-solid equilibrium data were used to evaluate the Langmuir parameters and the heat of adsorption. The experimental results showed that silver impregnated carbon was very effective to capture elemental mercury and the amount of mercury adsorbed by the carbon decreased as the bed temperature increased. In addition, to evaluate the possibility of adsorbent recovery, desorption was also studied. Desorption runs showed that both the adsorbing material and the mercury could be easily recovered, since at the end of desorption the residue on solid was almost negligible. The material balance on mercury and the constitutive equations of the adsorption phenomenon were integrated, leading to the evaluation of only one kinetic parameter which fits well both the experimentally determined breakthrough and desorption curves.     

EDTA滴定法测定高锰水体总硬度的干扰和消除

测定水质总硬度最常用的是EDTA 滴定法,该法易受到多种因素的影响,而锰是重要影响因素之一。分析了锰对EDTA滴定法的影响,对比了两种掩蔽剂对不同浓度锰的掩蔽效果和对检测结果的影响。对实验结果进行了总结分析,为EDTA滴定法测定高锰水体总硬度过程中不同掩蔽剂的选择提供一定的依据。     

高氯低COD值水样的无汞快速测定法

以硝酸银和硫酸铬钾代替硫酸汞来消除 COD 测定中的氯离子干扰,同时将重铬酸钾溶液的浓度降低为0.100 mol／L,并用硫磷混酸代替硫酸,该方法经过对标准样品和实际样品的测定,表现出对于测定氯离子含量低于25000 mg／L的高氯低 COD 值水样具有较好的准确度和精密度,同时可以实现银盐的回收再利用。     

二氯荧光黄为指示剂的硝酸银滴定法测定废水中氯化物

采用以二氯荧光黄为指示剂的硝酸银滴定法测定废水中氯化物。优化实验条件后,以该法测定质控样,相对误差-1.30%～2.70%,相对标准偏差0.10%～0.14%,加标回收率约为98%。用该法测定废水中氯化物是合理可行的。     

重铬酸盐滴定法测定COD的影响因素研究

消解酸度、滴定酸度、还原性离子、消解时间等是影响重铬酸钾滴定法测定水中化学需氧量(COD)的重要因素。本文对这些影响因素开展研究，结果表明，消解酸度从50%(v/v)减少至30%,COD的测定值降低了35%～57%。氯离子的氧化产物为氯气，但采取0.025 mol/L的重铬酸盐时不能被完全氧化；铵离子单独存在时对测定COD值无贡献，但与氯离子共存时有贡献；碘离子则无此现象。     

自动电位滴定法测定烟气氨法脱硫模拟浆液中氯离子的研究

氯离子含量是氨法脱硫工艺中的一个重要监控指标,用自动电位滴定法测定氨法脱硫浆液中的氯离子。结果表明,实验加入乙醇有利于增大电位突跃幅度;pH值为3~5时实验结果准确;加标回收率为90%~110%;与莫尔法相比,测定结果准确度、精密度更高,且不受灰分颜色干扰;与离子色谱法测定结果准确度、精密度相近,但测定高浓度氯离子电位滴定法更有优势。