Modeling assessment for ammonium nitrogen recovery from wastewater by chemical precipitation

Chemical precipitation to form magnesium ammonium phosphate (MAP) is an effective technology for recovering ammonium nitrogen (NH4 +-N). In the present research, we investigated the thermodynamic modeling of the PHREEQC program for NH4 +-N recovery to evaluate the effect of reaction factors on MAP precipitation. The case study of NH4 +-N recovery from coking wastewater was conducted to provide a comparison. Response surface methodology (RSM) was applied to assist in understanding the relative significance of reaction factors and the interactive effects of solution conditions. Thermodynamic modeling indicated that the saturation index (SI) of MAP followed a polynomial function of pH. The SI of MAP increased logarithmically with the Mg2+/NH4 + molar ratio (Mg/N) and the initial NH4 +-N concentration (CN), respectively, while it decreased with an increase in Ca2+/NH4 + and CO3 2??/NH4 + molar ratios (Ca/N and CO3 2??/N), respectively. The trends for NH4 +-N removal at different pH and Mg/N levels were similar to the thermodynamic modeling predictions. The RSM analysis indicated that the factors including pH, Mg/N, CN, Ca/N, (Mg/N) (CO3 2??/N), (pH)2, (Mg/N)2, and (CN)2 were significant. Response surface plots were useful for understanding the interaction effects on NH4 +-N recovery.     

Effect of anaerobic digestion on the high rate of nitritation, treating piggery wastewater

Laboratory reactors were operated by using piggery wastewater and the effluent of anaerobic digester from piggery wastewater plants to study the effect of anaerobic digestion on nitritation rate.     

铅酸电池的回收处理工艺

本文阐述了铅酸电池的资源化回收利用的工艺技术,通过分析废铅合金板的回收再利用技术及电解液、含铅废水、废气处理工艺的优、缺点探索铅酸电池回收利用技术的发展趋势。     

酸析+臭氧+MBR工艺处理手机显示屏厂废水

哈威特光电技术有限公司是一家生产手机显示屏强化玻璃的企业,主要生产废水为油墨废水、研磨废水、清洗废水,其中油墨废水COD浓度高达8 000～12 000 mg/L,废水呈碱性且可生化性差;污水处理采用酸析+臭氧+MBR工艺,其中酸析法主要对油墨废水进行预处理,臭氧氧化提高综合废水的B/C比,最后进入膜生化装置MBR处理,出水能达到污水综合排放标准(GB8978-1996)的一级标准。     

磁性膨润土材料吸附处理印染废水研究

针对目前膨润土在应用中的一些问题,对膨润土进行磁性能改性,通过共沉淀法制备磁性膨润土颗粒,并对其进行了X射线衍射和磁性能表征分析.以阴离子染料OrangeⅡ为目标化合物,研究了磁性膨润土材料对OrangeⅡ废水的吸附效果,并探讨了主要工艺参数如阳离子表面活性剂的质量浓度、pH、温度等对染料去除率的影响.结果表明:阳离子...     

土壤阴离子表面活性剂总量亚甲基蓝法研究

文章通过设计正交试验,针对提取的主要因素提取液配比、提取时间、提取温度和提取剂用量确定最优的前处理方法,建立与国标《水质阴离子表面活性剂亚甲基蓝分光光度法》(GB7494-87)对应的土壤阴离子表而活性剂(LAS)的亚甲基蓝分光光度法.土壤样品烘干后经20 mL乙醇水溶液(70％)提取,水浴恒温振荡仪45℃下振荡2h,...     

稀土磁盘水处理方案技术经济比较

文章针对日照钢铁集团公司2150热轧水处理工程浊环水处理方案选择,对传统沉淀过滤法和先进的稀土磁盘法进行了对比和分析,稀土磁盘法在效果、占地、投资和运行维护费用上有较多优势,最终选用该工艺。     

工业废水中钡的排放限值研究

在查阅大量文献资料基础上,总结了环境中钡的来源和特性,采用电感耦合等离子原子发射光谱方法测定地表水及稀土废水中的钡元素含量.对仪器的工作参数和被测元素的分析谱线进行了优化和选择,结合钡的化学毒性,提出了废水中钡的标准是5mg/L的建议.     

高压脉冲电凝-Fenton-生化法处理制药废水

通过高压脉冲电凝-Fenton对制药废水进行预处理,出水进入UASB-AO生化处理系统.研究表明:高压脉冲电凝-Fenton氧化法的最佳工况条件为进水pH值为4.0左右,高压脉冲电凝反应时间为45 min,H2O2投加量为4mL/L,Fenton氧化时间为60min.高压脉冲电凝-Fenton对CODCr去除率为36.5%～39.2%,ρ(BOD5)/ρ(CODCr)从0.13提高到0.32-0.34,废水的可生化性大大提高,UASB厌氧反应器去除率为81.4%～82.1%,AO系统去除率为88.0%～88.5%,而整个生化处理系统对CODCr去除率为95.4%～97.9%,最终出水各项指标可达到GB 8978-1996<污水综合排放标准>中一级标准.     

活性污泥吸附絮凝中纤板废水的研究

利用实验室培养的活性污泥吸附絮凝预处理中纤板废水中的悬浮物和有机物。研究结果表明,当污泥投加量为6~9 g/L,废水pH值为6,吸附絮凝时间为30 min,沉淀时间为30 min时,处理效果最好,对废水中SS,COD和SCOD的去除率分别为29%,24%和17%左右。该方法为含高悬浮物、高有机物工业废水的预处理开辟了新途径。