单宁为模板制备纳米二氧化钛 及其对钍的吸附性能

以杨梅单宁(BT)为模板,水热法合成纳米二氧化钛(BT-NTO)。采用XRD、FTIR、SEM和TEM技术对BT-NTO的结构及形貌进行了表征。将BT-NTO用于吸附溶液中的Th~(4+),在溶液pH为3.5、温度为25℃、Th~(4+)初始浓度为0.5 mmol/L的条件下,BT-NTO对Th~(4+)的吸附量为0.905 8 mmol/g;吸附过程符合准二级动力学方程和Langmuir等温吸附方程;溶液中共存的Zn~(2+)、Ni~(2+)、Co~(2+)、Sr~(2+)、Yb~(3+)、Nd~(3+)、Sm~(3+)、Gd~(3+)、La~(3+)、Cl-、ClO4-离子对Th~(4+)吸附量影响较小;BT-NTO的重复使用性能较好。     

预氧化聚丙烯腈/g-C3N4光催化降解罗丹明B

以聚丙烯腈(PAN)和g-C_3N_4为原料,采用超声波辅助分散的溶液浸渍法及煅烧法制备了具有共轭结构的预氧化聚丙烯腈/g-C_3N_4复合光催化剂(CPAN/g-C_3N_4),采用XRD、SEM、FTIR、UV-Vis DRS、EIS等技术对光催化剂进行了表征,考察了CPAN/g-C_3N_4对罗丹明B(Rh B)的可见光催化降解性能。结果表明:CPAN与g-C_3N_4具有良好的协同作用,使g-C_3N_4片状结构堆叠体颗粒显著减小,明显增强了光催化剂在全部光谱范围内的光吸收,有效提高了光生电子-空穴分离效率;在PAN与g-C_3N_4质量比为1∶200、煅烧温度250 ℃、煅烧时间1 h条件下所制备的CPAN/g-C_3N_4光催化活性最高,且具有良好的光催化活性稳定性。超氧自由基和光生空穴为CPAN/g-C_3N_4复合光催化剂光降解罗丹明B的主要活性物种。     

CePO4-TiO2固溶体的NH3-SCR活性

采用共沉淀法合成了不同Ce与Ti摩尔比的CePO₄-TiO₂复合材料,利用XRD、TEM、NH₃-TPD和H₂-TPR技术对其物理化学性质进行了表征,并对其NH₃-SCR活性进行了评价。实验结果表明：随着CePO₄含量的增加,催化剂的活性提高;当Ce与Ti的摩尔比为8:2时催化剂的活性最高,230 ℃的NO转化率达到100%,且具有更广的温度窗口,优于纯CePO₄。表征结果显示,CePO₄与TiO₂形成固溶体后,颗粒尺寸较为均匀,强酸位的数量增多,氧化还原性能提升,从而提高了催化剂的SCR反应活性,同时改善了其抗水抗硫性能。     

直链烷基苯磺酸盐促进剩余污泥产生短链脂肪酸的研究

采用批试试验的方法研究了十二烷基苯磺酸钠(C12-LAS)对剩余污泥在厌氧发酵过程中产生的短链脂肪酸(SCFAs)的影响.结果表明,C12-LAS的投加极大地提高了剩余污泥厌氧发酵过程中的SCFAs产量.当C12-LAS加入量低于0.1g·g-1时,SCFAs产量随着C12-LAS加入量的增加而增加,然而,当C12-LAS加入量高于0.1g·g-1时,SCFAs产量反而有所降低.从污泥产酸量以及经济成本考虑,C12-LAS的最佳投加量为0.02g·g-1,此时剩余污泥的SCFAs最大产量出现在第6天.进一步的研究表明,C12-LAS不仅促使大量的碳水化合物和蛋白质脱离污泥颗粒并溶解到液相中,而且抑制了产甲烷菌的活性.尽管剩余污泥经历着酸化过程,但由于其释放出大量的NH4 -N,污泥在整个厌氧发酵过程中的pH值逐渐升高.     

黄钠铁矾渣制备透明氧化铁黄的研究

研究了以黄钠铁矾渣为原料,采用滴加法制备透明铁黄的工艺条件,讨论了亚铁浓度、温度、通气量、搅拌速度及添加剂用量等因素对铁黄制备的影响.用XRD和TEM对产品进行表征.结果表明,铁黄粒子呈针状;长轴为95～125 nm,短轴为18～25 nm;无团聚现象,单分散性好.     

4-硝基苯胺与人血清白蛋白相互作用的研究

通过荧光和紫外光谱法研究了4-硝基苯胺与人血清白蛋白（HSA）的作用.结果表明,4-硝基苯胺对HSA的内源荧光具有强烈的猝灭作用.猝灭机理为静态猝灭,同时伴随有非辐射能量转移的发生.根据双对数方程计算其结合常数和结合位点数.确定4-硝基苯胺与HSA有一类结合部位.根据热力学参数得出4-硝基苯胺与HSA之间的主要作用力为氢键和疏水作用力.同步荧光的结果表明,作用点位靠近色氨酸,并且使色氨酸的疏水环境增强.     

基于IME6400的MPEG-4嵌入式视频监控系统实现

本文基PMPEG-4的编码原理,利用嵌入式及网络技术设计实现了嵌入式视频监控系统.     

基于Linux的嵌入式无线图像监控系统

介绍一种基于Linux的嵌入式操作系统和CDMA 1X无线数据业务的图像监控系统方案.系统以LvRLinux操作系统为软件平台,以ARM9微处理器AT91RM9200为硬件平台,采用MPEG-4的专用编码芯片G07007SB对采集到的视频信号进行压缩编码.然后生成MPEG-4视频流.AT91RM9200将视频流进行处理、缓存后通过串口发送到CDMA 1X无线模块,通过CDMA 1X业务将图像数据发送到远端服务器.远端服务器具有固定的实IP地址.远端服务器通过SOCK2ET接收图像数据并进行解码显示,还可以通过发送控制信号实现对下位机的控制.     

A study on oxidative degradation of polyacrylamide in wastewater with UV/FENTON/C4H4O62−

The degradation of polyacrylamide (PAM) in simulate wastewater was studied in UV/Fenton/C₄H₄O₆^2? system. The factors such as molecular ratio of H₂O₂/Fe²⁺/C₄H₄O₆^2?, pH, and the dosage of Fenton reagent that could affect the PAM degradation in the UV/Fenton/C₄H₄O₆^2? system were investigated. The experimental results showed that adding C₄H₄O₆^2? to UV/Fenton system could form photosensitive ferrous complexes, which led to higher degradation efficiency of PAM. The degradation rate of PAM could be up to 95.2% under the following conditions: the concentration of H₂O₂, Fe²⁺, and C₄H₄O₆^2? were 22.5, 2.25, and 2.25 mmol/L, respectively (i.e., molecular ratio of H₂O₂/Fe²⁺/C₄H₄O₆^2? was 10:1:1), the pH value was 3.0.     

A numerical study on the effects of EGR and spark timing to combustion characteristics and NOx emission of a GDI engine

EGR is one of the most significant strategies for reducing especially nitrogen oxides (NO_x) emissions from internal combustion engines. The thermal efficiency of spark ignition engines is lower than compression ignition engines because of its lower compression ratio. If the compression ratio is increased to obtain higher thermal efficiency, there may be a knocking tendency in spark ignition engines. EGR can be used in order to reduce NO_x emissions and avoid knocking phenomena at higher compression ratios. In-cylinder temperature at the end of combustion is decreased and heat capacity of fresh charge is increased when EGR applied. Besides EGR, spark timing is another significant parameter for reducing exhaust emissions such as nitrogen oxides, and unburned hydrocarbon (UHC). In this study the effects of EGR and spark timing on spark ignition engine were investigated numerically. KIVA codes were used in order to model combustion process. The combustion process has been modeled for a single cylinder, four stroke and gasoline direct injection (GDI) spark ignition engine. The results showed that in-cylinder pressure and heat release rate decrease as EGR ratio increase. In-cylinder pressure increases with the advancing of spark timing. Advancing spark timing increases the heat release rate and in-cylinder temperature. The simulation results also showed that EGR reduced exhaust gas temperature and NO_x emissions.