表面活性剂改性4A分子筛对Cr(VI)的吸附行为

采用浸渍法对4A分子筛进行表面改性,通过引入阳离子表面活性剂,使4A分子筛表面附着季铵型阳离子,并与反离子Br-形成"阴离子交换膜",从而促使更多的Cr(VI)阴离子通过离子交换吸附到改性4A分子筛上,通过X-射线衍射(XRD)和傅里叶变换红外光谱(FTIR)对样品的物相结构和组成进行表征分析。研究表明,表面活性剂的类型和疏水碳氢链结构会影响4A分子筛的吸附能力,十八烷基三甲基溴化铵(OTAB)碳氢链长,在分子筛表面形成的双分子层密,对Cr(VI)的吸附量最大。采用准一级、准二级、Elovich和Bangham动力学模型对六价铬的吸附数据进行拟合,其中准一级动力学方程最符合十八烷基三甲基溴化铵改性分子筛的吸附行为。同时,分别从Langmuir和Redlich-Peterson等温吸附模型获得六价铬的最大吸附量为13.98 mg/g,且改性分子筛以均一表面吸附为主。     

人工湿地基质对NH4＋-N吸附性能

为研究建筑废物红砖和工业废物煤渣用作人工湿地脱氮基质的可行性,分别通过静态吸附实验和动态NHf—N去除效果实验进行考察。结果表明,红砖和煤渣对NH4＋-N最大静态吸附量分别为0．2533mg／g和0．0533mg／g,其吸附等温曲线均符合Freundlich型吸附方程,吸附常数分别为0．0419和0．0091;红砖煤渣组合对污水中NH4＋-N平均动态脱除率达到41．18％,高于红砖的37．63％和煤渣的30．92％。     

用煤矸石合成4A沸石分子筛处理氨氮废水

以煤矸石为原料,采用碱熔-水热法合成4A沸石分子筛。由于煤矸石中铝、硅主要以高岭土形式存在,其活化过程是合成4A沸石分子筛关键环节。为提高4A沸石分子筛钙离子的交换能力,增加对模拟废水氨氮的去除率,实验考察了碳酸钠与煤矸石质量比、活化温度、活化时间、晶化温度和晶化时间对4A沸石分子筛钙离子交换能力的影响,同时也考察了模拟废水的pH、4A沸石分子筛加入量及吸附时间对氨氮去除率的影响。结果表明,最佳工艺条件为,碳酸钠与煤矸石质量比为0.9、活化温度为800℃、活化时间1.5 h、晶化温度90℃和晶化时间3 h。合成4A沸石分子筛的钙离子交换能力为310 mg/g,在pH为6的100 mL模拟氨氮废水中加入6 g 4A沸石分子筛吸附40 min后,废水中氨氮的去除率达到86%。通过最佳工艺条件合成4A沸石分子筛,在处理氨氮废水方面具有一定的应用前景。     

硅藻土固定化颗粒污泥对海水养殖废水除氨性能

针对实际海水养殖废水低碳高氮的特点,采用间歇式活性污泥法(SBR)和好氧活性污泥添加硅藻土载体的方式,考察硅藻土载体和活性污泥共同作用下的好氧曝气系统对海水养殖废水中氨态氮(NH4+-N)、亚硝酸态氮(NO2--N)和化学耗氧量(COD)的去除效果,以及对污泥沉降性能和硝化细菌特征的影响。实验结果表明,常温条件下,溶解氧(DO)≥ 4.5 mg/L,pH控制在7.0 ~ 8.0,HRT为11 h,沉降时间10 min,反应器可以处理NH4+-N浓度在50 mg/L左右的海水养殖废水,NH4+-N和COD去除率分别达到98.93%左右和76.62%以上,NO2--N出水浓度低于0.028 mg/L。载体污泥颗粒照片和扫描电镜结果表明,添加硅藻土载体内核后,颗粒污泥的成熟期缩短,颗粒的稳固度和沉降性能提高。在系统启动成功稳定运行后,通过FISH分析表明,在氨氧化菌(AOB)与亚硝酸盐氧化菌(NOB)成为优势菌群后,AOB大约占总菌群的33.5%,并且AOB与NOB菌群数量约为1:1.33,AOB和NOB两大类菌群之和约占总菌群的77.2%,成为系统中优势菌群。     

CCl4体外引发自由基反应的简易实验方法

通过对不同剂量CCl4与小鼠肝匀浆温育反应液中丙二醛(MDA)含量的测定,确立了CCl4体外引发自由基反应的简易实验方法,并对实验方法进行了考核评定.同时以Hg2 对CCl4体外引发小鼠肝匀浆自由基反应的影响为应用实例进行了研究,结果表明,Hg2 与CCl4的毒性有协同作用.     

Technical and theoretical considerations in the HLA typing of amniotic fluid cells for prenatal diagnosis and paternity testing

HLA typing of amniotic fluid cells has been used for the prenatal diagnosis of the HLA linked diseases congenital adrenal hyperplasia (21-OH-deficiency (21-OH-def) type) and complement C4 deficiency and it has also been used for the prenatal de termination of paternity. There are, however, technical difficulties in this test associated with the weak expression of some B locus antigens on amniotic fluid cells, and theoretical difficulties related to associations between particular HLA antigens and the 21-OH-def allele. Since certain HLA-B locus antigens are found in significantly increased frequencies among patients with 21-OH-def, there is a relatively high incidence of HLA-B homozygosity among the patients and over 40 percent of the parents of these patients share one or more HLA-B locus antigens. Results of some prenatal HLA typing tests may thus be difficult to interpret, and supplementary tests should be used whenever possible. HLA typing of amniotic cells is, however, the only available procedure for prenatal diagnosis of C4 deficiency and it is the best available procedure for prenatal determination of paternity. A modification of our original procedure allows HLA typing to be performed with increased numbers of HLA typing sera, and sera with optimum reactivity for amniotic fluid cells have now been selected for the definition of most of the more commonly expressed HLA antigens. Although amniotic fluid cells do not express DR antigens, amniotic fluid cells can be typed for the HLA-linked marker glyoxalase I (GLO) and this may be the informative for prenatal diagnosis in some cases.     

废渣──Al(OH)_3凝胶再利用研究

研究了对处理铝材加工含Al3＋的酸性废液过程中产生的二次污染物Al（OH）3凝胶废渣的应用。含水分约90％、80％左右的Al（OH）3凝胶200g分别与14～16mL、22～24mL95％的工业浓硫酸酸反应，可制得浓度为20％～23％的Al（SO4）3溶液，经稀释可用作造纸原料。     

Relationships between anaerobic consortia and removal efficiencies in an UASB reactor degrading 2,4 dichlorophenol (DCP)

To gain more insight into the interactions between anaerobic bacteria and reactor performances (chemical oxygen demand-COD, 2,4 dichlorophenol-2,4 DCP removals, volatile fatty acid-VFA, and methane gas productions) and how they depended on operational conditions the microbial variations in the anaerobic granular sludge from an upflow anaerobic sludge blanket (UASB) reactor treating 2,4 DCP was studied. The study was composed of two parts. In the first part, the numbers of methanogens and acedogens in the anaerobic granular sludge were counted at different COD removal efficiencies. The relationships between the numbers of methanogens, the methane gas production and VFA production were investigated. The COD removal efficiencies increased to 74% from 30% while the number of total acedogens decreased to 10 from 30 cfu ml(-1). The number of total methanogens and acedogens varied between 11 x 10(3) and 10 x 10(9)MPN g(-1) and 10 and 30 cfu ml(-1) as the 2,4 DCP removal efficiencies were obtained between 60% and 99%, respectively. It was seen that, as the number of total acedogens decreased, the COD removal efficiencies increased. However, the number of total methanogens increased as the COD removal efficiencies increased. Correlations between the bacterial number and with the removal efficiencies obtained in different operational conditions were investigated. From the results presented in this paper a high correlation between the number of bacteria, COD removals, methane gas percentage, 2,4 DCP removals and VFA was observed. In the second part, methanogen bacteria in the anaerobic granular sludge were identified. Microbial observations and biochemical tests were applied to identify the anaerobic microorganisms from the anaerobic granular sludge. In the reactor treating 2,4 DCP, Methanobacterium bryantii, Methanobacterium formicicum, Methanobrevibacter smithii, Methanococcus voltae, Methanosarcina mazei, Methanosarcina acetivorans, Methanogenium bourgense and Methanospirillum hungatei were identified.     

A numerical study on the effects of EGR and spark timing to combustion characteristics and NOx emission of a GDI engine

EGR is one of the most significant strategies for reducing especially nitrogen oxides (NO_x) emissions from internal combustion engines. The thermal efficiency of spark ignition engines is lower than compression ignition engines because of its lower compression ratio. If the compression ratio is increased to obtain higher thermal efficiency, there may be a knocking tendency in spark ignition engines. EGR can be used in order to reduce NO_x emissions and avoid knocking phenomena at higher compression ratios. In-cylinder temperature at the end of combustion is decreased and heat capacity of fresh charge is increased when EGR applied. Besides EGR, spark timing is another significant parameter for reducing exhaust emissions such as nitrogen oxides, and unburned hydrocarbon (UHC). In this study the effects of EGR and spark timing on spark ignition engine were investigated numerically. KIVA codes were used in order to model combustion process. The combustion process has been modeled for a single cylinder, four stroke and gasoline direct injection (GDI) spark ignition engine. The results showed that in-cylinder pressure and heat release rate decrease as EGR ratio increase. In-cylinder pressure increases with the advancing of spark timing. Advancing spark timing increases the heat release rate and in-cylinder temperature. The simulation results also showed that EGR reduced exhaust gas temperature and NO_x emissions.     

A study on oxidative degradation of polyacrylamide in wastewater with UV/FENTON/C4H4O62−

The degradation of polyacrylamide (PAM) in simulate wastewater was studied in UV/Fenton/C₄H₄O₆^2? system. The factors such as molecular ratio of H₂O₂/Fe²⁺/C₄H₄O₆^2?, pH, and the dosage of Fenton reagent that could affect the PAM degradation in the UV/Fenton/C₄H₄O₆^2? system were investigated. The experimental results showed that adding C₄H₄O₆^2? to UV/Fenton system could form photosensitive ferrous complexes, which led to higher degradation efficiency of PAM. The degradation rate of PAM could be up to 95.2% under the following conditions: the concentration of H₂O₂, Fe²⁺, and C₄H₄O₆^2? were 22.5, 2.25, and 2.25 mmol/L, respectively (i.e., molecular ratio of H₂O₂/Fe²⁺/C₄H₄O₆^2? was 10:1:1), the pH value was 3.0.