Numerical evaluation of the effectiveness of NO2 and N2O5 generation during the NO ozonation process

Wet scrubbing combined with ozone oxidation has become a promising technology for simultaneous removal of SO₂ and NO_x in exhaust gas. In this paper, a new 20-species, 76-step detailed kinetic mechanism was proposed between O₃ and NO_x. The concentration of N₂O₅ was measured using an in-situ IR spectrometer. The numerical evaluation results kept good pace with both the public experiment results and our experiment results. Key reaction parameters for the generation of NO₂ and N₂O₅ during the NO ozonation process were investigated by a numerical simulation method. The effect of temperature on producing NO₂ was found to be negligible. To produce NO₂, the optimal residence time was 1.25 sec and the molar ratio of O₃/NO about 1. For the generation of N₂O₅, the residence time should be about 8 sec while the temperature of the exhaust gas should be strictly controlled and the molar ratio of O₃/NO about 1.75. This study provided detailed investigations on the reaction parameters of ozonation of NO_x by a numerical simulation method, and the results obtained should be helpful for the design and optimization of ozone oxidation combined with the wet flue gas desulfurization methods (WFGD) method for the removal of NO_x.     

High-resolution modeling and evaluation of ozone air quality of Osaka using MM5-CMAQ system

High-resolution modeling approach is increasingly being considered as a necessary step for improving the monitoring and predictions of regional air quality. This is especially true for highly urbanized region with complex terrain and land-use. This study uses Community Multiscale Air Quality (CMAQ) model coupled with MM5 mesoscale model for a comprehensive analysis to assess the suitability of such high-resolution modeling system in predicting ozone air quality in the complex terrains of Osaka, Japan. The 1-km and 3-km grid domains were nested inside a 9-km domain and the domain with 1-km grid covered the Osaka region. High-resolution Grid Point Value-Mesoscale Model (GPV-MSM) data were used after suitable validation. The simulated ozone concentrations were validated and evaluated using statistical metrics using performance criteria set for ozone. Daily maxima of ozone were found better simulated by the 1-km grid domain than the coarser 9-km and 3-km domains, with the maximum improvement in the mean absolute gross error about 3 ppbv. In addition, 1-km grid results fared better than other grids at most of the observation stations that showed noticeable di erences in gross error as well as correlation. These results amply justify the use of the integrated high-resolution MM5-CMAQ modeling system in the highly urbanized region, such as the Osaka region, which has complex terrain and land-use.     

五羰基铁对正辛硫醇中硫的脱除研究

由于能源化石类燃料中均包含不同含量的硫化物,随着人类对这些能源的不断利用,引发的环境污染等问题日趋严重。利用五羰基铁(Fe(CO)5)分解条件温和可控,产物无杂质,分解后的Fe0可以与硫原子原位键合等特点。文章尝试采用Fe(CO)5作为脱硫剂在温和条件下进行脱除正辛硫醇的研究。实验结果表明:随着压强(101~5 067 kPa)、Fe(CO)5加入量(50~250μL)、时间(1~6 h)和温度(0~180℃)的不同,Fe(CO)5脱硫效率具有明显差异,在此基础上得到最佳脱硫条件及最高脱除效率:常压、Fe(CO)5加入量200μL(1.4 mmol)、t=2h和T=140℃时,达到最高硫容3 450 mg/L。分别采用IR、XPS手段对脱硫反应机理进行了探索。IR结果表明:在1 084 cm-1处为硫氧峰,在797 cm-1归属为铁氧峰。XPS结果表明:167.8 eV处可能为S4+,711.6 eV处可能为Fe3+。因此,正辛硫醇脱除的可能机理为巯基断裂,并在空气中与氧结合,最终形成S4+,而Fe(CO)5的Fe经过脱硫之后,在空气中不稳定,最终被氧化成Fe3+。     

BOD_5样品分析中稀释倍数的确定

首先正确估计样品ＢＯＤ５浓度范围，并测定稀释水的溶解氧，然后根据稀释倍数公式计算３个适当的稀释倍数．与其它方法相比，本方法省时、可靠，适用性强，能够确保ＢＯＤ５样品分析一次成功．在ＢＯＤ５样品分析中具有广泛的应用价值．     

La-Co-Fe-Cu/HZSM-5在尾气碳颗粒燃烧中的催化性能

采用柠檬酸络合低温浸渍法制备分子筛负载钙钛矿型复合氧化物催化剂。采用XRD、SEM和H2-TPR等手段对催化剂性能进行表征,并在微型固定床反应器中对催化剂进行活性评价。结果表明,在钙钛矿型复合氧化物中进行B位离子掺杂,可以改善催化活性,碳颗粒燃烧温度降低。在20%LaCoO3/HZSM-5催化剂中用铁离子部分取代钴离子可以改善碳颗粒的燃烧性能,取代量增加碳颗粒燃烧温度降低,但是生成CO2的选择性也降低,以20%LaCo0.2Fe0.8O3/HZSM-5为催化剂,Tig、Tm和Tf分别为256℃、399℃和403℃,但生成CO2的选择性只有72.5%。在20%LaCo1-xFexO3/HZSM-5中的钙钛矿型复合氧化物B位离子中加入铜离子后,在碳颗粒燃烧反应中生成CO2的选择性得到明显改善,Sco2提高10个单位以上。以20%LaCo0.2Fe0.6Cu0.2O3/HZSM-5为催化剂,在碳颗粒燃烧反应中生成CO2的选择性可以达到94.7%,Tig、Tm和Tf分别为242℃、427℃和445℃。     

油罐喷射火燃烧模拟

针对由一定压力的单相或两相介质泄漏或压力泄放系统排放引起的喷射火,利用gambit生成计算区域网格,得到相应的计算模型.再利用Fluent软件中的离散相模型计算气体流动,采用Realizable k-epsilon湍流模型和部分预混燃烧模型来预测燃料的燃烧,模拟了戊烷燃料燃烧和湍动多相流场,给出了燃烧速度矢量、温度和组...     

Catalytic destruction of pentachlorobenzene in simulated flue gas by a V2O5-WO3/TiO2 catalyst

Pentachlorobenzene (PeCB) in simulated flue gas was destructed by a commercial V₂O₅-WO₃/TiO₂ catalyst in this study. The effects of reaction temperature, oxygen concentration, space velocity and some co-existing pollutants on PeCB conversion were investigated. Furthermore, a possible mechanism for the oxidation of PeCB over the vanadium oxide on the catalysts was proposed. Results show that the increase of gas hourly space velocity (GHSV) and the decrease of operating temperature both resulted in the decrease of PeCB removal over the catalyst, while the effect of the oxygen content in the range of 5-20% (v/v) on PeCB conversion was negligible. PeCB decomposition could be obviously affected by the denitration reactions under the conditions because of the positive effect of NO but negative effect of NH₃. The introduction of SO₂ caused the catalyst poisoning, probably due to the sulfur-containing species formed and deposited on the catalyst surface. The PeCB molecules were first adsorbed on the catalyst surface, and then oxidized into the non-aromatic acyclic intermediates, low chlorinated aromatics and maleic anhydride.     

不同生长期的Pseudomonas putida 5-x细胞对工业废水中Cu~(2+)的吸附

研究了不同生长阶段的Cu2 + 吸附细菌Pseudomonasputida 5 x对Cu2 + 的吸附容量 .结果表明在低硫培养基中 ,当P putida 5 x细胞生长刚进入对数生长期时 ,单位细胞对Cu2 + 的吸附溶量最低 .而当生长进入稳定生长期的后期或死亡期的早期时 ,单位细胞对Cu2 + 的吸附量最大 .实验结果还表明 ,高浓度的Cu2 + 对对数期细胞的吸附能力有一定的抑制 ,而对死亡期的细胞影响较小 .早期研究已证明细胞对重金属离子的吸附和细胞表面某些对重金属离子具有亲和性的功能基团 (如某些膜蛋白及羰基化合物 )有关 .利用透视电子显微镜观察了不同生长阶段的细胞表面结构及对铜离子的吸附效果 ,发现生长后期细胞表面吸附有较多的Cu2 + ,这表明生长后期的细胞表面可能含有较多的这类功能基团     

分光光度法测定雨水中微量过氧化氢的研究

本文提出了以钛（ＩＶ） 过氧化氢 ２ （３，５ 二溴 ２ 吡啶偶氮） ５ 二乙氨基苯酚（３，５ ｄｉＢｒ ＰＡＤＡＰ）三元配合物体系光度测定雨水中微量过氧化氢的方法，该方法简便，灵敏度和选择性较高，所得结果令人满意     

用二氧化氯降解废水中的苯胺类化合物（2）──降解机理的探讨

本文在上文（１）的基础上，进一步研究了经二氧化氯处理前后ＢＯＤ＿５／ＣＯＤ的变化规律，其比值大于或接近０．３．其降解产物有醌及醌的氧化产物和ＮＨＩ．对苯胺及二氧化氯来说其．反应级数为１，整个反应为二级反应．