NiO-CuO/ZSM-5催化剂对催化裂化烟气的脱硫脱硝性能

采用浸渍法制备了不同NiO和CuO质量分数的NiO-CuO/ZSM-5催化剂,并以CH4为还原剂研究了NiO-CuO/ZSM-5催化剂对催化裂化烟气的脱硫脱硝活性。XRD分析结果表明,NiO质量分数为4%、CuO质量分数为6%的催化剂4%NiO-6%CuO/ZSM-5中的ZSM-5结构完好,CuO和NiO高度分散在ZSM-5骨架中,表明具有较好的催化活性。4%NiO-6%CuO/ZSM-5的脱硫脱硝起活温度均较低,无氧条件下最高NO转化率和SO2转化率分别为94.7%和95.9%,O2体积分数为1.0%时的NO转化率和SO2转化率分别为97.7%和89.0%。     

Evaluation of a classification method for biodegradable solid wastes using anaerobic degradation parameters

We studied the biochemical and anaerobic degradation characteristics of 29 types of materials to evaluate the effects of a physical composition classification method for degradable solid waste on the computation of anaerobic degradation parameters, including the methane yield potential (L₀), anaerobic decay rate (k), and carbon sequestration factor (CSF). Biochemical methane potential tests were conducted to determine the anaerobic degradation parameters of each material. The results indicated that the anaerobic degradation parameters of nut waste were quite different from those of other food waste and nut waste was classified separately. Paper was subdivided into two categories according to its lignin content: degradable paper with lignin content of <0.05 g g VS^?1, and refractory paper with lignin content >0.15 g g VS^?1. The L₀, k, and CSF parameters of leaves, a type of garden waste, were similar to those of grass. This classification method for degradable solid waste may provide a theoretical basis that facilitates the more accurate calculation of anaerobic degradation parameters.     

堇青石负载Pd和过渡金属氧化物催化剂的表征及其对CO的催化氧化活性

以堇青石蜂窝陶瓷(CC)为载体,采用浸渍法制备了堇青石负载Pd和过渡金属混合氧化物催化剂,记作Pd-M-Mn(M=Cu,Co,Fe,Ni)/CC。实验结果表明:Pd-Co-Mn/CC催化剂的催化活性最高;随着Pd负载量的增加,CO转化率提高;当Pd负载量为1.00%时,反应温度为150℃时CO转化率达到98%,200℃时CO转化率达到100%;在反应温度150℃条件下,Pd-Co-Mn/CC催化剂(Pd负载量1.00%)的CO转化率在前30h内小幅度下降,随后稳定在90%以上,反应100h后,催化剂表面颜色由黑色变为棕褐色。     

利用钢铁盐酸酸洗废液在填料塔中制备FeCl3

以钢铁盐酸酸洗废液为原料,亚硝酸钠为催化剂,氧气为氧化剂,在填料塔中催化氧化制备三氯化铁。考察了反应温度、催化剂加入量和添加方式、循环流量等对制备三氯化铁的影响。实验结果表明,在优化的工艺条件为料液预热温度为60 ℃、催化剂加入量为钢铁盐酸酸洗废液总质量的0.30%、料液循环流量6.0 m³/h的条件下,反应80~120 min,酸洗废液中的Fe²⁺完全氧化为Fe³⁺。     

拜耳法赤泥粒径分级预处理的研究

赤泥是从铝土矿中提取氧化铝的过程中产生的工业废渣.分析了拜耳法赤泥的粒径分布,以及主要化学组成和矿物组成在不同粒径赤泥中的变化规律.在此基础上,提出先将赤泥粒径分级预处理,然后根据粗细粒径赤泥的差异分别进行回收利用的思路.研究结果表明,赤泥中粒径大于0.075 mm的粗颗粒以铁、硅、钙为主,实践证明可以通过磁选或重选工...     

餐厨垃圾厌氧消化中硬脂酸钙的形成及作用

在稳定运行的餐厨垃圾单相厌氧消化体系中,出现白色颗粒状物质,且随着负荷的提高,其数量和粒径不断增加。利用能谱技术分析白色颗粒的元素组成,结合傅里叶红外光谱和13C核磁共振技术分析白色颗粒中的官能基团。经过研究分析认为,该白色颗粒的主要成分为长链羧酸钙盐,具体为硬脂酸钙。同时,对其形成过程进行了分析。该物质的形成对餐厨垃圾中油脂的去除提供了新的思路和途径。     

活性炭纤维(ACF)应用于有机废气回收和净化的进展

活性炭纤维(ACF)有比普通活性炭吸附量大、吸附和脱附速度快等优点,因此应用于有机废气的回收和净化,具有良好的经济、环境和社会效益。文中介绍了ACF的微观结构、表面化学以及吸附性能,并综述了近年来ACF在有机废气回收和治理方面的国内概况。     

Emergy analysis of the recycling options for construction and demolition waste

Construction and demolition (C&D) waste is becoming a major contributor to environmental pollution. In Shanghai, China, the quantity of C&D waste is 2.11E+07 t/yr, which accounts for 45% of the total quantity of solid waste. There has been a growing promotion of recycling C&D waste as an effective way to solve this waste problem. However, the evaluation of the efficiency of recycling C&D waste as a potential source of resources is largely based on traditional economic analysis. The economic analysis emphasizes money instead of the harmony between economic benefit and environmental effects. There is a need for a new strategic approach to investigate the efficiency of recycling C&D waste to achieve the integration between economic, social and environmental effects. Emergy theory can be employed to analyze different recycling options for C&D waste. With reference to the Chinese construction industry, this paper demonstrates that the close-loop recycling option is better than the open-loop recycling option for C&D waste in terms of the integration of social, environmental and sustainable aspects. To evaluate different technology solutions for C&D waste recycling, the emergy theory and method is not limited to a cost-benefit balance but can include economic, social, environmental and sustainable effects.     

A hybrid method for quasi-three-dimensional slope stability analysis in a municipal solid waste landfill

Limited space for accommodating the ever increasing mounds of municipal solid waste (MSW) demands the capacity of MSW landfill be maximized by building landfills to greater heights with steeper slopes. This situation has raised concerns regarding the stability of high MSW landfills. A hybrid method for quasi-three-dimensional slope stability analysis based on the finite element stress analysis was applied in a case study at a MSW landfill in north-east Spain. Potential slides can be assumed to be located within the waste mass due to the lack of weak foundation soils and geosynthetic membranes at the landfill base. The only triggering factor of deep-seated slope failure is the higher leachate level and the relatively high and steep slope in the front. The valley-shaped geometry and layered construction procedure at the site make three-dimensional slope stability analyses necessary for this landfill. In the finite element stress analysis, variations of leachate level during construction and continuous settlement of the landfill were taken into account. The "equivalent" three-dimensional factor of safety (FoS) was computed from the individual result of the two-dimensional analysis for a series of evenly spaced cross sections within the potential sliding body. Results indicate that the hybrid method for quasi-three-dimensional slope stability analysis adopted in this paper is capable of locating roughly the spatial position of the potential sliding mass. This easy to manipulate method can serve as an engineering tool in the preliminary estimate of the FoS as well as the approximate position and extent of the potential sliding mass. The result that FoS obtained from three-dimensional analysis increases as much as 50% compared to that from two-dimensional analysis implies the significance of the three-dimensional effect for this study-case. Influences of shear parameters, time elapse after landfill closure, leachate level as well as unit weight of waste on FoS were also investigated in this paper. These sensitivity analyses serve as the guidelines of construction practices and operating procedures for the MSW landfill under study.     

Environmental assessment of garden waste management in the Municipality of Aarhus, Denmark

An environmental assessment of six scenarios for handling of garden waste in the Municipality of Aarhus (Denmark) was performed from a life cycle perspective by means of the LCA-model EASEWASTE. In the first (baseline) scenario, the current garden waste management system based on windrow composting was assessed, while in the other five scenarios alternative solutions including incineration and home composting of fractions of the garden waste were evaluated. The environmental profile (normalised to Person Equivalent, PE) of the current garden waste management in Aarhus is in the order of −6 to 8 mPE Mg⁻¹ ww for the non-toxic categories and up to 100 mPE Mg⁻¹ ww for the toxic categories. The potential impacts on non-toxic categories are much smaller than what is found for other fractions of municipal solid waste. Incineration (up to 35% of the garden waste) and home composting (up to 18% of the garden waste) seem from an environmental point of view suitable for diverting waste away from the composting facility in order to increase its capacity. In particular the incineration of woody parts of the garden waste improved the environmental profile of the garden waste management significantly.