约束空间可燃气体燃烧爆轰特性的数值研究

在可燃气体的输送、贮存、加工和使用过程中,容易发生可燃气体的燃烧和爆炸事故。文中基于有限体积方法,采用五阶WENO格式进行左右状态量的重构后,利用ROE格式进行空间离散,自行开发程序对甲烷氧气的气相爆轰波传播过程进行了数值研究。计算结果表明:在CH4质量分数为10%的混合气体中,高温高压气团可诱导气相发生爆轰,爆轰波以2133.3 m/s的速度传播。在带有障碍物的约束空间内,文中分析了障碍物不同高度、不同间距条件下爆轰波传播时波的绕射、马赫反射等现象,给出障碍物表面压力随时间变化历程和冲量值,揭示波与障碍物的相互作用机理以及由此引发流场的变化规律,为有效地控制可燃气体的燃烧速率、防治爆炸灾害的发生提供理论依据。     

稻田土菌群驯化对稻秆两步发酵产甲烷效果的影响

为提高稻秆的降解率及其厌氧发酵甲烷产量,采用高氨氮畜禽废水作为氮源以驯化稻田土壤微生物,优化其降解稻秆的初始pH值,并评估水解产物液体发酵产甲烷性能.结果表明,混合组驯化的微生物产纤维素酶活性及对稻秆木质素的降解率高于其它组及先前文献报道,分别达到4.01 IU和51.96%,且后期水解液中总有机碳（Total organic carbon, TOC）及还原糖含量最高.随着初始pH值的提高,稻秆中纤维素、半纤维素和木质素的降解率显著增加,稻秆水解液中的挥发性脂肪酸（Volatile fatty acids, VFAs）和TOC含量均显著增加,并在第7 d达到最高值.将水解稻秆7 d的水解液进行厌氧发酵显示,在初始pH=9.0条件下累积甲烷产量达到最大,为37.60 mL·mL^-1水解液.本实验结果表明, 驯化的稻田土微生物在碱性条件下可以更有效地降解稻秆,提高水解液中TOC及VFAs含量,从而提高厌氧发酵的甲烷产量.     

循环流化床烟气悬浮脱硫技术中试及机理分析

设计了新的循环流化床烟气悬浮脱硫中试装置,其烟气处理量达3500m³/h.首先进行了进料钙硫比(Ca/S)、过饱和温度对装置脱硫效率影响实验,进一步研究了脱硫塔内固体颗粒物循环和烟气流速等因素对脱硫装置性能的影响.对比实验研究表明:在Ca/S=1.2时,固体颗粒物的循环使系统脱硫效率提高15% 左右;脱硫塔内烟气设计流速可以偏高一些.本文同时对系统脱硫过程进行了机理分析,指出了延长脱硫剂有效停留时间的途径.     

The deflectors influence on flow complexity,bed morphology,sediment transport and water quality of urban lotic waters - A laboratory study

In this laboratory study different combinations of bed (sand, pebble gravel [gravel], and a mix of sand and gravel) and flow (typical and overtopping) were experimented with to investigate the impact of porous deflectors in flow diversity, water quality, and fish performance in prismatic open channels. Deflectors changed the gradually varied flow to a rapidly varied flow, as a sudden change in the water depth was observed at the deflectors, and this change was large for smooth beds. With the presence of gravel, the scouring near the downstream deflector was almost twice that of the sand bed, and with the scouring at its own upstream deflector, irrespective of whether the flow was typical or overtopping. This behavior was a result of sand mobilization due to shear stress and sand mobilization aided gravel transport. The mixed bed showed less gravel movement compared to the gravel-only bed. The percentage of sediment washed out was minor for all bed scenarios, indicating that sediment transport was local. Relative to the sand bed without deflectors (representing a typical urban canal), deflectors resulted in reduced and improved water quality (in terms of sediment load) for sand, and mixed bed, respectively. The fishes found refuge and were comfortable in the pool areas created by deflectors unlike in channels without deflectors where they showed exhaustion.     

Collecting representative dust samples: A comparison of various sampling methods in underground coal mines

Former methods used in the U.S. to assess hazardous and explosible coal dust date back to the 1950s. As mining technologies advanced, so too have the hazards. Given the results of the recent coal dust particle size survey and full-scale experimental mine explosion tests, the National Institute for Occupational Safety and Health (NIOSH) recommended a new minimum standard, in the absence of background methane, of 80% total incombustible content (TIC) be required in the intake airways of bituminous coal mines, replacing the previous 65% TIC requirement. Most important to monitoring and maintaining the 80% TIC is the ability to effectively collect and analyze representative dust samples that would likely disperse and participate in dust explosion propagation. Research has shown that dust suspended on elevated surfaces is usually finer, more reactive, and more readily dispersible while floor deposits of dust are generally coarser and more difficult to disperse given the same blast of air. The roof, rib, and floor portions of the dust samples were collected and analyzed for incombustible content separately and the results were compared to a band sample of the roof, rib, and floor components. Results indicate that the roof and rib dust samples should be kept separate from floor dust samples and considered individually for analyses. The various experimental collection methods are detailed along with preferred sampling approaches that improve the detectability of potentially hazardous accumulations of explosible dust.     

The use of nanovermiculite catalyst in the study of removal of the organic load and degradation of atrazine via ozone process in RPB reactor

Abstract

The main objective of this study is the degradation of a synthetic solution of atrazine by a modified vermiculite catalyzed ozonation, in a rotating packed bed (RPB) reactor. A 0.5?L RPB reactor was used to perform the experiments, using a Central Composite Design (CCD) response surface to construct the quadratic model based on the factors: pH, catalyst concentration and reactor rotation frequency. The response variable was the removal of the organic load measured in terms of Chemical Oxygen Demand (COD). After the complete quadratic model was constructed through the response surface, the COD degradation process had an optimal removal of 41% under the following conditions: pH 8.0, rotation of 1150?rpm and catalyst concentration 0.66?g L^?1.     

Sources of underground CO: Crushing and ambient temperature oxidation of coal

As a harmful gas in underground coal mine, CO seriously threatened the safety of miners. Currently, the spontaneous combustion of residual coal in goaf is generally considered as the main source of underground CO. CO gas is also widely used as an indicator gas in fire prediction in mines. However, high concentrations of CO are also detected in some mines without spontaneous combustion of coal. Therefore, in the paper, with four ranks of coal, we studied other two potential CO sources: crushing and oxidation at ambient temperature. The more completely crushed coal produces more CO. The concentration of generated CO is inversely proportional to moisture content in coal. Therefore, the addition of water can inhibit the generation process of CO during the crushing process of coal. Lignite with low metamorphic grade can be oxidized to produce CO at ambient temperature (25 °C), and anthracite with high coal rank can be only oxidized to produce CO at 60 °C. Infrared spectra indicated that the coal with rich aliphatic hydrocarbons and oxygen-containing functional groups are more susceptible to oxidation at room temperature. Moreover, the smaller particle size of coal is more beneficial to the oxidation at ambient temperature to generate CO. CO generation during coal oxidation is also closely related to the ventilation rate.     

以氢气为主要成分的其他可燃气体对低浓度甲烷爆炸特性的影响

为研究矿井火区中一氧化碳(CO)、氢气(H_2)、乙烯(C_2H_4)和乙烷(C_2H_6)等其他可燃气体对甲烷(CH_4)爆炸特性的影响,利用可视球形气体爆炸系统开展了多元可燃气体爆炸压力特性试验,观察并分析了峰值爆炸压力、最大爆炸压力上升速率及其相应时间。通过高速摄影系统拍摄了视窗范围内爆炸火焰传播图像,基于边缘检测方法确定了火焰前锋位置,继而得到最大火焰传播速度。分析了以氢气为主要成分的其他可燃气体对低浓度CH_4-空气混合物压力特性和火焰传播行为的影响。结果表明,多元可燃气体的存在增加了低浓度CH_4-空气混合物的爆炸危险性。随混合气体体积分数增加,低浓度CH_4-空气混合物的峰值爆炸压力、最大爆炸压力上升速率和最大火焰传播速度非线性增加;此外,到达峰值爆炸压力、最大爆炸压力上升速率的时间显著缩短。     

表面活性剂在甲烷氧化菌降解煤体甲烷中的适用性研究

甲烷氧化菌液在进入煤储层后会产生较高的毛管压力,且随着甲烷氧化菌降解煤层瓦斯的进行,毛管压力逐渐增大,容易引起水锁伤害。采取向甲烷氧化菌菌液加入复配表面活性剂以期减缓菌液造成的水锁伤害,通过测试所选表面活性剂十二烷基苯磺酸钠（SDBS）与椰子油脂肪酸二乙醇酰胺（CDEA）对菌液表面张力的降低程度来了解表面活性剂与菌液的配伍比例,并对含复配表面活性剂的甲烷氧化菌对煤层甲烷的降解进行研究。研究结果表明:表面活性剂与菌液最佳配伍比例为SDBS∶CDEA为1∶4,最佳配伍浓度为0.5％,且表面活性剂在菌液中稳定性较好;菌液中添加复配表活剂20 mL,在混合气体压力为2 MPa、氧浓度为 1％、温度为 30 ℃时,添加复配表面活剂菌液的甲烷最终降解率为51.65％,比未添加复配表面活剂菌液高出11％左右。因此,向甲烷氧化菌菌液中添加复配表面活性剂具有很好的适用性。     

水稻田的甲烷释放特性及其生物学机理

本文报导采用土柱法和田间原位法研究渍水稻田甲烷释放特性的结果。不同生育期的测定表明,早稻以分蘖盛期时释放量最大,以后逐渐减少,晚稻从分蘖始期起逐渐增加,至分蘖盛期、末期时达到最大,随后在孕穗期急剧减少,至生长后期又有所回升。以原位法测定表明,晚间和上午释放的甲烷量较多,中午几乎无甲烷释放,下午又有少量释放。不同施肥区稻田甲烷释放量明显不同,以施猪粪有机肥区为最高,次为施尿素无机氮区,不施肥区最低。但各施肥区水稻不同生育期的甲烷释放趋势完全一致,以分蘖期释放量最大,稻田释放的甲烷主要是稻植株释放的,可占总释放量的85％以上。行株间土壤释放的量不多。田间水释放极少,就植株而言,甲烷释放部位主要是在与土壤密切结合的未扰动的根基和根系部位,水面下茎秆白色部分和水上绿色部分几乎无释放。根系也主要是靠近根基的上半部分,根尖部位甲烷形成活性明显小得多。且研究表明,产甲烷细菌附存于根表而不进入根内组织。根际土壤中产甲烷细菌、厌氧性纤维素分解细菌和甲烷氧化细菌的数量以及总挥发有机酸含量都明显高于和行间土壤。