呼和浩特市可镇污水处理厂工程设计

呼和浩特市可镇污水处理厂近期建设规模1.0×104m3/d,远期总规模2.5×104m3/d。污水处理主体工艺采用组合式A2/O生化池+砂滤,污泥处理采用污泥贮池+带式浓缩脱水一体机,尾水采用液氯消毒,设计出水水质执行GB 18918—2002《城镇污水处理厂污染物排放标准》一级A排放标准。介绍了该工程的工艺流程、设计参数,总结分析了工艺设计的技术特点。同时阐述了针对低温条件下的运行保障措施和要求,为寒冷地区同类污水处理厂的设计提供参考和借鉴。     

乙醇处理对树脂基纳米水合氧化铁结构及其除砷性能的影响

通过考察乙醇处理对树脂基纳米水合氧化铁(D201-HFO)结构及其除砷性能的影响,评价乙醇处理在复合材料制备中的必要性.结果表明,乙醇处理后负载水合氧化铁(HFO)在D201树脂内的分散性增加,材料对砷的饱和吸附量提高约20%,且复合材料的比表面积、孔容、孔径分别增加了52%、65%、28%;但乙醇处理对复合材料的机械强度和负载HFO的晶型无影响,在pH值、离子竞争对该材料除砷性能的影响趋势方面也无明显作用,对复合材料固定床除砷性能及再生方面也无明显作用.总体而言,乙醇处理对D201-HFO复合材料实际除砷性能影响不大,从技术经济性考虑可以省略.     

含铬废水的处理技术及机理简述

介绍了废水中六价铬的来源及存在形态,以及处理含铬废水的物理、物化、化学及生物等各种工艺,并对各种工艺的机理和优缺点进行分析,展望含铬废水的治理前景。     

Biodegradation by bioaugmentation of dairy wastewater by fungal consortium on a bioreactor lab-scale and on a pilot-scale

A fungal consortium including Aspergillus niger, Mucor hiemalis and Galactomyces geotrichum was tested for the treatment of dairy wastewater. The bio-augmentation method was tested at lab-scale (4 L), at pilot scale (110 L) and at an industrial scale in Wastewater Treatment Plants (WWTP). The positive impact of fungal addition was confirmed when fungi was beforehand accelerated by pre-culture on whey (5 g/L lactose) or on the dairy effluent. Indeed, chemical oxygen demand (COD) removal yields increased from 55% to 75% for model medium, diluted milk. While after inoculation of an industrial biological tank from a dairy factory with the fungal consortium accelerated by pre-cultivation in a 1000 L pilot plant, the outlet COD values decreased from values above the standard one (100 mg/L) to values in the range of 50-70 mg/L. In addition, there was a clear impact of fungal addition on the ’hard’ or non-biodegradable COD owing to the significant reduction of the increase of the COD on BOD 5 ratio between the inlet and the outlet of the biological tank of WWTP. It was in the range of 451%-1111% before adding fungal consortium, and in the range of 257%-153% after bio-augmentation with fungi. An inoculated bioreactor with fungal consortium was developed at lab-scale and demonstrated successfully at pilot scale in WWTP.     

Iron and lead ion adsorption by microbial flocculants in synthetic wastewater and their related carbonate formation

Although microbial treatments of heavy metal ions in wastewater have been studied, the removal of these metals through incorporation into carbonate minerals has rarely been reported. To investigate the removal of Fe^3＋ and Pb^2＋, two representative metals in wastewater, through the precipitation of carbonate minerals by a microbial flocculant （MBF） produced by Bacillus mucilaginosus. MBF was added to synthetic wastewater containing different Fe^3＋ and Pb^2＋ concentrations, and the extent of flocculation was analyzed. CO2 was bubbled into the mixture of MBF and Fe^3＋/Pb^2＋ to initiate the reaction. The solid substrates were analyzed via X-ray diffraction, transmission electron microscopy and energy dispersive spectroscopy. The results showed that the removal efficiency decreased and the MBF adsorption capacity for metals increased with increasing heavy metal concentration. In the system containing MBF, metals （Fe^3＋ and Pb^2＋）, and CO2, the concentrated metals adsorbed onto the MBF combined with the dissolved CO2, resulting in oversaturation of metal carbonate minerals to form iron carbonate and lead carbonates. These results may be used in designing a method in which microbes can be utilized to combine CO2 with wastewater heavy metals to form carbonates, with the aim of mitigating environmental problems.     

Waste oyster shell as a kind of active filler to treat the combined wastewater at an estuary

Estuaries have been described as one of the most difficult environments on Earth. It is difficult to know how to treat the combined wastewater in tidal rivers at the estuary, where the situation is very different from ordinary fresh water rivers. Waste oyster shell was used as the active filler in this study in a bio-contact oxidation tank to treat the combined wastewater at the Fengtang Tidal River. With a middle-experimental scale of 360 ma/day, the average removal efficiency of COD, BOD, NH3-N, TP and TSS was 80.05%, 85.02%, 86.59%, 50.58% and 85.32%, respectively, in this bio-contact oxidation process. The living microbes in the biofilms on the waste oyster shell in this bio-contact oxidation tank, which were mainly composed of zoogloea, protozoa and micro-metazoa species, revealed that waste oyster shell as the filler was suitable material for combined wastewater degradation. This treatment method using waste oyster shell as active filler was then applied in a mangrove demonstration area for water quality improvement near the experiment area, with a treatment volume of 5 × 10^3 m^3/day. Another project was also successfully applied in a constructed wetland, with a wastewater treatment volume of 1 ×10^3 m^3/day. This technology is therefore feasible and can easily be applied on a larger scale,     

呼和浩特地区污水厂能耗评价与碳排放分析

污水处理过程的能耗和温室气体排放方面的研究对于应对能源危机和气候危机具有重要作用。文章利用层次分析法,建立了具有4层15项指标的能耗评价体系。结合城镇污水处理系统的绿色指标体系,选取呼和浩特地区具有代表性、处理规模相近的2座中小型污水厂进行能耗评价。结果表明:处理能力利用率、处理工艺系统稳定性和污水厂高程布置所对应的3项评价指标在所选择的能耗影响因素中所占权重较大,分别为:0.143 0,0.302 4和0.145 6。进一步运用IPCC计算方法对污水处理厂进行碳排放概算,得出A、B污水处理厂的碳排放量分别为:19.401 t CO2/104t、18.378 t CO2/104t。A、B污水处理厂的实际比能耗分别为0.293 kW.h/m3、0.195 kW.h/m3。将碳排放数据与实际能耗情况对比得出:污水处理厂的能耗水平越高,单位碳排放量也越大。     

基于生命周期评价的城市固体废弃物处理模式研究进展

通过回顾2003-2010年国内外不同城市固体废弃物管理体系生命周期评价结果,列举比较了不同固体废弃物处理模式下的全球变暖潜力、酸化潜力和净能源效用等影响评价因子的大小,得出城市固体废弃物处理模式环境影响等级:填埋的环境影响潜值最大,焚烧的环境影响潜值小于填埋,而结合堆肥后环境影响潜值降低;此外,将固体废弃物资源化引入到处理模式后,特别是垃圾源头分类回收后,环境影响潜值大大降低。结合我国城市固体废弃物处理现状,提出单一的处理模式应转变为综合处理模式,多种生活垃圾处理方式适当的有机结合,因地制宜地开展固体废弃物资源化管理,以及餐厨垃圾源头分类收集处理等建议,为政府能有效利用城市固体废弃物处理设施的能力提供参考。     

低温条件下污水处理运行研究

低温是造成寒冷地区冬季生活污水生化处理效果差的主要原因。当温度降低至4cC左右时,活性污泥中大多数微生物的生长活性受到抑制,只有少数的耐冷微生物可以存活下来并保持一定的活性。本课题组以往的研究结果证明：在我国北方地区,完全可以分离到在低温下高效降解污水中有机物的耐冷细菌。通过投加耐冷茵可使污水的去除效率大大提高。但由于投加的耐冷茵的流失等原因,必须隔一定时间再次投菌,既费时费力,又增加投资。     

我国城市垃圾处理现状及问题分析

随着人口的增长和人们生活城市生活垃圾产量的增长,成分日趋复杂,危害也日益显露和突出,这种危害不是单方面的因素,而是全方面的因素所引起的,如生活水平质量的提高,消费观的改变,人们总体环保意识的欠缺等等,本文通过分析我国城市垃圾处理现状,提出一些切实可行的方法,一起规范和提高我国垃圾处理水平。