连续流动氢化物发生原子荧光法测定水中硒

文章介绍连续流动一氢化物发生一原子荧光测定水中硒的方法,研究了盐酸浓度、硼氢化钾浓度、灯电流、光电倍增管负高压、泵速、载气和屏蔽气流量等对测定硒的影响,找出测定水中硒最佳条件,在最佳条件下,校准曲线相关系数为0.9999.方法检出限为0.0095μg/L,方法的测量范围为0.038-300μg/L,回收率在91.8%-...     

微波酸活化粉煤灰吸附酸性大红染料废水实验研究

以微波酸活化改性后的粉煤灰为吸附剂,对酸性大红染料废水进行吸附脱色处理,考察了吸附时间、pH值、吸附剂投加量等对吸附脱色效果的影响。在酸性大红染料溶液初始浓度为100 mg/L、pH=5、活化粉煤灰投加量为10 g/L吸附1 h时,活化粉煤灰对酸性大红的脱色效果较好,去除率可达96%。对实验数据进行相关数学模型拟合,结果表明微波酸活化改性后的粉煤灰吸附去除酸性大红的等温吸附平衡符合Langmuir吸附等温式,改性前后的吸附过程动力学符合准二级吸附动力学模型,线性相关系数良好。     

火焰原子吸收法测定水中的总铬

用火焰原子吸收光谱法测定水中总铬,乙炔流量100L/h、燃烧头高度为9mm、狭缝宽度0.2 nm时,灵敏度和重现性最好.1 mg/L铬溶液中盐酸含量5％、氯化铵含量0.5％时,吸光度较高,相对标准偏差最低.该方法操作简便,灵敏度好,精确度和准确度高,便于推广,适合水中总铬的测定.     

火焰原子吸收光谱法测定电镀废水中高浓度的锡

采用盐酸消解样品,用火焰原子吸收光谱法测定电镀废水中高浓度的锡的质量浓度,方法简单可靠。通过实验样品的分析,验证了方法的准确度和精密度。该方法干扰少,数据准确,适合废水分析。     

富营养化水体中黑水团的吸收及反射特性分析

对黑水团水体光学特性进行研究,是利用遥感技术监测和评估黑水团事件的前提.针对2015年7月在太湖发生的黑水团现象,采集了太湖黑水团区(区域一)、蓝藻水华区(区域二)、清水区(区域三)共36个水样,对这3个区域的水体遥感反射率以及吸收特性进行对比分析.结果表明:1区域一水体的总颗粒物、色素颗粒物和非色素颗粒物吸收系数比区域二、区域三高出1~2倍,在400~500 nm之间,区域一CDOM吸收系数相比另外两个区域的水体高出2倍左右.导致黑水团区域水体具有很低的遥感反射率,被人眼感知时呈现为黑色;2黑水团区域水体M值低于滇池、巢湖和太湖的M值变化范围,说明黑水团中CDOM的腐殖酸含量较高.此外,叶绿素a浓度与CDOM在350 nm处吸收系数之间具有很好的相关性,表明蓝藻的降解可能是黑水团中CDOM的一个主要来源;3在380 nm之后,黑水团区域的水体总吸收以色素颗粒物占主导,但在短波350~380 nm处,CDOM对总吸收的贡献率高于色素颗粒物和非色素颗粒物.     

微波消解-火焰原子吸收分光光度法测定固体废物中的钡

采用微波消解法对固体废物浸出液样品进行前处理,采用乙炔-空气火焰原子吸收法测定钡的含量,检出限为2．04mg／L,加标回收率为94．5％,精密度为4．85％-6．81％。     

低温柴油吸收工艺在高温油品储罐罐顶废气净化中的应用

采用罐区减排措施和低温馏分油吸收-脱硫工艺处理高温油品罐罐顶废气,在处理气量43.0~384.5 m3/h,柴油流量10~20 m3/h,吸收柴油温度10~15℃条件下,废气经过净化后,硫化氢和有机硫化物去除率大于97.2%,净化气体非甲烷总烃浓度小于8.35 g/m3,均低于GB20950-2007《储油库大气污染物排放标准》和GB 16297-1996《大气污染物综合排放标准》中相关污染物的限值。     

微波消解—火焰原子吸收分光光度法测定土壤中的钴、钼

土壤样品的传统消解方法是用电热板硝酸-氢氟酸-高氯酸体系,消解时间长,试剂用量大,对操作人员身体危害大,并且测定结果也不准确。本文阐述了微波消解——原子吸收分光光度法测定土壤中的钴、钼。通过硝酸-盐酸-氢氟酸-高氯酸消解体系,选择出微波消解的最佳消解条件,通过对微波消解体系和传统消解体系进行对比试验,微波消解体系具有赶酸时间短,准确度高,对人体危害小,是一种值得推广的土壤消解方法。     

Experimental research of LNG accidental underwater release and combustion behavior

Evaluating potential hazards caused by accidental LNG release from underwater pipelines or vessels is a significant consideration in marine transportation safety. The aim of this study was to capture the dynamic behavior of LNG jet released under water and to analyze its vapor dispersion characteristics and combustion characteristics on the water surface during different release scenarios. Controlled experiments were conducted where LNG was jet released from a cryogenic storage tank. The dynamic process of LNG being jet released from orifices of different sizes and shapes, as well as the rising plume structure, were captured by a high-speed camera. The leakage flow rate and pipeline pressure were recorded by a flow meter and pressure gauge, respectively. The concentration distribution that emanated from the water surface was measured utilizing methane sensors in different positions with various wind speeds. The flame combustion characteristics of LNG vapor clouds, which immediately ignited upon the enclosed water tank, were also recorded. Additionally, the mass burning rate of the flame on the water surface was evaluated, and a new correlation between the ratio of flame length and width was established. The results indicated a large dimensionless heat release rate (Q*) and a continuous release flow rate in a limited burning area. This study could provide greater understanding of the mechanisms of LNG release and combustion behavior under water.     

Study of the influence of melamine polyphosphate and aluminum hydroxide on the flame propagation and explosion overpressure of aluminum magnesium alloy dust

When aluminum magnesium alloy dust floats in the air, a certain ignition energy can easily cause an accidental explosion. To prevent and control the occurrence of accidental explosions and reduce the severity of accidents, it is necessary to carry out research on the explosion suppression of aluminum magnesium alloy dust. This paper uses a vertical glass tube experimental device and a 20 L spherical explosive experimental device to carry out experimental studies on the suppression of the flame propagation and explosion overpressure of aluminum magnesium alloy dust with melamine polyphosphate (MPP) and Al(OH)₃. With increasing MPP and Al(OH)₃ concentrations, the flame brightness darkened, the flame velocity and propagation distance gradually decreased, and P_max and (dp/dt)_max decreased significantly. When the amount of MPP added reached 60%, the flame propagation distance decreased to 188 mm, which is a decrease of 68%, and the explosion overpressure decreased to 0.014 MPa, effectively suppressing the explosion of aluminum magnesium alloy dust. The experimental results showed that MPP was more effective than Al(OH)₃ in inhibiting the flame propagation and explosion overpressure of the aluminum magnesium alloy dust. Finally, the inhibitory mechanisms of the MPP and Al(OH)₃ were further investigated. The MPP and Al(OH)₃ endothermic decomposition produced an inert gas, diluted the oxygen concentration and trapped active radicals to terminate the combustion chain reaction.