京西门头沟区自然植被滞尘能力及效益研究

利用2006年夏季实地测量的植物叶片滞尘数值,得出常绿乔木、落叶阔叶乔木、灌木以及草地4种不同植物类型的平均滞尘能力,再将其与用遥感方法估算出的叶面积指数以及植被统计数据相结合,评估了门头沟区自然植被总体的滞尘能力、滞尘量与滞尘效益.结果表明: 自然植被具有明显的滞尘功能,门头沟区自然植被的年滞尘量为39.47×104 t,由此带来的滞尘效益价值为67.10×106元;灌木林和落叶阔叶林2种植被类型,是研究区自然植被滞尘能力和年滞尘量的主要组成部分;常绿乔木的滞尘时间长于其他任何植物种类,其年滞尘量与滞尘能力所占比例有所增加.      

生物滴滤塔处理正丁醇废气的研究

实验分别采用清水吸收法和生物滴滤法处理模拟正丁醇废气,结果表明,在实验工况条件下,清水吸收的净化效率随进口浓度的增加而增加,净化效率可达99%,最佳液气比为2.1L/m3;生物滴滤塔的净化效率随着进气流量、液体流量和进气浓度的增加而降低,当进气流量<1.0m3/h时,其对降解效率的影响较小。     

米糠生物质解毒含铬(Ⅵ)水溶液的研究

农林生物质是一种成本低、环境友好的重金属废水处理材料,也是受重金属污染环境的修复材料之一.实验讨论了初始pH值、米糠用量、吸附时间对含铬(Ⅵ)水溶液解毒的影响.结果表明,米糠对Cr(Ⅵ)存在吸附作用,同时也有解毒还原能力.100 mL浓度为100 mg/L的含铬溶液,在初始pH为2、米糠用量为3 g、吸附-反应平衡时间7 h的条件下,生物质吸附去除溶液中的铬为14.4%,而原溶液中Cr(Ⅵ)解毒了57.2%,米糠生物质吸附总铬的能力为0.48 mg Cr/g(生物质).米糠生物质有潜在的吸附铬和修复受铬污染环境的利用价值.     

4-硝基苯胺与人血清白蛋白相互作用的研究

通过荧光和紫外光谱法研究了4-硝基苯胺与人血清白蛋白（HSA）的作用.结果表明,4-硝基苯胺对HSA的内源荧光具有强烈的猝灭作用.猝灭机理为静态猝灭,同时伴随有非辐射能量转移的发生.根据双对数方程计算其结合常数和结合位点数.确定4-硝基苯胺与HSA有一类结合部位.根据热力学参数得出4-硝基苯胺与HSA之间的主要作用力为氢键和疏水作用力.同步荧光的结果表明,作用点位靠近色氨酸,并且使色氨酸的疏水环境增强.     

活性碳纤维在环境保护中的应用

由于活性碳纤维的吸附面积大,可以作为固相微萃取的纤维用于对环境污染物质的分析检测,包括含硫和含氯的一些有机化合物.同时,活性碳纤维具有良好的导电性能,可以作为电极,能有效地去除环境中城市污水、燃料废水和腐植酸的污染.     

液相络合-铁屑还原-酸吸收回收法脱除烟气中的NOx

用"Fe2 螯合剂吸收-铁屑还原-酸吸收"回收法脱除烟气中的NOx,研究了铁屑脱硝过程的影响因素,确定了脱硝过程的合适工艺条件,并对络合脱硝溶液的再生和循环利用进行了研究.结果表明:最佳工艺参数为:络合脱硝溶液中Fe2 EDTA浓度20mmol·l-1,pH值6.0,温度65℃;在此条件下,用两个反应器串联,对O2含量为10.5%的模拟烟气可取得90%以上的脱硝效率.     

UV/TiO2光催化还原Cr(Ⅵ)过程中吸附作用的影响及其消除

研究了水体中Cr(Ⅵ)离子在UV/TiO₂体系中光催化还原过程.结果表明,Cr(Ⅵ)离子UV/TiO₂光催化还原过程符合Langmuir-Hinshelwood动力学规律.不存在有机物时,TiO₂吸附作用是该反应的前提.pH=1.5～2.5时吸附性能较好,而且pH=1.5～10的初始反应速率同pH值有线性关系.在TiO₂表面的竞争吸附能力按PO₄^3->SO₄^2->Cl^->NO₃^-依次减弱.甲酸、甲醛有机物的协同作用可提高Cr(Ⅵ)离子的光催化还原速率和效率,并消除由暗态吸附对反应所起的作用,磷酸根离子极强的竞争吸附能力,使有机物的协同作用减弱.     

Study of the influence of melamine polyphosphate and aluminum hydroxide on the flame propagation and explosion overpressure of aluminum magnesium alloy dust

When aluminum magnesium alloy dust floats in the air, a certain ignition energy can easily cause an accidental explosion. To prevent and control the occurrence of accidental explosions and reduce the severity of accidents, it is necessary to carry out research on the explosion suppression of aluminum magnesium alloy dust. This paper uses a vertical glass tube experimental device and a 20 L spherical explosive experimental device to carry out experimental studies on the suppression of the flame propagation and explosion overpressure of aluminum magnesium alloy dust with melamine polyphosphate (MPP) and Al(OH)₃. With increasing MPP and Al(OH)₃ concentrations, the flame brightness darkened, the flame velocity and propagation distance gradually decreased, and P_max and (dp/dt)_max decreased significantly. When the amount of MPP added reached 60%, the flame propagation distance decreased to 188 mm, which is a decrease of 68%, and the explosion overpressure decreased to 0.014 MPa, effectively suppressing the explosion of aluminum magnesium alloy dust. The experimental results showed that MPP was more effective than Al(OH)₃ in inhibiting the flame propagation and explosion overpressure of the aluminum magnesium alloy dust. Finally, the inhibitory mechanisms of the MPP and Al(OH)₃ were further investigated. The MPP and Al(OH)₃ endothermic decomposition produced an inert gas, diluted the oxygen concentration and trapped active radicals to terminate the combustion chain reaction.     

Numerical study on premixing characteristics and explosion process of starch in a vertical pipe under turbulent flow

Fire and explosion accidents are frequently caused by combustible dust, which has led to increased interest in this area of research. Although scholars have performed some research in this field, they often ignored interesting phenomena in their experiments. In this paper, we established a 2D numerical method to thoroughly investigate the particle motion and distribution before ignition. The optimal time for the corn starch dust cloud to ignite was determined in a semi-closed tube, and the characteristics of the flame propagation and temperature field were investigated after ignition inside and outside the tube. From the simulation, certain unexpected phenomena that occurred in the experiment were explained, and some suggestions were proposed for future experiments. The results from the simulation showed that 60–70 ms was the best time for the dust cloud to ignite. The local high-temperature flame clusters were caused by the agglomeration of high-temperature particles, and there were no flames near the wall of the tube due to particles gathering and attaching to the wall. Vortices formed around the nozzle, where the particle concentration was low and the flame spread slowly. During the explosion venting, particles flew out of the tube before the flame. The venting flame exhibited a “mushroom cloud” shape due to interactions with the vortex, and the flame maintained this shape as it was driven upward by the vortex.     

原子吸收法测定土壤中铅的方法

通过湿法消解土壤样品,利用石墨炉原子吸收分光光度法(GAAS)和火焰原子吸收分光光度法(FAAS)测定不同土壤样品中铅的含量,以验证2种方法的有效性并加以对比。实验结果表明:2种方法均满足土壤中铅含量的测定要求,测定的标准土样含量均在标准值的不确定度范围内,GAAS方法测定结果更接近保证值。二者的相对标准偏差(RSD)值均低于1.5%,FAAS方法的精密度更高,且具有快速简单等优势。