电子束照射法脱硫脱氮技术工艺

在阐明电子束照射法脱硫脱氮技术的机理、流程、特点的基础上 ,探讨了该工艺在应用过程中存在的主要经济、技术问题。     

生物脱硫中细菌的载体培养条件优化与动力学研究

选用氧化亚铁硫杆菌作为烟气脱硫的主要菌种在活性炭载体上进行固定化培养,研究了不同培养条件下氧化亚铁硫杆菌的生长过程,考察了细菌在载体中培养时接种量、载体投加量对细菌生长的动力学过程的影响,同时通过计算机拟合,确定了各个条件下的细菌生长动力学参数．从而确定了培养的优化条件。     

固相萃取-气相色谱/质谱法测定水中多环芳烃

建立了固相萃取-气相色谱／质谱联用测定水中多环芳烃(PAHs)的分析方法．优化了固相萃取条件。结果表明,固相萃取效率高、萃取时间短,采用MS的选择离子检测方式对实际水样中PAHs进行定性定量分析,平均回收率在80．4％～115％之间,相对标准偏差为7．03％～18．5％,方法的检出限在0．010～0．020μg／L之间。通过实际样品中PAHs的分析表明,该法快速,溶剂用量少,能满足痕量分析的要求。     

气相色谱法测定苯系物标准样品

提出了以二硫化碳为稀释剂，用氯苯作内标物，采用程序升温，调节载气流量，在一根色谱柱上使苯系物标准样品中的7个组分得到完全分离。对苯系物标准样品进行多次测定，各组分的测定结果均在标准样品的保证值范围内，相关标准差小于3％，方法的准确度和精密度均较好。     

Optimization of the O3/H2O2 process with response surface methodology for pretreatment of mother liquor of gas field wastewater

• Real ML-GFW with high salinity and high organics was degraded by O₃/H₂O₂ process. • Successful optimization of operation conditions was attained using RSM based on CCD. • Single-factor experiments in advance ensured optimal experimental conditions. • The satisfactory removal efficiency of TOC was achieved in spite of high salinity. • The initial pH plays the most significant role in the degradation of ML-GFW. The present study reports the use of the O₃/H₂O₂ process in the pretreatment of the mother liquor of gas field wastewater (ML-GFW), obtained from the multi-effect distillation treatment of the gas field wastewater. The range of optimal operation conditions was obtained by single-factor experiments. Response surface methodology (RSM) based on the central composite design (CCD) was used for the optimization procedure. A regression model with Total organic carbon (TOC) removal efficiency as the response value was established (R² = 0.9865). The three key factors were arranged according to their significance as: pH>H₂O₂ dosage>ozone flow rate. The model predicted that the best operation conditions could be obtained at a pH of 10.9, an ozone flow rate of 0.8 L/min, and H₂O₂ dosage of 6.2 mL. The dosing ratio of ozone was calculated to be 9.84 mg O₃/mg TOC. The maximum removal efficiency predicted was 75.9%, while the measured value was 72.3%. The relative deviation was found to be in an acceptable range. The ozone utilization and free radical quenching experiments showed that the addition of H₂O₂ promoted the decomposition of ozone to produce hydroxyl radicals (·OH). This also improved the ozone utilization efficiency. Gas chromatography-mass spectrometry (GC-MS) analysis showed that most of the organic matters in ML-GFW were degraded, while some residuals needed further treatment. This study provided the data and the necessary technical supports for further research on the treatment of ML-GFW.     

Evaluation of the technoeconomic feasibility of electrochemical hydrogen peroxide production for decentralized water treatment

• Gas diffusion electrode (GDE) is a suitable setup for practical water treatment. • Electrochemical H₂O₂ production is an economically competitive technology. • High current efficiency of H₂O₂ production was obtained with GDE at 5–400 mA/cm². • GDE maintained high stability for H₂O₂ production for ~1000 h. • Electro-generation of H₂O₂ enhances ibuprofen removal in an E-peroxone process. This study evaluated the feasibility of electrochemical hydrogen peroxide (H₂O₂) production with gas diffusion electrode (GDE) for decentralized water treatment. Carbon black-polytetrafluoroethylene GDEs were prepared and tested in a continuous flow electrochemical cell for H₂O₂ production from oxygen reduction. Results showed that because of the effective oxygen transfer in GDEs, the electrode maintained high apparent current efficiencies (ACEs,>80%) for H₂O₂ production over a wide current density range of 5–400 mA/cm², and H₂O₂ production rates as high as ~202 mg/h/cm² could be obtained. Long-term stability test showed that the GDE maintained high ACEs (>85%) and low energy consumption (<10 kWh/kg H₂O₂) for H₂O₂ production for 42 d (~1000 h). However, the ACEs then decreased to ~70% in the following 4 days because water flooding of GDE pores considerably impeded oxygen transport at the late stage of the trial. Based on an electrode lifetime of 46 days, the overall cost for H₂O₂ production was estimated to be ~0.88 $/kg H₂O₂, including an electricity cost of 0.61 $/kg and an electrode capital cost of 0.27 $/kg. With a 9 cm² GDE and 40 mA/cm² current density, ~2–4 mg/L of H₂O₂ could be produced on site for the electro-peroxone treatment of a 1.2 m³/d groundwater flow, which considerably enhanced ibuprofen abatement compared with ozonation alone (~43%–59% vs. 7%). These findings suggest that electrochemical H₂O₂ production with GDEs holds great promise for the development of compact treatment technologies for decentralized water treatment at a household and community level.     

一起钢质无缝气瓶爆炸事故技术分析

文章简要描述了一起消防气体灭火钢质气瓶爆炸事故,对爆炸气瓶进行了断口分析、金相试验和理化试验,并分析了事故的原因,提醒制造厂家规范制造工艺,对预防类似事故的发生具有一定的参考意义。     

Limiting explosible concentration of hydrogen–oxygen–helium mixtures related to the practical operational case

This paper presents data on the limiting (minimum) concentrations of hydrogen in oxygen, in the presence of added helium, at elevated temperature and pressure related to the practical operational case. A 5 L explosion vessel, an ignition sub-system and a transient pressure measurement sub-system were used. Through a series of experiments carried out using this system, the limiting concentrations of hydrogen in oxygen and helium at different initial pressures and temperatures for the practical operational case were studied, and the influence of ignition energy and initial temperature on the limiting concentration of hydrogen in oxygen and helium was analyzed and discussed. The variation of ignition energy within the studied range is found to have a significant effect on the limiting concentration of hydrogen in oxygen and helium at lower initial temperature. However, when the ignition energy is higher than 32 mJ, the limiting hydrogen concentration remains almost changeless as the initial temperature increases from 21 °C to 90 °C. The limiting explosible concentration of hydrogen–oxygen–helium mixture decreases as the ignition energy increases when the initial temperature is lower. When the initial temperature is higher, the ignition energy has little effect on the limiting hydrogen concentration of hydrogen–oxygen–helium mixtures. When the initial temperature reaches 90 °C, the limiting hydrogen concentration remains almost changeless with an increase in ignition energy. The limiting explosible concentration of hydrogen in the mixtures, at the initial temperature of 21 °C and the ignition energy of 0.5 mJ, is 8.5% and that of oxygen is 11.25%.     

Dynamic behavior of direct spring loaded pressure relief valves in gas service: Model development,measurements and instability mechanisms

A synthesis of previous literature is used to derive a model of an in-service direct-spring pressure relief valve. The model couples low-order rigid body mechanics for the valve to one-dimensional gas dynamics within the pipe. Detailed laboratory experiments are also presented for three different commercially available values, for varying mass flow rates and length of inlet pipe. In each case, violent oscillation is found to occur beyond a critical pipe length, which may be triggered either on valve opening or closing. The test results compare favorably to the simulations using the model. In particular, the model reveals that the mechanism of instability is a Hopf bifurcation (flutter instability) involving the fundamental, quarter-wave pipe mode. Furthermore, the concept of the effective area of the valve as a function of valve lift is shown to be useful in explaining sudden jumps observed in the test data. It is argued that these instabilities are not alleviated by the 3% inlet line loss criterion that has recently been proposed as an industry standard.     

Optimization of HSE in maintenance activities by integration of continuous improvement cycle and fuzzy multivariate approach: A gas refinery

Gas refineries have been continuously focusing on Health, Safety and Environment programs to improve maintenance activities. Several researches have studied on this area with different analysis methods. This study presents an integrated approach for optimization of factors contributing to the implementation of Health, Safety and Environment (HSE) in maintenance activities. HSE managers in each sector answered standard questionnaire whit respect to HES. The methodology is based on fuzzy data envelopment analysis (FDEA) and Deming's continuous improvement cycle. Also, this method is used to rank the relevant performance efficiencies in certain and uncertain conditions of each HSE sectors whit considering HSE in maintenance activities. It corresponds and integrates its registered HSE-MS with OHSAS 18001:2007 and ISO 14001:2004 to evaluate multiple inputs and outputs of over 36 subsidiary HSE divisions with parallel mission and objectives simultaneously. Also, it determines efficient target indices and could assure continuous improvement in the organization. This is the first study that introduces an integrated approach to improve HSE management programs in a gas refinery by a robust and continuous improvement approach.