Explosion behavior of n-alkane/nitrous oxide mixtures

The explosion properties of alkane/nitrous oxide mixtures were investigated and were compared with those of the corresponding alkane/oxygen and alkane/air mixtures. The explosion properties were characterized by three parameters: the explosion limit, explosion pressure, and deflagration index. For the same alkane, the order of the lower explosion limits (LELs) of the mixtures was found to be alkane/oxygen ≈ alkane/air > alkane/nitrous oxide. In addition, the mixtures containing nitrous oxide tended to exhibit higher explosion pressures than the corresponding mixtures containing oxygen under fuel-lean conditions. The Burgess–Wheeler law was also observed to hold for the mixtures containing nitrous oxide.     

The Effects of Gas Flow Rate and the Interval Time of Water Supplement on Ethanol Production of Rice Straw by Simultaneous Saccharification and Fermentation

In the present work, characteristics of ethanol production from a single particle composing of pretreated rice straw, cellulase, and β-glucosidase were invesitgated by simultaneous saccharification and fermentation (SSF). The experiment experienced a start-up stage for S. cerevisiae biofilm formation, which was operated at an initial pH value of 4.8 for yeast solution, culture temperature of 30°C, flow rate of 0.8 mL/min for yeast solution, and stably operating stage for ethanol production at a culture temperature of 30°C. Investigations found that the maximal ethanol yield of 9.7 mg/g and the biofilm thickness of 0.37 mm were obtained at 30 mL/min of carrier gas flow rate. Also, the optimal interval time of water supplement was 4 h for SSF. The results show that the appropriate gas flow rate and the interval time of water supplement can keep the high activities of biofilm and enzymes during SSF and result in a high ethanol yield.     

工业废气中丙烯酸甲酯气相色谱法测定法

建立了用气相色谱法测定工业废气中丙烯酸甲酯的方法。废气中丙烯酸甲酯活性炭吸附,二硫化碳解吸,氢火焰离子化检测器检测,时间定性,峰面积定量。本方法前处理简便,分析灵敏度高,有机试剂使用量少,满足环境分析要求。     

空气和煤气吹脱法处理高氨氮废水的对比研究

研究了在实验室使用空气吹脱法去除高浓度氨氮废水的条件,通过正交实验得出其影响因素大小顺序为:废水pH>气液比r>废水温度tw>表面活性剂浓度c,最佳吹脱条件为pH=11.0,r=550,c=10mg/L,tw=75℃,最高氨氮去除效率达到71.4%。在某焦化厂以终冷塔后焦炉煤气为解吸介质,现场试验影响因素大小顺序为:o废水pH>废水温度tw>气液比r>煤气温度tg>表面活性剂浓度c,最佳吹脱条件为pH=11.5,tw=90℃,r=650,tg=55℃,c=20mg/L。为煤气吹脱解吸回收氨工艺的应用提出了建议。     

The ratio between nitrogen oxides and carbon monoxide total emissions as precursors of tropospheric hydroxyl content evolution

The Main Geophysical Observatory 2D channel photochemical model is used to study the behavior of tropospheric OH within the 30–60°N zonal belt in relation to changing NO_X and CO emissions. The changes of tropospheric OH as a function of the contributions by NO_X and CO emissions during the period 1850–2050 are calculated. Our estimations show that the largest annual increment of total tropospheric OH within the belt considered occurs in the 1985–1995 period, about 0.27% yr⁻¹. Based on scenarios of tropospheric pollution emissions in the first half of 21st century, the total tropospheric OH content will increase more slowly, by 0.12–0.15% yr⁻¹. The maximum growth of OH concentration occurs close to air pollution locations—in the lower troposphere during 1850–1995 but in the upper troposphere in the 21st century when the NO_X source from subsonic aircraft increases faster than the surface source.     

Fugitive Gas Emissions from Fuel Tanks

Many fuel installations and industrial operations often are associated with the release, whether deliberately or inadvertently, of fuel vapors into the surrounding atmosphere. Most of these releases may be considered to be relatively small on a thermal basis, but they do represent collectively a serious source of unburned hydrocarbon emissions into the atmosphere. Moreover, the emissions of methane from various sources of natural gas contribute significantly to green house gas emissions.

The paper presents computed results of the transient dissipation of a fixed mass of methane when released within vertical cylindrical vessels containing air, which are open to the outside atmosphere under ambient conditions. Particular attention is given to the rates of emission of gas into the outside atmosphere and how it is affected by the composition and mass of the fuel released and the size and configuration of the fuel retaining cylindrical tank. The corresponding transient formation, growth and subsidence of flammable zones within such a vessel are also described. Some guidelines for reducing the hazards associated with such releases are presented.     

Fluid Mechanics of Serpentine Flow Fields on a Porous Media

Laminar flows are investigated in single and double parallel serpentine channels mounted on a porous media and it is found that significant convective transport occurs in porous media for practical fuel cell conditions. This transport increases with increasing flow Reynolds number, with decreasing land width, and most significantly with increasing channel length.

Increasing the number of parallel channels significantly decreases the pressure drop across the fuel cell, but also significantly decreases the magnitude of convective transport in the porous media. Increased parasitic loads must be put in the context of the change in electrochemical performance.

This paper presents both data and a methodology for beginning to think about flow field design from a hydrodynamic perspective.     

用固相萃取-HPLC法测定水质中杀菌剂多菌灵的方法研究

用固相萃取法萃取水和废水中的多菌灵,取浓缩纯化后的有机相直接进样到高效液相色谱仪,用二极管矩阵检测器检测,根据保留时间外标法定量.     

Validation of geometry modelling approaches for offshore gas dispersion simulations

Computational Fluid Dynamics (CFD) codes are widely used for gas dispersion studies on offshore installations. The majority of these codes use single-block Cartesian grids with the porosity/distributed-resistance (PDR) approach to model small geometric details. Computational cost of this approach is low since small-scale obstacles are not resolved on the computational mesh. However, there are some uncertainties regarding this approach, especially in terms of grid dependency and turbulence generated from complex objects. An alternative approach, which can be implemented in general-purpose CFD codes, is to use body-fitted grids for medium to large-scale objects whilst combining multiple small-scale obstacles in close proximity and using porous media models to represent blockage effects. This approach is validated in this study, by comparing numerical predictions with large-scale gas dispersion experiments carried out in DNV GL's Spadeadam test site. Gas concentrations and gas cloud volumes obtained from simulations are compared with measurements. These simulations are performed using the commercially available ANSYS CFX, which is a general-purpose CFD code. For comparison, further simulations are performed using CFX where small-scale objects are explicitly resolved. The aim of this work is to evaluate the accuracy and efficiency of these different geometry modelling approaches.     

Influence of active mitigation barriers on LNG dispersion

In recent years, particular interest has been direct to the issues of risk associated with the storage, transport and use of Liquefied Natural Gas (LNG) due to the increasing consideration that it is receiving for energy applications. Consequently, a series of experimental and modeling studies to analyze the behavior of LNG have been carried out to collect an archive of evaporation, dispersion and combustion information, and several mathematical models have been developed to represent LNG dispersion in realistic environments and to design mitigation barriers.This work uses Computational Fluid Dynamics codes to model the dispersion of a dense gas in the atmosphere after accidental release. In particular, it will study the dispersion of LNG due to accidental breakages of a pipeline and it will analyze how it is possible to mitigate the dispersing cloud through walls and curtains of water vapor and air, also providing a criterion for the design of such curtains.