微生物发酵产物中溶藻物质的提取方法

微生物溶藻是藻类水华控制的研究热点,但目前仍缺乏去除微生物发酵产物中营养物质的方法学研究,对野外水体采集的微囊藻的溶藻活性研究也较少见。比较了不同极性溶剂对溶藻物质的固液萃取效率,研究了分子筛层析对溶藻物质的纯化效果,并测定了各提纯步骤的中间产物对野外水体采集的铜绿微囊藻的溶藻效果。结果表明,在溶藻活性基本保持稳定的前提下,固液萃取串联分子筛层析技术对TOC、TN和TP的总去除率平均高达97%,其中,固液萃取的分级去除率平均高达90%,而分子筛层析的分级去除率平均为70%,且分子筛层析后的产物对野外水体采集的铜绿微囊藻的去除率稳定在60%左右。结果说明,固液萃取与分子筛层析技术可以作为溶藻物质工业化提取与实验室纯化的重要方法。     

磺胺类制药废水中苯系物的快速同步检测

磺胺类制药废水是一类难降解有机废水,其中含有苯磺酰胺、苯磺酸、苯酚等苯系物,对这些物质的快速检测十分必要,针对这3种物质建立了基于高效液相色谱的快速同步检测方法。采用C₁₈柱为分离柱,比较了乙腈/水、甲醇/水和甲醇/缓冲盐3种流动相体系的分离效果,优化了230、240、250和260 nm 4种检测波长等条件。结果表明,V_甲醇∶V_{磷酸二氢铵溶液}(0.5%,pH=3.5)=50∶50作为流动相时,基线稳定,峰形较好,3种目标物在11 min内即可实现有效分离,且浓度为5~100 mg·L⁻¹时,3种目标物峰面积与质量浓度的线性关系良好(R²>0.999),检出限为15.0~29.4 μg·L⁻¹,相对偏差为0.05%~1.56%(n=5),该方法能同时检测苯磺酸、苯酚和苯磺酰胺,具有简便、灵敏、准确等优点,可为制药废水的快速检测和磺胺类药物降解机理的分析提供便利。     

Fatty acids composition of Caenorhabditis elegans using accurate mass GCMS-QTOF

The free living nematode Caenorhabditis elegans is a proven model organism for lipid metabolism research. Total lipids of C. elegans were extracted using chloroform and methanol in 2:1 ratio (v/v). Fatty acids composition of the extracted total lipids was converted to their corresponding fatty acids methyl esters (FAMEs) and analyzed by gas chromatography/accurate mass quadrupole time of flight mass spectrometry using both electron ionization and chemical ionization techniques. Twenty-eight fatty acids consisting of 12 to 22 carbon atoms were identified, 65% of them were unsaturated. Fatty acids containing 12 to17 carbons were mostly saturated with stearic acid (18:0) as the major constituent. Several branched-chain fatty acids were identified. Methyl-14-methylhexadecanoate (iso- 17:0) was the major identified branched fatty acid. This is the first report to detect the intact molecular parent ions of the identified fatty acids in C. elegans using chemical ionization compared to electron ionization which produced fragmentations of the FAMEs.     

Risk Assessment of 26 Polycyclic Aromatic Hydrocarbon (PAH) Compounds in Parkıng Garages

The aim of this study was to determine the level of 26 polycyclic aromatic hydrocarbons (PAHs) at parking garages and to provide the necessary annual information based on occupational inhalation exposure and non-occupational inhalation exposure, which carry risks for the environment. For this purpose, 22 samples were collected continuously from both gas and particulates phase PAHs from two parking garages at Konya City Center, Turkey. The exposure-based risk of these samples was evaluated using concentrations of the carcinogenic PAH compounds. None of the 26 PAHs measured had values exceeding the recommended exposure limits (RELs) standard values for inhalation rate recommended by the World Health Organization (WHO). Exposure levels of gas and particulate PAHs for the occupational group and the public (children and adults who spend time in shopping centers) were found to be 0.07–28.24 μgm^?3 and 0.05–5.753 μgm^?3, respectively, representing levels two to four times higher than those at the control site. Maximum daily inhalation of B[a]Py was estimated at 1.33 ngd^?1 for exposure of the public and as 274 ngd^?1 for the occupational group. It is believed that traffic makes a substantial contribution to the PAH profile, which had relatively high concentrations of naphthalene (Napth) and coronene (Coro). Highly carcinogenic dibenzo(a,l)pyrene (B[al]Pyre) was found in the ambient air at two parking garages. Napth and phenanthrene (Phen) were the main compounds found in nearly all the tested samples. In this study, benzo[e]pyrene (B[e]Py) was used as a reference for PAHs because its concentration is stable and does not change seasonally. Considering the importance of these compounds in relation to human health, the aim of this work was to characterize and quantify the more toxic PAHs in parking garages. Conducting PAH sampling and their chemical analysis is very costly and labor intensive. This study produced data that can be a powerful tool for environmental forensics.     

Gas flame acceleration in long ducts

In many practical situations, a flame may propagate along a pipe, accelerate and perhaps transform into a devastating detonation. This phenomenology has been known, more or less qualitatively, for a long time and mitigation techniques were proposed to try and avoid this occurrence (flame arresters, vents,...). A number of parameters need to be known and in particular the “distance to detonation” and more generally the flame acceleration characteristic scales. Very often, the ratio between the detonation run-up distance and the pipe diameter is used without any strong justification other that using a non-dimensional parameter (L/D). In this paper, novel experimental evidence is presented on the basis of relatively large scale experiments using 10 cm and 25 cm inner diameter duct with a length between 7 and 40 m. Homogeneous C₂H₄-air, CH₄-air, C₃H₈-air and H₂-air mixtures were used and different ignition sources. The interpretation suggests that the self-acceleration mechanism of the flame may be much better represented by flame instabilities than by turbulence build-up. One consequence would be that the maximum flame velocity and, following, the maximum explosion overpressure, would be rather linked with the run-up distance than with the L/D ratio.     

Thermodynamic investigation and hydrate inhibition of real gas flow through orifice during depressurization

A thermodynamic procedure has been proposed which can be used to predict the gas pressure, temperature and flow rate through orifice upon chock flow condition, using equation of state (EOS). The procedure applied for emergency depressurization operation incorporating the Peng-Robinson EOS and validated by comparing flow rates of a multi-component hydrocarbon gas mixture for thirteen experimental cases. The average absolute deviations of the predicted flow rates for orifice discharge coefficients of 0.85 and 0.9, are 7.36% and 2.03%, respectively. The corresponding error for API 520 (American Petroleum Institute Recommendation Practice 520) method is 6.91%. In this work, the hydrate formation temperature and hydrate inhibitor type and its required weight fraction for preventing the hydrate formation upon orifice and its upstream conditions are evaluated by the EZ-Thermo software using the Moshfeghian–Maddox method. The results qualitatively show that the hydrate prevention is essential for the safety of the operation due to low temperature condition.     

基于轨迹模型的和田绿洲沙尘移动轨迹及气象特征分析

以塔克拉玛干沙漠南缘的和田绿洲为研究区域,使用HYSPLIT后向轨迹模型和NCEP的GDAS全球气象要素数据,将和田绿洲西北部的墨玉县城作为模拟受点(79.72°E,37.26°N),对2004—2018年墨玉县发生的2 891次沙尘天气进行36 h的后向轨迹模拟,并通过k-means聚类分析法,定量分析沙尘天气期间气流的传输路径及气象特征。结果表明：2004—2018年,研究区沙尘天气的发生频率变化幅度不大,没有明显的增减趋势;年内沙尘天气主要集中在春季和夏季（3—7月）,占全年沙尘天气总数的70.23%,5、6月是强沙尘暴最活跃期。在沙尘天气期间气流的移动高度和轨迹相差较大,按照气流的起源地和到达墨玉县的方向将沙尘暴分为NW-W簇、N-N簇、NE-E簇和E-ES簇4簇轨迹类型,其发生天数占比分别为18.9%、12.3%、60.1%和7.8%。由东向西的沙尘天气发生天数占比最高（60.1%）,但主要以浮尘天气为主;由西北向东南方向的沙尘发生频率不高,但移动速度最快,强沙尘暴和扬沙主要来自西北和西部方向;由北向南的沙尘暴速度最慢（1.36 m/s）,空气湿度最低（26.4%）,但气温最高（292.58 K）。定量印证了墨玉县沙尘暴不同传输路径,可为绿洲区沙尘暴研究提供参考。

     

Evaluation of the technoeconomic feasibility of electrochemical hydrogen peroxide production for decentralized water treatment

• Gas diffusion electrode (GDE) is a suitable setup for practical water treatment. • Electrochemical H₂O₂ production is an economically competitive technology. • High current efficiency of H₂O₂ production was obtained with GDE at 5–400 mA/cm². • GDE maintained high stability for H₂O₂ production for ~1000 h. • Electro-generation of H₂O₂ enhances ibuprofen removal in an E-peroxone process. This study evaluated the feasibility of electrochemical hydrogen peroxide (H₂O₂) production with gas diffusion electrode (GDE) for decentralized water treatment. Carbon black-polytetrafluoroethylene GDEs were prepared and tested in a continuous flow electrochemical cell for H₂O₂ production from oxygen reduction. Results showed that because of the effective oxygen transfer in GDEs, the electrode maintained high apparent current efficiencies (ACEs,>80%) for H₂O₂ production over a wide current density range of 5–400 mA/cm², and H₂O₂ production rates as high as ~202 mg/h/cm² could be obtained. Long-term stability test showed that the GDE maintained high ACEs (>85%) and low energy consumption (<10 kWh/kg H₂O₂) for H₂O₂ production for 42 d (~1000 h). However, the ACEs then decreased to ~70% in the following 4 days because water flooding of GDE pores considerably impeded oxygen transport at the late stage of the trial. Based on an electrode lifetime of 46 days, the overall cost for H₂O₂ production was estimated to be ~0.88 $/kg H₂O₂, including an electricity cost of 0.61 $/kg and an electrode capital cost of 0.27 $/kg. With a 9 cm² GDE and 40 mA/cm² current density, ~2–4 mg/L of H₂O₂ could be produced on site for the electro-peroxone treatment of a 1.2 m³/d groundwater flow, which considerably enhanced ibuprofen abatement compared with ozonation alone (~43%–59% vs. 7%). These findings suggest that electrochemical H₂O₂ production with GDEs holds great promise for the development of compact treatment technologies for decentralized water treatment at a household and community level.     

高效液相色谱法测定水中的六种邻苯二甲酸酯研究

建立了高效液相色谱法测定水中六种邻苯二甲酸酯(邻苯二甲酸二甲酯、邻笨二甲酸二乙酯、邻苯二甲酸二丁酯、邻苯二甲酸二(2-乙基己基)酯、邻苯二甲酸二辛酯、邻苯二甲酸丁基苄酯)的检测方法.对水样中邻苯二甲酸酯的萃取条件和高效液相色谱分析条件进行优化,采用正己烷二次萃取,浓缩定容后分析,以乙腈-水为流动相梯度洗脱,紫外检测波长226 nm,16 min可将六种邻苯二甲酸酯分离出.方法的检出限为0.13μg/L ～0.37 μg/L,加标回收率为78.6％～118.5％,相对标准偏差为0.82％～2.17％,是一种理想的测定水中六种邻苯二甲酸酯的方法.     

离子色谱法测定大气中的甲磺酸

建立了以玻璃纤维膜-KB120气溶胶采样器采集大气中甲磺酸的采样方法;以0.1mmol·l-1H3BO3/0.1mmol·l-1 Na2B4O7为淋洗液的甲磺酸离子色谱分析方法.分析方法的精密度和准确度分别为5%和4%.并实测了青岛冬季大气气溶胶中MSA,SO2-4和NO-3的平均浓度分别为0.10μg·m-3,30.40μg·m -3和17.98μg·m-3.