Flash point of biodiesel/glycerol/alcohol mixtures for safe processing and storage

Mixtures of biodiesel, glycerol, and ethanol/methanol are commonly processed and stored in biodiesel production. In this work, non-ideal models are used to calculate the Flash Points (FPs) of binary and ternary mixtures, using data available from different feedstocks. Despite the fact that biodiesel is considered safer than common diesel fuels, results show a synergistic effect of biodiesel/methanol and biodiesel/ethanol mixtures, resulting in a reduction of the flash point of mixtures to values lower than the ones of pure compounds. Most soluble ternary mixtures were found flammable, the only exception being mixtures with a relatively lower alcohol content (45% mol. ethanol or 42% methanol) at temperature lower than 303 K. Accidental increase in temperature can cause domino effect, due to the higher solubility and the formation of new flammable ternary mixtures.     

超高效液相色谱-串联质谱法同时分析地下水中24种内分泌干扰物

建立了基于超高效液相色谱-串联质谱法同时测定地下水中9种雌激素、5种雄激素、3种肾上腺皮质激素、4种酚类和3种非甾类激素共24种内分泌干扰物的方法。在活化后的MCX固相萃取柱中加入水样,再加入pH=5的水溶液淋洗,随后用碱化乙腈(4.5%,体积分数)洗脱。收集洗脱液并用氮气吹至近干后,用甲醇定容。采用Poroshell 120 Bonus-RP色谱柱(2.7 μm,100 mm×2.1 mm),以0.1%氨水溶液-乙腈为流动相进行梯度洗脱,实现液相分离。质谱检测采用MRM模式进行采集,通过正负离子模式切换同时进行测定,使用内标法定量。检测结果显示,目标物在线性范围内,决定系数R²均大于0.995,方法检出限为0.05~2.00 ng/L,加标回收率为68.8%~108%。该方法灵敏度高、准确度好,具有较强的实用价值。     

气相色谱法测定室内空气中挥发性卤代烃

建立了活性炭吸附-溶剂解吸-气相色谱测定室内空气中7种挥发性卤代烃的分析方法。样品经活性炭采样管富集后,用二硫化碳解吸,Agilent HP-1色谱柱分离,使用带有电子捕获检测器的气相色谱仪测定,以保留时间定性,外标法定量。当采样体积为10 L时,方法检出限范围是0.03~0.18 g/m3,加标回收率在72%~114%之间,相对标准偏差小于15%。结果表明,该方法可以应用于室内空气中痕量挥发性卤代烃样品的检测分析。     

顶空气相色谱法测定水中甲醛、乙醛和丙烯醛

建立了顶空气相色谱法同时测定水中甲醛、乙醛、丙烯醛的方法。目标化合物连续测定9次的相对标准偏差分别为0.01,1.89,3.54;检出限分别为0.03μg/L,5.68μg/L,10.3μg/L,实际水样加标回收率在98%~101%。方法简便,快速,灵敏度高,基体干扰小。适用于地表水、地下水和工业废水中甲醛、乙醛、丙烯醛的同时、快速测定。     

应急修复耦合资源回收的实践-以一起化工企业突发环境事件为例

通过东莞市一起铜氨蚀刻液泄漏引致突发环境事件的应急处理过程,介绍了污染控制和应急修复技术的应用情况,通过将高浓含氨污水蒸发制取NH4Cl产品,以及将污水处理至优于《地表水环境质量标准》（GB3838-2002）之Ⅰ类水质要求,作为我国首例应急修复耦合资源回收制取化工产品的成功案例,为化工类企业突发环境事件的应急处理提供决策参考.     

捕集阱顶空-气相色谱/质谱法检测地表水中25种挥发性有机物

建立了捕集阱顶空-气相色谱/质谱法检测地表水中25种挥发性有机物的分析方法。采用正交实验设计对捕集阱顶空条件进行了优化,该方法相关系数0.995,加标回收率为90%~110%,方法检出限为0.08~0.39μg/L,相对标准偏差(n=7)为0.7%~4.8%,仪器检出限低于0.04μg/L。方法准确度和灵敏度较好,可以满足对地表水中25种挥发性有机物的检测要求。     

Molecularly imprinted polymer for analysis of trace atrazine herbicide in water

A molecularly imprinted polymer (MIP) for atrazine was synthesized by non-covalent method. The binding capacity of MIP was 1.00 mg g^{? 1} polymer. The selectivity and recovery were investigated with various pesticides which are mostly, found in the environment, for both similar and different chemical structure of atrazine. The competitive recognition between atrazine and structurally similar compounds was evaluated and it was found that the system provided highest recovery and selectivity for atrazine while low recovery and selectivity were obtained for the other compounds. The highest recovery was obtained from MIP compared with non-imprinted polymer (NIP), a commercial C₁₈ and a granular activated carbon (GAC) sorbent. The method provided high recoveries ranged from 94 to 99% at two spiked levels with relative standard deviations less than 2%. The lower detection limit of the method was 80 ng L^{? 1}. This method was successfully applied for analysis of environmental water samples.     

Flame Propagation Across Gelled Alkane-In-Water Emulsions

Flame propagation rates were measured for flames spreading across surfaces of gel-like alkane-in-water emulsions. A long, slender, water-cooled trough was used to contain the mixtures. Abrupt changes in the flame propagation velocities - of nearly two orders of magnitude - were observed to occur near ‘critical’ concentrations of certain alkane/water mixtures. Four alkanes were used - pentane, hexane, heptane, and octane - and fuel rich emulsions (in which water was the continuous phase) were employed. The ability of the aqueous phase of the emulsion to inhibit the release of fuel into the vapor phase plays an important role in the observed behavior. That is, the rate at which fuel can diffuse through both the emulsion and the thin liquid layers that reside on it, is an essential kinetic aspect of the phenomena which determine the flame propagation rate across gelled alkane-in-water emulsions.     

实时合成水滑石分离模拟放射性核素锶的研究

采用实时合成水滑石的方法从高放废液中分离模拟放射性核素锶,通过单因素实验并借助XRD分析确定了最佳分离实验条件,同时,运用FTIR、SEM等技术手段对合成的含锶水滑石的结构、形貌进行了分析.结果表明,当Sr2+初始浓度为70mg.L-1、pH值为10.5、n(Mg+Sr)/n(Al)为3时,锶的去除率最高可达95%以上;XRD和SEM分析结果表明,锶嵌入了水滑石的晶格中,合成的含锶水滑石形貌为层状六边形;含锶水滑石煅烧产物主要为尖晶石,且煅烧产物中未见氧化锶,表明嵌入到水滑石晶格中的锶在煅烧后存在于尖晶石的晶体结构中.     

聚合物/表面活性剂二元体系对油水界面性质的影响

文章应用界面张力仪、Zeta电位仪和表面黏弹性仪测定了聚合物、表面活性剂及其二元复合体系的质量浓度对油水界面性质的影响,并应用透射电镜观察了采出液的液膜结构。结果表明,随着聚合物质量浓度的增加,油水界面的界面剪切黏度值和界面张力值增大,颗粒表面Zeta电位的绝对值增大;随着表面活性剂质量浓度的增加,油水界面的界面剪切黏度变化幅度很小,但界面张力显著减小,颗粒表面Zeta电位绝对值增大;聚合物与表面活性剂复合能够形成稳定的聚合体,具有较大的界面剪切黏度值,较小的界面张力和较高的Zeta电位值;体系中聚合物、表面活性剂及水中悬浮物形成了类似"晶体"结构。