On-line production of ferrate with an electrochemical method and its potential application for wastewater treatment – A review

A number of studies on the oxidation of various organic/inorganic contaminants by ferrate(VI) were reported in the 1980s and 1990s. The exploration of the use of ferrate(VI) for water and wastewater treatment has been well addressed recently. However, challenges have existed for the implementation of ferrate(VI) technology in practice due to the instability of a ferrate solution or high production cost of solid ferrate products. The research has been carried out aiming at the generation and application of ferrate(VI) in situ. This paper thus reviews ferrate chemistry and its overall performance as a water treatment chemical, discusses the factors affecting the ferrate yield efficiency using the electrochemical method, and finally, summarises the work on the production and use of ferrate in situ which is currently under study.     

Microwave enhanced advanced oxidation process for treating dairy manure at low pH

This study investigated the treatment of dairy manure using the microwave enhanced advanced oxidation process (MW-AOP) at pH 2. An experimental design was developed based on a statistical program using response surface methodology to explore the effects of temperature, hydrogen peroxide dosage and heating time on sugar production, nutrient release and solids destruction. Temperature, hydrogen peroxide dosage and acid concentration were key factors affecting reducing sugar production. The highest reducing sugar yield of 7.4% was obtained at 160°C, 0 mL, 15 min heating time, and no H₂O₂ addition. Temperature was a dominant factor for an increase of soluble chemical oxygen demand (SCOD) in the treated dairy manure. The important factors for volatile fatty acids (VFA) production were microwave temperature and hydrogen peroxide dosage. Temperature was the most important parameter, and heating time, to a lesser extent affecting orthophosphate release. Heating time, hydrogen peroxide dosage and temperature were significant factors for ammonia release. There was a maximum of 96% and 196% increase in orthophosphate and ammonia concentration, respectively at 160°C, 0.5 mL H₂O₂ and 15 min heating time. The MW-AOP is an effective method in dairy manure treatment for sugar production, nutrient solubilisation, and solids disintegration.     

双室微生物燃料电池处理硝酸盐废水

基于双室微生物燃料电池(microbial fuel cell,MFC),针对阴极分别接种活性污泥(A-MFC)和反硝化细菌(D-MFC),研究其产电情况和硝酸盐废水去除效果。结果表明,在产电的同时都可有效去除废水中的硝酸盐污染物。在外接电阻100Ω的情况下,2种MFC均具有良好的产电性能,A-MFC和D-MFC达到的最大输出电压分别为119.6 mV和117.2mV,最大功率密度分别为23.40 mW/m2和26.63 mW/m2;同时两者在阴极室的平均反硝化速率分别为1.86 mg/(L.d)和2.19 mg/(L.d),阳极室的平均COD去除率分别为81.9%和82.4%。另外,通过扫描电镜观察可知,A-MFC和D-MFC阴极碳布表面形貌存在差异,并且阳极与阴极碳布表面形貌差异显著。     

阴极液及底物浓度对AFB-MFC同步废水处理及产电性能影响

为了提高厌氧流化床微生物燃料电池（AFB-MFC）的性能,并为双室MFC寻找价廉、易得、无污染的阴极液,在曝气量16～24 L/h、温度（35±2）℃、回流量10.2 L/h、阴极底边距阴极室内底部17.3 cm、外电阻250 Ω、水力停留时间（HRT）14.0～14.9 h以及进水pH 7.81～8.37下,研究了阴极液及底物浓度对系统产电及废水处理性能的影响。结果表明,使用缓冲溶液、阳极室出水和自来水作阴极液时,自来水的产电性能最佳,阴极液种类不影响系统有机基质的去除。以自来水为阴极液时,阴极液pH及电导率随运行时间增加而增加,COD去除率为80.11%～89.29%,输出电压及功率密度开始随运行时间增加而增加,之后稳定在440～452 mV和48.40～51.08 mW/m²之间。增加底物浓度对COD去除率影响不大,而输出电压及功率密度随底物浓度增加而下降;底物COD浓度由3 307.09 mg/L增至9 520 mg/L时,COD去除率在85.77%～94.44%之间,输出电压及功率密度则分别由449 mV和50.40 mW/m²下降至406 mV和41.21 mW/m²。自来水作阴极液可避免二次污染及阴极液对阳极室微生物的影响,并得到高的产电能力。     

Generation of Monthly Precipitation Under Climate Change for the Upper Blue Nile River Basin,Ethiopia1

Abstract: This work develops a methodology to project the future precipitation in large river basins under limited data and climate change while preserving the historical temporal and spatial characteristics. The computationally simple and reliable conditional generation method (CGM) is presented and applied to generate reliable monthly precipitation data in the upper Blue Nile River Basin of Ethiopia where rain‐fed agriculture is prevalent. The results showed that the temporal analysis with the CGM performs better to reproduce the historical long‐term characteristics than other methods, and the spatial analysis with the CGM reproduced the historical spatial structure accurately. A 100‐year time series analysis using the outcomes of the six general circulation models showed that precipitation changes by the 2050s (2040 through 2069) can be ?7 to 28% with a mean increase of about 11%. The seasonal results showed increasing wet conditions in all seasons with changes of mean precipitation of 5, 47, and 6% for wet, dry, and mild seasons, respectively.     

The accounting method and application of CO2 emissions responsibility by the electricity sector at the provincial level in China

When accounting the CO₂ emissions responsibility of the electricity sector at the provincial level in China,it is of great significance to consider the scope of both producers’ and the consumers’ responsibility,since this will promote fairness in defining emission responsibility and enhance cooperation in emission reduction among provinces.This paper proposes a new method for calculating carbon emissions from the power sector at the provincial level based on the shared responsibility principle and taking into account interregional power exchange.This method can not only be used to account the emission responsibility shared by both the electricity production side and the consumption side,but it is also applicable for calculating the corresponding emission responsibility undertaken by those provinces with net electricity outflow and inflow.This method has been used to account for the carbon emissions responsibilities of the power sector at the provincial level in China since 2011.The empirical results indicate that compared with the production-based accounting method,the carbon emissions of major power-generation provinces in China calculated by the shared responsibility accounting method are reduced by at least 10%,but those of other power-consumption provinces are increased by 20% or more.Secondly,based on the principle of shared responsibility accounting,Inner Mongolia has the highest carbon emissions from the power sector while Hainan has the lowest.Thirdly,four provinces,including Inner Mongolia,Shanxi,Hubei and Anhui,have the highest carbon emissions from net electricity outflow- 14 million t in 2011,accounting for 74.42% of total carbon emissions from net electricity outflow in China.Six provinces,including Hebei,Beijing,Guangdong,Liaoning,Shandong,and Jiangsu,have the highest carbon emissions from net electricity inflow- 11 million t in 2011,accounting for 71.44% of total carbon emissions from net electricity inflow in China.Lastly,this paper has estimated the emission factors of electricity consumption at the provincial level,which can avoid repeated calculations when accounting the emission responsibility of power consumption terminals（e.g.construction,automobile manufacturing and other industries）.In addition,these emission factors can also be used to account the emission responsibilities of provincial power grids.     

A COMPARISON OF STREAMFLOW GENERATION MODELS FOR RESERVOIR CAPACITY-YIELD ANALYSIS1

ABSTRACT: An analysis of four streamflow generation schemes for the use in the estimation of the required conservation storage for a single reservoir is presented. The comparison of the generating schemes should aid in the selection of an appropriate model type for the reservoir sizing problem. The streamflow generation models are compared using two criteria. The first comparison is between the statistics of the generated streamflow sequences and the corresponding statistics from the historical record. The second evaluation compares the median reservoir size determined by each model with the required storage based on the historical flow sequence. The results of a comparative analysis for monthly streamflow data for the Rzav River in Yugoslavia are presented and discussed. The results indicate that both evaluation criteria are required to discriminate between the various options.     

MFAM模型在河流水质污染模拟及预测中的应用

文中以时间序列分析为基础，介绍了均值生成函数这一崭新概念，并且经成份因子提取分析推导建立了模拟序列的数字模型（简记为MFAM），经对黄河下游花园口断面的1988-1989年实测水质污染指标溶解氧（DO），氨氧，化学耗氧量（COD），五日生化需氧量（BOD5）等序列模拟，结果表明MFAM模型能较好地模拟河流水质污染指标的变化趋势，拟合平均误差只有5.2-6.4%，MFAM模型应用于预测1990-1991年水质污染指标变化，结果表明预测精度达85%以上，文中最后得出结论：MFAM模型应用于河流污染模拟和预测，是完全可行且十分方便。     

干旱对电力生产的影响

本文以１９９４年～１９９５年干旱对陕西省电力生产的影响为例，论述了干旱对电力生产的影响，在此基础上提出了相应的减灾对策．     

HYDRO-POWER SYSTEM SIMULATION TECHNIQUE1

ABSTRACT. The non-power requirements of a large hydro-power system of multiple-purpose projects often conflict with the best power peaking operation. In order to schedule an optimum multiple-purpose operation, advanced procedures that necessitate the use of computers are required. Special techniques are used in a computer program developed in the Reservoir Control Center, North Pacific Division of the Corps of Engineers that provide the ability to define operating constraints in order of priority. These techniques are easily adapted to practical reservoir regulation problems so that the program is useful in daily reservoir regulation scheduling.