垃圾焚烧中氯化物对重金属Cd迁移转化特性的影响

采用管式炉和模拟垃圾对垃圾焚烧中氯化物对重金属Cd迁移转化特性的影响进行了研究,使用ICP-AES(美国EPA消解方法)、SEM、EDS和XRD分析技术对重金属浓度、灰渣表面形貌、成分和灰渣X射线衍射物相等进行了分析.结果表明,氯化物的加入均使得97％以上的Cd分布于飞灰中,且随氯化物含量的增加在飞灰中的分布逐渐增加.有机氯PVC和无机氯NaCl含量的变化对Cd迁移分布的影响没有显著差别.PVC对Cd迁移分布影响受温度影响显著,550℃时Cd在飞灰中分布为80.51%,850℃时Cd在飞灰中的分布上升为97.91%,但在温度超过CdCl₂的熔点568℃后温度的影响较小.NaCl对Cd的迁移分布受温度影响不明显,加入NaCl后550℃时Cd在飞灰中分布为95.02%,1 000℃时在飞灰中的分布为96.58%.氯化物存在下停留时间对Cd迁移分布没有显著影响.底渣和飞灰的SEM/EDS和XRD分析表明,PVC和NaCl对Cd迁移转化作用机理不同.     

强化混凝去除微污染湖泊水浊度及TOC的研究

通过烧杯混凝试验和动态连续混凝试验,就混凝剂种类、投药量、pH值、水温等因素,研究强化混凝对水中浊度和TOC去除效果的影响。试验结果表明:PAC最佳投量为30mg/L,浊度去除率为90.19%,TOC去除率为38.2%,水温高于20℃时,聚合氯化铝对浊度和TOC去除率分别高达84.95%、33.18%以上。虽然pH值是影响有机物去除的主要参数,动态连续混凝试验表明,不改变pH值,强化混凝工艺依然能极大地改善出水水质,滤后水质浊度为0.1NTU,TOC为6.23mg/L。     

一起有机硅工厂燃爆事故的应急监测案例分析

本文介绍了绍兴市袍江工业区"2.20"浙江恒业成有机硅有限公司燃爆事故的应急监测,在监测过程中确立了气、水等环境介质作为监测对象,确定含硅有机物和氯化氢作为主要监测因子,并根据实际情况合理地选择了监测方法,以为事故的应急处理提供借鉴。     

气相色谱法测定空气和废气中氯乙烯的改进

因填充柱装柱繁琐,柱效低,最低检出浓度高,不能判别无组织废气中氯乙烯的浓度是否达到《大气污染物综合排放标准》（GB16297—1996）排放限值的要求;用毛细管柱能满足分析的要求。     

Metal chlorides loaded on activated carbon to capture elemental mercury

Activated carbon (AC) was considered to be an effective sorbent to control mercury in combustion systems. However, its capture capacity was low and it required a high carbon-to-mercury mass ratio. AC loaded with catalyst showed a high elemental mercury (Hg0) capture capacity due to large surface area of AC and high oxidization ability of catalyst. In this study, several metal chlorides and metal oxides were used to promote the sorption capacity of AC. As a result, metal chlorides were better than metal oxides loaded on AC to remove gaseous mercury. X-ray diffractometer (XRD), thermogravimetric analyzer (TGA) and specific surface area by Brunauer- Emmett-Teller method (BET) analysis showed the main mechanisms: first, AC had an enormous surface area for loading enough MClx; second, Cl and MxOy were generated during pyrogenation of MClx; finally, there were lots of active elements such as Cl and MxOy which could react with elemental mercury and convert it to mercury oxide and mercury chloride. The HgO and HgCl2 might be released from AC’s porous structure by thermo regeneration. A catalytic chemisorption mechanism predominates the sorption process of elemental mercury. As Co and Mn were valence variable metal elements, their catalytic effect on Hg0 oxidization may accelerate both oxidation and halogenation of Hg0. The sorbents loaded with metal chlorides possessed a synergistic function of catalytic effect of valence variable metal and chlorine oxidation.     

Review of hydrogen safety during storage,transmission, and applications processes

Hydrogen is considered an excellent clean fuel with potential applications in several fields. There are serious safety concerns associated with the hydrogen process. These concerns need to be thoroughly understood and addressed to ensure its safe operation. To better understand the safety challenges of hydrogen use, application, and process, it is essential to undertake a detailed risk analysis. This can be achieved by performing detailed consequence modellings and assessing risk using the computational fluid dynamics (CFD) approach. This study comprehensively reviews and analyses safety challenges related to hydrogen, focusing on hydrogen storage, transmission, and application processes. Range of release and dispersion scenarios are investigated to analyse associated hazards. Approaches to quantitative risk assessment are also briefly discussed.     

Quantified risk assessment on life and property loss from road collision vehicle fires with hydrogen-fueled tank

Hydrogen fuel cell vehicles pose hazards different from conventional vehicles. This paper performs a risk assessment on road collision vehicle fires with hydrogen-fueled tank of 70 MPa. The high voltage battery fire caused by road collision can lead to onboard hydrogen release or explosion. Events progressions are analyzed and typical hydrogen consequences are evaluated quantitatively, including hydrogen jet fires and tank catastrophic rupture. Perimeters around the accident scene are proposed for the safety of general public and first responders, respectively. Risks of fatalities, injuries, and damages are all quantified in financial terms to make it possible to combine and compare.     

O_3-脱硫灰-FeCl_3联合调理对污泥脱水性能的影响

以毛细吸水时间(CST)和滤饼含水率(Wc)为指标,探究O_3-脱硫灰-FeCl3联合调理对污泥脱水性能的影响。通过测定污泥各层胞外聚合物(EPS)含量、可溶性化学需氧量(SCOD)、Zeta电位以及红外光谱(FTIR),探讨了O_3、脱硫灰和FeCl_3调理污泥的作用机理。结果表明:O3-脱硫灰-FeCl_3联合调理污泥的效果明显好于O_3单独调理。SCOD和FTIR分析表明:部分EPS氧化分解为氨基酸、脂肪酸等小分子有机物或无机物,释放了部分表面吸附水和内部结合水。O_3能促进紧密粘附的胞外聚合物(TB-EPS)剥落;剥落的TB-EPS,部分转化为溶解性胞外聚合物(S-EPS)和松散粘附层胞外聚合物(LB-EPS),部分被Fe(OH)_3吸附。当O_3、脱硫灰和FeCl3投加量分别为85.72mg/g(DS)、400mg/g(DS)和60mg/g(DS)时,CST和Wc分别由1239.5s和83.69%降至204.3s和70.70%,脱水速度提高83.52%,脱水程度提高15.41%。     

Sulfate reducing bacterial community and in situ activity in mature fine tailings analyzed by real time qPCR and microsensor

Sulfate reducing bacteria(SRB) play significant roles in anaerobic environments in oil sands mature fine tailings(MFTs). Hydrogen sulfide(H2S) is produced during the biological sulfate reduction process. The production of toxic H_2S is one of the concerns because it may hinder the landscape remediation efficiency of oil sands tailing ponds. In present study, the in situ activity and the community structure of SRB in MFT and gypsum amended MFT in two settling columns were investigated. Combined techniques of H_2S microsensor and dissimilatory sulfite reductase β-subunit(dsrB) genes-based real time quantitative polymerase chain reaction(qPCR) were applied to detect the in situ H_2S and the abundance of SRB. A higher diversity of SRB and more H_2S were observed in gypsum amended MFT than that in MFT, indicating a higher sulfate reduction activity in gypsum amended MFT; in addition, the activity of SRB varied as depth in both MFT and gypsum amended MFT: the deeper the more H_2S produced. Long-term plans for tailings management can be assessed more wisely with the information provided in this study.     

纳米Fe_3O_4强化混凝-Fenton氧化预处理垃圾渗滤液

采用纳米Fe_3O_4与Fe Cl3制备复合混凝剂,利用混凝沉淀-Fenton氧化工艺预处理垃圾渗滤液原水,研究其处理效果。结果表明:在纳米Fe_3O_4投加量为2 g/L,Fe Cl3投加量为1.4 g/L时制备的复合混凝剂,在p H值为6.5,转速为300 r/min下快速搅拌1 min,转速为100 r/min下慢速搅拌30 min,沉淀时间为30 min的条件下,COD去除率为56.8%,ρ(COD)可由5 240 mg/L降低到2 264 mg/L;利用Fenton氧化处理混凝处理出水,在H_2O_2的投加量为5.5 g/L,n(H_2O_2)∶n(Fe2+)=4,p H值为6,反应时间为80 min,反应温度为25℃的最佳条件下,COD和氨氮的去除率分别为55.7%和40.1%,最终出水ρ(COD)和ρ(氨氮)分别为1 003 mg/L和670 mg/L;该组合工艺对垃圾渗滤液有较好的处理效果,COD、色度和氨氮的去除率分别为80.8%、59.5%和76.2%。