均相Fenton法深度处理丙烯腈生化尾水

采用均相Fenton法深度处理丙烯腈生化处理工艺尾水,通过单因素法分析了H_2O_2投加量、Fe~(2+)投加量、初始p H值和反应时间对尾水COD去除率的影响;并采用中心响应曲面法优化Fenton处理的工艺参数,得到最佳反应条件为:Fe~(2+)投加量为1.02 mmol·L-1,H_2O_2投加量为11.13 mmol·L~(-1),初始pH值为3.66,反应时间为105 min,COD去除率达到61.1%.处理后尾水COD值低于50 mg·L~(-1),可满足石化行业一级排放标准.Fenton工艺对尾水中特征污染物均有较好的去除效果,最佳反应条件下丙烯腈、间苯二甲腈、3-氰基吡啶的去除率分别为99.5%、97.6%、73.7%;Fenton法对3种特征污染物的降解能力从大到小依次为:丙烯腈间苯二甲腈3-氰基吡啶.三维荧光光谱分析表明,尾水中存在大量类富里酸荧光物质,其中,紫外区类富里酸含量最高,Fenton工艺在较短反应时间和较少的试剂投加量条件下,便可有效地去除这类难降解物质.     

温度对城市污水厂尾水反硝化MBBR深度脱氮的影响

为解决城市污水厂尾水再生利用时ρ(TN)高的问题,采用反硝化MBBR(移动床生物膜反应器)对城市污水厂尾水进行反硝化脱氮,并重点研究不同温度下分别以聚乙烯和聚丙烯为填料的反硝化MBBR的运行效果. 结果表明:在HRT(水力停留时间)为12 h、温度分别为13、19、25和30 ℃时,NO₃--N去除率和反硝化能力变化不大,聚乙烯和聚丙烯反硝化MBBR的NO₃--N去除率分别为80.1%～85.0%和78.2%～84.0%,二者的反硝化能力分别为6.7～7.1和6.5～7.0 mg/(L·h);较长的HRT弥补了低温时反硝化速率低的不足;随温度增加,生物量逐渐增加,但COD_Cr和DOM(溶解性有机物)的去除率变化不明显. 三维荧光图谱表明,出水中主要的DOM(溶解性有机质)为类色氨酸和类富里酸,聚乙烯和聚丙烯反硝化MBBR对DOM总荧光强度的去除率分别为47.6%～52.5%和24.1%～35.8%. 填料上的微生物以杆菌、丝状菌和球菌为主. 综合考虑脱氮效能和有机物污染物去除效能,聚乙烯和聚丙烯反硝化MBBR深度脱氮的最佳温度均为25 ℃.      

IC反应器的启动研究进展

针对IC反应器存在的启动时间较长的问题,对有关IC反应器的启动研究做一综述,为IC反应器的研究提供一定的参考和借鉴。     

基于DEA-Tobit的城市生态效率评价及影响因素研究——以江苏省为例

基于DEA-Tobit两阶段分析框架,利用超效率DEA模型评价了江苏省13个地级市及苏南、苏中、苏北3个区域2009~2013年的工业生态效率,并采用Tobit模型测量了城镇化率、产业结构、环境规制对该效率值的影响。研究表明:江苏省城市工业生态效率整体处于中上水平,但地区间差异较大:苏中优于苏南,苏南优于苏北;工业用水、工业用地消耗过多,工业废气排放过量是目前影响江苏省城市工业生态效率提升的主要原因;提高城镇化率对江苏省城市工业生态效率有积极的影响,产业结构调整对城市工业生态效率有微弱的抑制作用,环境规制对城市工业生态效率影响并不显著。     

对工业污染场地治理修复创新机制的思考

土壤污染受到社会的广泛关注,其中工业污染是土壤污染的重要来源。针对工业污染场地修复中利益相关方众多、修复质量控制和追责机制不完善、工程实施后可能遗留风险隐患等问题,文章提出工业污染场地治理修复及环境管理全流程中的治理修复质量控制、异位和原位修复的当期及长远风险监控、责任追究机制等关键环节上环境管理模式和机制的几点思考,以期为实现我国工业污染场地修复的环境管理提供借鉴。     

悬浮颗粒对污水氯消毒“拖尾”现象的影响

利用动力学方法研究了悬浮颗粒对二级出水氯消毒灭活大肠杆菌"拖尾"现象的影响规律.SS浓度越高,消毒拖尾区出现越早,灭活率越低.双对数回归对比表明,SS与灭活速度线性相关,浓度从6mg/L升高至85mg/L,总的灭活速度降低约10倍.采用多次拟合统计分析发现,SS浓度在10～55mg/L范围内,悬浮颗粒浓度与拖尾区起始时间及起始点对数灭活率线性相关(R20.99).在此范围内随SS浓度升高,拖尾起始点的时间由330min降低到55min,对数灭活率由5.8降低至0.8.有效去除SS不仅能够提高拖尾区灭活率,也可以提高消毒效率,降低消毒池的投资和运行费用.高氯投量及低pH值均能一定程度提高"拖尾"区灭活率.     

Degradation behavior of 17αup-ethinylestradiol by ozonation in the synthetic secondary effluent

Endocrine disrupting chemicals (EDCs) in the secondary effluent discharged from wastewater treatment plants (WWTPs) are of great concern in the process of water reuse. Ozonation has been reported as a powerful oxidation technology to eliminate micropollutants in water treatment. Due to the complexity of the wastewater matrix, orthogonal experiments and single factor experiments were conducted to study the influence of operational parameters on the degradation of 17αup-ethinylestradiol (EE2) in the synthetic secondary effluent. The results of the orthogonal experiments indicated that the initial ozone and natural organic matter (NOM) concentration significantly affected EE2 degradation efficiency, which was further validated by the single factor confirmation experiments. EE2 was shown to be effectively degraded by ozonation in the conditions of low pH (6), NOM (10 mg/L), carbonate (50 mg/L), but high suspended solid (20 mg/L) and initial ozone concentration (9 mg/L). The study firstly revealed that the lower pH resulted in higher degradation of EE2 in the synthetic secondary effluent, which differed from EDCs ozonation behavior in pure water. EE2 degradation by ozone molecule instead of hydroxyl radical was proposed to play a key role in the degradation of EDCs by ozonation in the secondary effluent. The ratio between O₃ and TOC was identified as an appropriate index to assess the degradation of EE2 by ozonation in the synthetic secondary effluent.     

Comparative study of leaching of silver nanoparticles from fabric and effective effluent treatment

Nano silver (Ag_n) is employed as an active antimicrobial agent, but the environmental impact of Ag_n released from commercial products is unknown. The quantity of nanomaterial released from consumer products during use should be determined to assess the environmental risks of advancement of nanotechnology. This work investigated the amount of silver released from three different types of fabric into water during washing. Three different types of fabric were loaded with chemically synthesized Ag nanoparticles and washed repeatedly under simulated washing conditions. Variable leaching rates among fabric types suggest that the manufacturing process may control the release of silver reaching the waste water treatment plants. In an attempt to recover the Ag_n for reutilization and to save it from polluting water, the effluents from the wash were efficiently treated with bacterial strains. This treatment was based on biosorption and was very efficient for the elimination of silver nanoparticles in the wash water. The process ensured the recovery of the Ag_n leached into the effluent for reutilization, thus preventing environmental repercussions.     

Case study evidence that direct regulation remains the main driver of industrial pollution avoidance and may benefit operational efficiency

Environmental regulation is required to reduce industrial pollution to levels that are socially acceptable and economically efficient, but there is debate over the most efficient form of such regulation. Typically, a limited range of environmental and economic parameters are accounted for in the econometric studies that inform that debate. This paper integrates evidence from two separate studies to assess a broad range of parameters related to the efficiency of industrial environmental regulation. Questionnaire responses from 25 Italian manufacturers of building-chemicals and 28 Irish pharmaceutical manufacturers provided evidence on the environmental effectiveness and operational impacts of different regulatory instruments. Combined with extensive emissions data from Irish pharmaceutical manufacturers, survey results enabled a quantitative estimation of pollution avoidance specifically attributable to direct regulation. The monetised social benefit of avoided pollution was found to be equal to direct compliance costs. Chemical manufacturers in Italy and Ireland stated that direct regulation is a more important driver of industrial environmental performance than economic or voluntary regulation, and their responses indicated that direct compliance costs may be countered somewhat by stimulated operational improvements. It was concluded that direct regulation is an effective approach for multi-pollutant control in an industrial context, and that the efficiency of such regulation may be underestimated in studies that do not consider the full range of pollutants and operational effects.     

基于GIS的工业水污染调查研究——以滇池流域为例

污染源调查是在进行流域水污染控制与富营养化治理技术研究和《全国第一次污染源普查》基础上,根据调查年环境统计数据、环保局排污企业的申报登记、排污许可证发放以及重点企业抽样调查、监测数据等多源资料,对企业数量及污染排放情况进行校核,基于GIS空间分析技术,建立滇池流域工业企业污染源数据库。根据滇池流域工业产业结构、分布和污染现状调查,结合昆明市社会经济发展及工业布局相关规划,预测工业发展可能带来的环境污染,提出相应的产业结构布局和相关治理政策的建议意见,为滇池的水污染防治和昆明市的发展战略规划提供参考。