Selective intrauterine growth restriction in monochorionic diamniotic twin pregnancies

Selective intrauterine growth restriction (sIUGR) occurs in 10 to 15% of monochorionic (MC) twins, and it is associated with a substantial increase in perinatal mortality and morbidity. Clinical evolution is largely influenced by the existence of intertwin placental anastomoses: pregnancies with similar degrees of fetal weight discordance are associated with remarkable differences in clinical behavior and outcome. We have proposed a classification of sIUGR into three types according to umbilical artery (UA) Doppler findings (I-normal, II-absent/reverse end-diastolic flow, III-intermittent absent/reverse end-diastolic flow), which correlates with distinct clinical behavior, placental features and may assist in counseling and management. In terms of prognosis, sIUGR can roughly be divided in two groups: type I cases, with a fairly good outcome, and types II and III, with a substantial risk for a poor outcome. Management of types II and III may consist in expectant management until deterioration of the IUGR fetus is observed, with the option of cord occlusion if this occurs before viability. Alternatively, active management can be considered electively, including cord occlusion or laser coagulation. Both therapies seem to increase the chances of intact survival of the larger fetus, while they entail, or increase the chances of, intrauterine demise of the IUGR fetus. Copyright © 2010 John Wiley & Sons, Ltd.     

Removal of Fe(III) using a polystyrene anchored Schiff base

Salicylaldehyde Schiff base of amino-methylated polystyrene has been developed as a novel reagent for the removal of Fe(III) from solutions. The selectivity of the metal ion uptake over a wide range of different concentrations of metal ion, effect of pH, ligand concentration and the influence of other foreign ions were studied. A very good selectivity was achieved for the removal of the ion. It was found that 0.01 g of the ligand was sufficient to achieve about 96% removal of the metal ion in terms of concentration (ppm) from a 30 ppm solution in acidic pH.     

化学修饰碳糊电极测定废水中痕量铜

研制了732型阳离子交换树脂碳糊修饰电极,在盐酸－乙二胺体系中,对Cu（Ⅱ）显示出良好的离子交换和选择性,电极具有很好的重现性和较长的使用寿命,可用于废水中痕量铜的测定。     

流化床三维电极电催化氧化深度处理焦化废水

研究了以焦粒为粒子电极的流化床三维电极反应器对二级生化处理后的焦化废水进行深度处理。结果表明：采用以焦粒为粒子电极的流化床三维电极反应器能有效降解废水中的有机物,COD去除率依赖于粒子投加量、电流密度、电导率、pH值、曝气量等操作参数的影响。在电导率（以S计）为7.1 m.cm-1,曝气量为160 L.h-1,电流密度（以A计）为48 m.cm-2,pH值为5.0,投加量30 g.L-1时,电解30 min,COD的去除率超过60%,表明流化床三维电极反应器在焦化废水深度处理中有很好工程应用前景。     

ZrO2掺杂的V2O5/TiO2催化剂表征及催化还原NOx

采用共沉淀法制备出不同锆掺杂量的钛锆复合载体(TiO2-ZrO2),运用XRD和BET研究其微观结构,结果显示钛锆物质的量之比1∶1时复合载体具有最大的比表面积,可达256.01 m.2g-1.以此为载体制备了V2O5/TiO2-ZrO2催化剂,并添加少量CeO2对其改性.采用XRD、BET、H2-TPR、原位FT-IR等手段研究其活性组分的表面分散状态、氧化还原特性和表面酸性.结果显示,V2O5高度分散在载体上;与纯V2O5相比,复合载体上V2O5的还原峰向低温方向发生了偏移;催化剂表面包含了大量的B酸和L酸.模拟氨气催化还原NO(NH3-SCR)的脱硝反应活性测试表明,V2O5/TiO2-ZrO2催化剂具有较好的热稳定性和较宽的活性窗口,少量CeO2的加入提高了催化剂的低温活性.     

2021年青岛市一次PM_(2.5)和沙尘混合空气污染过程分析

以2021年3月青岛市空气自动站监测数据为依据,借助环境气象激光雷达、气溶胶激光雷达、在线离子色谱仪等技术手段,并利用后向轨迹模式(HYSPLIT)对青岛市一次PM_(2.5)和沙尘混合空气污染过程、气象条件、颗粒物组成以及传输路径等进行了综合分析。结果表明:静小风、湿度大、垂直方向逆温以及高空多次向近地面的污染物输送是第1阶段PM_(2.5)污染的主要原因,NO^(-)_(3)、SO^(2-)_(4)、NH^(+)_(4)浓度分别占水溶性离子浓度总和的51.7%,24.8%,22.4%,三者之和占ρ(PM_(2.5))的52.3%,机动车源、工业源和燃烧源贡献较大,其中尤以机动车源影响最显著;第2阶段各子站颗粒物浓度变化呈现明显的传输特征,PM_(2.5)中Ca^(2+)浓度升至第1阶段的6倍,沙尘源影响显著,污染气团主要来自蒙古国和我国内蒙古,前期由西北地区直接到达青岛,后期是经渤海湾、烟台到达青岛东南海域,最后回流至青岛;冷高压强度较弱导致近地面水平扩散条件不利,ρ(PM_(10))长时间维持在较高水平。     

检测2,4-D的一次性安培型免疫传感器

2,4-D是广泛使用的除草剂,以2,4-D为检测目标,研究了安培型免疫传感器.首先采用1-乙基-3-(3-二甲基氨丙基)碳二亚胺盐酸盐(EDC)作为交联剂制备2,4-D与BSA以及PLL的偶联物.用结合比1∶16的2,4-D与偶联物制备兔抗血清.免疫传感器的制备包括2个步骤,使用丝网印刷工艺制备一次性碳电极,然后通过戊二醛交联在电极表面固定2,4-D与多聚赖氨酸(PLL)的偶联物.待测水样与2,4-D抗血清和HRP酶标二抗进行间接免疫竞争反应.在HRP酶在邻苯二胺和H₂O₂的共同作用下发生酶促反应,检测还原电流以反映2,4-D的浓度.试验了不同浓度抗血清和酶标二抗对检测信号的影响,结果表明,2,4-D的检测下限达到1.69ng/mL,线性区间1.69～30 000ng/mL,适合饮用水中2,4-D的检测要求.     

苯酚在金刚石膜电极上的电化学氧化降解过程

采用循环伏安法、交流阻抗法、恒电位计时电流法,并结合高效液相色谱方法,研究了苯酚在金刚石膜电极上的电化学氧化降解过程.结果表明,苯酚在电化学氧化降解中经历了苯二酚、苯醌的形成和进一步被氧化的过程,苯二酚在反应过程中的积累很少,迅速氧化为苯醌,而醌类中间产物则较难进一步氧化,在反应过程中积累的浓度较高.苯酚在金刚石膜电极上有不同的电化学氧化反应途径,在低于金刚石膜电极析氧电位下,发生单纯直接电化学氧化过程;在高于金刚石膜电极析氧电位下,间接电化学氧化和直接电化学氧化将同时发生作用.     

Characteristics of NO reduction with non-thermal plasma

As a new type of NO removal system, NO reduction in N2-NO plasma was applied to solve the difficulties in the traditional methods, such as higher energy-consumption, larger equipment size and high cost, and so on. Using the experimental NO reduction system with single-pair electrode tip discharge structure, the NO reduction characteristics of N~-NO system were revealed to guide the engineering practice; the results of NO reduction with single-pair electrode tip discharge plasma also have the same instructive meaning to the NO reduction with multi-pair electrode tip discharge plasma. The amount of both active N atom and NO removal rate increased with the distance /g increasing between the two electrode tips and then dropped when the distance exceeded a certain value. The NO removal rate increased while the voltage between two electrode tips or the resident time of gas flow increased. The distance is a key geometrical variable factor that can determine the intensity of electric field between two electrode tips and the resident time of gas. In this paper, the effects of the dielectric features on NO reduction using dielectric-barrier discharge plasma system were also studied. The results of NO removal rate with different dielectrics such as Al2O3, CaO. MgO and glass showed that the electric field intensity is different with different dielectric, because it brings different energy to particles in discharge room and thus it causes different NO removal rate.     

电解反应器电极排列方式研究

提高电极表面反应物扩散速率以及提高反应器效率是强化电解反应器处理能力、降低电耗的重要途径,安装中心推进式搅拌叶轮、辅射状电极的新型电解反应器可达到这2个目的.数学推导证明,新型电解反应器与同心圆状电极电解反应器效率比大于2.利用研制的反应器效率为9.9 m2/m3的新型电解槽,完成了电镀工业高质量浓度含氰废水处理的工业试验,废水氰化物平均质量浓度为17 000 mg/L,平均电解时间为17.7 h,氰化物去除率为99.6%,处理每kg CN-耗电15.1 kW·h.2年多的工业应用表明,带中心推进式搅拌叶轮的辐射状电极电解槽,具有操作容易、氰化物去除率高、回收金属方便、处理成本低等优点,其性能优于常规的同心圆状电极电解槽.