不锈钢波纹管应力腐蚀防护方法研究

不锈钢波纹管是现代工业广泛使用的金属弹性元件,长期应用实践表明,在特殊环境条件下,波纹管常常发生因应力腐蚀引发的爆炸失效事故,对环境、安全构成极大威胁。本文详细阐述了固溶处理不锈钢波纹管组形变马氏体含量分布、残余应力分布。不锈钢波纹管在加工、成型过程中,波峰波谷会发生塑性变形,一部分奥氏体组织转变为马氏体组织。试验研究结果表明,固溶处理后残余应力变为压应力,残余应力比未固溶处理波纹管的大大减小;固溶处理后形变马氏体含量较少,且分布均匀,约占0.25%;残余应力越大,马氏体含量越高,不锈钢SCC敏感性大。对固溶处理前后波纹管应力腐蚀开裂进行实验研究,研究表明,固溶处理可提高波纹管抗SCC性能;喷丸强化可提高波纹管抗SCC能力,表面硬度、强度增大,也可延长疲劳寿命。     

Preparation of novel activated carbons from H2SO4-pretreated corncob hulls with KOH activation for quick adsorption of dye and 4-chlorophenol

Corncob hull was immersed in 25 wt% H(2)SO(4) and was carbonized in an oven at 290 °C for 2h to obtain the char. The char was then activated for 1h at 780 °C by KOH at weight ratio of KOH/char of 2.5, 3.0, and 3.5. SEM photos of the carbons revealed that the cell wall of corncob hull was etched into thin film structure. It was shown that the adsorption isotherms of methylene blue and 4-chlorophenol on the carbons were well fitted by the Langmuir equation. Moreover, the adsorption kinetics could be satisfactorily described by the Elovich equation. The normalized standard deviations are less than 2.8%. The high fraction of adsorption amount adsorbed within 1 min to that at saturation demonstrated the advantage of the prepared activated carbons. The fraction of adsorption amount within 1 min to that at saturation (q(1)/q(mon)) for the adsorption of 4-CP is high up to 0.807. Such quick adsorption behavior was mainly attributed to the presence of the thin film structure of carbons.     

水体中亚硝酸盐的光降解

一定浓度的亚硝酸盐溶液经太阳光模拟器照射一定时间后,观测溶液中亚硝酸盐的含量变化.改变溶液条件（介质、pH）和光照条件（时间、光强）等实验条件,同时进行黑暗对照实验,探求影响亚硝酸盐光解的因素和规律.结果表明,在光照的8 h内,时间越长亚硝酸盐的降解率越大,基本符合一级反应动力学曲线;光照强度越大亚硝酸盐的降解程度越大...     

碱性介质中还原高浓度Cr(VI)细菌的分离及其特性

目前国内外处理含铬废水的微生物仅局限于酸性或中性环境,且处理Cr(VI)的浓度仅为200mgL-1左右,难以工业化应用,尤其是不可能处理诸如铬渣渗滤液之类的碱性含铬废水及铬渣.本研究从铬渣堆埋场附近取得菌样,经富集、分离、驯化,得到能在碱性介质中高效还原Cr(VI)的无色杆菌属(Achromobactersp.)菌株,该菌为G-,具有周身鞭毛及可运动性.对其生理及还原Cr(VI)的特性进行了研究,结果表明:该菌嗜碱,好氧,耐盐及高Cr(VI),在有氧、pH为10.30、30℃等条件下,含Cr(VI)1570mgL-1的废水经该菌处理16h后浓度降至0.6mgL-1.处理后的沉淀物中铬以Cr(OH)3的非晶形态存在,其中总铬含量为21.44%,Cr(VI)检测不出,具有很大的回收价值.图4表3参16     

离子色谱法测定有害工业固体废物浸出液中的氟化物

用离子色谱法（简称ＩＣ）测定有害工业固体废物浸出液中的氟化物，其测定方法较化学法（离子选择电极法）手续简便、快速、准确．     

溶液吸收/分光光度法检测空气中偏二甲肼含量

GJB2373-95采用固体吸附/分光光度法监测空气中偏二甲肼,但是采集空气中偏二甲肼所用的SG-2固体吸附剂和采样管制作繁琐,分析步骤复杂,不适合连续监测。文章以单位自行研制的偏二甲肼动态配气系统配制已知浓度空气样品为测试环境,用标定过的美国Interscan气体检测仪实时监测其浓度为13.4×10-6～13.6×10-6,采用溶液吸收法采样并简化GJB2373-95标准方法的分析步骤。依据两种方法分别做出各自的标准曲线,并采用固体吸附法和溶液吸收法各采集两个平行样,样品采样体积分别为3.28L、3.31L和3.12L、3.14L,对应各自的标准曲线,计算出两组样品偏二甲肼含量分别为10.7×10-6、11.0×10-6和12.1×10-6、12.0×10-6。经传感器实时监测值作为第三方数据比对,结果表明溶液吸收/分光光度法监测结果准确,分析步骤简单、省时。     

Analytical solutions of three-dimensional contaminant transport in uniform flow field in porous media: A library

The purpose of this study is to present a library of analytical solutions for the three-dimensional contaminant transport in uniform flow field in porous media with the first-order decay, linear sorption, and zero-order production. The library is constructed using Green’s function method (GFM) in combination with available solutions. The library covers a wide range of solutions for various conditions. The aquifer can be vertically finite, semi-infinitive or infinitive, and laterally semi-infinitive or infinitive. The geometry of the sources can be of point, line, plane or volumetric body; and the source release can be continuous, instantaneous, or by following a given function over time. Dimensionless forms of the solutions are also proposed. A computer code FlowCAS is developed to calculate the solutions. Calculated results demonstrate the correctness of the presented solutions. The library is widely applicable to solve contaminant transport problems of one- or multiple- dimensions in uniform flow fields.     

美国水务管理经验分析与借鉴

对美国水务管理体制模式、运行机制及特点进行分析,为我国的水务管理及水资源合理开发利用提供思路与借鉴。     

无铅焊料合金中重金属元素浸出行为的研究

选用Sn.3.5Ag-0.5Cu、Sn-3.5Ag、Sn-0.5Cu无铅焊料合金及它们与Cu的钎焊接头,研究了它们在典型的酸性、碱性和盐溶液中的重金属元素的浸出规律.结果表明,焊料合金中的主要浸出元素Sn在酸性或碱性溶液中的浸出量都不是太多,而在NaCl盐溶液中浸出量增大2个数量级.制备成钎焊接头后,在酸性环境中,Sn-3.5Ag和Sn.0.5Cu钎焊接头中Sn的浸出量增加1个数量级以上,而在NaOH碱性环境中.Sn-3.5Ag-0.5Cu钎焊接头中Sn的浸出量相对较高.该结果对电子垃圾填埋环境选择及相关决策提供了参考.     

改变垫水层沸点的薄层扬沸实验研究

扬沸是油池火灾的一种特殊现象,燃料和垫水层交界面的过热温度和沸腾状态是决定扬沸是否发生以及发生时间的最主要因素,过热温度由沸点决定。在垫水层中添加氯化钠能够改变垫水层的沸点,从而改变交界面的过热温度。在垫水层添加氯化钠使其成为饱和氯化钠水溶液,对此条件下的油池火燃烧进行实验探究,以验证前人关于扬沸临界条件的研究结果,并为扬沸防治提供思路。垫水层改变为饱和氯化钠溶液后,柴油实验组均没有发生扬沸,且观察到火焰温度和热辐射强度的下降。表明此方法可以有效抑制扬沸的发生。