Supercritical water oxidation of tannery sludge: Stabilization of chromium and destruction of organics

The supercritical water oxidation (SCWO) of industrial tannery sludge was investigated to understand the simultaneous destruction of organic pollutants and recovery of high content chromium. Experiments were performed in a batch reactor at temperatures of 350–500 °C, reaction time of 150–300 s and different oxygen ratios, to exhibit the effect of operation conditions. Results showed that removal efficiency of chemical oxygen demand (COD) increased with higher temperature, larger oxidant amount and reaction time; a maximum value of 96% was obtained. Meanwhile, destruction yield was much higher under supercritical conditions than that in subcritical water. In addition, removal efficiency of Cr from sludge reached more than 98% under all conditions; higher temperature played a positive role. Further, leaching toxicity tests of heavy metals in solid products were conducted based on toxicity characteristic leaching procedure. All heavy metals except nickel showed a greatly reduced leaching toxicity through their stabilization. The chromium oxide recovered in ash was amorphous below 550 °C, so that the structure of Cr could not be identified by X-ray diffraction pattern. Special attention should be paid on nickel as its leaching toxicity increased due to the corrosion of reactor surface under severe reaction conditions.     

Transport modes and pathways of the strongly sorbing pesticides glyphosate and pendimethalin through structured drained soils

Leaching of the strongly sorbing pesticides glyphosate and pendimethalin was evaluated in an 8-month field study focussing on preferential flow and particle-facilitated transport, both of which may enhance the leaching of such pesticides in structured soils. Glyphosate mainly sorbs to mineral sorption sites, while pendimethalin mainly sorbs to organic sorption sites. The two pesticides were applied in equal dosage to a structured, tile-drained soil, and the concentration of the pesticides was then measured in drainage water sampled flow-proportionally.The leaching pattern of glyphosate resembled that of pendimethalin, suggesting that the leaching potential of pesticides sorbed to either the inorganic or organic soil fractions is high in structured soils. Both glyphosate and pendimethalin leached from the root zone, with the average concentration in the drainage water being 3.5 and 2.7 μg L⁻¹, respectively. Particle-facilitated transport (particles >0.24 μm) accounted for only a small proportion of the observed leaching (13-16% for glyphosate and 16-31% for pendimethalin). Drain-connected macropores located above or in the vicinity of the drains facilitated very rapid transport of pesticide to the drains. That the concentration of glyphosate and pendimethalin in the drainage water remained high (>0.1 μg L⁻¹) for up to 7 d after a precipitation event indicates that macropores between the drains connected to underlying fractures were able to transport strongly sorbing pesticides in the dissolved phase. Lateral transport of dissolved pesticide via such discontinuities implies that strongly sorbing pesticides such as glyphosate and pendimethalin could potentially be present in high concentrations (>0.1 μg L⁻¹) in both water originating from the drainage system and the shallow groundwater located at the depth of the drainage system.     

SPE-HPLC法测定固体废物浸出液中苯酚类物质

选择Agilent Bond Elut Plexa作为固相萃取柱,结合高效液相色谱测定固体废物浸出液中12种苯酚类化合物,通过试验优化条件,使目标物在0.100 mg/L~10.0 mg/L范围内线性良好,方法检出限在0.004μg/L~0.068μg/L之间,3个质量浓度水平加标回收率为78.0%~105%,测定6次结果的RSD为0.7%~5.0%。将该方法用于测定江苏省某工业园区污水处理企业5个废水处理污泥样品,结果 2,4,6-三氯苯酚和2,4-二硝基苯酚检出。     

固体废物浸出液中氰化物测定方法的探讨

用金矿废渣样品进行氰化物的浸提试验,对浸提剂的pH值、浸提次数等条件进行优化。经实际样品验证,确定pH值〉12的碱性水溶液为最佳浸提剂,浸出液中易释放氰化物和总氰化物可用硝酸银滴定法或异烟酸一巴比妥酸分光光度法测定,方法检出限分别为0．25mg／L、0．001mg／L,加标回收率为90．0％～92．0％,测定结果的RSD〈8％。     

Remediation of metal contaminated soil with mineral-amended composts

This study examined the use of two composts derived from green waste and sewage sludge, amended with minerals (clinoptilolite or bentonite), for the remediation of metal-contaminated brownfield sites to transform them into greenspace. Soils contaminated with high or low levels of metals were mixed with the mineral-enhanced composts at different ratios and assessed by leaching tests, biomass production and metal accumulation of ryegrass (Lolium perenne L.). The results showed that the green waste compost reduced the leaching of Cd and Zn up to 48% whereas the composted sewage sludge doubled the leachate concentration of Zn. However, the same soil amended with composted sewage sludge showed an efficient reduction in plant concentrations of Cd, Cu, Pb or Zn by up to 80%. The results suggest that metal immobilisation and bioavailability are governed by the formation of complexes between the metals and organic matter. The amendment with minerals had only limited effects.     

Environmental behaviour of a construction made of a mixture of hydraulic binders and air pollution control residues from municipal solid waste incineration Part 2. Simulation tests and validation of the source term modelling

The reuse of waste materials requires the development of assessment methods for the long-term release of pollutants (source term) from wastes (or materials containing wastes) in contact with water. These methods depend on the scenario conditions: characteristics of the materials (especially physical structure and composition), contact with water… The scenario studied here is a water storage reservoir for fire extinguishing. The reservoir construction is made of a mixture of hydraulic binders and air pollution control (APC) residues from municipal solid waste incinerator (MSWI). The modelling of the source term is performed in five steps ranging from the physico-chemical characterisation of the material to the validation of the proposed model by means of field simulation devices. This paper follows a first publication on source term modelling using laboratory tests which therefore concerns the comparison of the results obtained with the previously established model. The first laboratory scale simulation test aims at taking into account the role of the leachate carbonation in the leaching behaviour of the studied material. The results obtained show that air carbonation of the leachate does not fundamentally change mass transfer mechanisms of easily soluble species (especially for alkaline metals). For these species, the use of the apparent diffusional model (model proposed in the previous paper) is, therefore, at first, a satisfactory solution for the prediction of long term leaching behaviour. The field scale test enables us to validate and calibrate the release model determined on a laboratory scale basis.     

The characterization of total and leachable metals in foundry molding sands

Waste molding sands from the foundry industry have been successfully used as a component in manufactured soils, but concern over metal contamination must be addressed before many states will consider this beneficial use. Since there is little data available on this topic, the purpose of this study was to characterize total and leachable metals from waste molding sands. A total elemental analysis for Ag, Al, As, B, Ba, Be, Cd, Co, Cr, Cu, Fe, Mg, Mn, Mo, Ni, Pb, Sb, V, and Zn was conducted on 36 clay-bonded and seven chemically bonded molding sands. Total metal concentrations in the molding sands were similar to those found in agricultural soils. The leaching of metals (i.e. Ag, As, Ba, Be, Cd, Cr, Cu, Ni, Pb, Sb, and Zn) was assessed via the toxicity characteristic leaching procedure (TCLP), synthetic precipitation leaching procedure (SPLP), and ASTM water leach test. Based on the TCLP data, none of the 43 molding sands would meet the Resource Conservation and Recovery Act (RCRA) characteristic for toxicity due to high Ag, As, Ba, Cd, Cr, and Pb. Compared to the TCLP results, the metal concentrations were generally lower in the SPLP and ASTM extracts, which is likely related to the buffering capacity of the extraction fluids.     

Persistence of C-labeled atrazine and its residues in a field lysimeter soil after 22 years

Twenty-two years after the last application of ring-¹⁴C-labeled atrazine at customary rate (1.7 kg ha⁻¹) on an agriculturally used outdoor lysimeter, atrazine is still detectable by means of accelerated solvent extraction and LC-MS/MS analysis. Extractions of the 0-10 cm soil layer yielded 60% of the residual ¹⁴C-activity. The extracts contained atrazine (1.0 μg kg⁻¹) and 2-hydroxy-atrazine (42.5 μg kg⁻¹). Extractions of the material of the lowest layer 55-60 cm consisting of fine gravel yielded 93% of residual ¹⁴C-activity, of which 3.4 μg kg⁻¹ was detected as atrazine and 17.7 μg kg⁻¹ was 2-hydroxy-atrazine. The detection of atrazine in the lowest layer was of almost four times higher mass than in the upper soil layer. These findings highlight the fact that atrazine is unexpectedly persistent in soil. The overall persistence of atrazine in the environment might represent a potential risk for successive groundwater contamination by leaching even after 22 years of environmental exposure.     

Long-term mercury dynamics in UK soils

A model assuming first-order losses by evasion and leaching was used to evaluate Hg dynamics in UK soils since 1850. Temporal deposition patterns of Hg were constructed from literature information. Inverse modelling indicated that 30% of 898 rural sites receive Hg only from the global circulation, while in 51% of cases local deposition exceeds global. Average estimated deposition is 16 μg Hg m⁻² a⁻¹ to rural soils, 19 μg Hg m⁻² a⁻¹ to rural and non-rural soils combined. UK soils currently hold 2490 tonnes of reactive Hg, of which 2140 tonnes are due to anthropogenic deposition, mostly local in origin. Topsoil currently releases 5.1 tonnes of Hg⁰ per annum to the atmosphere, about 50% more than the anthropogenic flux. Sorptive retention of Hg in the lower soil exerts a strong control on surface water Hg concentrations. Following decreases in inputs, soil Hg concentrations are predicted to decline over hundreds of years.     

Oxygen-containing polycyclic aromatic hydrocarbons (OPAHs) in urban soils of Bratislava, Slovakia: patterns, relation to PAHs and vertical distribution

We determined concentrations, sources, and vertical distribution of OPAHs and PAHs in soils of Bratislava. The ∑14 OPAHs concentrations in surface soil horizons ranged 88-2692 ng g⁻¹ and those of ∑34 PAHs 842-244,870 ng g⁻¹. The concentrations of the ∑9 carbonyl-OPAHs (r = 0.92, p = 0.0001) and the ∑5 hydroxyl-OPAHs (r = 0.73, p = 0.01) correlated significantly with ∑34 PAHs concentrations indicating the close association of OPAHs with parent-PAHs. OPAHs were quantitatively dominated by 9-fluorenone, 9,10-anthraquinone, 1-indanone and benzo[a]anthracene-7,12-dione. At several sites, individual carbonyl-OPAHs had higher concentrations than parent PAHs. The concentration ratios of several OPAHs to their parent-PAHs and contribution of the more soluble OPAHs (1-indanone and 9-fluorenone) to ∑14 OPAHs concentrations increased with soil depth suggesting that OPAHs were faster vertically transported in the study soils by leaching than PAHs which was supported by the correlation of subsoil:surface soil ratios of OPAH concentrations at several sites with K_OW.