有机膦萃取分离制革污泥淋滤液中Cr和Fe

采用磷酸二(2-乙基己基)酯(D2EHPA)和磷酸三丁酯(TBP)为萃取剂,萃取分离制革污泥淋滤液中的Cr3 与Fe3 .结果表明,在pH 2.2时,采用5?EHPA-正己烷萃取体系,Fe3 的萃取率达到99%,有效地分离了制革污泥淋滤液中的Fe3 和Cr3 .以5 mol·l-1的盐酸作为反萃剂反萃负载有机相,20min时的反萃率可以达到90%左右.以TBP和 D2EHPA为萃取剂萃取分离Cr3 与Fe3 时,降低了污泥淋滤液中Fe3 的萃取率,这是由于TBP的加入降低了D2EHPA的有效浓度.同时TBP的加入阻碍了萃取物分子和反萃剂的接触,降低了Fe3 的反萃率.     

城市垃圾焚烧飞灰中重金属的形态及酸浸出性研究

研究了城市垃圾焚烧飞灰中重金属形态在不同粒径上的分布,以及HNO3对飞灰中重金属的浸出性.结果表明:飞灰中重金属主要以残渣态存在,可交换离子态含量很少;易挥发性的重金属在较大粒径上有较高分布,亲石性重金属Cr和Ni的分布与粒径的相关性不大,在各粒径上的分布较均匀;飞灰中以碳酸盐结合态存在的重金属对酸不稳定,易被HNO3浸出,而残渣态部分对酸较稳定,不易被HNO3浸出.     

玄武湖沉积物中磷的形态分布特征

利用分级提取法分析了玄武湖的沉积磷形态,在玄武湖沉积物中,铝结合态磷的含量较低,平均值为64 mg/kg,其余形态磷中,铁结合态磷为241 mg/kg,有机磷为335 mg/kg,钙结合态磷为394 mg/kg.在环境变化的条件下,铁结合态磷可以释放到间隙水和上层水体中,是湖泊产生富营养化的重要因素;铝结合态磷由于含量少,对湖泊富营养化影响很小;钙结合态磷相对稳定且很难被生物利用,对湖泊富营养化影响不大;有机磷对水体有机负荷影响较大,并影响水体富营养化程度.     

Sustainable method towards magnetic ordered mesoporous polymers for efficient Methylene Blue removal

The difficulty in achieving high removal efficiency for contaminants in textile wastewater over a wide range of pH impedes the progress of its treatment technique greatly. Herein, a facile and sustainable strategy was adopted for constructing magnetic ordered mesoporous polymers (M-OMPs) without the assistance of organic solvent and catalyst. The prepared M-OMPs were endowed with high special surface area and good superparamagnetism simultaneously, and exhibited high removal efficiency (>99%) for Methylene Blue (MB) within a short time (10 min) at a concentration of 50 mg/L. What's more, high removal efficiency was achieved over a wide range of pH 2-12 and the adsorption capacity for MB on M-OMPs was substantially retained even after 5 adsorption-desorption cycles, further demonstrating the application potential of M-OMPs in the decontamination of textile wastewater.     

微波技术在固体废弃物处理中的应用

介绍了微波加热的基本原理,综述了微波技术在工业污泥、医疗垃圾、废旧轮胎、电子垃圾以及建筑垃圾等固体废弃物处理中的应用现状,展望了微波技术在污染控制领域的应用前景.     

钙法提钒尾渣的浮选脱硫试验

根据钙法提钒尾渣的矿物特性,采用浮选法分离其中的石膏以实现脱硫,分别考察了矿浆pH、矿浆液固比、捕收剂添加量及浮选中水循环次数等因素对浮选指标的影响,并进行了理论分析,确定了钙法提钒尾渣浮选脱硫的优选工艺参数.试验结果表明,在矿浆pH为7、矿浆液固比为5:1、捕收剂添加量为0.6～0.8 kg/t的条件下,可获得w(S...     

全白土催化剂生产废水的处理

用4种无机絮凝剂和3种有机絮凝剂进行了脱除全白土催化剂生产废水（简称废水）中固体悬浮物（SS）的实验研究。实验结果表明：在废水pH6．8条件下,无机絮凝剂和有机絮凝剂脱除废水中SS的效果均较差,用无机絮凝剂时的SS去除率低于26％,用有机絮凝剂时的SS去除率低于18％;废水pH对SS去除率的影响较大,当调节废水pH为8．0时,无机絮凝剂中硫酸铝脱除废水中的SS效果最好,在硫酸铝加入量为0．02mg／L、沉降时间为2h的最佳操作条件下,SS的去除率可达93％。     

分子印迹技术在环境科学领域中的应用

分子印迹技术（MIT）是一门新兴的边缘科学技术,它的产生与发展为环境科学打开了又一视角。介绍了MIT的产生与发展及基本原理,综述了MIT在环境科学领域中的应用,主要包括MIT在固相萃取、膜分离、色谱分析、传感器及分子印迹聚合物作为催化剂在环境修复中的应用。     

聚丙烯中空纤维膜萃取水溶液中铜离子的研究

研究了聚丙烯中空纤维膜萃取二(2-乙基己基)膦酸(D2EHPA)水溶液中铜离子的工艺条件.结果表明,两相流速、膜面积对萃取率基本无影响;而水溶液的pH值和有机相初始铜离子浓度的改变使萃取率在40%-99%之间变化.整个萃取过程的传质阻力主要来源于D2EHPA和 Cu2 的界面配位络合反应阻力,铜浓度比较高时,传质阻力与铜浓度无关;而当铜浓度降低时,传质阻力随着铜浓度的降低而增大.     

The effects of leachate recirculation with supplemental water addition on methane production and waste decomposition in a simulated tropical landfill

In order to increase methane production efficiency, leachate recirculation is applied in landfills to increase moisture content and circulate organic matter back into the landfill cell. In the case of tropical landfills, where high temperature and evaporation occurs, leachate recirculation may not be enough to maintain the moisture content, therefore supplemental water addition into the cell is an option that could help stabilize moisture levels as well as stimulate biological activity. The objectives of this study were to determine the effects of leachate recirculation and supplemental water addition on municipal solid waste decomposition and methane production in three anaerobic digestion reactors. Anaerobic digestion with leachate recirculation and supplemental water addition showed the highest performance in terms of cumulative methane production and the stabilization period time required. It produced an accumulated methane production of 54.87 l/kg dry weight of MSW at an average rate of 0.58 l/kg dry weight/d and reached the stabilization phase on day 180. The leachate recirculation reactor provided 17.04 l/kg dry weight at a rate of 0.14l/kg dry weight/d and reached the stabilization phase on day 290. The control reactor provided 9.02 l/kg dry weight at a rate of 0.10 l/kg dry weight/d, and reached the stabilization phase on day 270. Increasing the organic loading rate (OLR) after the waste had reached the stabilization phase made it possible to increase the methane content of the gas, the methane production rate, and the COD removal. Comparison of the reactors' efficiencies at maximum OLR (5 kgCOD/m(3)/d) in terms of the methane production rate showed that the reactor using leachate recirculation with supplemental water addition still gave the highest performance (1.56 l/kg dry weight/d), whereas the leachate recirculation reactor and the control reactor provided 0.69 l/kg dry weight/d and 0.43 l/kg dry weight/d, respectively. However, when considering methane composition (average 63.09%) and COD removal (average 90.60%), slight differences were found among these three reactors.