燃煤流化床钙基脱硫剂对NO转变率的影响及机理

在φ150mm×1000mm流化床试验台上,温度区间840℃～960℃,研究了钙基脱硫剂品种、粒径和Ca/S比对NO转变率的影响.阐述了钙基脱硫剂使NO转变率增加机理试验发现,同等质量钙基脱硫剂使NO增加的次序为氧化钙、石灰石、方解石;Ca/S比越大,NO转变率越高;粒径为1～2mm时NO转变率最大,2～3mm时次之,0.2～1mm时最小.加入脱硫剂降低了HCl、HF、SO₂的浓度,导致O、H、HO₂浓度升高,CO的氧化反应加速,在床料、燃料灰催化作用下CO与NO的反应减慢,最终导致NO浓度升高.     

低温等离子体技术及其在柴油机排气处理中的应用

概述了等离子体特点及分类 ,介绍了低温等离子体的产生及其净化柴油机排气的应用进展 ,分析了低温等离子体技术有效处理柴油机排气的机理 ,阐述了未来低温等离子体处理柴油机排气的主要方向与应用前景。     

Effect of flue gas recirculation on nitric oxide (NO) emissions during the coal grate-fired process

Flue gas recirculation (FGR) is a low nitrogen oxide (NO_X) combustion technology. The present study used standard gas to simulate the cycle gas (the main ingredients of which are oxygen (O₂), nitrogen (N₂), and carbon dioxide (CO₂)). The coal grate-fired process was divided into three zones, namely (1) volatilization zone, (2) main combustion zone, and (3) char combustion and burn-out zone. The effects of FGR on coal combustion and NO emissions were investigated in these zones of a unit-boiler experimental system. An industrial test was then conducted on a chain boiler that previously used FGR. Data showed that if the cycle gas was directed into the furnace from the volatilization zone, the curve of the coal surface temperature moved backwards, the temperature peak increased, and coal ignition was delayed. When the FGR rate was 20%, NO emissions/g coal was 41.8% less than in the absence of FGR, in the overall combustion process except for the volatilization zone. An industrial test demonstrated that FGR decreased the NO emissions and incomplete-combustion loss of gas. NO and carbon monoxide (CO) emissions were reduced by 26.9 and 38%, respectively. These observations may prove to be beneficial in reducing ambient air pollution and saving energy.     

基于8—羟基喹啉与NO^—2—磺胺重氮盐的偶联反应示波极谱法测定NO^—2

研究了８－羟基喹啉与ＮＯ＾－２－碘胺重氮盐偶联反应的条件及其产物的极谱行为。二阶导数波高与ＮＯ＾－２的浓度在０．００２－０．２ｍｇ／Ｌ内呈良好的线性关系,回收率为９８％－１０３％,已用于环境水样中ＮＯ＾－２的测定。     

氧化镁基催化吸附剂的制备及脱硝性能研究

采用共混合法制备氧化镁基催化吸附剂,通过正交实验设计找出其组分的最佳配比.利用该催化吸附剂对烟气进行脱硝实验,考察了焙烧温度、焙烧时间和床层温度对氧化镁基催化吸附剂去除NO的影响.结果表明,利用氧化镁基催化吸附剂可以对烟气进行直接催化分解脱硝,其最佳的焙烧温度和时间分别为350～500 ℃和3～4 h,脱硝率可达85%～95%.利用红外光谱(FT-IR)、X射线衍射(XRD)对脱硝处理前后的氧化镁基催化吸附剂进行了分析,探讨其脱硝的机制.     

Characterization of metal doped-titanium dioxide and behaviors on photocatalytic oxidation of nitrogen oxides

A series of nanosized ion-doped TiO_2 catalysts with different ion content(between 0.1 at.% and 1.0 at.%) have been prepared by wet impregnation method and investigated with respect to their behavior for UV photocatalytic oxidation of nitric oxide.The catalytic activity was correlated with structural,electronic and surface examinations of the catalysts using X-ray diffraction analysis (XRD),ultraviolet-visible(UV-Vis)absorption spectroscopy,transmission electron microscopy(TEM),energy disperse spectrometer (EDS)and high resolution-transmission electron microscopy (HR-TEM) techniques.An enhancement of the photocatalytic activity was observed for Zn~(2 ) doping catalyst ranged from 0.1 at.% to 1.0 at.% which was attributed to the lengthened lifetime of electrons and holes.The improvement in photocatalytic activity could be also observed with the low doping concentration of Cr~(3 )(0.1 at.%). However,the doping of Fe~(3 ),Mo~(6 ),Mn~(2 ) and the high doping concentration of Cr~(3 ) had no contribution to photocatalytic activity of nitric oxide.     

Mn-Ce-Fe/TiO2低温催化还原NO的性能

采用浸渍法制备了Mn-Ce-Fe/TiO2.研究了其组分配比、焙烧温度等制备条件和NO进口浓度、空速、O2含量、NH3/NO摩尔比等操作条件对Mn-Ce-Fe/TiO2 NH3低温还原NO活性的影响,并探讨了H2O、SO2对Mn-Ce-Fe/Ti O2活性的影响.结果表明,Mn:Fe:Ce摩尔比为5:2:4、500℃下焙烧的Mn-Ce-Fe/TiO2在无H2O、SO2,NO体积分数为0.1%,空速为5000h～,反应温度为130℃、O2含量为6%、NH3/NO摩尔比为1.1的条件下,NO转化率接近98%,Fe的加入大大提高了催化剂的单独抗水和同时抗硫抗水性能,130℃下,体积分数10%的H2O对该催化剂的活性基本没有影响,转化率保持在96%以上;通硫、水后的400min内,活性仅下降3%.单独通人S02时,该催化剂中毒程度较深.该催化剂有望应用于基本不含SO2的燃气锅炉烟气和不含SO2的硝酸尾气等NO,工业废气的低温脱硝.     

成都市大气中O3污染水平及来源分析

根据2009年夏季成都市区大气中O3的监测结果,对大气中O3的浓度、分布进行了分析,并与2001年夏季成都市区的监测结果比较,分析臭氧污染水平的变化。结合同期NO2、VOCs监测结果,研究O3与两种前体物之间的相互关系。结果表明,近年来成都市区O3浓度呈上升趋势;O3浓度与NO2浓度变化趋势相反,表现为消耗NO2型光化学污染。     

臭氧生物活性炭工艺深度处理微污染原水

以广州东江水源为原水,研究了臭氧生物活性炭深度处理工艺对污染物的去除效果。结果表明:实验期间炭滤出水高锰酸盐指数、NH4+-N、NO2--N和浊度指标平均值分别为1.09mg/L、0.04mg/L、0.003mg/L和0.42ntu,平均去除率达65.34%、96.03%、98.24%和96.33%。所测项目相对于国家新颁布的《生活饮用水卫生标准》(5479-2006)达标率为100%。     

Mn-Ce/TiO2低温SCR催化剂成型过程添加剂的影响

催化剂成型过程中添加剂的种类和添加量对成型后催化剂的机械强度、成型效果和催化性能有很大影响.本文研究了Mn-Ce/TiO₂催化剂制备过程中添加剂对催化剂的低温脱硝性能和机械性能的影响.结果表明,添加10%的拟薄水铝石作为黏结剂,可使催化剂具有较强的机械强度;添加2.5%的活性炭作为造孔剂,可以有效改善催化剂的孔结构.催化剂成型后脱硝性能下降,反应温度为90℃和120℃时,催化剂的NO_x转化率分别下降了15%和30%左右,当温度到达150℃及以上时,催化剂成型前后的脱硝性能基本一致.最后,通过BET、FT-IR、NH₃-TPD和H₂-TPR表征分析原因：成型后催化剂比表面积和孔容下降,催化剂的表面酸性位点和氧化还原能力下降都会影响催化剂的脱硝性能,所以催化剂成型后低温活性变差.