NaOH预处理对杂交狼尾草厌氧发酵产沼气的影响

研究了Na OH预处理对杂交狼尾草厌氧消化制沼气的影响。采用质量分数分别为0%、2%、4%、6%和8%的Na OH溶液对杂交狼尾草进行碱预处理,在中温(35℃)、TS质量分数6%、接种率20%及初始p H为7.0条件下,进行厌氧发酵实验。对比了处理前后原料木质纤维素含量,探讨了不同浓度预处理对发酵过程沼气产量、甲烷浓度、p H以及产气速率的影响。结果表明,Na OH预处理有助于提高杂交狼尾草厌氧发酵的产气量和产气速率,其中4%Na OH预处理为较优条件。经4%Na OH溶液常温浸润24 h后,杂交狼尾草木质素降解率最大,比未处理实验组提高了31.2%;厌氧发酵总产气量比未处理实验组提高了31.6%。     

KMnO_4氧化复合NaOH液相吸收同时脱硫脱硝的实验研究

利用鼓泡吸收装置研究了KMnO_4/NaOH氧化吸收NO和SO_2过程,得出以下结论:同时脱硫脱硝时的脱硝效果要好于单独脱硝,但脱硫效果相差相当;KMnO_4和NaOH初始浓度的增加都能促进NO_x的脱除,但KMnO_4的促进作用更加明显;较低浓度SO_2的加入可促进NO_x脱除,然而过高浓度的SO_2会抑制NO_x的脱除。KMnO_4/NaOH同时脱硫脱硝可使脱硝率达70%左右,且脱硫率达98%以上,总体上效果理想。     

Preparation and characterization of activated carbon from a new raw lignocellulosic material: Flamboyant (Delonix regia) pods

Activated carbons were prepared from flamboyant pods by NaOH activation at three different NaOH:char ratios: 1:1 (AC-1), 2:1 (AC-2), and 3:1 (AC-3). The properties of these carbons, including BET surface area, pore volume, pore size distribution, and pore diameter, were characterized from N₂ adsorption isotherms. The activated carbons obtained were essentially microporous and had BET surface area ranging from 303 to 2463 m² g⁻¹.¹³C (CP/MAS and MAS) solid-state NMR shows that the lignocellulosic structures were completely transformed into a polycyclic material after activation process, thermogravimetry shows a high thermal resistance, Boehm titration and Fourier-transform infrared spectroscopy allowed characterizing the presence of functional groups on the surface of activated carbons. Scanning electron microscopy images showed a high pore development. The experimental results indicated the potential use of flamboyant pods as a precursor material in the preparation of activated carbon.     

含锌铅废物碱法浸出工艺

各种工业过程中产生的大量含锌铅废物中含有大量的有毒重金属.必须在危险废物处置场所进行处置,这导致处置成本增加.采用强碱浸出的方法回收含锌铅废物中的Zn和Pb,考察了浸出温度、NaOH浓度、液固比(浸提液体积/原料质量)和搅拌速率等工艺参数对Zn、Pb和杂质金属浸出率的影响,得出其最佳工艺条件.在温度为70℃、液固比为13:1、搅拌速率为800r/min条件下.用5 mol/L的NaOH浸出含锌铅废物,浸出液中Zn和Pb的质量浓度分别达33.47、11.21 g/L,浸出率分别达到94.24%和93.47%.     

Impacts of sodium hydroxide and sodium hypochlorite aging on polyvinylidene fluoride membranes fabricated with different methods

This study compared the effects of chemical aging on the polyvinylidene fluoride(PVDF)membranes fabricated with the methods of non-solvent induced phase separation(NIPS)(named NIPS-PVDF) and thermally induced phase separation(TIPS)(named TIPS-PVDF). The chemical solutions of sodium hypochlorite(NaClO) and sodium hydroxide(NaOH) were chosen at the concentration of 5000 mg/L. The equivalence of 5 and 10 years was respectively selected as the time of aging. The physicochemical evolutions of membrane aging are characterized on the base of morphology analysis, chemical components, permeation ability and mechanical properties. The aging of NIPS-PVDF membrane led to the elimination of surface hydrophilic additives, while NaO H focused on the dehydrofluorination process resulting in the formation of conjugated chains of polyene on the skeleton structure. The chemical components of the surface of TIPS-PVDF membrane were removed continuously during the aging processes of both NaClO and NaOH, which was caused by the saponification of surface additives and the chain scissions of skeleton structure, but without producing any obvious conjugated chains of polyene. All the aging processes led to the increase of contact angle and the decrease of mechanical properties, and the permeability was reduced first and increased later due to the enlargement of surface membrane pores and membrane block. With the influence of membrane aging, selectivity of membrane was decreased(except coliform bacteria). At the beginning of filtration, the turbidity and particle count were at relatively high levels and declined with the filtration process.     

投加不同碱性药剂对管网铁释放的影响

针对不同水源切换可能使管网铁释放增加而引起黄水的问题,搭建了管网模拟中试系统,比较了投加3种不同碱性药剂对管网铁释放的影响. 结果表明:①投加NaHCO₃调节进水碱度,当进水碱度为94~251 mg/L(以CaCO₃计)时,增加进水碱度能够有效抑制管网系统的铁释放,并且出水中ρ(TFe)(TFe为总铁)达到GB 5749—2006《生活饮用水卫生标准》(<30 mg/L). ②pH为7.83~9.01时,采用投加NaOH调节进水pH对管网铁释放无明显抑制作用甚至有所促进;而投加Ca(OH)₂调节进水pH虽然能够在一定程度上抑制管网铁释放,但抑制效果有限,不能保证出水中ρ(TFe)达标. ③当进水中ρ(SO₄2-)较低时,试验后期停止投加NaHCO₃或Ca(OH)₂后,管网系统铁释放能够维持在较低水平;但当进水中ρ(SO₄2-)较高时,停止投加NaHCO₃或Ca(OH)₂后,管网铁的释放又会明显升高.      

An experimental study for H2S and CO2 removal via caustic scrubbing system

In this study, removal of hydrogen sulfide (H₂S) and carbon dioxide (CO₂) from simulated syngas has been studied on one column scrubbing system. Gas flow rate as a measure of gas residence time and superficial gas velocity, gas composition, inlet H₂S load, flow modes (countercurrent and cocurrent) and packing geometry were the parameters in the design and/or operation of an acid gas scrubber system. Better H₂S scrubbing efficiencies have been obtained in countercurrent flow mode than that of cocurrent flow mode. When accordingly designed, static mixer with its superior performance on H₂S removal overweighed to structured packings. The coexistence of CO₂ and H₂S has been shown to increase the sodium hydroxide (NaOH) consumption along the scrubber column thereby decreasing the H₂S removal efficiency at higher H₂S loads. The gas residence time as changing with the gas velocity was found to be more dominant on acid gas removal efficiency than the effect of superficial gas velocity within the experimented range. A gas residence times of equal or above 3 s were seemed to be closer to the optimum point.     

水中~（14）C取样与测量方法的实验研究

目前由于日本福岛核电事故,全世界高度关注核污染,14C作为影响人体健康8个主要放射性核素之一,在核电站的运行过程中随流出物大量排入周围的环境中,因此也受到人们的关注。作者在前人工作的基础上设计了一种采样及测定水中14C的分析方法,并确定出了该方法对水中碳取样效率、NaOH溶液对CO2捕集效率、CaCO3沉淀制备效率、液闪对Ca14CO3的探测效率等的最优化条件。实际测得探测下限为0.12 mBq/L。     

Evaluation of leaching characteristic and kinetic study of lithium from lithium aluminum silicate glass-ceramics by NaOH

The behavior and mechanism of Li leaching from lithium aluminum silicate glass-ceramics which can be used as a secondary source of Li using aqueous NaOH solution was investigated. The Li leaching efficiency is increased with increasing concentration of NaOH, specific surface area, and reaction temperature. When leached under optimum conditions, 2 mol/L NaOH, 53 μm particle undersize, 1:10 solid/liquid ratio, 250 r/min stirring speed, 100°C reaction temperature, 12 hr, the Li leaching efficiency was approximately 70%. However, when the leaching experiment was performed for 48 hr, the concentration of Li⁺ ions contained in the leach liquor decreased from 1160 to 236 mg/L. To investigate the origin of this phenomenon, the obtained leach residue was analyzed by X-ray diffraction, scanning electron microscopy, and energy-dispersive X-ray spectroscopy. These analyses show that zeolite was formed around the lithium aluminum silicate glass-ceramics, which affected the leaching of by adsorbing Li⁺ ions. In addition, using the shrinking-core model and the Arrhenius equation, the leaching reaction with NaOH was found to depends on the chemical reaction of the two reactants, with a higher than 41.84 kJ/mol of the activation energy.     

Pyrolysis of low-density polyethylene using synthetic catalysts produced from fly ash

Catalytic pyrolysis of low-density polyethylene (LDPE) was investigated using various fly ash-derived silica–alumina catalysts (FSAs). FSAs were prepared by a simple activation method that basically includes NaOH treatment of fly ash by a fusion method, followed by an aging process. A series of LDPE pyrolysis experiments was conducted and the catalytic performance of FSAs was assessed in terms of the degradation temperature and the simulated boiling point distribution of the liquid products. The effects of synthesis conditions such as NaOH/fly ash weight ratio and aging time were examined by X-ray diffractometer (XRD), Brunauer-Emmett-Teller (BET) surface area analyzer, and scanning electron microscope to clarify the controlling factors affecting the catalytic activity. To obtain catalyst with high activity, it is necessary to produce sufficient silica and alumina species that can be easily co-precipitated into solid acid catalyst by destruction of the fly ash structure and to optimize the activation time for catalyst synthesis to prevent the transformation into inactive phases. The catalytic performance of FSA obtained from optimal conditions was equivalent to that of commercial catalysts, demonstrating the effectiveness of the catalyst.