负载TiO2浮石对污水处理厂二沉池出水的矿化与灭菌研究

城市污水处理厂第二沉淀池出水的污染物浓度较低,经过矿化及灭菌等深度处理后可以回用,从而减轻对淡水资源的需求。本实验采用溶胶-凝胶法制备了负载TiO2的浮石光催化剂,对城市污水处理厂第二沉淀池出水进行了矿化及灭菌处理研究。采用低压汞灯对处理水样照射2h,有机物降解率可以达到50％,灭菌效率达到100％。处理后的水可以作为农作物灌溉、城市绿化和娱乐用水。负载在浮石表面的TiO2薄膜经过10次的光催化循环实验后,没有明显破损,可以再次循环使用。TiO2浮石具有质轻、机械性能好和价格低等优点,该方法处理废水的适用浓度低,可以广泛应用于微污染水和城市污水处理厂出水的深度处理。     

碱激发胶凝材料及其固化Pb^2＋的试验研究

对碱激胶凝材料（碱-偏高岭土、碱-矿渣和碱-粉煤灰）与水-水泥体系固化Ph^2＋进行了试验研究,其中水-水泥体系为对比样。结果表明：对于相同稠度的碱激发胶凝材料,即使Pb^2＋含量达到2．4％,除了碱-粉煤灰的抗压强度略低外,其他都达到30MPa以上,满足填埋或做建筑基材的使用要求;与水泥相比,碱激发胶凝材料能显著降低重金属离子（Ph^2＋）浸出浓度,其规律性与其NH4交换容量大小的规律性一致,与其固化体的抗压强度的大小没有相关性。     

用H2O2/Fe^3＋处理高浓度含甲醛废水的研究

研究采用H2O2/Fe^3＋催化氧化处理高浓度含甲醛废水,探讨了双氧水和催化剂投加量、反应pH及反应温度等操作条件对处理效果的影响,并通过酸溶解回用失活催化剂。结果表明,较优的操作条件为：H2O2/COD（质量比）=2.2～2.6,Fe^3＋/H2O2（摩尔比）=0.048～0.058,反应pH1.80～2.68,反应温度50℃,反应时间40 min;在上述操作条件下,甲醛去除率达到99%以上,COD去除率达到85%以上。失活的催化剂可通过稀酸溶解后循环使用,其效果与三价铁盐作催化剂的基本相同。采用H2O2/Fe^3＋处理含甲醛废水具有比采用H2O2/Fe^2＋较优的效果。     

Structure and thermal stability of toxic chromium(VI) species doped onto TiO2 powders through heat treatment

Chromium(VI)-containing sorbents in the form of sludge or solid residue from treatment processes are often landfilled or used as fill materials, therefore the long-term stability of metal binding is important. The reduction of Cr(VI)–Cr(III) through heat treatment may be a useful detoxification method. After heating at 500, 900, 1000, and 1100 °C for 4 h, the transformation of chemical states of chromium on 105 °C-dried, 7.9% Cr(VI)-doped TiO₂ powders was studied on the basis of surface area measurements, scanning electron microscopy (SEM) images, X-ray diffraction (XRD), and extended X-ray absorption fine structure (EXAFS) spectra. It was shown that Cr(VI) was reduced to Cr(III) in the Cr(VI)-doped samples after heating within 500–900 °C. The present results also suggested that the chromium octahedral was bridged to the titanium tetrahedral and was incorporated in TiO₂ minerals formed after 1000 °C treatment.     

负载型TiO2薄膜光催化剂降解亚甲基蓝

采用溶胶-凝胶法制备了玻璃负载的TiO2薄膜光催化剂,研究了该催化剂对亚甲基蓝溶液的光催化降解,考察了反应时间、水样的初始浓度、溶液的pH等对光催化降解效果的影响。     

固定化真菌漆酶对分散兰-2BLN的脱色和降解

采用改良壳聚糖固定化的真菌漆酶对染料分散兰-2BLN进行脱色和降解条件的研究,探索了固定化漆酶活力、处理时间、染料浓度、温度和pH对其降解效果的影响。结果表明,固定化漆酶脱色降解分散兰-2BLN的适宜条件为：固定化漆酶活力18.2U／mL,染料浓度100mg／L,温度40℃,pH4.6,在上述条件下降解1.5h,分散兰-2BLN脱色率能达到87.68％。重复分批使用固定化漆酶处理2BLN兰,在使用6批次后,脱色率仍能保持在55％以上,其催化效率得到了较大提高。     

HPA／ZnFe2O4-TiO2光催化剂的制备及对马拉硫磷的可见光降解

以纳米TiO2载体,利用浸渍法制备了HPA／ZnFe2O4-TiO2光催化剂。对制备的催化剂进行了XRD、BET、TEM和UV-vis DRS表征。结果表明,催化剂样品均为锐钛矿相且ZnFe2O4很好地分散在载体表面,HPA／ZnFe2O4-TiO2光催化荆的平均粒径为10nm且在380-670nm均有强的光响应;反应最佳的HPA浓度为O.08molfL,最佳的ZnFe2O4负载量为1％。考察了HPA溶液初始浓度、ZnFe2O4负载量、溶液初始pH值、H2O2用量、催化剂用量对催化剂活性的影响。在溶液初始pH=13,H2O2=6mmol／L,催化剂用量为2g/L的最优条件下,光照反应进行100min后,马拉硫磷的降解率可达87％;重复4次后马拉硫磷的降解率仍可以达到67％。     

Gas/particle partitioning of atmospheric PCDD/Fs in a satellite town in Eastern China

Gas/particle partitioning of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) in ambient air was investigated in a satellite town in Eastern China from April 2007 to January 2008 comprehending large temperature variations (from 3 to 34 °C, daily average). Molecular weight, molecular structure and ambient temperatures are the three major factors that govern the gas/particle partitioning of atmospheric PCDD/Fs throughout the year. Generally, good agreements were obtained (except for winter) between measured particulate fractions and theoretical estimates of both the Junge–Pankow adsorption model and Harner Bidleman absorption model using different sets of subcooled liquid vapor pressure and octanol–air partition coefficient (K_oa), respectively. Models utilizing estimates, derived from gas chromatographic retention indices (GC-RIs), are more accurate than that of entropy-based. Moreover, during winter, the K_oa-based model using the GC-RIs approach performs better on lower chlorinated PCDD/Fs than that of -based. Furthermore, possible sources of mismatch between measured and predicted values in winter (3–7 °C) were discussed. Gas adsorption artifact was demonstrated to be of minor importance for the phenomena observed. On the other hand, large deviations of slopes (m_r) and intercepts (b_r) in logK_p vs. plots from theoretical values are observed in the literature data and these are found to be linearly correlated with ambient temperatures (P<0.001) in this study. This indicates that the non-equilibrium partitioning of PCDD/Fs in winter may be significantly influenced by the colder temperatures that may have slowed down the exchange between gaseous and particulate fractions.     

Influence of titanium dioxide nanoparticles on speciation and bioavailability of arsenite

In this study, the influence of the co-existence of TiO₂ nanoparticles on the speciation of arsenite [As(III)] was studied by observing its adsorption and valence changing. Moreover, the influence of TiO₂ nanoparticles on the bioavailability of As(III) was examined by bioaccumulation test using carp (Cyprinus carpio). The results showed that TiO₂ nanoparticles have a significant adsorption capacity for As (III). Equilibrium was established within 30 min, with about 30% of the initial As (III) being adsorbed onto TiO₂ nanoparticles. Most of aqueous As (III) was oxidized to As(V) in the presence of TiO₂ nanoparticles under sunlight. The carp accumulated considerably more As in the presence of TiO₂ nanoparticles than in the absence of TiO₂ nanoparticles, and after 25-day exposure, As concentration in carp increased by 44%. Accumulation of As in viscera, gills and muscle of the carp was significantly enhanced by the presence of TiO₂ nanoparticles.     

CO_2 Emission Induced by Urban Household Consumption in China

Household consumption is one of the important factors that induce COL emission. Based on input-output model, this article calculated the intensity of CO2 emission of different income groups and seven provinces in China, and then estimated total CO2 emission induced by urban household consumption from 1995 to 2004 in China based on statistic data of household living expenditure. The results show that CO2 emission per capita induced by household consumption had increased from 1583 to 2498 kg CO2 during 1995-2004. The ratio of consumption-induced CO2 emission to total CO2 emission had risen from 19% to 30% in the past decade. Indirect CO2 emission accounted for an important part of the consumption-induced emission, the ratio of indirect emission to consumption-induced emission had risen from 69% to 79% during the same period. A significant difference in consumption-induced CO2 emission across different income groups and different regions has been observed. COs emission per capita of higher income groups and developed regions increased faster than that of lower income groups and developing regions. Changing lifestyle has driven significant increase in CO2 emission. Especially, increases in private transport expenditure （for example, vehicle expenditure） and house building expenditure are key driving factors of growth in consumption-induced COL emission. There are big differences in the amount of CO2 emission induced by change in lifestyle across different income groups and provinces. It can be expected that lower income households and developing regions will increase consumption to improve their livings with income growth in the future, which may induce much more CO2 emission. A reasonable level of CO2 emission is necessary to satisfy human needs and to improve living standard, but a noticeable fact is that CO2 emission per capita induced by household consumption in developed areas of China had reached a quite high level. Adjustment in lifestyle towards a low-carbon society is in urgent need.