太原市大气扩散示踪试验

太原市位于山西中部,东、西两山夹峙,汾河南北中贯,地形北部较高,南部开放,西部有一缺口,是一个封闭不完全的盆地。风速较小,1971—1980年平均风速为2.5m/s,静风频率为24％。在无系统天气过境时,近地层气象十分复杂,城南和城北、河东和河西的地面风往往不同。 近年来,太原市大气污染日趋严重,我们于1985年10—11月在太原地区进行了大气扩散示踪试验,以期能对该地区大气污染物的输送和扩散有所了解。     

负载型TiO2固定相光催化氧化法降解水中呋码唑酮

以高压汞灯为光源、负载在海砂上的ＴｉＯ２为催化剂，采用敞口固定床型光催化反应器对水中难降解的呋码唑酮（ＦＴＤ）进行了固定相光催化氧化实验。结果表明，反应速率可用ＬａｎｇｍｕｉｒＨｉｎｓｈｅｌｗｏｏｄ方程描述，与光分解相比，光催化氧化的突出优点是矿化程度高，相同光辐射条件下反应１００ｍｉｎ，０．１０ｍｍｏｌ／Ｌ的ＦＴＤ水溶液经光催化氧化后ＴＯＣ的去除率为８９．１％，而经光分解后ＴＯＣ的去除率仅为２８．８％；在反应体系中投加少量臭氧或过氧化氢可以显著提高ＦＴＤ的氧化效率，说明光催化氧化可以兼容Ｏ３／ＵＶ、Ｈ２Ｏ２／ＵＶ等光激发氧化工艺。制得的负载型ＴｉＯ２具有较高的机械强度和化学稳定性，可重复利用。探讨了充氧、ＦＴＤ浓度及ｐＨ值等对光催化氧化过程的影响。     

西安地区土壤CO2 释放量和释放规律

根据碱溶液吸收法,对西安地区不同植被条件下土壤CO2释放量进行了昼夜观测,观测资料显示,西安地区各月份土壤CO2释放量在一昼夜内具有明显的变化,从当日上午到次日上午,CO2释放量表现出由低变高再变低的规律,土壤CO2释放量变化与温度变化具有相同的特征,但释放量的变化具有滞后性,相对于温度的变化滞后4－6h左右,温度是决定土壤CO2释放量昼夜变化规律的主要因素,它的升高和降低分别造成了土壤CO2和放量的增加和减少,不同植被条件下,土壤CO2释放量不同,林地释放量大于草地,草地释放量大于裸地,夜间12h释放量大于白天12h释放量。     

Preparation and characterization of visible-light-active nitrogen-doped TiO2 photocatalyst

A visible-light photocatalyst was prepared by calcination of the hydrolysis product of Ti(SO4)2 with ammonia as precipitator. The color of this photocatalyst was vivid yellow. It could absorb light under 550 nm wavelength. The crystal structure of anatase was characterized by XRD. The structure analysis result of X-ray fluorescence(XRF) shows that doped-nitrogen was presented in the sample. The photocatalytic activities were evaluated using methyl orange and phenol as model pollutants. The photocatalytic activities of samples were increasing gradually with calcination temperature from 400℃ to 700℃ under UV irradiation. It can be seen that the degradation of methyl orange follows zero-order kinetics. However, the calcination temperatures have no significant influence on the degradation of phenol under sunlight. The N-doped catalyst shows higher activity than the bare one under solar irradiation.     

云南省酸雨控制区二氧化硫污染现状及综合防治措施

能源结构的特点,使酸雨控制区的二氧化硫排放量高居不下,"西电东送"将进一步增加酸雨控制区的二氧化硫排放量.必须采取严格的、切实有效的综合防治措施削减二氧化硫排放量,确保"十五"期间酸雨控制区总目标的实现.     

膨胀珍珠岩负载TiO2光催化脱色性能的研究

以钛酸四丁酯为原料 ,膨胀珍珠岩为载体 ,用溶胶 -凝胶法制备可漂浮于水面的负载型TiO2 。利用该负载型TiO2 对罗丹明B(RB)进行光催化脱色实验 ,结果表明 ,浸渍 3次的负载型TiO2 光催化活性最高 ,催化剂最佳用量为 5 0 0mg/10 0mLRB ,经 5h光照 ,对 10 0mL浓度为 1mg/L和 2 .5mg/LRB脱色率分别为 76 .6 7%和 4 7.2 7% ;该催化剂使用寿命长 ,2 5h后催化剂脱色性能没有减弱 ,可重复使用 ;经 8h光照 ,染料废水脱色效果好。     

Euglena gracilis as a model for the study of Cu and Zn toxicity and accumulation in eukaryotic cells

We have observed the effect of copper and zinc on the biology of Euglena gracilis. The cells displayed different sensitivities to these metals, as the apparent LC₅₀ for Cu²⁺ was 0.22 mM, and for Zn²⁺ it was 0.88 mM. While Zn²⁺ was able to increase cell proliferation even at 0.1 mM, the minimal CuCl₂ concentration tested (0.02 mM) was sufficient to impair cell division. Higher concentrations of these metals not only inhibited cell division in a concentration-dependent manner, but also interfered with the metabolism of E. gracilis. A higher accumulation of proteins and lipids per cell was observed at the DI₅₀ concentration for metal-treated cells. These results suggest that the test concentration of both metals leads to a failure in completing cell division. Ultrastructural analysis indicated a chloroplast disorganization in copper-treated cells, as well as the presence of electron dense granules with different shapes and sizes inside vacuoles. Microanalysis of these granules indicated an accumulation of copper, thus suggesting a detoxification role played by the vacuoles. These results indicate that E. gracilis is an efficient biological model for the study of metal poisoning in eukaryotic cells. They also indicate that copper and zinc (copper being more poisonous) had an overall toxic effect on E. gracilis and that part of the effect can be ascribed to defects in the structure of chloroplast membranes.     

Two-site kinetic modeling of bacteriophages transport through columns of saturated dune sand

Breakthrough curves, on a semi-log scale, from tests in porous media with block-input of viruses, bacteria, protozoa and colloidal particles often exhibit a typical skewness: a rather slowly rising limb and a smooth transition of a declining limb to a very long tail. One-site kinetic models fail to fit the rising and declining limbs together with the tail satisfactorily. Inclusion of an equilibrium adsorption site does not seem to improve simulation results. This was encountered in the simulation of breakthrough curves from a recent field study on the removal of bacteriophages MS2 and PRD1 by passage through dune sand. In the present study, results of laboratory experiments for the study of this issue are presented. Breakthrough curves of salt and bacteriophages MS2, PRDI, and phiX174 in 1 D column experiments have been measured. One- and two-site kinetic models have been applied to fit and predict breakthrough curves from column experiments. The two-site model fitted all breakthrough curves very satisfactorily, accounting for the skewness of the rising limb as well as for the smooth transition of the declining limb to the tail of the breakthrough curve. The one-site model does not follow the curvature of the breakthrough tail, leading to an overestimation of the inactivation rate coefficient for attached viruses. Interaction with kinetic site 1 is characterized by relatively fast attachment and slow detachment, whereas attachment to and detachment from kinetic site 2 is fast. Inactivation of viruses and interaction with kinetic site 2 provide only a minor contribution to removal. Virus removal is mainly determined by the attachment to site 1. Bacteriophage phiX174 attached more than MS2 and PRD1, which can be explained by the greater electrostatic repulsion that MS2 and PRD1 experience compared to the less negatively charged phiX174.     

附载型复合光催化剂TiO2·SiO2/beads降解有机磷农药

研究以四异丙醇钛 [Ti( iso- O C3 H7) 4]、硅酸乙酯为原料 ,以空心玻璃微球为载体 ,用溶胶—凝胶法制备可漂浮附载型复合光催化剂 Ti O2 · Si O2 / beads的过程 ,利用附载型复合光催化剂降解有机磷农药。结果表明 ,复合型光催化剂 Ti O2 · Si O2 摩尔比存在最佳值 ,n ( Ti O2 ) / m ( Si O2 ) =30 / 70时 ,光催化剂活性最高 ,其活性是同样降解条件下、同样含量 Degussa P- 2 5Ti O2 的 2倍左右。该光催化剂比表面大 ,吸附性强。并用 XRD和 SEM对附载型复合光催化剂进行表征     

Untersuchungskonzept zur Charakterisierung toxischer Stoffe in belastetem Wasser

Zusammenfassung  Zur ?kotoxikologischen Beurteilung von belastetem Wasser werden h?ufig einfache Biotests eingesetzt. Nicht selten werden dabei toxische Effekte festgestellt. Es stellt sich dann die Frage nach den verantwortlichen Wasserinhalts-stoffen. Durch Festphasenextraktion (SPE) werden diese angereichert, gewonnen und dünnschichtchromatographisch unter Verwendung der automatisierten Mehrfachentwicklung aufgetrennt. Von der DC-Platte wird ein Streifen abgetrennt und darauf direkt die biologische Detektion mit Mikroorganismen (Bacillus subtilis, Leuchtbakterien) durchgeführt. Dadurch k?nnen toxische Banden erkannt werden, Auf dem DC-Plattenrest wird von der toxischen Bande mit einem DC-scanner ein UV-Spektrum aufgenommen, die entsprechende Bande herausgekratzt, der toxische Stoff eluiert und infrarotspektroskopisch untersucht. Durch Spektrenvergleich gelingt es meistens, den Stoff zu charakterisieren. In der vorliegenden Arbeit wird am Beispiel eines Zitzengummieluates das Analysenkonzept vorgestelit. Es zeigte sich, dass dieser Gummiartikel einen Vulkanisationsbeschleuniger (2-Mercaptobenzothiazol) freisetzt. Online-Publikation am: 21.12.1999