Cu／A1-Ce-PILC在丙烯选择性催化还原NO反应中的失活研究

采用聚合羟基复合阳离子合成交联黏土A1-Ce-PILC，经SO4^2-改性后，以浸渍法制备了铜基交联黏土催化剂Cu／A1-Ce-PILC，并将其应用于C3H6选择性催化还原NO的反应，350℃时NO转化率达到最大值56％，700℃时下降至22％．为探究催化剂高温失活的原因，采用XPS、TPR、TGA、Py-IR和DSC对反应前后催化剂的物化性能进行了表征．结果表明，经过H2预处理活化后活性组分Cu物种以Cu^＋形式存在，而高温反应后Cu物种除以Cu^＋和Cu^2＋ 2种形式存在外，还出现了少量CuO物种；高温反应过程中A1-Ce-PILC上结构羟基和SO4^2-流失导致催化剂表面酸性减弱；此外，还存在表面积炭覆盖了部分活性中心并堵塞了催化剂孔道的现象．这三者的共同影响促进了C3H6深度氧化，抑制了NO还原，从而导致催化剂的失活．     

烟束曲霉菌丝球对Cr(Ⅵ)的去除-还原与吸附作用

采用投加烟束曲霉(Aspergillus fumisynnematus)菌丝球的方法去除含铬废水中的Cr(Ⅵ),通过研究模拟含铬废水中Cr(Ⅵ)与总Cr浓度及pH值的变化规律来确定烟束曲霉菌丝球对Cr(Ⅵ)的去除作用.结果表明,烟束曲霉菌丝球对Cr(Ⅵ)的去除作用包括还原与吸附,以还原作用为主,兼有一定程度的吸附.适宜条件(30℃,150 r·min-1,pH=1.30,投加量10.0 g)下菌丝球能在48 h内将100 mL浓度为10～200 mg·L-1Cr(Ⅵ)溶液中的Cr(Ⅵ)全部去除,其中对总Cr的吸附率为30%～50%,对Cr(Ⅵ)的还原率则达到了99%以上,吸附平衡后解吸出来的Cr的形态95%以上为Cr(Ⅲ).考察了溶液初始pH值、Cr(Ⅵ)初始浓度、菌丝球投加量及温度对菌丝球去除Cr(Ⅵ)作用的影响.结果表明,菌丝球只有在低pH值时才能达到对Cr(Ⅵ)较好的去除效果.溶液初始pH值及Cr(Ⅵ)初始浓度的降低、菌丝球投加量及温度的升高均能提高菌丝球对Cr(Ⅵ)的去除率,溶液初始pH值的降低及菌丝球投加量的增加均可提高菌丝球对总Cr的吸附率,温度则主要通过改变菌丝球的结构形态来影响菌丝球对总Cr的吸附作用.菌丝球对Cr(Ⅵ)及Cr(Ⅲ)均存在吸附作用,吸附在菌丝球上的Cr(Ⅵ)在酸性环境下易被还原成Cr(Ⅲ).     

兰州市城市生活垃圾处理研究

城市生活垃圾是指在城市日常生活中或者为城市日常生活提供服务的活动中产生的固体废物以及法律、行政规定视为城市生活垃圾的固体废弃物.随着中国城市化进程的加快和人民生活水平的提高,城市生活垃圾也在以每年8%～10%的速度增长,若垃圾问题得不到妥善解决,就会制约兰州市的发展.在对兰州市城市生活垃圾处理现状及存在问题分析的基础上,根据兰州市生活垃圾的特性,提出兰州市城市生活垃圾的处理办法:兰州市城市生活垃圾应当推行分类收集制度,由目前单一的卫生填埋处理走向资源化综合处理.     

Risk reduction concept to provide design criteria for Emergency Systems for onshore LNG plants

The functional safety requirement is widely applied in the process plant industry in accordance with the international standards, such as IEC and ISA. The requirement is defined as safety integrity level (SIL) based on the risk reduction concept for protection layers, from original process risk to tolerable risk level. Although the standards specify both, the Prevention System and the Emergency System, as level of protection layers, the standards specify in detail only the use of the Prevention System (i.e., Safety Instrumented System (SIS)). The safety integrity level is not commonly allocated to the Emergency System (e.g., Fire and Gas System, Emergency Shutdown System and Emergency Depressuring System). This is because the required risk reduction can be normally achieved by only the Prevention System (i.e., SIS and Pressure Safety Valve (PSV)). Further, the risk reduction level for the Emergency System is very difficult to be quantified by the actual SIL application (i.e., evaluated based on the single accident scenario, such as an accident from process control deviation), since the escalation scenarios after Loss of Containment (LOC) greatly vary depending on the plant design and equipment. Consequently, there are no clear criteria for evaluating the Emergency System design. This paper aims to provide the functional safety requirement (i.e., required risk reduction level based on IEC 61508 and 61511) as design criteria for the Emergency System.In order to provide clear criteria for the Emergency System evaluation, a risk reduction concept integrated with public’s perception of acceptable risk criteria is proposed and is applied to identify the required safety integrity level for the Emergency System design. Further, to verify the safety integrity levels for the Emergency Systems, the probabilistic model of the Emergency Systems was established considering each Emergency System (e.g., Fire and Gas System, Emergency Shutdown System and Emergency Depressuring System) relation as the Overall Emergency System. This is because the Overall Emergency System can achieve its goal by the combined action of each individual system, including inherent safe design, such as separation distance.The proposed approach applicability was verified by conducting a case study using actual onshore Liquefied Natural Gas Plant data. Further, the design criteria for Emergency Systems for LNG plants are also evaluated by sensitivity analysis.     

不同酶强化污泥为燃料微生物燃料电池特性对比分析

采用单室无膜悬浮阴极微生物燃料电池(MFC),对比分析了蛋白酶和淀粉酶强化剩余污泥为燃料的MFC(ESMFC)产电特性、酶特性和污泥减量化效果。研究表明,投加蛋白酶的ESMFC最大功率密度比对照组增加106.2%,投加淀粉酶时ESMFC最大功率密度比对照组增加48%。蛋白酶作用主要体现在投加后的前12小时,而淀粉酶作用时间则较长,为投加后的前144小时,但在运行前期,由于高温作用,导致系统内的酶活性较强,投加的淀粉酶作用则不明显。投加蛋白酶的系统内TCOD、TSS和VSS去除率分别为82%、65%和85%,而投加淀粉酶的系统内TCOD、TSS和VSS去除率分别达到86%、67%和88%。此研究对于ESMFC中外加酶的选择具有一定意义。     

燃煤烟气低温SCR脱硝中试研究

低温选择性催化还原(SCR)脱硝是国内外脱硝技术研发的热点,但目前主要集中在实验室小试范围,无法完全反映催化剂在实际烟气中的运行状况。在30 t/h循环流化床燃煤锅炉脱硫除尘装置后建设了2 000~5 000 m3/h的SCR脱硝中试装置,经系统研究发现,中试使用的蜂窝式催化剂对SO2和NO具有很强的吸附能力,且反应温度、喷氨速率和气体空速均会影响催化脱硝效率。为期5 d的连续运行实验结果表明,催化剂的脱硝效率一直稳定在30%~50%,并未发现明显的失活,这证明设计除雾除尘器、较大的混合器、混合器与反应器间较长的管路均有利于缓解催化剂因SO2、H2O和飞灰中的碱性金属导致的失活。     

Reduction of Baltic Sea Nutrient Inputs and Allocation of Abatement Costs Within the Baltic Sea Catchment

The Baltic Sea Action Plan (BSAP) requires tools to simulate effects and costs of various nutrient abatement strategies. Hierarchically connected databases and models of the entire catchment have been created to allow decision makers to view scenarios via the decision support system NEST. Increased intensity in agriculture in transient countries would result in increased nutrient loads to the Baltic Sea, particularly from Poland, the Baltic States, and Russia. Nutrient retentions are high, which means that the nutrient reduction goals of 135 000 tons N and 15 000 tons P, as formulated in the BSAP from 2007, correspond to a reduction in nutrient loadings to watersheds by 675 000 tons N and 158 000 tons P. A cost-minimization model was used to allocate nutrient reductions to measures and countries where the costs for reducing loads are low. The minimum annual cost to meet BSAP basin targets is estimated to 4.7 billion €.     

模拟垃圾填埋场稳定化过程研究

采用垃圾填埋堆体模拟装置，对杭州市城市生活垃圾在１９９８年２月至１９９８年１０月期间稳定化过程中的垃圾渗滤液水质指标变化、堆体内部温度变化、垃圾减量化、沉降高度和产气量进行了研究，装入模拟装置的２２１ｋｇ生活垃圾经８个月的降解后，垃圾减量化显著，总量降至１２７ｋｇ，其中有机组分由９４．８ｋｇ（４２．９％）降至２０．９３ｋｇ（１６．５％），无机组分由７２．７１ｋｇ（３２．９％）降至５３．６５ｋｇ（４     

微型生物与金属腐蚀的研究

主要研究了海洋微生物与金属腐蚀的相关性。通过调查、分析海洋微生物的性质,尤其是硫酸盐还原菌（ＳＲＢ）,用移植埋片法对海底沉积物中ＳＲＢ含量的分析,建立了ＳＲＢ含量与腐蚀率之间的表象关系,为海洋工程设计提供了重要数据。