直埋式光纤传感钻孔注浆耦合材料配合比试验研究

采用钻孔埋设传感光纤是岩土体分布式光纤传感直埋技术的一种,为使传感光纤与周围土体变形协调,通常在钻孔内注浆,使传感光纤与周围岩土介质凝固为一体。根据对浆液凝固时间无特定要求和有特定要求的2种情况,通过试验研究了钻孔注浆耦合材料、配合比及其凝固后强度。结果表明:通过调整水泥与膨润土的比例以及水固比可以控制凝固体的无侧限抗压强度,使其强度与原位岩土体的近似相同;添加适量的水玻璃可以加快浆液的凝固速度。针对石家庄某隧道原位土体的力学参数,得到了满足现场施工要求的最优配合比,使浆液凝固后的力学指标与原位土体的近似相同。     

碱激发电解锰渣制备水泥掺合料

电解锰渣是湿法冶炼金属锰的残渣,为降低其对环境的浸出毒性影响并提高其在水泥产品中的掺入量,利用碱激发技术处理电解锰渣制备水泥掺合料是一种可行的方法。主要研究了碱激发剂种类、掺量对电解锰渣的激发效果,并将碱激发电解锰渣用作水泥掺合料与水泥按不同比例混合研究对水泥抗压强度和浸出毒性的影响。结果表明：碱激发电解锰渣活性显著提高,NaOH中Na2O当量为10%时试件M-SH10的3、7、28 d抗压强度最高,分别为7.15、9.46、10.03 MPa;将此条件下激发的电解锰渣按质量比取15%与85%的水泥混合制得的掺合料其抗压强度较净水泥试件有一定程度的提高;浸出毒性结果显示Cd、Cr、Pb、Ni、Mn和Zn浓度均下降,且低于GB 8978-1996限值。     

稳定剂协同水泥固化/稳定化重金属污染土壤的工程特性

采用稳定剂（SR）协同水泥（PC）固化/稳定化重金属污染土壤,以Pb、Zn浸出毒性和药剂吨处理成本为综合指标确定PC和SR的最优配比,并对固化土体进行无侧限抗压强度、不固结不排水三轴压缩实验和柔性壁渗透实验,探讨固化土体强度以及渗透特性。结果表明,最优配比为SR掺量 2.5%,PC掺量8%;最优配比下固化土体中重金属铅锌的浸出浓度分别降低97.5%和74.5%,均低于固体危险废物浸出标准值。其养护28 d无侧限抗压强度达到1 080 kPa,比未固化土体对应值高9.6倍;随着PC掺量增加,固化体的有效黏聚力及有效内摩擦角均不断增大,其中最优配比固化土体有效黏聚力达到216.9 kPa,有效内摩擦角为34.8°。加入稳定剂SR使固化体渗透系数增大,但随着PC掺量增加,渗透系数急剧降低。其中最优配比固化土体渗透系数相对未固化复合污染土体降低一个数量级至10-6cm·s-1,可有效增强土体的防渗阻隔能力,提高稳定化土壤的安全利用率。     

Polycyclic aromatic hydrocarbons, black carbon, and molecular markers in soils of Switzerland

Polycyclic aromatic hydrocarbons (PAH) were analysed in 23 soil samples (0–10 cm layer) from the Swiss soil monitoring network (NABO) together with total organic carbon (TOC) and black carbon (BC) concentration, as well as some PAH source diagnostic ratios and molecular markers. The concentrations of the sum of 16 EPA priority PAHs ranged from 50 to 619 μg/kg dw. Concentrations increased from arable, permanent and pasture grassland, forest, to urban soils and were 21–89% lower than median numbers reported in the literature for similar Swiss and European soils. NABO soils contained BC in concentrations from 0.4 to 1.8 mg/g dw, except for two sites with markedly higher levels. These numbers corresponded to 1–6% of TOC and were comparable to the limited published BC data in soil and sediments obtained with comparable analytical methods. The various PAH ratios and molecular markers pointed to a domination of pyrogenically formed PAHs in Swiss soils. In concert, the gathered data suggest the following major findings: (1) gas phase PAHs (naphthalene to fluorene) were long-range transported, cold-condensated at higher altitudes, and approaching equilibrium with soil organic matter (OM); (2) (partially) particle-bound PAHs (phenanthrene to benzo[ghi]perylene) were mostly deposited regionally in urban areas, and not equilibrated with soil OM; (3) Diesel combustion appeared to be a major emission source of PAH and BC in urban areas; and (4) wood combustion might have contributed significantly to PAH burdens in some soils of remote/alpine (forest) sites.     

富里酸吸附TNT的环境影响因素

采用振荡平衡法对富里酸(FA)吸附TNT的主要环境影响因素以及其热力学特性进行了研究。结果表明:随着pH值的升高,FA对TNT的吸附量先减少后增加,pH=7.0时吸附量最小;随着离子强度(IS)的增大,FA对TNT的吸附量逐渐增加;随着温度的升高,FA对TNT的吸附量逐渐减少;ΔH0=-5.62 kJ/mol、ΔG0 S0 < 0,表明FA对TNT的吸附为自发的放热反应,且吸附过程中系统的无序性降低。FA对TNT的吸附机制主要包括范德华力、疏水作用、偶极作用力以及氢键力,并且范德华力和疏水作用会随着温度的升高逐渐减弱。     

氯气和光气爆燃事故源强估算

在建立化学品泄漏的气体排放、液体排放、两相排放模式和爆炸燃烧的火球和气爆，蒸气云爆炸及绝热扩散和池蒸发扩展等模式的基础上，估计分析了氯气和光气爆燃事故源强，即爆炸能量及碎片抛射、冲击波、热辐射和毒云等后果影响     

桂林市极端天气气候事件分析

桂林是以"甲天下"的山水美景而闻名的国际旅游城市,极端天气气候事件造成的灾害将给其社会经济的发展带来负面影响.本文采用桂林1951～2004年的资料,统计干旱、暴雨、高温和强对流天气等极端天气气候事件的出现频率、强度并分析其演变趋势.结果显示,近50年来,桂林市极端天气气候事件除暴雨、干旱强度增大外,频率变化呈平稳或减小趋势.     

不同混凝剂处理低温低浊水

针对低温低浊水处理难度大的问题进行了一系列的混凝实验,实验结果表明,随着混凝剂投加量的增加,剩余浊度呈现先降低后升高的趋势,单独使用HPAC时,剩余浊度在投加量为14 mg/L时达到最低(2.39 NTU)。pH值对余铝含量具有重要的影响,3种铝系混凝剂均在pH=7.0时余铝含量达到最低。AlCl3对水中有机物的去除率较其他3种混凝剂低。絮体形成与破碎受搅拌强度的影响很大,当破碎强度增加到50 r/min,使用PACl、HPAC、FeCl3作混凝剂时絮体粒径下降不明显,当破碎强度增加到100 r/min时,絮体粒径有明显的下降。破碎结束后,絮体粒径有所恢复,但是并不能增长到破碎前的粒径。PACl、HPAC以及FeCl3形成的絮体的沉降性较好,上覆水浊度下降较快,经过3 h的沉降后,剩余浊度分别达到1.82、1.44和0.97 NTU。     

Virus retention and transport through Al-oxide coated sand columns: effects of ionic strength and composition

Knowledge of the factors that influence the fate and transport of viruses in porous media is very important for accurately determining groundwater vulnerability and for developing protective regulations. In this study, six saturated sand column experiments were performed to examine the effects of a positively charged Al-oxide, which was coated on sand particles, on the retention and transport of viruses (phiX174 and MS-2) in background solutions of different ionic strength and composition. We found that the Al-oxide coating on sand significantly removed viruses during their transport in a phosphate buffered saline (PBS) solution. Mass balance calculations showed that 34% of the input MS-2 was inactivated/irreversibly sorbed on the surface of Al-oxide coated sand whereas 100% of phiX174 was recovered. Results from this study also indicated that higher ionic strength facilitated the transport of both phiX174 and MS-2 through the Al-oxide coated sand. This was attributed to the effect of ion shielding, which at higher ionic strength decreased the electrostatic attraction between the viral particles and the sand surface and consequently decreased virus sorption. Strong effect of the ionic strength indicates that an outer-sphere complexation mechanism was responsible for the virus sorption on the Al-oxide coated sand. Ion composition of the background solutions was also found to be a significant factor in influencing virus retention and transport. Virus transport was enhanced in the presence of phosphate (HPO(4)(2-)) as compared to bicarbonate (HCO(3)(-)), and the effect of HPO(4)(2-) was more significant on MS-2 than on phiX174. The presence of bivalent cations (Ca(2+) and Mg(2+)) increased virus transport because the cations partially screened the negative charges on the viruses therefore decreased the electrostatic attraction between the positively charged sand surface and the negatively charged viruses. Mass recovery data indicated that bivalent cations gave rise to a certain degree of inactivation/irreversibly sorption of phiX174 on the surface of Al-oxide coated sand. On the contrary, the bivalent cations appeared to have protected MS-2 from inactivation/irreversibly sorption. This study provides some insights into the mechanisms responsible for virus retention and transport in porous media.     

Leaching characteristics of bisphenol A from epoxy-resin pavement materials

We investigated the leaching characteristics of bisphenol A (BPA) from two kinds of epoxy-resin pavement materials, one containing epoxy resins (EPs) and the other containing epoxy-acrylate resins (EPAs). Both samples contained residual BPA monomer, at levels of 9.0?µg?g^?1 for the EP resin sample and 4.4?µg?g^?1 for the EPA resin sample. These amounts were larger than amounts previously measured for polycarbonate samples. The amount of BPA leached from the samples increased with temperature. The leaching of BPA from EP was more strongly affected by temperature than the leaching from EPA. The pH also affected the amount of leached BPA. The maximum leached amount was observed under alkaline conditions (pH 10.8) for both sample types. The amounts of BPA that might leach from pavement materials during 1?h of heavy rain were estimated to be 0.9?µg?m^?2 for EP and 3.5?µg?m^?2 for EPA. Our results indicate that EPs disposed of in waste landfills without any treatment may be a source of BPA in leachate at landfill sites.