重庆黔江区大气降水的化学特征及来源分析

通过2013年6月—2014年5月对黔江区大气降水的化学组成分析研究表明,降水样品的p H值分布范围在4.91~7.32之间;SO2-4是降水中主要的阴离子,占阴离子总量的68.9%,Ca2+是降水中含量较高的阳离子,占阳离子总量的41.4%;SO2-4/NO-3浓度比为6.78,表明降水类型为硫酸盐型。陆源性离子Ca2+、Mg2+以及海源性离子Na+和Cl-之间存在明显的相关关系。海水和土壤的富集系数表明,研究区域的SO2-4和NO-3主要归因于人为活动的影响。     

基于Ubiquitous-Joint模型的层状岩坡稳定性分析

在应力的作用下,层状岩土体表现出来的力学行为比较复杂,目前广泛使用的各向同性模型不再适用,因此,有必要建立合理描述层状岩质边坡的力学模型。以某公路边坡为工程背景,首先,探讨了层状岩质边坡的失稳机制;然后,利用快速拉格朗日差分法(FLAC3D),建立该边坡的数值分析模型,探讨了强度折减技术在U-biquitous-Joint模型中的实施方法,即对岩体和层理面参数同时进行折减,采用计算不收敛作为边坡临界失稳判据;最后,通过数值计算,分析层状岩质边坡稳定性的影响因素,得到边坡整体安全系数F随节理倾角β先减小后增大,呈现两头高中间低的形态。     

表面设置防火涂料高强混凝土柱的耐火极限

前期试验表明,表面设置厚度20 mm的某非膨胀型防火涂料可较好地抑制高强混凝土的高温爆裂.本文通过试验反算给出了该涂料对应不同温度区间的平均导温系数;随后,利用结构抗火分析软件SAFIR对表面设置该涂料的高强混凝土柱的耐火极限进行了计算分析,考察了截面尺寸、轴压比、荷载偏心率及配筋率等因素的影响,在此基础上提出了相应的...     

基于因子分析和BP神经网络的滑坡抗剪强度参数取值

滑坡抗剪强度参数取值是一直困扰滑坡防治工程设计的一大难题,目前其研究方法主要有试验法、反分析和统计分析法,但都没有考虑其他基本物理力学参数的影响。为此,提出了以某一区域工程地质条件相似的滑坡基本物理力学参数为基础,采用SPSS数学分析软件分析滑坡各基本物理力学参数与抗剪强度的相关性,筛选出对滑坡抗剪强度影响较大的因子;然后采用BP神经网络模型研究区域滑坡抗剪强度与影响因子的网络结构,并以建立的神经网络结构对该区域的滑坡抗剪强度参数进行估算;最后以万州区滑坡为例进行分析和验证。研究结果表明,采用神经网络计算的结果与滑坡试验得到的结果误差基本都在5%左右,精度较高。     

Sources of ambient volatile organic compounds and their contributions to photochemical ozone formation at a site in the Pearl River Delta, southern China

The Positive Matrix Factorization (PMF) receptor model and the Observation Based Model (OBM) were combined to analyze volatile organic compound (VOC) data collected at a suburban site (WQS) in the PRD region. The purposes are to estimate the VOC source apportionment and investigate the contributions of these sources and species of these sources to the O₃ formation in PRD. Ten VOC sources were identified. We further applied the PMF-extracted concentrations of these 10 sources into the OBM and found "solvent usage 1", "diesel vehicular emissions" and "biomass/biofuel burning" contributed most to the O₃ formation at WQS. Among these three sources, higher Relative Incremental Reactivity (RIR)-weighted values of ethene, toluene and m/p-xylene indicated that they were mainly responsible for local O₃ formation in the region. Sensitivity analysis revealed that the sources of "diesel vehicular emissions", "biomass/biofuel burning" and "solvent usage 1" had low uncertainties whereas "gasoline evaporation" showed the highest uncertainty.     

垃圾填埋场生物覆盖材料筛选及甲烷减排

通过模拟柱实验研究了消化污泥、矿化垃圾和黏土作为垃圾填埋场生物覆盖材料的甲烷氧化能力。3种材料的甲烷日氧化率平均值、总氧化率和氧化速率V(CH4)分别是:消化污泥10.27%、75.82%、1.76 mmol/(kg·d);矿化垃圾11.05%、75.61%、2.04 mmol/(kg·d);黏土9.05%、68.15%、1.33 mmol/(kg·d),消化污泥和矿化垃圾对甲烷的氧化能力均大于黏土。进一步探讨了消化污泥中添加粉煤灰、建筑垃圾和黏土进行改性后对甲烷的氧化能力,考察了改性污泥的渗透系数和抗压强度。结果表明:粉煤灰对消化污泥的改性效果最好,其日氧化率平均值、总氧化率和V(CH4)分别达到17.27%、92.37%和2.35 mmol/(kg·d),粉煤灰与消化污泥以1∶1～1.5∶1混配后可满足填埋场对覆盖材料渗透系数和抗压强度的要求。     

厌氧颗粒污泥的性能研究

对接种市政消化污泥EGSB反应器内所形成的颗粒污泥在低浓度(100～500 mg/L)、低温(8～15℃)、微氧(氧化还原电位为380～400 mV)等条件下的沉速、粒径、活性、形态等性能进行研究.结果表明:厌氧中温(35℃左右)稳定运行时,颗粒污泥的沉速较大,在低温或微氧时,颗粒污泥的沉速相对较低,但都能维持在15 m/h以上,不会被冲出反应器而造成污泥的流失.低温时大颗粒污泥所占重量百分比在逐渐增加,微氧使得颗粒污泥粒径分配更加均匀.低温时,颗粒污泥的产甲烷活性明显降低,降幅为55.5%;但微量氧的加入并没有使EGSB反应器内颗粒污泥的产甲烷活性降低,反而提高了10%.中温稳定运行时,颗粒污泥规则、密实,微生物菌群中甲烷八叠球菌明显增多.低温时,颗粒污泥的表面和内部微生物排列都比较松散,而且出现大量微生物胞外分泌物;低温中高浓度时,甲烷八叠球菌没有出现,鬃毛甲烷菌属占优势.微氧时颗粒污泥同样是规则、密实的,菌种更加丰富,颗粒表面和内部的优势菌群不同,但在中高浓度时没有出现甲烷八叠球菌的明显优势.     

Colloid transport in unsaturated porous media: the role of water content and ionic strength on particle straining

Packed column and mathematical modeling studies were conducted to explore the influence of water saturation, pore-water ionic strength, and grain size on the transport of latex microspheres (1.1 microm) in porous media. Experiments were carried out under chemically unfavorable conditions for colloid attachment to both solid-water interfaces (SWI) and air-water interfaces (AWI) using negatively charged and hydrophilic colloids and modifying the solution chemistry with a bicarbonate buffer to pH 10. Interaction energy calculations and complementary batch experiments were conducted and demonstrated that partitioning of colloids to the SWI and AWI was insignificant across the range of the ionic strengths considered. The breakthrough curve and final deposition profile were measured in each experiment indicating colloid retention was highly dependent on the suspension ionic strength, water content, and sand grain size. In contrast to conventional filtration theory, most colloids were found deposited close to the column inlet, and hyper-exponential deposition profiles were observed. A mathematical model, accounting for time- and depth-dependent straining, produced a reasonably good fit for both the breakthrough curves and final deposition profiles. Experimental and modeling results suggest that straining--the retention of colloids in low velocity regions of porous media such as grain junctions--was the primary mechanism of colloid retention under both saturated and unsaturated conditions. The extent of stagnant regions of flow within the pore structure is enhanced with decreasing water content, leading to a greater amount of retention. Ionic strength also contributes to straining, because the number of colloids that are held in the secondary energy minimum increases with ionic strength. These weakly associated colloids are prone to be translated to stagnation regions formed at grain-grain junctions, the solid-water-air triple point, and dead-end pores and then becoming trapped.     

全烧垃圾流化床炉飞灰制备免烧砖的性能研究

开展了水泥固化全烧垃圾循环流化床焚烧炉飞灰特性及其制备免烧砖的研究.同时,分析了飞灰的特性,研究了水泥用量对砖体抗压强度和重金属浸出毒性的影响,并对固化前后飞灰在不同p H值溶液环境下的重金属渗滤特性和基于改进RCR连续提取法的重金属形态分布进行了对比研究.结果表明:飞灰中Cd、Cu、Pb、Ni的浸出浓度分别达到1.76、60.29、5.36、1.48 mg·L-1,远超出生活垃圾填埋标准的规定,Cd、Zn、Cu的酸可交换态部分很高,分别为48%、21.26%、20.72%.水泥基材具有良好的稳定效果,添加量达到30%时,免烧砖中重金属的浸出毒性已远低于标准值.随着水泥掺量的提高,免烧砖的抗压强度呈上升趋势,当水泥比例为30%时,强度可达到12.8 MPa,35%水泥比例的砖体,其抗压强度则达到国标建筑用砖的MU15级.与原始飞灰相比,砖体中重金属在不同渗滤液p H下的浸出趋势并未改变,浸出量却显著下降,p H的适应范围变宽.另外,重金属中酸可交换态部分降至低于1%,主要转变成了可还原态,对环境的污染风险大幅降低.     

河道疏浚废弃淤泥改良土的强度变化规律探讨

通过系列室内试验,研究了添加生石灰改良高含水量疏浚淤泥的处理土的无侧限抗压强度的主要影响因素;探讨了高含水量疏浚淤泥生石灰处理土的无侧限抗压强度与原泥初始含水量、生石灰掺入比、处理土含水量的关系,得出了生石灰处理土的无侧限抗压强度随着含水量降低率的增加而线性增加的变化规律;建立了生石灰处理土无侧限抗压强度与原泥初始含水量及处理土含水量的定量表达式,给出了生石灰改良高含水量疏浚淤泥的处理土不排水强度的预测方法,可为高含水量疏浚淤泥的有效利用和相关工程设计、施工提供理论基础和指导。