Source identification of copper, lead, nickel, and zinc loading in wastewater reclamation plant influents from corrosion of brass in plumbing fixtures

A natural experiment indicated that a link between the presence and concentration of four elements, copper, lead, nickel, and zinc in the influent to two wastewater reclamation plants to the presence and concentrations of the same four elements in the tap water of residential properties. There were 36 populations of results that were assessed for the normality of their distribution, the difference in their median concentrations, the similarity in the ratios of their median concentrations, and the correlations of the concentrations. The results of this study suggest that brass corrosion is the major source of these four elements in the water reclamation plants influent and that there are two distinct populations of brass sources, those in the early stages of dezincification where the release of the non-copper elements is dominant and those in the later stages where the release of copper dominates and the type of brass that is corroding.     

逆流湍动床生物膜反应器液相混合特性的研究

研究了实验室规模逆流湍动床的水力学特性。以亚硝酸钠作为示踪剂,采用刺激响应技术,通过测定停留时间分布(RTD),考察了反应器的内部流动状况。考察了不同固含率（0～0.3）、表观气速（1.1～8.8 mm/s）和表观液速（0.66～1.7 mm/s）对RTD的影响。研究表明,表观气速增大、固含率减小和适当提高表观液速都会使反应器返混增强,更接近CSTR。反应器死区百分率低,结构性能良好;死区百分率与表观气速和液速相关性不强,而与固含率负相关。逆流湍动床的RTD可用轴向扩散模型、等体积多釜串联模型和不同体积2釜串联模型来模拟,这些模型的特征参数Pe、N和α分别为1.25～1.79、1.46～1.67和0.74～0.90。     

An Auxiliary Method to Reduce Potential Adverse Impacts of Projected Land Developments: Subwatershed Prioritization

An index based method is developed that ranks the subwatersheds of a watershed based on their relative impacts on watershed response to anticipated land developments, and then applied to an urbanizing watershed in Eastern Pennsylvania. Simulations with a semi-distributed hydrologic model show that computed low- and high-flow frequencies at the main outlet increase significantly with the projected landscape changes in the watershed. The developed index is utilized to prioritize areas in the urbanizing watershed based on their contributions to alterations in the magnitude of selected flow characteristics at two spatial resolutions. The low-flow measure, 7Q10, rankings are shown to mimic the spatial trend of groundwater recharge rates, whereas average annual maximum daily flow, , and average monthly median of daily flows, , rankings are influenced by both recharge and proximity to watershed outlet. Results indicate that, especially with the higher resolution, areas having quicker responses are not necessarily the more critical areas for high-flow scenarios. Subwatershed rankings are shown to vary slightly with the location of water quality/quantity criteria enforcement. It is also found that rankings of subwatersheds upstream from the site of interest, which could be the main outlet or any interior point in the watershed, may be influenced by the time scale of the hydrologic processes.     

Impact of different land uses on polycyclic aromatic hydrocarbon contamination in coastal stream sediments

PAHs are ubiquitous environmental pollutants that can cause adverse health and ecological effects. In the present study, we examined the impact of land use on the concentration and composition of PAHs in 28 coastal stream sediments on the Island of Oahu, Hawaii. In densely populated urban areas, the concentration range of total PAHs in the stream sediments affected by mixed residential and industrial activities (RI) are 0.40-9.05 ppm, which is significantly higher than the 0.36-4.21 ppm detected in the stream sediments affected predominantly by urban residential land uses (UR). The stream sediments affected by agricultural activities (AG) reported a concentration range of 0.09-2.14 ppm, which is lower than those of the RI and UR stream sediments. The molecular weight of PAH is a factor, as only high molecular weight (HMW) PAHs were significantly affected by land uses (ANOVA P = 0.009). Correlation analysis showed that only in the UR stream sediments were significant correlations observed between PAH concentration and two anthropogenic indicators: population density (r = 0.57, P = 0.027) and vehicle density (r = 0.55, P = 0.034). The fractional concentrations of PAHs were analyzed by using PCA analysis, which led to the separate clustering of the RI and AG stream sediments and suggest distinct PAH sources between the two land uses. Two PAH source indicators, including Ant/(Ant + Phe) and Fl/(Fl + Py), indicates that PAHs sources in the RI stream sediments are most likely of petroleum origin, while PAHs in the UR and AG stream sediments most likely came from combustion activities. In addition, the concentration and relative potency of carcinogenic PAHs in the coastal stream sediments exhibited similar patterns as the total PAH concentration with respect to land uses.     

Characterization of eco-cement paste produced from waste sludges

In this study, marble sludge, sewage sludge, drinking water treatment plant sludge, and basic oxygen furnace sludge were used as replacements for limestone, sand, clay, and iron slag, respectively, as the raw materials for the production of cement in order to produce eco-cement. It was found that it is feasible to use marble sludge to replace up to 50% of the limestone and also that other materials can serve as total replacements for the raw materials typically used in the production of cement. The major components of Portland cement were all found in eco-cement clinkers. The eco-cement was confirmed to produce calcium hydroxide and calcium silicate hydrates during the hydration process, increasing densification with the curing age. The compressive strength (S_c) and microstructural evaluations conducted at 28 d revealed the usefulness of eco-cement. It was observed that the S_c data correlated linearly with the pore volume (P) data at 28 d. The proposed model equation could be represented as S_c = 178-461P (correlation coefficient, R² = 0.96). Two parameters, the large capillary pore volume and the medium capillary pore volume, were evaluated using multiple regression analysis.     

常温下ABR处理低浓度废水性能及污泥特性

研究了常温(17~25℃)下4隔室厌氧折流板反应器(ABR)处理低浓度废水的运行效果及污泥特性。在水力停留时间(HRT)为24 h,进水COD浓度为1 500、1 000和500 mg/L左右时,平均COD去除率分别为94%、93%和87%。进水COD浓度保持在500 mg/L左右,将HRT降为12 h和8 h,COD的去除率仍达到83%以上。厌氧污泥性质测定结果表明,最后隔室中的污泥浓度、颗粒化程度及产甲烷活性与其他隔室相比明显较低,说明低浓度进水对最后隔室厌氧污泥的性质影响较大。颗粒污泥扫描电镜观察显示,各隔室颗粒污泥内部微生物组成差异较大,第1隔室颗粒污泥以产甲烷球菌为主,第2隔室颗粒污泥中没有明显的优势菌,但杆状菌比第1隔室明显较多,第3、4隔室颗粒污泥中以索氏甲烷丝菌为优势菌。     

A novel approach for characterization of polycyclic aromatic hydrocarbon (PAH) pollution patterns in sediments from Guanabara Bay, Rio de Janeiro, Brazil

A novel multivariate method based on principal component analysis of pre-processed sections of chromatograms is used to characterize the complex PAH pollution patterns in sediments from Guanabara Bay, Brazil. Five distinct sources of 3- to 6-ring PAHs could be revealed. The harbour is the most contaminated site in the bay, its plume stretches in a South West to North East direction and the chemical profile indicates mainly pyrogenic sources mixed with a fraction of high-molecular-weight petrogenic PAHs. Rio São João de Meriti is the second largest source of PAHs, and introduces mainly a fraction of low-molecular-weight petrogenic PAHs from the western region of Rio de Janeiro. The sites close to the ruptured pipeline at the Duque de Caxias Refinery show a distinctive pollution pattern indicating a heavy petroleum fraction. The method also led to the identification of new potential indicator ratios also involving coeluting peaks (e.g., triphenylene and chrysene).     

Strength and workability of masonry mortars manufactured with ladle furnace slag

Ladle furnace basic slag (LFS) is a by-product of the steelmaking process. It has rarely been recovered in the past and is usually disposed of in landfill sites. Despite containing stable chemical substances of great quality, some of which are potentially hydraulic, its practical applications have been limited. This paper discusses the attractive option of using LFS in the manufacture of masonry mortars for use in the construction industry, which requires an analysis of the principal characteristics of such mortars, i.e. workability and mechanical strength. It reports on a comparative study, using standard commercial admixtures, between conventional masonry mortars and mortars manufactured with LFS as a partial replacement for sand and cement, the results of which imply considerable economic savings in sand and cement, improvements in the properties of the mortars and in overall sustainability, by avoiding disposal and conserving natural resources.     

Characterization of Volatile Organic Compounds (VOCs) and Their Sources in the Air of Izmir, Turkey

Air samples were collected in Izmir, Turkey at two (suburban and urban) sites during three sampling programs in 2002 and 2004 to determine the ambient concentrations of several monoaromatic, chlorinated and oxygenated volatile organic compounds (VOCs). Samples were analyzed for 60 VOCs using gas chromatography/mass spectrometry and 28 compounds were detected in most samples. On the average, urban air VOC concentrations were about four times higher than those measured at the suburban site. Toluene (40.6%) was the most abundant compound in suburban site and was followed by benzene (7.4%), o,m-xylene (6.5%), and 1,2-dichloroethane (5.1%). In urban site, toluene (30.5%), p-xylene (14.9%), o,m-xylene (11.4%), and ethyl benzene (7.2%) were the dominating compounds in summer. In winter, toluene (31.1%), benzene (23.9%), 1,2-dichloroethane (9.5%), and o,m-xylene (8.2%) were the most abundant compounds. Receptor modeling (positive matrix factorization) has been performed to estimate the contribution of specific source types to ambient concentrations. Six source factors (gasoline vehicle exhaust, diesel vehicle exhaust+residential heating, paint production/application, degreasing, dry cleaning, and an undefined source) were extracted from the samples collected in the urban site. Three source factors (gasoline vehicle exhaust, diesel vehicle exhaust, and paint production/application) were identified for the suburban site.     

C2-C6 Background Hydrocarbon Concentrations Monitored at a Roof Top and Green Park Site, in Dublin City Centre

A 5 week monitoring campaign was carried out in Dublin City centre, to establish which site gave a more accurate background city centre estimation: a roof-top or green field site. This background represented a conservative estimate of HC exposure in Dublin City centre, useful for quantifying health effects related to this form of pollution and also for establishing a local background relative to the four surrounding main roads when the wind direction is travelling towards each road with the background receptor upwind. Over the entire monitoring campaign, the lowest concentrations and relative standard deviations were observed at the green field site, regardless of time of day or meteorological effects.