农药厂周边有机磷农药在生物体中残留的检测方法研究

对中美两国固定源测试技术体系进行总结并按照辅助类参数、烟气类污染物、烟尘类污染物、有机类污染物、元素及卤化物、在线监测规范进行分类并比较,指出两国测试体系的异同。结合目前形势指出中国烟尘、烟气及VOCs类污染物监测体系面临问题并提出建议。     

Bioconcentration and half-life of quinalphos pesticide in rice-fish integration system in the Mekong Delta,Vietnam

In order to determine the distribution and enable the elimination of quinalphos, a popular active pesticide compound used in the Mekong Delta, an experiment was set up in a rice-fish integration system in Can Tho City, Vietnam. Fish was stocked into the field when the rice was two-months old. Quinalphos was applied twice in doses of 42.5 g per 1000 m². Water, fish and sediment samples were collected at time intervals and analyzed by a Gas Chromatography Electron Capture Detector system. The results show that quinalphos residues in fish muscles were much higher than those of the water and the bioconcentration factor (logBCF) was above 2 for the fish. The half-life of first and second quinalphos applications were 12.2 and 11.1 days for sediment, 2.5 and 1.1 days for silver barb, 1.9 and 1.3 days for common carp, and 1.1 and 1.0 days for water, respectively.     

基于变权灰色云模型的江苏省水环境系统脆弱性评价

水环境系统脆弱性是水资源利用与生态环境研究的热点问题,通过研究水环境系统的内在机理,综合考虑影响水环境系统脆弱性的资源、环境、经济、社会等因素,借助驱动力-压力-状态-影响-响应-管理（DPSIRM）框架构建水环境系统脆弱性评价指标体系。在此基础上,构建基于变权灰色云模型的评价方法,对2004~2014年江苏省水环境系统脆弱性进行评价。结果表明：2004~2014年水环境系统脆弱性指数由47.056提高到63.210,脆弱性等级由“重度脆弱”演化为“中度脆弱”,并长期维持在“中度脆弱的”等级,2014年出现了向“轻度脆弱”状态转变的趋势。分析各个子系统对水环境系统脆弱性影响程度可知,影响子系统和响应子系统对江苏省水环境脆弱性系统的影响程度逐年增加;而压力子系统和管理子系统对水环境系统脆弱性的影响程度逐年下降;其它子系统对水环境系统脆弱性的影响维持在一定水平小幅度波动。     

录井系统雷击危害分析及模拟试验研究

针对雷击电磁辐射对录井系统的危害问题,建立了录井系统线路雷击危害模拟试验模型,采用8/20 μs冲击电流发生器,开展了录井系统的雷击耦合试验,定量分析了雷击电磁辐射对录井系统的影响。研究结果表明:随着电流的增大和距离电流通道的减小,耦合的电压随之增大;线缆长度越长耦合的电压越大,最大耦合电压达到了2 720 V;屏蔽层接地可以有效地减小电磁辐射对线缆的耦合作用。     

生理因素对驾驶人行为及风险感知影响研究综述

为全面认识驾驶人行为及风险感知并分析行为成因,从驾驶人生理因素着手,从驾驶人视力、阻塞性睡眠呼吸暂停综合征和肌肉骨骼疾患3个方面梳理国内外驾驶人行为及风险感知的研究成果与研究不足。研究结果表明:驾驶人的生理疾病对其驾驶能力和危险感知存在显著影响;生理疾病严重程度与异常驾驶行为中的一般性失误、危险性失误行为之间具有显著正相关关系,疾病严重程度越高,出行失误行为的频率越高;之后可从理论和实验两方面着手,针对驾驶人的不同属性进行研究。     

基于尾涡强度的无人机与民机纵向安全间隔评估研究

为了解决无人机频频入侵机场净空,与民航客机发生危险接近的问题,以碰撞风险为量化指标,对无人机与民机需要保持的纵向安全间隔进行评估研究。分析民机尾涡流场对无人机运行的影响,利用Crow近场涡强度消散理论,得到实际尾迹影响区改进Reich碰撞模板,据此建立CNS/GPS性能环境下的纵向间隔评估模型,通过Matlab进行间隔值求解。研究结果表明:模型可以较为准确地反映民机起飞初始爬升阶段无人机尾随运行时导航性能和尾涡迹对所需最小间隔值的影响,并得到给定安全目标水平的计算结果。     

石化装置安全仪表系统KooN表决结构的误跳车率定量分析

为了更准确量化安全仪表系统的误跳车率,基于联锁回路SIF中传感器、逻辑解算器、执行机构引发误跳车的不同失效机理和模型,考虑共因失效对误跳车率的影响,提出1种更符合实际并适用于异型KooN结构的新子系统误跳车率计算模型（STR of Non-identical Redundant System,SNRS）。针对SIF回路的误跳车率计算,建立了1种分析安全联锁SIF回路误跳车率（Reliability based Spurious Trip,RST）的计算框架。研究结果表明:以某聚丙烯装置第三反应器保护系统为例,将SNRS和RST方法与目前主流的多种计算方法进行数值计算对比,验证了方法的有效性,能够有效进行定量分析。     

深部“三软”高应力软岩巷道卸压耦合支护技术

为解决杨河煤业高应力软岩巷道的支护问题,对杨河煤业深部软沿巷道变形破坏特征及原因进行分析,提出支架-锚杆-围岩卸压耦合支护技术,并结合42轨道下山试验巷道对耦合卸压支护技术参数进行阐述,通过矿压观测结果可知:42轨道下山在采用卸压耦合支护技术后,有效控制了巷道强烈变形。     

A comparative study of vocational education and occupational safety and health training in China and the UK

In order to enhance Chinese workers’ occupational safety awareness, it is essential to learn from developed countries’ experiences. This article investigates thoroughly occupational safety and health (OSH) in China and the UK; moreover, the article performs a comparison of Chinese and British OSH training-related laws, regulations and education system. The following conclusions are drawn: China’s work safety continues to improve, but there is still a large gap compared with the UK. In China a relatively complete vocational education and training (VET) system has been established. However, there exist some defects in OSH. In the UK, the employer will not only pay attention to employees’ physiological health, but also to their mental health. The UK’s VET is characterized by classification and grading management, which helps integrate OSH into the whole education system. China can learn from the UK in the development of policies, VET and OSH training.     

Usability of non-standard lower anchor configurations for child restraint system (CRS) installation

Abstract

Objectives: The objective of this study was to determine whether the amount of tension required for proper child restraint system (CRS) installation varies with lower anchor spacing and to determine whether nonexperts can produce adequate tension on wider-than-standard lower anchor configurations.

Methods: CRSs were installed by certified child passenger safety technicians (CPSTs; n?=?6 subjects, n?=?72 installations) and nonexperts (n?=?30 subjects, n?=?120 installations) on a mock-up vehicle seat fixture with lower anchors set at 11 (standard), 15, 19, and 23 in. apart from one another. Each CPST installed a rear-facing (RF) infant base, RF convertible, and forward-facing (FF) convertible into each of the 4 spacing configurations in random order. The CPSTs were instructed to tighten the lower connector strap until the tension was exactly at the threshold between passing and failing the 1-in. test. Each nonexpert installed one CRS model into all 4 spacing conditions in random order. Nonexperts were instructed to install the CRS to the best of their ability. The tension produced on the lower connector strap was recorded via load cell in the lower anchor assembly of the vehicle seat. Resultant tension magnitudes were compared across spacing conditions using matched pair t-tests. The CPSTs’ mean 1-in. test threshold values were compared to tensions produced by nonexperts. Installations were visually evaluated for errors and qualitative usability feedback was collected via survey.

Results: CPSTs installed the infant base with higher tensions in the 15-, 19-, and 23-in. configurations compared to the standard 11-in. configuration (P = .034, .032, and .003, respectively). The nonexperts installed the infant base with higher tension in the 15- and 23-in. configurations compared to the 11-in. configuration (P = .004 and .026, respectively). The RF convertible and FF convertible installations showed no significant differences in tension among any of the spacing configurations for either group. Only 19% of the nonexperts’ installations were tight enough to pass CPST thresholds, and the pass rate did not vary with respect to lower anchor spacing. In feedback surveys, the nonexpert group did not show a consistent preference for either standard or wider-than-standard lower anchor configurations.

Conclusions: The amount of tension required to pass the 1-in. rule did not vary with lower anchor spacing configurations for the RF and FF convertible CRS, but the infant base required more tension in wider anchor configurations. Nonexperts tended to produce less than ideal tension in all configurations, although their tension magnitudes increased for the infant base in wider configurations.