Influence of driving cycles on exhaust emissions and fuel consumption of gasoline passenger car in Bangkok

The influence of different driving cycles on their exhaust emissions and fuel consumption rate of gasoline passenger car was investigated in Bangkok based on the actual measurements obtained from a test vehicle driving on a standard chassis dynamometer. A newly established Bangkok driving cycle (BDC) and the European driving cycle (EDC) which is presently adopted as the legislative cycle for testing automobiles registered in Thailand were used. The newly developed BDC is constructed using the driving characteristic data obtained from the real on-road driving tests along selected traffic routes. A method for selecting appropriate road routes for real driving tests is also introduced. Variations of keyed driving parameters of BDC with different driving cycles were discussed. The results showed that the HC and CO emission factors of BDC are almost two and four times greater than those of EDC, respectively. Although the difference in the NOx emission factor is small, the value from BDC is still greater than that of EDC by 10%. Under BDC, the test vehicle consumes fuel about 25% more than it does under EDC. All these differences are mainly attributed to the greater proportion of idle periods and higher fluctuations of vehicle speed in the BDC cycle. This result indicated that the exhausted emissions and fuel consumption of vehicles obtained from tests under the legislative modal-type driving cycle (EDC) are significantly different from those actually produced under real traffic conditions especially during peak periods.     

The estimated reduction in the odds of loss-of-control type crashes for sport utility vehicles equipped with electronic stability control

INTRODUCTION: Using data from the NASS General Estimates System (GES), the method of induced exposure was used to assess the effects of electronic stability control (ESC) on loss-of-control type crashes for sport utility vehicles. METHOD: Sport utility vehicles were classified into crash types generally associated with loss of control and crash types most likely not associated with loss of control. Vehicles were then compared as to whether ESC technology was present or absent in the vehicles. A generalized additive model was fit to assess the effects of ESC, driver age, and driver gender on the odds of loss of control. In addition, the effects of ESC on roads that were not dry were compared to effects on roads that were dry. RESULTS: Overall, the estimated percentage reduction in the odds of a loss-of-control crash for sport utility vehicles equipped with ESC was 70.3%. Both genders and all age groups showed reduced odds of loss-of-control crashes, but there was no significant difference between males and females. With respect to driver age, the maximum percentage reduction of 73.6% occurred at age 27. The positive effects of ESC on roads that were not dry were significantly greater than on roads that were dry.     

Occupational Exposure to Polycyclic Aromatic Hydrocarbons During Diesel Combustion

Identification and determination of polycyclic aromatic hydrocarbons (PAHs) in Diesel exhaust in the working environment and assessment of workers’ occupational exposure to these suspected human carcinogens were the aim of this experimental investigation.

The range of exposure factors calculated on the basis of 9 individual PAH concentrations determined in personal air samples shows that time-averaged concentration of these compounds did not exceed the Polish Maximum Admissible Concentration (MAC) value for PAHs, that is, 2 μg·m^–3. The highest concentrations of PAHs were determined in the breathing zone of forklift operators. The maximum exposure factor was 0.427 μg·m^–3 (about 1/4 of MAC).     

抽出式通风煤巷掘进过程中粉尘浓度分布规律的数值模拟

根据气固两相流理论，针对矿井掘进工作面的特点，采用计算流体力学的离散相模型（DPM）对掘进工作面通风过程中粉尘浓度进行数值模拟，总结抽出式通风掘进巷道中粉尘浓度的沿程分布及变化规律。     

街道峡谷内汽车排放污染物浓度分布的观测与数值模拟

在上海某典型街道峡谷内按一定的空间布点,在一定时段内同时对各布点进行采样并做一氧化碳浓度分析,同时记录车辆种类、车流量、气象条件等,分析街道峡谷内污染物浓度的分布.运用风向频率加权(WDFW)方法,结合大气流动和污染物扩散的CFD模型进行数值模拟计算.结果表明,数值模拟结果和现场观测结果较吻合,建筑物低的一侧污染物浓度远高于建筑物高的一侧污染物浓度,两侧的污染物浓度随着高度的增加而降低.     

应用CALINE4模式估算机动车排放污染物的浓度——以济南市主干道为例

随着经济的快速发展,机动车排气污染已成为我国城市空气污染的重要来源,而且在一定时段,机动车排气污染已成为空气污染最主要的污染源之一。以济南市经十路为例,采用实地调查的方法,得出各时段的车流量,选用大气环评助手EIAA中的CALINE4模式对机动车尾气中的主要污染物CO、NOx、THC的排放浓度进行估算,得出3种污染物CO、NOx、THC最大值均出现在7:00—8:00之间,最小值均出现在12:00-13:00之间,排放强度由大到小为:CO、THC、NOx。     

用电解锰阳极泥和含SO_2工业尾气制备硫酸锰

以电解锰阳极泥与电解锌生产中产生的含SO_2尾气为原料,经过反应、浸出、浸出液两次净化和浓缩结晶制备硫酸锰,考察了反应时间、含SO_2尾气的流量及反应温度对Mn~(4+)转化率的影响.实验结果表明:在反应时间45 min、反应温度20～30 ℃、含SO_2尾气流量16 L/min的条件下,Mn~(4+)转化率达90%以上;尾气中SO_2利用率随尾气流量增加而降低;所得MnSO_4·H_2O产品质量达到GB1622-86<工业级硫酸锰标准>.     

Physical Modeling of Emissions from Naturally Ventilated Underground Parking Garages

The dispersion of pollutants from naturally ventilated underground parking garages has been studied in a boundary layer wind tunnel. Two idealized model setups have been analysed, one was simulating pollutant dispersion around an isolated rectangular building and one was representing dispersion in a finite array of idealized building blocks. Flow and dispersion close to modelled ground level emission sources was measured. The results illustrate the complexity of the flow around buildings and provide insight in pollutant transport from ground level sources located directly on building surfaces. As a result, areas critical with respect to high pollutant concentrations could be visualized. Particularly, the results show high concentration gradients on the surface of the buildings equipped with modelled emission sources. Inside the boundary layers on the building walls, a significant amount of pollutants is transported to upwind locations on the surface of the building. The paper documents the potential of physical modelling to be used for the simulation and measurement of dispersion close to emission sources and within complex building arrangements.     

我国汽车尾气污染,污染控制与对策

本文综述了我国汽车尾气污染的现状与发展趋势，着重阐述了我国汽车尾气的催化剂研制和催化净化器技术水平和现状，提出了我国汽车尾气污染控制技术的发展方向，并探讨了减少汽车尾气污染的对策和建议。     

汽车尾气净化催化剂涂层改性研究

汽车尾气净化催化剂的净化转化效果及其耐久性，与催化剂涂层的涂覆量以及涂层和载体的结合强度密切相关。本文研究了几种不同类型表面活性剂对浆料固体含量、涂层涂覆量以及涂层结合强度的影响。研究结果表明，不使用表面活性剂时，30％为最佳的固体含量；在使用表面活性剂的情况下，浆料的固体含量可以提高至35％。非离子型表面活性剂有助于提高催化剂涂层涂覆量，而使用离子型表面活性剂的浆料球磨过程中产生大量泡沫，无法涂覆。使用非离子型表面活性剂的催化剂涂层的结合强度最好。