Kinetics of selective catalytic reduction of NO by NH3 on Fe-Mo/ZSM-5 catalyst

The catalyst of Fe-Mo/ZSM-5 has been found to be more active than Fe-ZSM-5 and Mo/ZSM-5 separately for selective catalytic reduction (SCR) of nitric oxide (NO) with NH3. The kinetics of the SCR reaction in the presence of O2 was studied in this work. The results show that the observed reaction orders were 0.74-0.99, 0.01-0.13, and 0 for NO, O2 and NH3, respectively, at 350-450℃. And the apparent activation energy of the SCR was 65 kJ/mol on the Fe-Mo/ZSM-5 catalyst. The SCR mechanism was also deduced. Adsorbed NO species can react directly with adsorbed ammonia species on the active sites to form N2 and H2O. Gaseous O2 might serve as a reoxidizing agent for the active sites that have undergone reduction in the SCR process. It is also important to note that a certain amount of NO was decomposed directly over the Fe-Mo/ZSM-5 catalyst in the absence of NH3.     

基于非线性响应函数和蒙特卡洛模拟的滇池流域污染负荷削减情景分析

为定量了解滇池外海水质对流域污染负荷削减率的响应变化程度,并评估相关决策的潜在风险,在长期的水质模拟结果基础之上,本文使用内嵌非线性响应函数的蒙特卡罗模拟方法,在2个不确定性水平下（5%和10%的变异范围）分析滇池外海为达到3个水质目标情景（Ⅲ类、Ⅳ类和Ⅴ类）的污染负荷削减及其不确定性.模型结果表明,在2种不确定性水平...     

Reducing sulfates concentration in the tannery effluent by applying pollution prevention techniques and nanofiltration

The use of large quantities of sulfuric acid and other sulfur-containing chemicals causes high sulfate concentrations in the wastewater of a tannery. The aim of this work was reducing the sulfate concentration in the final wastewater from a tannery. For that, firstly a study about the main sulfate sources in a tannery was carried out and the total sulfates load in the tannery wastewater was evaluated. Two measures for sulfates reduction were studied: the recycling of unhairing wastewater to the soaking drums and the reuse of the chromium sulfate from the tanning washing wastewater after its separation by nanofiltration (NF). The first measure proposed was studied experimentally in laboratory drums of 5 L of volume. Two series of experiments with different volumes of unhairing wastewater in the soaking bath were carried out. The quality of the final leather was evaluated by means of mechanical tests. NF experiments were carried out in a laboratory pilot plant with a spiral wounded membrane element. Concerning the results, the combination of 50% unhairing wastewater and 50% of fresh water was appropriate in order to obtain leather with an acceptable quality. Besides, it drove to a diminution of approximately 10% in the addition of sulfide in the unhairing. Related to the NF experiments, 97% of the sulfates were rejected by the membrane. The separated ions could be recycled to the tanning drums. The application of the two measures (firstly the recycling of the unhairing wastewater and secondly the NF of the tanning washing wastewater) drove to a reduction of 14.82 kg SO₄⁻² t⁻¹ of raw hide.     

电渗析法再生CO_2电还原电解液的研究

探索了电渗析法再生CO2电还原电解液的可行性。以HCOOK溶液作为CO2电还原反应后的模拟液,采用单室电渗析装置对其进行再生,考察了电流、时间、温度等操作条件对电流效率和再生率的影响,研究结果表明:在常温条件下,操作电流低于极限电流时,采用电渗析法再生CO2电还原电解液具有高的电流效率和再生率。     

Effect of manufacturing methods of AgCl/Al2O3 catalyst on selective catalytic reduction of NOx

The AgCl/Al2O3 catalyst has potential for use in the selective catalytic reduction (SCR) of NOx. A compound hydrocarbon, following oxygenation is used as a type of reducing agent. In this experiment, the AgCl/Al2O3 catalyst was produced by four different methods, and the differences among their reduction catalysis of NOx were compared. Ethanol was used as a type of reducing agent. X-ray diffraction analysis was performed to study the crystalline structure and scanning electron microscope and transmission electron microscope (TEM) were applied to determine the microindentation. The results indicated that, in the range of 350–400°C, there was no significant difference on the NOx reduction rate; however, there was dispersion at high and low temperature ranges. The size of the AgCl particles was about 20–100 nm.     

臭氧处理循环冷却水节能减排效益分析

文章基于臭氧(O3)处理法处理循环冷却水因可以同时达到阻垢脱垢、缓蚀、杀菌等多重功能,其在国外已得到广泛应用,同时国内也逐步普及应用的环境下,结合国内外长期的工程实践经验,从节水、节能、减排和公共卫生效益四个方面,详细分析了臭氧处理循环冷却水所带来的巨大经济效益、社会效益和环境效益。     

电厂二氧化碳捕捉技术对比研究

由于全球温室效应的不断加剧,发展二氧化碳捕捉技术变得十分必要.通过分析燃烧前捕捉、燃烧后捕捉和富氧燃烧捕捉三种二氧化碳捕捉方式流程及其特点,指出三种不同的二氧化碳捕捉技术的发展现状以及应用途径.通过具体对比现有二氧化碳捕捉技术的工作原理以及优缺点,针对现有的几种具体的二氧化碳捕捉技术进行详细的分析,积极应用各种物理、化...     

型煤产业发展与提高

本文论述发展工业型煤产业的重要意义和技术质量保证,洁净煤技术是控制污染和节约能源,提高煤炭资源利用率的重要技术项目,将粉煤生产成型煤,为工业、民用提供洁净的燃料,既充分利用煤炭资源同时改善能源结构,又有显著的环保效益,国家把煤炭产业列入中国洁净煤技术有限发展项目,目前制约型煤产业的发展要造气型和燃烧型煤并举,同时有利于用户的节能效益。     

鄂尔多斯节能减排现状及建议

鄂尔多斯作为典型资源型城市,资源性产业在国民经济中长期占据主导地位,因此节能减排任务十分艰巨。本文分析总结了“十一五”以来鄂尔多斯市节能减排取得的成效及采取的主要措施,并在此基础上提出了几点建议。     

电动交通工具的污染减排及对策

燃油交通工具是城市温室气体的重要来源之一,因此使用电动交通工具成为解决城市污染减排的重要措施.文章就正确认识电动交通工具污染减排的作用,蓄电池的生产管理、回收利用等进行了讨论,并提出了相应的对策和建议.