Phenol removal from aqueous environments by natural & chemically modified kaolin clay

Natural, acid and base modified kaolin clays were studied for the sake of phenol and 4-chlorophenol removal from aqueous environments and their application to real ground and industrial wastewater samples. Scanning electron microscope (SEM), infrared spectroscopy (IR), X-ray diffraction (XRD), Thermo Gravimetric Analysis (TGA), Differential Thermal Analysis (DTA), and Surface area analysis were employed for characterization of the adsorbents microstructure. Operating factors such as adsorbent dose, solution pH, initial phenol concentration, and contact time were studied. The experimental data displayed that the increase of the adsorbent dose, contact time, and pH value from 2 to 7 increases the efficiency of the removal process. Optimal conditions for phenolic removal were; contact time of 300 min, primary phenol solution of 25 mg/L, pH 7 and 2.5 g/L as an appropriate adsorbent dose using crude (natural), acid modified and base modified kaolin clays. The higher phenolic removal efficiencies were obtained at 5 mg/L as 90, 97, 96.2%, respectively, for the adsorbents in the previously mentioned order. The adsorption capacity in the removal of phenol and 4-chlorophenol were 7.481 and 4.195, 8.2942 and 3.211, and 8.05185 and 18.565 mg/g, respectively, for the adsorbents in the same mentioned order. The adsorption equilibrium data were fitted and analyzed with four isotherm models, namely, Langmuir, Freundlich, Temkin, and Dubinin–Radushkevich isotherm equations. The adsorption process of phenol on studied adsorbents was exothermic, spontaneous and thermodynamically favorable proved by the negative values of their thermodynamic parameters ΔH° and ΔG°. The correlation coefficient (R²) for all concentrations was higher than 0.94, which indicates that in the studied system, the data suitably fit the first-order kinetics. The % desorption capacity was amounted to 96%, 91.11%, and 87.06% of adsorbed phenol, respectively, for the adsorbents in the previous order using 0.1N NaOH and 10% V/V ethanol solutions as eluents at 25°C, indicating the reusability of the adsorbents. Kaolin and its modified forms can be introduced as eco-friendly and low-cost adsorbents in water remediation implementation.     

模拟酸雨对氧化锰吸附砷(Ⅲ)的解吸行为研究

以合成的氧化锰为吸附剂研究了酸雨pH值、酸雨离子强度、解吸时间和解吸次数等因素对模拟酸雨解吸砷(Ⅲ)的影响。实验结果表明:氧化锰对砷(Ⅲ)吸附容量较大,等温平衡吸附量为:48.38 mg/g。模拟酸雨的pH值与离子强度对砷(Ⅲ)的解吸影响不大;解吸反应在90 min后基本达到平衡,平衡解吸量为2.69×10-2mg/g;随解吸次数的增加解吸量变化不大。氧化锰对砷(Ⅲ)的吸附主要是专性的配位吸附,吸附砷(Ⅲ)后难以被模拟酸雨解吸。     

水溶性羧甲基壳聚糖对Cd2+的解吸行为研究

为改善壳聚糖(CTS)的水溶性及对重金属的配位能力,合成水溶性好并能与重金属形成配位作用的水溶性羧甲基壳聚糖(WSCC),研究了WSCC对镉的增溶、解吸行为,考察了pH、离子强度、有机质含量和WSCC初始浓度对镉的解吸影响。结果表明:WSCC对碳酸镉的增溶效果显著,当其质量浓度为2g/L时溶液中Cd2+可达到275mg/L;WSCC对镉解吸能力随着土壤中有机质含量的增加而降低,pH的升高、离子强度的增加和WSCC初始浓度的增加有利于镉的解吸;WSCC对镉污染土壤的解吸更符合准二级动力学方程,该静态解吸研究可以为镉污染土壤的修复提供基础信息及依据。     

生物与化学表面活性剂协同洗脱土壤中PCBs的研究

通过序批实验和土柱淋洗实验研究了由生物表面活性剂鼠李糖脂(RL)与非离子化学表面活性剂十二烷基醇聚氧乙烯(6)醚(POE(6))混合得到的复配试剂洗脱污染土壤中多氯联苯(PCBs)的作用效果及其作用机理。结果表明,同一土样中,从批实验得到的PCBs洗脱率略高于土柱淋洗实验。RL与POE(6)两种单一试剂对人工污染土样中的PCBs洗脱率均大于60%,而对陈化土样中的洗脱率均不到20%,且土壤中的TOC含量越高,PCBs的洗脱率越低。在质量浓度为301 mg/L(10 CMC)及1 505 mg/L(50 CMC)的RL-POE(6)复配试剂中,RL与POE(6)对人工污染土壤中PCBs的洗脱具有一定的协同作用。当复配试剂的浓度为301 mg/L时,RL与POE(6)对陈化土样中PCBs的洗脱没有协同作用;但当RL-POE(6)的浓度增加到1 505 mg/L时,RL与POE(6)对陈化土样中PCBs的洗脱具有明显的协同作用。     

泥炭对甲苯的吸附-解吸行为研究

用热处理方法对泥炭进行活化改性,探讨了对甲苯的吸附性能及影响因素,并研究了甲苯在泥炭上的吸附/解吸行为。结果表明,粒径在0.6～1 mm之间的泥炭在160℃热处理5 h,在pH为7的条件下对甲苯有良好的吸附效果,对甲苯的吸附量为0.32 mg/g。泥炭对甲苯的吸附在20 min内基本达到平衡,可用二级吸附速率方程进行拟合。甲苯在泥炭上的吸附和解吸均呈现明显的非线性,用Langmuir模型能较好地描述,泥炭对甲苯的饱和吸附量为0.939 mg/g。甲苯在泥炭上的平均解吸率为6.393%,并且出现了滞后现象,表明苯系物与泥炭有较强的结合能力。研究结果为应用泥炭作为PRB装填介质进行原位修复甲苯污染的地下水提供了理论依据。     

Compound specific carbon and hydrogen stable isotope analyses of volatile organic compounds in various emissions of combustion processes

This study presents carbon (δ¹³C) and hydrogen (δD) isotope values of volatile organic compounds (VOCs) in various emission sources using thermal desorption-gas chromatography-isotope ratio mass spectrometry (TD-GC-irMS). The investigated VOCs ranged from C6 to C10. Samples were taken from (i) car exhaust emissions as well as from plant combustion experiments of (ii) various C3 and (iii) various C4 plants. We found significant differences in δ values of analysed VOCs between these sources, e.g. δ¹³C of benzene ranged between (i) −21.7 ± 0.2‰, (ii) −27.6 ± 1.6‰ and (iii) −16.3 ± 2.2‰, respectively and δD of benzene ranged between (i) −73 ± 13‰, (ii) −111 ± 10‰ and (iii) −70 ± 24‰, respectively. Results of VOCs present in investigated emission sources were compared to values from the literature (aluminium refinery emission). All source groups could be clearly distinguished using the dual approach of δ¹³C and δD analysis. The results of this study indicate that the correlation of compound specific carbon and hydrogen isotope analysis provides the potential for future research to trace the fate and to determine the origin of VOCs in the atmosphere using thermal desorption compound specific isotope analysis.     

Cr(Ⅵ)在Mg-Al型类水滑石上的脱附性能研究

研究了Cr(Ⅵ)在带结构正电荷的Mg-Al型类水滑石(HTlc)上的脱附性质,考察了多种脱附剂的脱附性能,研究了脱附剂种类、浓度、pH值和脱附时间等因素的影响。实验表明,脱附平衡时间比吸附平衡时间稍长,不同的脱附剂脱附效果不一样,对同一种脱附剂来说,随着脱附剂浓度的增大,脱附量增大;随着pH值的升高,脱附量总体呈上升趋势。     

离子液体R3NANR3的制备及其脱硫性能

以二元酸和短链叔胺为原料,合成了已二酸三乙胺盐离子液体———R3NANR3。对该离子液体进行SO2气体的循环吸收和解吸行为的研究。实验结果表明,R3NANR3离子液体能对SO2气体进行有效的化学吸收。该吸收过程分二步进行,以第一步吸收为主。室温下(20℃)该离子液体在3 h以内吸收速率较快,3 h后吸收速率减慢并逐渐达到平衡。R3NANR3离子液体与SO2气体饱和吸收量的物质的量之比为1.08。较高温度将导致SO2气体的解吸,在90℃时饱和吸收液能较充分地解吸,残留量为0.0010 mol/L。多次吸收和解吸测试表明,R3NANR3离子液体能实现对SO2气体的循环吸收和分离,将成为烟气中SO2气体的脱除和利用的重要循环吸收剂。     

施用高炉渣对土壤磷吸附-解吸特性的影响

采用振荡平衡法,研究了施用高炉渣对土壤磷的吸附解吸特征的影响。结果表明:Langmuir、Freundlich和Temkin方程都能较好地描述高炉渣对土壤磷的吸附特征,但以Langmuir模型为最优。与对照处理相比,施用高炉渣的土壤吸附平衡常数k值增大,自由能ΔG降低,最大吸附量Xm和最大缓冲容量MBC提高;磷的解吸量增加,总解吸量和总解吸率分别是对照处理的1.05～1.25倍和1.02～1.36倍;施用高炉渣还能减弱吸附-解吸过程中的滞后效应。上述结果说明施用高炉渣可以改善土壤保蓄和供应磷的能力。     

交联壳聚糖珠吸附活性染料的动力学研究

利用交联剂环氧氯丙烷(ECH)对壳聚糖进行改性,制备了交联壳聚糖珠,对活性染料(活性艳蓝ST-RV)的脱色性能进行了研究。分别从起始染料浓度(100～200 g/cm3)、温度(30～50℃)以及pH(7～9)考察了对染料吸附的动力学影响。当起始染料浓度为200 g/cm3,温度30℃,pH=7时,交联壳聚糖珠对ST-RV的吸附量达到77.49 mg/g。用准一级和二级动力学模型描述了动力学数据并确定了速率常数,最后进行了交联壳聚糖珠的再生实验。结果表明,吸附数据符合二级动力学模型;当pH=10时,交联壳聚糖珠可少量解吸。