Biospheric influence on carbon dioxide measurements in Italy

The study concerning carbon dioxide measurements taken during the 1997, 1998 and 1999 summer campaigns at two different altitude stations and biospheric conditions are presented. The higher station (Mt. Cimone, 2165 m a.s.l.) is characterised by 360° free horizon and is located on a rocky mountain while the lower (Ninfa lake, 1550 m a.s.l.) is located inside the red spruce and beech forest. The different behaviour of CO₂ at the two mountain stations has been registered. It shows the strong effect of nighttime soil emission and vegetation respiration on CO₂ mixing ratio increases and of diurnal vegetative activity on CO₂ concentration decreases at the lower measurement site. The baseline character of the higher measurement site has been confirmed by comparison of CO₂ diurnal amplitudes recorded at the two stations.     

Semi-analytical solution of two-dimensional sharp interface LNAPL transport models

In this paper, we present semi-analytical solutions for two-dimensional equations governing transport of Light Non-Aqueous Phase Liquids (LNAPL) in unconfined aquifers. The proposed model is based on sharp interface displacement and steady groundwater flow assumptions, where both the water–LNAPL interface and the LNAPL–air interface are represented as sharp interfaces. In the case of steady groundwater flow, these equations can be reduced to a two-dimensional nonlinear solute transport equation, with the LNAPL thickness in the free product lens being the primary unknown variable. The linearized form of this solute transport equation falls into the category of two-dimensional transport equation with time-dependent dispersion coefficients. This equation can be solved analytically for an infinite domain region. In this paper, the general form of the analytical solution for the transport equation, as well as the solutions for some specific cases are presented. To demonstrate the utility of the proposed solution, numerical results obtained for two example problems are discussed and presented comparatively with a finite-element solution and other more restrictive solutions available in the literature. Although the solutions discussed in this paper have some simplifying assumptions, such as sharp-interfaces between fluid phases, steady groundwater flow and homogeneous aquifer properties, the semi-analytical solutions presented in this study may be used effectively as bench mark solutions in evaluating LNAPL migration in the subsurface. These solutions are simple and cost effective to implement and may be used in the calibration of other more complex numerical solutions that can be found in the literature.     

带压开采陷落柱突水影响因素数值模拟

为研究承压水压与煤层陷落柱位置这两种因素对陷落柱突水的影响,在分析固流耦合数学模型的基础上,利用数值模拟软件FLAC3D,以双柳矿地质条件为背景,分别对3 MPa和5 MPa承压水压下开采上、下两组煤4种情况进行模拟,分析陷落柱及其周边围岩的渗流-塑性破坏耦合场、应力场和位移场的变化.结果表明:随着工作面推进至接近陷落柱,工作面前方集中应力场与柱体周边应力场发生耦合,并出现应力集中,当水压为5 MPa开采上组煤时应力集中系数最大,最容易形成突水危险区域;当上组煤工作面距离陷落柱为30 m时,陷落柱渗流场与集中应力场开始连通,在开采下组煤时这一距离比上组煤扩大15 ～ 20 m;煤层底板随工作面推进发生压缩-膨胀周期变化,引起拉伸、剪切破坏.     

基于井口涌水量变化类型判断岩溶含水层厚度

针对含水相对均匀的溶洞-裂隙水含水岩组,为判断岩溶含水层厚度,通过对空气潜孔锤钻进工艺施工钻孔井口涌水量变化进行分析,结果发现:利用该工艺施工的钻孔井口涌水量一般会出现稳定型、降低型和增长型三种变化类型;井口涌水量变化类型反映了岩溶含水层是空间尺度上发育的垂向地下水系统,具有分层特征,其厚度与碳酸盐岩岩溶化程度的不均一性耦合,体现了碳酸盐岩岩体内不同空隙的发育规模、密度及其相互间的联系程度;明确了地下水埋深状况以及含水层的构成条件。故采用空气潜孔锤钻进工艺施工的钻孔,在非干孔情形下,可以利用井口涌水量的变化类型判断岩溶含水层厚度。     

常见金属硫化物电化学反应环境效应及其影响因素分析

金属硫化物矿物作为重要的金属矿产资源之一,在自然界广泛分布并易氧化(电化学反应)引起重金属离子和酸性矿山废水污染的环境效应。本文以黄铁矿和黄铜矿为例全面分析了金属硫化物矿物环境效应产生机制,以及影响金属硫化物矿物电化学反应的各种因素,指出了当前研究存在的不足。这对金属硫化物矿区环境污染的源头控制与修复具有重要的指导意义。     

重庆三叠系碳酸盐岩热储热水水文地球化学特征

地下热水的水文地球化学特征研究有利于地下热水的开发,对重庆三叠系碳酸盐岩热储热水的研究可以更好地实现重庆地下热水的可持续开发。通过2009年1月和2009年7月对重庆市三叠系碳酸盐岩热储热水进行野外监测、取样和室内分析,发现重庆三叠系碳酸盐岩热储热水水化学性质相近,pH呈中性,水温30℃~50℃,电导率为1 320 μs/cm~3 250 μs/cm,水化学类型为SO₄-Ca(Mg)型,是典型的碳酸盐岩热储中-低温地下热水。温泉水的主要阳离子为Ca²⁺和Mg²⁺,阴离子为SO₄^2-和HCO₃^-,除青木关温泉外,SO₄^2-和Ca²⁺、Mg²⁺随时空变化较小,体现了碳酸盐岩中石膏与地下热水的水-岩作用对地下热水水文地球化学特征的控制。热水中的方解石和白云石都处于饱和与不饱和的临界状态,没有明显钙华沉积的现象;Na-K-Mg-Ca图解显示各个季节地下热水的物质来源基本一致,均没有达到水岩平衡状态。     

乙醇对含水层中燃油芳香烃内在生物修复的潜在风险

内在生物修复,是在没有工程措施促进的情况下利用土著微生物降解含水层内灾害性物质的一种修复技术,在燃油烃污染管理方面具有显著的成本效益。该技术需要确定自然衰减过程,并能够继续提供有效的风险保护。针对燃油污染含水层,北美与欧洲认为内在生物修复是值得优先考虑的应用技术。然而,随着乙醇燃油的推广使用,我国在应用这样的经验时需要考虑乙醇的潜在影响。现有的文献研究表明乙醇存在能够阻止燃油主要污染物芳香烃(BTEX)的生物降解,降低水环境的pH值,并可能增强BTEX在水中的溶解性,或存在对生物的毒性,或因为乙醇降解降低介质的渗透性能。因此,需要更好地认识乙醇的潜在风险,为发展乙醇燃油污染含水层修复策略提供科学依据。     

Surface clogging process modeling of suspended solids during urban stormwater aquifer recharge

Aquifer recharge,which uses urban stormwater,is an effective technique to control the negative effects of groundwater overexploitation,while clogging problems in infiltration systems remain the key restricting factor in broadening its practice.Quantitative understanding of the clogging process is still very poor.A laboratory study was conducted to understand surface physical clogging processes,with the primary aim of developing a model for predicting suspended solid clogging processes before aquifer recharge projects start.The experiments investigated the clogging characteristics of different suspended solid sizes in recharge water by using a series of one-dimensional fine quartz sand columns.The results showed that the smaller the suspended particles in recharge water,the farther the distance of movement and the larger the scope of clogging in porous media.Clogging extents in fine sand were 1 cm,for suspended particle size ranging from 0.075 to 0.0385 mm,and 2 cm,for particles less than 0.0385 mm.In addition,clogging development occurred more rapidly for smaller suspended solid particles.It took 48,42,and 36 hr respectively,for large-,medium-,and small-sized particles to reach pre-determined clogging standards.An empirical formula and iteration model for the surface clogging evolution process were derived.The verification results obtained from stormwater recharge into fine sand demonstrated that the model could reflect the real laws of the surface clogging process.     

地质封存中CO_2盐水溶液的表观摩尔体积模型

在现有CO2盐水溶液密度模型的基础上,根据CO2地下盐水溶液密度实验数据,考虑了温度、压力和CO2质量分数三个参数的影响,建立了CO2盐水溶液的表观摩尔体积模型。模型结果表明该模型能在30~50℃、10~20 MPa温压范围内准确预测CO2在盐水溶液中的表观摩尔体积,将预测结果与实验数据进行对比发现最大相对误差为0.25%,平均相对误差为0.1%,模型预测精度明显高于现有的CO2盐水溶液表观摩尔体积模型,为CO2地下盐水层封存提供了必要的基础。     

基于吸附质-分子探针的新型交联壳聚糖的吸附特性

研究了CCTS对低浓度游离酸的吸附特性,基于吸附质-分子探针电位法,考察了吸附剂活性中心数目、游离酸种类和温度对吸附行为的影响。结果表明,在30℃时,CCTS吸附游离酸的过程,遵循单分子层机理进行吸附。吸附剂―吸附质相互作用能U制约表观吸附速率常数K,K、U大小分别为2.519×10-2,4.084×10-2,9.398×10-2L/min和7.264,7.420,7.926 kJ/mol,两者存在线性相关性,呈逐渐增大趋势。K、U大小随着活性中心数目G的增加而增大。CCTS吸附游离酸为吸热过程,吸附表观活化能Ea为33.98 kJ/mol。3种类型游离酸K、U的大小顺序为:HClO4>HNO3>H2SO4,吸附分维数Dw分别为1.384、1.567、1.911,Dw值越大,导致表观吸附速率常数降低。