锌精炼铅塔燃烧系统烟气温度模糊控制研究

针对锌精馏铅塔动态过程中的非线性、非最小相位特征、不稳定性、时滞和负荷干扰,基于模糊控制策略下给出了锌精馏铅塔燃烧系统新的控制方法.运用模糊控制系统对锌精馏铅塔的烟气温度进行仿真研究和实时控制结果表明,该研究所设计的模糊控制器能够克服许多干扰因素,产生了良好的控制效果.     

基于正交试验方法的毛细矩形槽道平均流速影响因素分析

目的 分析毛细矩形槽道平均流速的影响因素.方法 通过公式推导毛细矩形槽道平均流速的有关影响因素,并且从中提取出部分因素,选用三因素三水平的正交试验表对流速进行分析,三因素分别为槽道宽度、槽道深度、槽道长度.通过CFX仿真得出对应的平均流速.结果 得到了各因素水平变化对毛细矩形槽道平均流速的影响程度.槽道宽度及槽道深度对...     

高效液相色谱-三重四级杆/复合线性离子阱质谱法测定饮用水中22种邻苯二甲酸酯

建立了一种同时测定饮用水中22种邻苯二甲酸酯(PAEs)的高效液相色谱-三重四级杆/复合线性离子阱质谱方法:饮用水样品经针头过滤器过滤,选用Biphenyl液相色谱柱进行分离,以含0.1%甲酸的水溶液和含0.1%甲酸的甲醇溶液为流动相,电离模式为电喷雾正离子,选用多反应监测触发增强子离子扫描模式进行检测。结果表明,22种PAEs的灵敏度良好,定量限为0.001～0.1 μg/L。配制浓度为0.1～100.0 μg/L的混标溶液进行进样分析,分析结果显示,22种PAEs在该范围内的线性关系良好,相关系数均大于0.995,方法的平均回收率为82.9%～108.9%,相对标准偏差为0.9%～11.2%。同时,使用增强子离子扫描谱图进行搜库匹配,定性准确性高。该方法适用于饮用水中PAEs的检测。     

阴角邻面火灾作用下L型钢管混凝土柱耐火极限研究

运用有限元软件ABAQUS计算L形带肋钢管混凝土柱阴角相邻两面受火全过程下的耐火极限,分析了阴角邻面受火方式下构件内部温度场和应力场的变化规律,在此基础上分析荷载比、宽厚比、计算长度、加劲肋纵向间距、荷载偏心率、荷载角等参数对耐火极限的影响规律。数据表明:荷载比、计算长度对构件耐火极限影响较大,随着荷载比和计算长度的增大,耐火极限基本呈线性下降;加劲肋间距对构件耐火性能影响较小;由于L形柱的特殊形式,偏心荷载对耐火极限的影响规律较复杂,荷载作用点偏向低温区可以提高耐火极限。     

石油污染土壤原位生物修复的强化实验研究

为研究添加营养物质和高效降解石油微生物对油污土壤生物修复的作用,通过分层土柱的方法,连续监测了不同条件下不同土层的含水率、石油烃含量、细菌数量及脱氢酶活性。结果表明:添加营养物质同时接种高效微生物可使降解效果明显改善,降解率比在自然条件下提高近50%,而单纯添加营养物质不接种高效微生物可使降解率比在自然条件下提高约25%。降解初期,上层土壤降解效果较好,而到中后期,中下层降解效果好于上层。微生物数量和脱氢酶活性与石油降解率之间存在良好的相关性,脱氢酶活性比微生物数量更能反映修复过程中微生物的存活状态。添加营养物质和高效降解石油微生物对油污土壤原位生物修复具有强化作用。     

火灾下约束钢柱临界温度的简化计算方法

在火灾条件下,约束钢柱轴力由于升温而增加,会导致在较低的温度下发生屈曲;但屈曲后,钢柱的轴向温度膨胀得到释放,轴力下降,因此屈曲后钢柱仍能继续承栽。本文通过计算长度系数将转动约束钢柱转换为铰支钢柱,给出了一种轴向约束钢柱在火灾升温条件下的临界温度的简化计算方法——轴力放大系数设计方法。此法通过轴力放大系数将轴向约束钢柱转化为无约束钢柱,再按无约束钢柱计算得到钢柱的临界温度。用验证过的有限元模型对简化计算方法进行了验证,计算结果表明简化方法吻合较好。     

约束高强度Q460钢柱抗火性能分析

为了研究高强度约束钢柱在火灾下的反应,根据高强度结构钢Q460在高温下的力学性能参数,建立了约束高强度钢柱受火分析模型,得到了高强度约束钢柱在火灾下的轴向位移、跨中挠度、最大应力以及临界温度。采用有限元分析对理论结果进行了验证,两者吻合很好。利用验证过的该文计算方法计算了2种荷栽比、长细比和约束刚度比条件下的高强钢柱的抗火性能;采用CECS200:2006的力学性能参数计算了约束普通钢柱的抗火性能。通过对高强钢和普通钢的抗火性能分析发现,轴向约束明显降低钢柱的临界温度,长细比、荷载比越大,临界温度越低;高强钢的抗火性能要优于普通钢。     

Enhanced retention of linuron, alachlor and metalaxyl in sandy soil columns intercalated with wood barriers

A study has been made of the effect a reactive barrier made of pine (softwood) or oak (hardwood) wood intercalated in a sandy soil column has on the retention of linuron, alachlor and metalaxyl (pesticides with contrasting physicochemical characteristics). The leaching of pesticides has been carried out under a saturated flow regime and breakthrough curves (BTCs) have been obtained at flow rates of 1 mL min⁻¹ (all pesticides) and 3 mL min⁻¹ (linuron). The cumulative curves in the unmodified soil indicate a leaching of pesticides >80% of the total amount of compound added. After barrier intercalation, linuron leaching decreases significantly and a modification of the leaching kinetics of alachlor and metalaxyl has been observed. The theoretical R factors increased ∼2.6-3.3, 1.2-1.6-fold, and 1.4-1.7-fold and the concentration of the maximum peak decreased ∼6-12-fold, 2-4-fold and 1.2-2-fold for linuron, alachlor and metalaxyl, respectively. When considering the three pesticides, significant correlations have been found between the theoretical retardation factor (R) and the pore volume corresponding to the maximum peaks of the BTCs (r = 0.77; p < 0.05) or the total volume leached (r = −0.78; p < 0.05). The results reveal the efficacy of reactive wood barriers to decrease the leaching of pesticides from point sources of pollution depends on the type of wood, the hydrophobicity of the pesticide and the adopted water flow rate. Pine was more effective than oak in decreasing the leaching of hydrophobic pesticide linuron or in decreasing the maximum peak concentration of the less hydrophobic pesticides in soils. Efficacy of these wood barriers was limited for the least hydrophobic pesticide metalaxyl.     

Transport of chlorinated dioxins and furans in soil columns: modeling pentachlorophenol pole-treating oil influence

Column experiments were conducted to validate a screening model predicting the influence of pentachlorophenol (PCP) pole-treating oil on the vertical migration of its impurities, chlorinated dioxins and furans (PCDD/Fs). PCP pole-treating oil (15 mL d⁻¹) and water (20 mL d⁻¹) were added daily to the top of sand and organic soil columns during 35 d. Column soil samples were analyzed to determine concentrations of hydrocarbons and PCDD/Fs at several depths in the columns (0-30 cm) and their evolution in time (7, 14, 21 and 35 d).The model predicted a significant vertical migration of PCDD/Fs due to the presence of oil as a free phase and PCDD/Fs were found in the different column layers at concentrations consistent with model predictions (same order of magnitude). Measured PCDD/Fs concentrations are in total disagreement with literature data and with model prediction in the absence of oil free phase, which implies PCDD/F properties alone cannot be used to predict their fate in the current context: the influence of PCP pole-treating oil must be accounted for to properly explain their migration.     

Hydrothermal liquefaction phase behavior of microalgae & model compounds in fused silica capillary reactor

A fused silica capillary reactor combined with a heating/cooling stage, a microscope and a digital camera were used to investigate phase behavior during the hydrothermal liquefaction of microalgae (Dunaliella tertiolecta) and model compounds, including soya protein and glycine, starch, glucose and xylose, stearic acid and palmitic acid. Bubbles were generated at 246°C and disappeared at 360°C upon heating when Dunaliella tertiolecta used as feedstocks. Moreover, liquid products were generated at 300°C upon heating and oily liquid products began to separate out at 250°C upon cooling. The phase behavior of soya protein was similar to that of the Dunaliella tertiolecta. Meanwhile, there only observed the bubbles generation during hydrothermal liquefaction of glycine. Heating the starch, glucose and xylose above 350°C generated black solids from carbonization. Stearic acid and palmitic acid only had the process of melting, dissolution, dispersion and precipitation.