Catalysts for decomposing ozone tail gas

The preparation of immobilizing-catalysts for decomposing ozone by using dipping method was studied. XRD, XPS and TEM were used to characterize the catalysts. The three kinds of catalysts were selected preferentially, and their catalytic activities were investigated. The results showed that the catalyst with activated carbon dipping acetate( active components are Mn:Cu = 3:2, active component proportion in catalyst is 15%, calcination temperature is 200℃ ) has the best catalytic activity for ozone decomposing. One gram of catalyst can decompose 17.6g ozone at initial ozone concentration of 2.5g/m^3 and the residence time in reactor of 0.1s. The experimental results also indicated that humidity of reaction system had negative effect on catalytic activity.     

催化裂化废水连续萃取脱酚研究

选用焦化粗柴油为萃取剂，在转盘萃取搭连续试验装置中，对催化裂化含酚废水进行脱酚预处理。结果表明，用焦化粗柴油做萃取剂，进水ｐＨ值为８０～９０不加调节；油水比（体积比）１７∶１～２１∶１；转盘转数１１００ｒ／ｍｉｎ，酚萃取脱除率达到８５％以上。萃取后的粗柴油依据现有工艺而进行加氢精制，不需进行再生等后处理。整个萃取工艺简单易行，能满足预处理的要求     

Cu／A1-Ce-PILC在丙烯选择性催化还原NO反应中的失活研究

采用聚合羟基复合阳离子合成交联黏土A1-Ce-PILC，经SO4^2-改性后，以浸渍法制备了铜基交联黏土催化剂Cu／A1-Ce-PILC，并将其应用于C3H6选择性催化还原NO的反应，350℃时NO转化率达到最大值56％，700℃时下降至22％．为探究催化剂高温失活的原因，采用XPS、TPR、TGA、Py-IR和DSC对反应前后催化剂的物化性能进行了表征．结果表明，经过H2预处理活化后活性组分Cu物种以Cu^＋形式存在，而高温反应后Cu物种除以Cu^＋和Cu^2＋ 2种形式存在外，还出现了少量CuO物种；高温反应过程中A1-Ce-PILC上结构羟基和SO4^2-流失导致催化剂表面酸性减弱；此外，还存在表面积炭覆盖了部分活性中心并堵塞了催化剂孔道的现象．这三者的共同影响促进了C3H6深度氧化，抑制了NO还原，从而导致催化剂的失活．     

大气环境的光触媒净化技术

介绍了光触媒对大气环境净化的机理，着重讨论了TiO2光触媒的活性、固定以及对大气污染杨的处理过程、问题等，并对光触媒技术的未来作了展望，以期推动我国在光触媒技术方面的研究。     

SCR反应塔入口段烟气速度场的数值模拟

使用商业计算软件CFX5．7．1，采用标准k-ε湍流模型，模拟了SCR脱硝反应塔入口段烟气速度场，并分析比较了导流板对烟气速度场的影响及均匀SCR反应塔进口处烟气速度场的作用。     

多相催化湿式氧化法处理高浓度难降解有机废水的研究

在高压反应釜内，采用自制颗粒贵金属催化剂催化湿式氧化法处理高浓度饲料抗氧化剂合成废水，探讨了温度、压力、进水pH等反应条件对废水处理效果的影响。在温度为220℃、总压为8MPa条件下，COD，TOC，TN和色度的去除率分别达到77．0％，66．1％，70．2％，91％；处理后的废水pH很低，催化剂显示出较好的耐酸性；随进水pH的增加，COD的去除率逐渐降低，出水pH增加。     

钯离子液相催化氧化低浓度磷化氢

采用Pd^2＋液相催化氧化低浓度PH3,考察了Pd^2＋浓度、O2体积分数、PH3质量浓度、混合气流量、反应温度等因素对Pd^2＋吸收液去除低浓度PH3效果的影响。实验结果表明,采用10mL Pd^2＋浓度为0．112mol／L的水溶液作为吸收液净化含低浓度PH3的混合气,在反应温度22℃、O2体积分数5％、PH3质量浓度850mg／m^3、混合气流量190mL／min的条件下,印min之内PH3去除率保持在90％以上。Pd^2＋浓度越高、O2体积分数越大、反应温度越高,PH3去除率越高;混合气流量越大,PH3去除率越低;反应温度越低、O2体积分数越大,PH3去除率的下降速率越小。     

钴（Ⅱ）－过氧化氢－苯基荧光酮体系催化光度法测定痕量钴的研究

本文研究了钴（Ⅱ）催化过氧化氢氧化苯基荧光酮的褪色反应,测定了反应级数和表观活化能,建立了测定痕量地的新方法。２５℃时本法检出限为２９×１０－１３ｇ／ｍｌ,线性范围为０．０４～２ｎｇ／１０ｍｌ,催化反应表观活化能为５６．１５ＫＪ／ｍｏｌ。该方法己用于维生素Ｂ１２、人发和茶叶中痕量钴的测定．结果满意,相对标准偏差为２．４～３．４％。     

Combination of biodiesel-ethanol-diesel fuel blend and SCR catalyst assembly to reduce emissions from a heavy-duty diesel engine

In this study, the efforts to reduce NOx and particulate matter （PM） emissions from a diesel engine using both ethanol-selective catalytic reduction （SCR） of NOx over an Ag/Al2O3 catalyst and a biodiesel-ethanol-diesel fuel blend （BE-diesel） on an engine bench test are discussed. Compared with diesel fuel, use of BE-diesel increased PM emissions by 14% due to the increase in the soluble organic fraction （SOF） of PM, but it greatly reduced the Bosch smoke number by 60%-80% according to the results from 13-mode test of European Stationary Cycle （ESC） test. The SCR catalyst was effective in NOx reduction by ethanol, and the NOx conversion was approximately 73%. Total hydrocarbons （THC） and CO emissions increased significantly during the SCR of NOx process. Two diesel oxidation catalyst （DOC） assemblies were used after Ag/Al2O3 converter to remove CO and HC. Different oxidation catalyst showed opposite effect on PM emission. The PM composition analysis revealed that the net effect of oxidation catalyst on total PM was an integrative effect on SOF reduction and sulfate formation of PM. The engine bench test results indicated that the combination of BE-diesel and a SCR catalyst assembly could provide benefits for NOx and PM emissions control even without using diesel particle filters （DPFs）.     

离子液体催化木质素转化制备丁香醛

木质素的高值转化对于生物质的全组分利用具有重要意义,直接关乎生物炼制产业链的经济可行性。离子液体作为一种新型催化剂,具有较高的可设计性、结构稳定性和热稳定性,可用于木质素催化转化制备具有高附加值的小分子产物以提高木质素的利用效率。以乙醇胺类和胍类离子液体为催化剂,考察了木质素种类与用量、催化剂种类与浓度、反应温度和pH值等因素对丁香醛收率的影响。结果表明：当催化剂为乙醇胺四氟硼酸盐[MEA]BF4,木质素与催化剂用量比为2∶1,固液比1∶150,温度160 ℃,pH=4.35,反应6 h后丁香醛收率最高,为9.20%。