粒子电极对苯酚废水的电催化降解

以溶胶-凝胶法制备了负载型复合金属氧化物Mn-Sn-Sb/γ-Al₂O₃粒子电极,用该粒子电极取代平板电极,对苯酚水溶液进行了电催化降解的研究,并考察了pH,电解质浓度,槽电压,进水ρ(苯酚),反应温度和气体流量等因素对苯酚去除率的影响.结果表明,当反应温度为25 ℃,pH为6.4,气体流量为0.5 L/min,槽电压为6.5 V,电解质浓度为0.025 mol/L时,电催化降解质量浓度为200 mg/L的苯酚水溶液150 min,苯酚去除率为94.0%,催化活性较高.提高进水ρ(苯酚),会使反应表现为自抑制作用;提高温度有利于苯酚电催化氧化的进行,但会增加石墨电极损耗和催化剂溶出量,因此在选择电催化氧化温度时要考虑设备的耐蚀性和电极的稳定性.      

电动生物修复中电极矩阵的优化设计

对电动生物修复中单对电极间的电场分布进行了模拟,并以此定义了修复的有效作用区.通过旋转叠加的方式,求出了各种电极矩阵构型的有效作用区分布,最后筛选出2种优化的电极构型,并通过小型实验加以验证.理论优化和实验结果表明,“中”字形和六边形分别是不同旋转方式下最优的电极构型.采用这2种电极构型,可节省电极材料费,同时保持系统的稳定性和污染物去除的均匀性,因而具有良好应用前景.     

三维固定床电极法降解焦化废水

采用三维电极固定床技术对焦化废水进行了深度处理的实验研究,并取得了相应的工艺参数。实验研究结果表明,三维电极技术能有效的处理焦化废水,在槽电压为12V,液体催化剂量为1500mg/L,反应时间为60min,pH为3,COD去除率可达62%。     

掺硼金刚石电极处理榨菜废水试验研究

掺硼金刚石(BDD)电极在电化学氧化难生物降解性废水时具有电化学性能良好、处理效果好等特点,因而受到广泛关注.本试验采用BDD电极电化学氧化榨菜废水,并考察了稀释比、初始pH值、电流密度、极板间距等参数对COD、氨氮(NH3-N)去除率的影响.试验结果表明:在稀释比为1∶2、电流密度50 mA·cm-2、未调节pH值、极板间距为15 mm的最优工况下,COD、NH3-N去除率分别为96.9%、100%.COD去除率满足线性方程y=0.435t(R2=0.9899),NH3-N去除率满足多项式拟合方程y=0.53+0.936t+0.031t2-3.46×10-4t3(R2=0.9956).研究表明,BDD电极电化学氧化榨菜废水是一种有效的高级氧化工艺.     

Mechanism of enhanced removal of quinonic intermediates during electrochemical oxidation of Orange Ⅱ under ultraviolet irradiation

The effect of ultraviolet irradiation on generation of radicals and formation of intermediates was investigated in electrochemical oxidation of the azo-dye Orange I1 using a TiO2-modified β- PbO2 electrode. It was found that a characteristic absorbance of quinonic compounds at 255 nm, which is responsible for the rate-determining step during aromatics degradation, was formed only in electrocatalytic oxidation. The dye can be oxidized by either HO radicals or direct electron transfer. Quinonic compounds were produced concurrently. The removal of TOC by photo-assisted electrocatalytic oxidation was 1.56 times that of the sum of the other two processes, indicating a significant synergetic effect. In addition, once the ultraviolet irradiation was introduced into the process of electrocatalytic oxidation, the degradation rate of quinonic compounds was enhanced by as much as a factor of two. The more efficient generation of HO radicals resulted from the introduction of ultraviolet irradiation in electrocatalytic oxidation led to the significant synergetic effect as well as the inhibiting effect on the accumulation of quinonic compounds.     

阳极内添加阳离子交换树脂提升辊压“三合一”膜电极MFC性能

阳极-隔膜-阴极的"三合一"膜电极结构能够最大程度减小阴阳极间距,提高微生物燃料电池(microbial fuel cell,MFC)的输出功率.为进一步提高MFC性能,本研究使用非贵金属材料构建了辊压"三合一"膜电极系统,其欧姆内阻降低至3~5Ω.以乙酸钠为底物,MFC的最高功率密度达到446 m W·m-2.向阳极内添加固体小球(如聚苯乙烯球和玻璃微球)可在辊压过程中增加阳极表面和内部的大孔,强化电解液向阴极的传递从而使MFC的功率密度提升10%.添加阳离子交换树脂能够进一步强化阳极内部的质子传递,提高阴极电位,从而将功率密度提升至543 m W·m-2.此外,阳极内添加阳离子交换树脂还可提高电池运行的稳定性和库仑效率.     

三维电极体系电催化氧化效率的研究

使用三维电极反应器处理不同盐量的草酸模拟废水,以IrO_2-Ta_2O_5/Ti为阳极、5 mm的球状活性炭(granular activatedcarbon,GAC)为填料,在电流密度100 A/m²,极板间距50 mm的条件下,进行电催化氧化过程中化学需氧量(Chemical oxygen demand,COD)、电流效率(Average current efficiency)以及能耗(Energy consumption)的对比,实验结果表明在盐量为0.50%～3.00%的范围内,由于双电层电容的储能作用,提高盐量造成COD去除率有所下降,但能够提高反应末期电流效率,同时由于操作电压的降低可减少反应能耗。通过对比苯酚和草酸的电催化氧化过程证明电催化氧化过程具有较强的氧化有机物的能力。     

采用Ti/PbO2阳极氧化进行污泥预处理的研究

提高市政污泥脱水性能是当前污泥预处理中的热点和难点.本文以毛细吸水时间(CST)作为衡量污泥预处理中脱水性能的指标,选用钛/二氧化铅网状极板为阴、阳电极,研究了电解电压、极板间距、电解质种类及电解质投加量等因素对电化学预处理市政污泥的影响.结果表明,电压对污泥脱水性能影响较大,在电压为20 V、极板间距为2 cm、电解质为0.6 g Na Cl的条件下,电化学处理市政污泥20 min效果最佳,污泥的CST下降率在90%以上.进一步探究表明,电解过程中污泥菌胶团结构首先被破坏,释放大量结合水,且菌胶团内的蛋白质和多聚糖释放到上清液中,二者浓度先升高;随后二者部分氧化分解,浓度降低,从而有效提高市政污泥脱水性能.     

波形电晕线排列形态对放电特性的影响实验与分析

为了明确波形电晕极的放电特性以指导工程设计与应用,在线-板式电除尘器中,实验研究了波形电晕极排列方式对电除尘器伏安特性的影响.试验中主要考虑了2个因素对波形电晕线放电性能的影响,即波形电晕线的偏转角和波形电晕极间距.其波形电晕极的具体布置方式分为:①波形电晕线偏转角分别为0°、45°、90°;②波形电晕极间距分别为14...     

Coulometric determination of dissolved hydrogen with a multielectrolytic modified carbon felt electrode-based sensor

A multielectrolytic modified carbon electrode (MEMCE) was fabricated by the electrolytic-oxidation/reduction processes. First, the functional groups containing nitrogen atoms such as amino group were introduced by the electrode oxidation of carbon felt electrode in an ammonium carbamate aqueous solution, and next, this electrode was electroreduced in sulfuric acid. The redox waves between hydrogen ion and hydrogen molecule at highly positive potential range appeared in the cyclic voltammogram obtained by MEMCE. A coulometric cell using MEMCE with a catalytic activity of electrooxidation of hydrogen molecule was constructed and was used for the measurement of dissolved hydrogen. The typical current vs. time curve was obtained by the repetitive measurement of the dissolved hydrogen. These curves indicated that the measurement of dissolved hydrogen was finished completely in a very short time (ca. 10 sec). A linear relationship was obtained between the electrical charge needed for the electrooxidation process of hydrogen molecule and dissolved hydrogen concentration. This indicates that the developed coulometric method can be used for the determination of the dissolved hydrogen concentration.