我国农药工业三废治理方法

详细介绍了我国农药生产中排放的废水、废气、废渣的常用治理技术,通过改进生产工艺和回收利用减少三废的实例,以及主要品系农药生产废水治理方法选择的思路。     

脱硫灰与钾矿石复合生产钾钙硅镁硫肥料研究

对脱硫灰与钾矿石复合生产钾钙硅镁硫肥的研究意义、反应原理、生产流程、环境安全性能以及施肥方法等进行了介绍和评估,并对其应用前景进行了展望。研究结果表明:利用脱硫灰与钾矿石复合生产钾钙硅镁硫肥在理论上可行;生产出的产品中硫酸钾的含量达10.34%～12.0%,枸溶氧化钙19.06%～32.28%,枸溶二氧化硅10.98%～14.46%,枸溶氧化镁1.46%～1.82%。产品的pH值从原脱硫灰的10.65下降到9.60。重金属含量低于农用粉煤灰国家标准,生产过程中不会产生SO2等有害气体污染。肥料的生产成本低于350元/t,该肥料不但可以增加土壤中钾、钙、硅、镁和硫等中微量元素的含量,而且可以提高或改善农作物的产量和品质。达到变废为宝,促进循环经济发展之目的。     

污泥热解残渣制备聚合氯化铝的实验研究＊

含铝污泥热解或焚烧残渣制备聚合氯化铝的研究,有利于实现污水处理过程投加的铝盐絮凝药剂的回收与高效循环利用,减少污染物排放和资源消耗。针对辽河油田欢三联稠油污水处理污泥的热解残渣具有较高铝含量的特点,开展采用盐酸进行铝溶出及制备聚合氯化铝的实验研究。结果表明:焙烧温度为700～750℃,焙烧时间控制在1h即可。将经过焙烧活化的残渣在常温下进行酸溶,酸溶时间为2～5h,选用25%～30%盐酸,氧化铝与盐酸的摩尔比为1∶1.0～1∶1.2为宜。将溶出的铝溶液制备聚合氯化铝,在常温下采用CaO粉末来调节pH值为3.5,聚合反应时间为1d,即可得聚合氯化铝溶液。     

医疗废物焚烧处理核心技术的开发及应用

国内已建成的医疗废物焚烧设施目前普遍存在进料系统不稳定、玻璃结渣和高浓度HCl气体的排放的问题。这些技术难点已成为医疗废物焚烧处置行业发展的瓶颈。本文介绍了可解决上述问题的"可调节医疗废物恒流量进料技术"、"医废焚烧防玻璃结渣技术"和"含高浓度氯化氢医废尾气处理技术"三项医疗废物焚烧处理核心技术的主要特点及技术指标与应用实例。     

The dissipation rates of trichlorfon and its degradation product dichlorvos in cabbage and soil

The residual levels and dissipation rate of trichlorfon, and its degradation product, dichlorvos, in cabbage crops and the soil in which these were grown, were determined by gas chromatography at two geographically distant experimental sites, one in Kunming and one in Beijing, China. Trichlorfon was applied at two dosages (900 g ai ha⁻¹ and 1350 g ai ha⁻¹). Maximum final residues of trichlorfon in soil and cabbage were 1.23 mg kg⁻¹ and 1.81 mg kg⁻¹ respectively at Kunming, and 0.35 mg kg⁻¹ and 0.70 mg kg⁻¹ respectively at Beijing. However, the final residues of dichlorvos in both cabbage and soil was only 0.04 mg kg⁻¹ at Kunming, and only 0.03 mg kg⁻¹, or “not detectable”, at Beijing. The mean half-life of trichlorfon in cabbage was 1.80 d with a dissipation rate of 90% over 5 d, while that in soil was 3.05 d with a dissipation rate of 90% over 14 d at one experimental site. The dissipation rates of trichlorfon and its degradation product dichlorvos at the two experimental sites were different, suggesting that degradation of these pesticides was affected by local soil characteristics and climate. When applied at both the recommended dosage and at 1.5 times this, no detectable residues of either trichlorfon or dichlorvos were found in soil or cabbage at harvest. Although trichlorfon can easily degrade into dichlorvos, which is highly toxic to humans and other animals, the observed low residual levels of dichlorvos suggest that trichlorfon is safe when applied at the recommended dosage.     

The formation of bound residues of diazinon in four UK soils: implications for risk assessment

The behaviour of diazinon in the soil determines the likelihood of further pollution incidents, particularly leaching to water. The most significant processes in the control of the fate of diazinon in the soil are microbial degradation and the formation of bound residues. Soils from four sites in the UK were amended with diazinon and its ¹⁴C labelled analogue and incubated for 100 days. After 0, 10, 21, 50 and 100 days, the formation of bound residues was assessed by solvent extraction, and the microbial degradation of diazinon by mineralisation assay. In microbially active soils, diazinon is degraded rapidly, reducing the risk of future pollution incidents. However, where there was limited mineralisation there was also significantly lower formation of bound residues, which may lead to water pollution via leaching. The formation of bound residues was dependent on extraction type. Acetonitrile extraction identified bound residues in all soils, with the bound residue fraction increasing with increasing incubation time.     

硫酸铝渣去除水中磷研究

分别以蒸馏水和太湖水为例,研究了硫酸铝渣去除水中磷的能力,并分析了其对水体Al3+、SO24-以及pH的影响.结果表明:(1)除太湖水pH为9.0、10.0两种条件外,随着磷平衡浓度的增加,硫酸铝渣除磷量趋于某一定值,其规律符合Langmuir吸附等温式;太湖水pH为9.0、10.0两种条件下,硫酸铝渣除磷量符合Fre...     

催化裂解法处理有机硅高沸物

采用催化裂解法处理有机硅高沸物,解决高沸物储存过程中的安全、环保问题。研究了催化剂种类、HCl加入量和精馏高沸物加入量对高沸物转化率的影响。实验结果表明:在以N,N-二丁基-1-丁胺为催化剂、合成高沸物为原料、HCl加入量为13%(w)的条件下,高沸物转化率为83.10%,二甲基二氯硅烷收率为23.78%;合成高沸物中精馏高沸物加入量为9.0%(w)时,高沸物转化率最高,为85.58%。     

污水污泥裂解及其性能的研究

以碘吸附值为裂解残渣吸附性能的指标,通过单因素实验和正交实验,确定了制备裂解残渣的最佳工艺条件,并对残渣的表面元素组成、孔结构组成、晶相组成和吸附性能等性质进行了表征。结果显示：以浓度均为5 mol/L的ZnCl₂和H₂SO₄作活化剂、复配比2∶1、活化温度600℃、活化时间1 h、固液比1∶2.5,制得的裂解残渣酸洗后碘值平均值可达892.8 mg/g;用制备的裂解残渣对苯酚废水进行处理,室温下振荡5 min,苯酚去除率即可达到87.9%,且符合Langmuir吸附等温线方程和Freundlich吸附等温线方程。     

Batch sorption dynamics and equilibrium for the removal of lead ions from aqueous phase using activated carbon developed from coffee residue activated with zinc chloride

Lignocellulosic materials are good precursors for the production of activated carbon. In this work, coffee residue has been used as raw material in the preparation of powder activated carbon by the method of chemical activation with zinc chloride for the sorption of Pb(II) from dilute aqueous solutions.The influence of impregnation ratio (ZnCl₂/coffee residue) on the physical and chemical properties of the prepared carbons was studied in order to optimize this parameter. The optimum experimental condition for preparing predominantly microporous activated carbons with high pore surface area (890 m²/g) and micropore volume (0.772 cm³/g) is an impregnation ratio of 100%. The developed activated carbon shows substantial capability to sorb lead(II) ions from aqueous solutions and for relative impregnation ratios of 75 and 100%, the maximum uptake is practically the same. Thus, 75% represents the optimal impregnation ratio.Batch experiments were conducted to study the effects of the main parameters such as contact time, initial concentration of Pb(II), solution pH, ionic strength and temperature. The maximum uptake of lead(II) at 25 °C was about 63 mg/g of adsorbent at pH 5.8, initial Pb(II) concentration of 10 mg/L, agitation speed of 200 rpm and ionic strength of 0.005 M. The kinetic data were fitted to the models of pseudo-first order and pseudo-second order, and follow closely the pseudo-second order model. Equilibrium sorption isotherms of Pb(II) were analyzed by the Langmuir, Freundlich and Temkin isotherm models. The Freundlich model gives a better fit than the others.Results from this study suggest that activated carbon produced from coffee residue is an effective adsorbent for the removal of lead from aqueous solutions and that ZnCl₂ is a suitable activating agent for the preparation of high-porosity carbons.